Towards a Multi-Pixel Photon-to-Digital Converter for Time-Bin Quantum Key Distribution
Simon Carrier, Michel Labrecque-Dias, Ramy Tannous, Pascal Gendron, Frederic Nolet, Nicolas Roy, Tommy Rossignol, F. Vachon, Samuel Parent, Thomas D. Jennewein, Serge A. Charlebois, J.‐F. Pratte
We present an integrated single-photon detection device custom designed for quantum key distribution (QKD) with time-bin encoded single photons. We implemented and demonstrated a prototype photon-to-digital converter (PDC) that integrates an 8 × 8 single-photon avalanche diode (SPAD) array with on-chip digital signal processing built in TSMC 65 nm CMOS. The prototype SPADs are used to validate the QKD functionalities with an array of time-to-digital converters (TDCs) to timestamp and process the photon detection events. The PDC uses window gating to reject noise counts and on-chip processing to sort the photon detections into respective time-bins. The PDC prototype achieved a 22.7 ps RMS timing resolution and demonstrated operation in a time-bin setup with 158 ps time-bins at an optical wavelength of 410 nm. This PDC can therefore be an important building block for a QKD receiver and enables compact and robust time-bin QKD systems with imaging detectors.
We present an integrated single-photon detection device custom designed for quantum key distribution (QKD) with time-bin encoded single photons. We implemented and demonstrated a prototype photon-to-digital converter (PDC) that integrates an 8 × 8 single-photon avalanche diode (SPAD) array with on-chip digital signal processing built in TSMC 65 nm CMOS. The prototype SPADs are used to validate the QKD functionalities with an array of time-to-digital converters (TDCs) to timestamp and process the photon detection events. The PDC uses window gating to reject noise counts and on-chip processing to sort the photon detections into respective time-bins. The PDC prototype achieved a 22.7 ps RMS timing resolution and demonstrated operation in a time-bin setup with 158 ps time-bins at an optical wavelength of 410 nm. This PDC can therefore be an important building block for a QKD receiver and enables compact and robust time-bin QKD systems with imaging detectors.
Single-photon detection concept is the most crucial factor that determines the performance of quantum key distribution (QKD) systems. In this paper, a simulator with time domain visualizers and configurable parameters using continuous time simulation approach is presented for modeling and investigating the performance of single-photon detectors operating in Gieger mode at the wavelength of 830 nm. The widely used C30921S silicon avalanche photodiode was modeled in terms of avalanche pulse, the effect of experiment conditions such as excess voltage, temperature and average photon number on the photon detection efficiency, dark count rate and afterpulse probability. This work shows a general repeatable modeling process for significant performance evaluation. The most remarkable result emerged from the simulated data generated and detected by commercial devices is that the modeling process provides guidance for single-photon detectors design and characterization. The validation and testing results of the single-photon avalanche detectors (SPAD) simulator showed acceptable results with the theoretical and experimental results reported in related references and the device's data sheets.
The implementation and commercialization of quantum cryptography technologies have to face some challenges related to the development of single-photon detectors operating at 1550 nm. The main requirements are: i) high detection efficiency; ii) low noise; iii) high count rate; iv) low timing jitter. Different technologies are currently available for single-photon detection at 1550 nm, but semiconductor devices (like Single-Photon Avalanche Diode, SPAD) offer a photon detection efficiency that is inherently higher than any photocathode employed in vacuum tube detectors. Additionally InGaAs/InP SPADs can detect single photons at 1550 nm with low noise when moderately cooled by means of thermo-electric coolers. Consequently, InGaAs/InP SPAD can be the enabling technology of practical quantum key distribution (QKD) systems, provided that the maximum count rate is increased above 1 Mcps. The main limit is the afterpulsing effect that usually sets too long (< 10 μs) a hold-off time after each avalanche ignition. We present the developments achieved in InGaAs/InP SPAD device design, fabrication technology and front-end electronics, aimed at decreasing the afterpulsing effect, while not impairing photon detection efficiency and timing jitter. The new InGaAs/InP SPADs provide count rates higher than 1 Mcps and temporal response with 60 ps Full-Width at Half Maximum and very short (30 ps time constant) tail. The front-end electronics includes a wide-band pulse generator able to gate the SPAD up to 133 MHz repetition rate. Eventually, a fast avalanche-quenching scheme minimizes quenching time to less than 1 ns, thus effectively reducing afterpulsing by decreasing the total charge flowing through the junction.
Time-to-Digital Converters (TDCs) are a crucial tool in a wide array of fields, in particular for quantum communication, where time taggers performance can severely affect the quality of the entire application. Nowadays, FPGA-based TDCs present a viable alternative to ASIC ones, once the non-linear behavior due to the intrinsic nature of the device is properly mitigated. To compensate for said nonlinearities, a calibration procedure is required, which should be maintained throughout its runtime. Here we present the design and the demonstration of a TDC that is FPGA-based showing a residual FWHM jitter of 27 ps, that is scalable for multichannel operation. The target application in Quantum Key Distribution (QKD) is discussed with a calibration method based on the exploitation of single-photon detection that does not require stopping the data acquisition or using any estimation methods, thus increasing accuracy and removing data loss. The calibration was tested in a relevant environment, investigating the behavior of the device between 5 °C and 80 °C. Moreover, our design is capable of continuously streaming up to 12 Mevents/s for up to ~1 week without the TDC overflowing making it ready for a real-life scenario deployment.
Quantum key distribution (QKD) is a rapidly maturing quantum photonic technology that allows for the distribution of secure cryptographic keys under no assumptions of the attacker's computing power. A key hurdle for its large-scale adoption is the reduction of its hardware size and cost, for which photonic integration is a promising solution. However, there exists no perfect material platform for this task, and for QKD this leads to either design compromises or core functionalities left off-chip. This thesis makes the assertion that hybrid integrated photonics, where one combines two chip materials into one structure, can resolve some of these issues. Firstly, we present an edge-coupled hybrid transceiver that combines a silicon nitride waveguide chip with an indium phosphide modulator chip. Secondly, we pursue the hybrid integration of the single photon detectors. However, the appropriate solution of fast-gated telecom-wavelength avalanche diodes did not exist, and so in the second experimental chapter of this thesis we develop and characterise a linear array of GHz-gated InGaAs/InP SPADs. Finally, we demonstrate a hybrid integrated QKD receiver, consisting of a silica waveguide chip with the aforementioned SPAD array. This represents the first integrated QKD receiver without requiring either external single photon detectors or cryogenic cooling. The results support the benefits of hybrid integration for quantum key distribution, but also more widely for quantum photonic technology as it continues to emerge.
Photonic integration is a promising route to miniaturise the hardware of quantum key distribution (QKD), yet the monolithic integration of single-photon detectors remains a significant challenge. QKD receiver chips integrating superconducting detectors have been demonstrated, but their requirement for cryogenic cooling restricts their practical applications. High-frequency gated single-photon avalanche diodes (SPADs) provide a mature non-cryogenic alternative, and their fabrication into compact arrays would enable scalable hybrid integration. However, this faces several challenges related to efficient GHz array gating, inter-pixel crosstalk, and scalable waveguide coupling, which to date remain unaddressed. Here, we overcome the key challenges and develop GHz-gated InGaAs/InP SPAD arrays with performance viable for QKD and negligible inter-pixel crosstalk. We combine the arrays with low-loss silica waveguide chips to produce compact hybrid QKD receivers and perform BB84 protocol experiments, achieving secure key rates over 2 Mbps at short distances and 15 kbps over 100 km of fibre. Our work provides a method for flexible and scalable integration of waveguide-coupled SPADs for quantum information processing applications.
This paper introduces the design of a single photon detector based on the AT89C51 single chip microcontroller for quantum key distribution at telecommunication wavelengths. An avalanche photodiode (APD) is operated in Geiger mode and stabilized at temperature of 228K for translating the single photon signals into electrical pulses. The photon induced avalanche pulses are amplified and converted to digital data. The microcontroller discriminates the data, counting the number of photons, and then displays the photon number and the detection efficiency on a LCD display. The instrument can effectively support the study of quantum key distribution.