Investigation of an Integrated Two-Stage Reflective Quantum Amplifier

Xinyu Wu, Rutian Huang, Jianshe Liu +1 more

G.V. Prokopenko, D Balashov, S. V. Shitov +2 more

A 6 mm/spl times/6 mm chip comprising two identical DC SQUID based amplifiers (SQAs) has been designed, fabricated and tested as a two-stage RF amplifier in a frequency range 3.5-4.0 GHz. Each SQA consists of a double washer type DC SQUID with novel integrated input resonant circuit. The reflection coefficient of both input and output of the SQA has been measured in the two stage configuration. To avoid SQA saturation at the wide band noise tests a tunable 40 MHz bandpass YIG-filter has been used. The following parameters of the two-stage SQA have been measured at the 3.65 GHz: gain of (17.5/spl plusmn/1) dB, 3 dB bandwidth of about 250 MHz, and noise temperature (4.0/spl plusmn/0.5)K what corresponds to intrinsic flux noise S/spl phi//sup 1/2//spl ap/0.6 /spl mu//spl Phi//sub 0/Hz/sup -1/2/ and energy sensitivity /spl epsiv//sub i//spl ap/75 /spl planck/ (7.8/spl middot/10/sup -33/ J/Hz). If the measured RF mismatch between the input/output of SQA and source signal/post-amplifier is taken into account a gain of (20.5/spl plusmn/1.5) dB and noise temperature as low as (2.5/spl plusmn/1.0) K (intrinsic flux noise S/spl phi//sup 1/2//spl ap/0.4 /spl mu//spl Phi//sub 0/Hz/sup -1/2/, energy sensitivity /spl epsiv//sub i//spl ap/47 /spl planck/) can be estimated.

Eugene B. Gordon, Iu. L. Moskvin

M. Kiviranta

We have designed and fabricated an integrated two-stage SQUID amplifier, requiring only one bias line and one flux setpoint line. From the biasing viewpoint the two stages are connected in series while from the signal propagation viewpoint the stages are cascaded. A proof-of principle demonstration at T = 4.2 K is presented.

Olivia Lanes, Tzu-Chiao Chien, Xi Cao +7 more

Rutian Huang, Yunfan Shi, Jianshe Liu +1 more

Abstract A broadband on-chip multistage quantum amplifier (MQA) for reading out multiple superconducting qubits is proposed. The bandwidth of quantum amplifier is enhanced by concatenating amplifiers with modular nonreciprocal elements, which are superconducting isolators and circulators based on tunable inductor bridge. The circuit model of MQA is built and simulated. The variation of bandwidth, gain and gain-bandwidth product (GBP) of MQA with the number of stages and bandpass of the constitutive amplifiers are simulated. It is revealed that the bandwidth can be as large as ∼3.2 GHz with a gain of 20 dB at 4–8 GHz frequency range. For a 4-stage MQA composed of four quantum amplifiers with 20 dB gain and 0.3 GHz BW-pass, the bandwidth is 2.14 GHz at 20 dB gain, which is quite cost-efficient. Due to its non-reciprocity, MQA can effectively prevent signals from reflecting to quantum processors. In addition, MQA breaks the limitation of GBP and is easy to integrate with superconducting circuits. The MQA would play a crucial role in the high-fidelity readout of multiple qubits in large-scale superconducting quantum computers.