Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Sensors and Actuators A Physical

Amplitude-modulated RF field Rydberg atomic sensor based on homodyne technique

Kai Yang, Ruiqi Mao, Qiang An, Jianbing Li, Zhanshan Sun, Yunqi Fu

Published Jan 11, 2023• 19 citations
Publisher
DOI
10.1016/j.sna.2023.114167

Related papers

Fiber-coupled Vapor Cell for a Portable Rydberg Atom-based RF Electric Field Sensor

Matthew T. Simons, Joshua A. Gordon, Christopher L. Holloway

Applied Optics•Aug 1, 2018•0 citations

Advances in Rydberg atom-based radio frequency sensing

James P. Shaffer

Optical and Quantum Sensing and Precision Metrology II•Mar 13, 2024•0 citations

Probing bandwidth and sensitivity in Rydberg atom sensing via optical homodyne and rf heterodyne detection

Dixith Manchaiah, Stone Oliver, Samuel Berweger +2 more

Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.

arXiv:2509.20632•Physical Review A•Dec 22, 2025•5 citations

Embedding a Rydberg Atom-Based Sensor Into an Antenna for Phase and Amplitude Detection of Radio-Frequency Fields and Modulated Signals

Matthew T. Simons, Abdulaziz H. Haddab, Joshua A. Gordon +2 more

We demonstrate a Rydberg atom-based sensor embedded in a parallel-plate waveguide (PPWG) for amplitude and phase detection of a radio-frequency (RF) electric field. This embedded atomic sensor is also capable of receiving modulated communications signals. In this configuration, the PPWG antenna serves two functions. First, the PPWG antenna acts as a source for a local oscillator (LO) field. The LO is required to use an atomic vapor cell (a glass cell containing a Rydberg atom vapor) as a Rydberg atom-based mixer, which detects the amplitude and phase of a second RF field incident from some remote location. The second function of the PPWG antenna is to capture the RF field arriving from a remote location and concentrate it at the location of the atomic vapor cell for detection. To demonstrate this, we show several examples of phase and amplitude measurements of an RF field with the embedded Rydberg-atom sensor. We also demonstrate the discrimination of the polarization of an RF field and the ability to receive phase-modulated carrier communications signals with this integrated atomic sensor. Embedding the atomic sensor in an antenna allows for the full characterization of a radio frequency field, in that the magnitude, phase, and polarization of an RF field can be measured with one compact integrated quantum-based sensor. Furthermore, the embedded sensor head allows one to easily vary the LO in order to maximize the ability to measure phase and amplitude of the field or modulated signal.

IEEE Access•Jan 1, 2019•98 citations

Enhanced Sensitivity of Rydberg Atom-Based Radio Frequency Field Measurements Using Heterodyne Detection

Joshua Gordon, Matthew T. Simons, Abdulaziz H. Haddab +1 more

Bulletin of the American Physical Society•May 28, 2019•0 citations

Quantum-Based Amplitude Modulation Radio Receiver Using Rydberg Atoms

Zhenfei Song, Wanfeng Zhang, Xiaochi Liu +4 more

The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.

IEEE Globecom Workshops (GC Wkshps)•Dec 1, 2018•8 citations
Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.
We demonstrate a Rydberg atom-based sensor embedded in a parallel-plate waveguide (PPWG) for amplitude and phase detection of a radio-frequency (RF) electric field. This embedded atomic sensor is also capable of receiving modulated communications signals. In this configuration, the PPWG antenna serves two functions. First, the PPWG antenna acts as a source for a local oscillator (LO) field. The LO is required to use an atomic vapor cell (a glass cell containing a Rydberg atom vapor) as a Rydberg atom-based mixer, which detects the amplitude and phase of a second RF field incident from some remote location. The second function of the PPWG antenna is to capture the RF field arriving from a remote location and concentrate it at the location of the atomic vapor cell for detection. To demonstrate this, we show several examples of phase and amplitude measurements of an RF field with the embedded Rydberg-atom sensor. We also demonstrate the discrimination of the polarization of an RF field and the ability to receive phase-modulated carrier communications signals with this integrated atomic sensor. Embedding the atomic sensor in an antenna allows for the full characterization of a radio frequency field, in that the magnitude, phase, and polarization of an RF field can be measured with one compact integrated quantum-based sensor. Furthermore, the embedded sensor head allows one to easily vary the LO in order to maximize the ability to measure phase and amplitude of the field or modulated signal.
The highly-excited Rydberg states are with a unique property of radio-frequency (RF) resonance, and Rydberg atoms at room temperature are promising for developing a broadband RF electric field sensor and relevant metrology standards. In this paper, the working mechanism of an atomic amplitude-modulation(AM) radio receiver is investigated in detail, and various factors affecting the communication quality are discussed. The modulation RF signal can be directly retrieved by measuring the transmission of a probe laser at resonance of rubidium D2 transition using a fast photo-diode detector, without any conventional demodulation process. Various communication experiments are tested at a 10.22 GHz carrier, and a modulation bandwidth of 1 MHz and an acceptable data transfer rate of about 1 Mbps have been achieved using current detection techniques. Owing to a potential high sensitivity and ultra-broadband capability of free-space RF field sensing, the quantum receiver has great significance compared with conventional electronics-based receivers, including but not limited to a weak signal, long-distance, and broadband communication in free space or via a fiber link.