Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Astronomische Nachrichten

Coherent quantum states in resonant‐mass gravitational wave detectors

Carlos Frajuca, Lucas B. Selbach, Douglas Alves da Silva, Dinalva Aires de Sales, Fabrício Ferrari, Nadja S. Magalhães

Published Jan 1, 2023• 3 citations
Publisher

Abstract

Abstract This work describes the importance of quantum coherent states when a resonant‐mass gravitational wave detector absorbs energy from a gravitational wave in an amount very close to the quantum limit. In this case, quantum non‐demolition measurements become essential as well. As the main result, for a coherent‐state signal, the detector behaves as if the signal was a classical one.

DOI
10.1002/asna.20220129

Related papers

Advanced interferometry, quantum optics and optomechanics in gravitational wave detectors

David E. McClelland, N. Mavalvala, Y. Chen +1 more

Abstract Currently operating laser interferometric gravitational wave detectors are limited by quantum noise above a few hundred Hertz. Detectors that will come on line in the next decade are predicted to be limited by quantum noise over their entire useful frequency band (from 10 Hz to 10 kHz). Further sensitivity improvements will, therefore, rely on using quantum optical techniques such as squeezed state injection and quantum non‐demolition, which will, in turn, drive these massive mechanical systems into quantum states. This article reviews the principles behind these optical and quantum optical techniques and progress toward there realization.

Laser & Photonics Review•Mar 14, 2011•80 citations

Quantum limits on resonant-mass gravitational-radiation detectors

J. N. Hollenhorst

The methods of quantum detection theory are applied to a resonant-mass gravitational-radiation antenna. Quantum sensitivity limits are found which depend strongly on the quantum state in which the antenna is prepared. Optimum decision strategies and their corresponding sensitivities are derived for some important initial states. The linear detection limit (${E}_{min}\ensuremath{\sim}\ensuremath{\hbar}\ensuremath{\omega}$) is shown to apply when the antenna is prepared in a coherent state. Preparation of the antenna in an excited energy eigenstate or in a state highly localized in position or momentum space leads to increased sensitivity. A set of minimum-uncertainty states for phase-sensitive detection is introduced.

Physical review. D. Particles, fields, gravitation, and cosmology/Physical review. D. Particles and fields•Mar 15, 1979•340 citations

Quantum Measurement Theory in Gravitational-Wave Detectors

S. L. Danilishin, Farid Ya Khalili

The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting. 1 ar

•Jan 1, 2012•87 citations

Quantum Measurement Theory in Gravitational-Wave Detectors

S. L. Danilishin, Farid Ya. Khalili

The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting.

arXiv:1203.1706•Living Reviews in Relativity•Apr 26, 2012•218 citations

Quantum Measurements in Gravitational-Wave Detectors

Yanbei Chen

Laser interferometric gravitational-wave detectors measure tiny motions of macroscopic test masses. Complex interferometer configurations and quantum optical techniques will be used to enhance sensitivity in future interferometers, which will reach and surpass the Standard Quantum Limit.

Frontiers in Optics•Jan 1, 2006•0 citations

The uncertainty principle in resonant gravitational wave antennae and quantum non-demolition measurement schemes

Pierluigi Fortini, Roberto Onofrio, Alessandro Rioli

A review of current efforts to approach and to surpass the fundamental limit in the sensitivity of the Weber type gravitational wave antennae is reported. Applications of quantum non-demolition techniques to the concrete example of an antenna resonant with the transducer are discussed in detail. Analogies and differences from the framework of the squeezed states in quantum optics are discussed.

•Jan 1, 1993•0 citations
Abstract This work describes the importance of quantum coherent states when a resonant‐mass gravitational wave detector absorbs energy from a gravitational wave in an amount very close to the quantum limit. In this case, quantum non‐demolition measurements become essential as well. As the main result, for a coherent‐state signal, the detector behaves as if the signal was a classical one.
Abstract Currently operating laser interferometric gravitational wave detectors are limited by quantum noise above a few hundred Hertz. Detectors that will come on line in the next decade are predicted to be limited by quantum noise over their entire useful frequency band (from 10 Hz to 10 kHz). Further sensitivity improvements will, therefore, rely on using quantum optical techniques such as squeezed state injection and quantum non‐demolition, which will, in turn, drive these massive mechanical systems into quantum states. This article reviews the principles behind these optical and quantum optical techniques and progress toward there realization.
The methods of quantum detection theory are applied to a resonant-mass gravitational-radiation antenna. Quantum sensitivity limits are found which depend strongly on the quantum state in which the antenna is prepared. Optimum decision strategies and their corresponding sensitivities are derived for some important initial states. The linear detection limit (${E}_{min}\ensuremath{\sim}\ensuremath{\hbar}\ensuremath{\omega}$) is shown to apply when the antenna is prepared in a coherent state. Preparation of the antenna in an excited energy eigenstate or in a state highly localized in position or momentum space leads to increased sensitivity. A set of minimum-uncertainty states for phase-sensitive detection is introduced.
The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting. 1 ar
The fast progress in improving the sensitivity of the gravitational-wave detectors, we all have witnessed in the recent years, has propelled the scientific community to the point at which quantum behavior of such immense measurement devices as kilometer-long interferometers starts to matter. The time when their sensitivity will be mainly limited by the quantum noise of light is around the corner, and finding ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of the Standard Quantum Limit and the methods of its surmounting.