Atom interferometry has hugely benefitted from advances made in cold atom physics over the past twenty years, and ultra-precise quantum sensors are now available for a wide range of applications [1]. In particular, cold atom interferometers have shown excellent performances in the field of acceleration and rotation measurements [2,3], and are foreseen as promising candidates for navigation, geophysics, geo-prospecting and tests of fundamental physics such as the Universality of Free Fall (UFF). In order to carry out a test of the UFF with atoms as test masses, one needs to compare precisely the accelerations of two atoms with different masses as they fall in the Earth’s gravitational field. The sensitivity of atom interferometers scales like the square of the time during which the atoms are in free fall, and on ground this interrogation time is limited by the size of the experimental setup to a fraction of a second. Sending an atom interferometer in space would allow for several seconds of excellent free-fall conditions, and tests of the UFF could be carried out with precisions as low as 10-15 [4]. However, cold atoms experiments rely on complex laser systems, which are needed to cool down and manipulate the atoms, and these systems are usually very sensitive to temperature fluctuations and vibrations. In addition, when operating an inertial sensor, vibrations are a major issue, as they deteriorate the performances of the instrument. This is why cold atom interferometers are usually used in ground based facilities, which provide stable enough environments. In order to carry out airborne or space-borne measurements, one has to design an instrument which is both compact and stable, and such that vibrations induced by the platform will not deteriorate the sensitivity of the sensor. We report on the operation of an atom interferometer on board a plane carrying out parabolic flights (Airbus A300 Zero-G, operated by Novespace). We have constructed a compact and stable laser setup, which is well suited for onboard applications. Our goal is to implement a dual-species Rb-K atom interferometer in order to carry out a test of the UFF in the plane. In this perspective, we are designing a dual-wavelength laser source, which will enable us to cool down and coherently manipulate the quantum states of both atoms. We have successfully tested a preliminary version of the source and obtained a double species magneto-optical trap (MOT).
We miniaturized the complex optical system responsible for the cooling, pumping, and imaging of an on-chip-based cold-atom inertial sensor. This optical bench uses bonded miniature optics and includes all the necessary optical functions. The bench has a volume of 35×25×5cm 3 . We developed a laser frequency lock adapted to the optical bench using saturated absorption in a rubidium cell. The entire laser source based on frequency doubling of 1.56 µm fiber lasers, including the control system and the saturated absorption module, fits in a 5 U rack. Using the miniaturized bench, we realized two- and three-dimensional magneto-optical traps for rubidium 87 atoms.
A transportable atom interferometer-based gravity gradiometer has been developed at JPL to carry out measurements of Earth's gravity field at ever finer spatial resolutions, and to facilitate high-resolution monitoring of temporal variations in the gravity field from ground- and flight-based platforms. Existing satellite-based gravity missions such as CHAMP and GRACE measure the gravity field via precise monitoring of the motion of the satellites; i.e. the satellites themselves function as test masses. JPL's quantum gravity gradiometer employs a quantum phase measurement technique, similar to that employed in atomic clocks, made possible by recent advances in laser cooling and manipulation of atoms. This measurement technique is based on atomwave interferometry, and individual laser-cooled atoms are used as drag-free test masses. The quantum gravity gradiometer employs two identical atom interferometers as precision accelerometers to measure the difference in gravitational acceleration between two points (Figure 1). By using the same lasers for the manipulation of atoms in both interferometers, the accelerometers have a common reference frame and non-inertial accelerations are effectively rejected as common mode noise in the differential measurement of the gravity gradient. As a result, the dual atom interferometer-based gravity gradiometer allows gravity measurements on a moving platform, while achieving the same long-term stability of the best atomic clocks. In the laboratory-based prototype (Figure 2), the cesium atoms used in each atom interferometer are initially collected and cooled in two separate magneto-optic traps (MOTs). Each MOT, consisting of three orthogonal pairs of counter-propagating laser beams centered on a quadrupole magnetic field, collects up to 10(exp 9) atoms. These atoms are then launched vertically as in an atom fountain by switching off the magnetic field and introducing a slight frequency shift between pairs of lasers to create a moving rest frame for the trapped atoms. While still in this moving-frame molasses, the laser frequencies are further detuned from the atomic resonance (while maintaining this relative frequency shift) to cool the atom cloud's temperature to 2 K or below, corresponding to an rms velocity of less than 2 cm/s. After launch, the cold atoms undergo further state and velocity selection to prepare for atom interferometry. The atom interferometers are then realized using laser-induced stimulated Raman transitions to perform the necessary manipulations of each atom, and the resulting interferometer phase is measured using laser-induced fluorescence for state-normalized detection. More than 20 laser beams with independent controls of frequency, phase, and intensity are required for this measurement sequence. This instrument can facilitate the study of Earth's gravitational field from surface and air vehicles, as well as from space by allowing gravity mapping from a low-cost, single spacecraft mission. In addition, the operation of atom interferometer-based instruments in space offers greater sensitivity than is possible in terrestrial instruments due to the much longer interrogation times available in the microgravity environment. A space-based quantum gravity gradiometer has the potential to achieve sensitivities similar to the GRACE mission at long spatial wavelengths, and will also have resolution similar to GOCE for measurement at shorter length scales.
Atom optics has been a highly active field of research with many scientific breakthroughs over the past two decades, largely due to successful advances in laser technology, microfabrication techniques, and the development of laser cooling and trapping of neutral atoms. This dissertation details several atom optics experiments with the motivation to develop tools and techniques for precision atom wave interferometry. It provides background information about atom optics and the fundamentals behind laser cooling and trapping, including basic techniques for cold gas thermometry and absorptive detection of atoms. A brief overview of magnetic trapping and guiding in tight wire-based traps is also provided before the experimental details are presented. ❧ We developed a novel laser source of 780 nm light using frequency-doubled 1560 nm fiber amplifier. This laser system provided up to a Watt of tunable frequency stabilized light for two Rb laser cooling and trapping experiments. One system generates Bose-Einstein condensates in an optical trap while the second is based on atom chip magnetic traps. The atom chip system, detailed in this thesis, was designed and built to develop the tools necessary for transport and loading large numbers of cold atoms and explore the potential for guided atom interferometry. Techniques and results from this experiment are presented, including an efficient magnetic transport and loading method to deliver cold atom to atom chip traps. We also developed a modeling tool for the magnetic fields formed by coiled wire geometries, as well as planar wire patterns. These models helped us design traps and determine adiabatic transportation of cold atoms between macro-scale traps and micro-traps formed on atom chips. Having achieved near unity transfer efficiency, we demonstrated that this approach promises to be a consistent method for loading large numbers of atoms into micro-traps. Furthermore, we discuss an in situ imaging technique to investigate magnetic field contours of the traps and the dynamics of atoms within those confining potentials. We also controlled the propagation along the atom chip guides by accelerating atoms with longitudinal magnetic gradients, and investigated an atom focusing scheme. ❧ While the atom chip wire guides perform a role analogous to optical fibers guiding light waves, ""free space"" cold atoms offer great opportunity for precision interferometry. We describe a second on-going atom optics experiment that measures gravity gradients using a pair of atom fountain interferometers separated by one meter. We have demonstrated Gravity Gradiometer resolution down to 4x10⁻⁹ g/m using a 40 kg test mass. The atomic physics subsystem is described in detail, including the vacuum, cold atom source, optics, magnetic coils and shields, and vibration isolation and compensation. The system is designed to be a compact, robust, transportable instrument, taking strides towards future gravity gradient measurements in the field. In the realm of space applications, there has been interest for micro-gravity science experiments aboard the International Space Station, along with instrument development for gravity mapping of Earth and planetary bodies with satellite-based instruments. Furthermore, there are ground-based applications for gravity imaging of local density distributions, precision measurement of gravity, as well as proposals for redefining the kilogram, detecting gravitational waves and determining the Gravitational constant.
Atom interferometry is a maturing quantum technology which provides one of the most precise approaches to explore fundamental physics, e.g. to search for dark matter, and one day to observe gravitational waves in the frequency range from 10 mHz - 10 Hz. Standard atom interferometers use Bragg or Raman two-photon transitions for the coherent manipulation of matter waves. In a Michelson configuration for atom-aided gravitational waves detection, two orthogonal arms are built to reject laser noise, in the same way as optical interferometers. Atom interferometers utilizing an optical clock transition for coherent manipulation are less affected by the technical noise of the laser, and as a result that single baseline detectors become feasible.At LP2N, we are building a vertical gravity-gradiometer based on atom interferometry using strontium atoms probed on such a clock transition. The final experimental setup will implement a 6-meter tall atomic fountain to realize gradiometry with two or more separated atomic clouds.In my dissertation, I present the realization of the experimental setup in all its sub-systems, and the first experiments with atoms at millikelvin temperature obtained with the first cooling stage with blue light. The laser system for the second red cooling phase and for the coherent manipulation is ready; meanwhile, we realized a dual-frequency Zeeman slower that improves the atomic flux by a factor of six. We also present a study of an original scheme to achieve pulsed and fast light-atom interaction in a narrow-linewidth cavity by exploiting the Stark shift as a high bandwidth switch; this technique could open to the use of narrow-linewidth cavities – and notably their high power buildup - in several contexts, like atom interferometry and quantum information.