Abstract Large-scale superconducting quantum computing systems entail high-fidelity control and readout of large numbers of qubits at millikelvin temperatures, resulting in a massive input-output bottleneck. Cryo-electronics, based on complementary metal-oxide-semiconductor (CMOS) technology, may offer a scalable and versatile solution to overcome this bottleneck. However, detrimental effects due to cross-coupling between the electronic and thermal noise generated during cryo-electronics operation and the qubits need to be avoided. Here we present an ultra-low power radio-frequency (RF) multiplexing cryo-electronics solution operating below 15 mK that allows for control and interfacing of superconducting qubits with minimal cross-coupling. We benchmark its performance by interfacing it with a superconducting qubit and observe that the qubit’s relaxation times (T1) are unaffected, while the coherence times (T2) are only minimally affected in both static and dynamic operation. Using the multiplexer, single qubit gate fidelities above 99.9%, i.e., well above the threshold for surface-code based quantum error-correction, can be achieved with appropriate thermal filtering. In addition, we demonstrate the capability of time-division-multiplexed qubit control by dynamically windowing calibrated qubit control pulses. Our results show that cryo-CMOS multiplexers could be used to significantly reduce the wiring resources for large-scale qubit device characterization, large-scale quantum processor control and quantum error correction protocols.
Abstract Quantum computers based on solid state qubits have been a subject of rapid development in recent years. In current noisy intermediate-scale quantum technology, each quantum device is controlled and characterised through a dedicated signal line between room temperature and base temperature of a dilution refrigerator. This approach is not scalable and is currently limiting the development of large-scale quantum system integration and quantum device characterisation. Here we demonstrate a custom designed cryo-CMOS multiplexer operating at 32 mK. The multiplexer exhibits excellent microwave properties up to 10 GHz at room and millikelvin temperatures. We have increased the characterisation throughput with the multiplexer by measuring four high-quality factor superconducting resonators using a single input and output line in a dilution refrigerator. Our work lays the foundation for large-scale microwave quantum device characterisation and has the perspective to address the wiring problem of future large-scale quantum computers.
To address the scalability challenges of traditional series-shunt RF switches, this article presents a scalable multipole N-throw (MPNT) RF switch designed for qubit quantum computers operating at cryogenic temperatures below 1 K. To demonstrate the scalability of the proposed switch in terms of the number of ports, a 4P4T switch with a series-resonance configuration was implemented. The 4P4T switch was fabricated using 65-nm bulk CMOS technology and measured at 300, 77, and 0.6 K using an on-PCB thru-reflect-line (TRL) de-embedding technique. The maximum insertion loss was measured to be 2.5 dB at 600 mK in a dilution refrigerator. The maximum isolation at 600 mK was measured as 25 dB.
Cryogenic CMOS control and readout circuits tightly interfaced with the qubits have emerged as a promising solution for future quantum computers with tens-of-thousands to millions of qubits [1] –[5]. A lownoise cryo-CMOS receiver at
3−4 K integrated tightly with the lowcryogenic quantum processor can relax or even potentially eliminated the need for the HEMT LNA, and keep the whole control loop at cryogenic temperature, hence avoiding any high-speed interconnects to room temperature (Fig. 1). Additionally, wide bandwidths in the receiver enables qubit-multiplexing, where qubits can be frequency multiplexed with a spacing of
10MHz−40MHz, allowing anywhere from 10’s-100’s of qubits to be packed in to a single readout line with gigahertz-scale bandwidths. A second critical metric is power consumption, since the cooling power available in a typical dilution refrigerator is limited to a few watts at
3−4 K. Therefore, the control and readout circuits should be designed with low power consumption, projected to be
<1 mW per qubit (Fig. 1). While there has been initial progress in the design of cryo-CMOS readout systems, a leap forward is required in their overall power consumption to be viable for future quantum systems. In this work, we showcase the design and implementation of the first sub-mWper-qubit cryo-CMOS RX - a wideband, I/Q-downconversion,
4 K receiver for qubit readout that achieves
>1.9GHz of IF bandwidth with
>50 dB conversion gain and
0.7 dB NF while consuming only
17 mW of power consumption, thanks to various design techniques including near-threshold operation and low-1/f-noise passive mixers, representing
3−5× lower power consumption than prior works [2]–[3] while achieving similar noise, BW and gain performance. In addition, we demonstrate a real-time qubit read-out measurement by integrating our cryogenic-CMOS receiver with a transmon qubit.
Large-scale cryogenic quantum systems are constrained by an input-output bottleneck between room-temperature electronics and millikelvin stages, particularly in superconducting qubit platforms. This bottleneck is most acute for output lines, where bulky and expensive microwave components limit scalability. A promising approach for scalable characterization and testing is to perform signal multiplexing directly at the qubit plane. We demonstrate a cryogenic CMOS (cryoCMOS) RF multiplexer operating at 10 millikelvin with record-low static power consumption of 200 pW. The device provides < 2 dB insertion loss and > 30 dB isolation across DC-8 GHz. Direct connection to transmon qubits marginally affects coherence times in the range of 100 microseconds, enabling multiplexing of readout, flux and, in principle, XY drive lines. This work introduces cryoCMOS multiplexers as valuable tools for scalable, high-throughput cryogenic characterization and testing, and advances co-integrated quantum-classical control for future large-scale quantum processors.
This paper presents a cryo-CMOS readout SoC based on a homodyne demodulation architecture with an integrating receiver. The homodyne receiver module for each qubit employs a dedicated local LO generator for a coherent detection under a frequency-division multiplexed multi-qubit readout environment. To mitigate the conventional issues of the homodyne demodulation in wireless communications, such as 1/f noise and DC offset by LO leakage, the proposed receiver incorporates effective calibration schemes by utilizing the specific operating conditions of the superconducting qubits. The implemented chip in 40 nm CMOS is tested at 4 K in a dilution refrigerator under an emulated SNR environment of superconducting qubit readout, i.e. -70 dBm input with a noise floor of -148 dBm/Hz. Measurement shows that circuit-only fidelity reaches 99% in 200 ns with an ideal single tone RF input. A back-to-back test using an on-chip 4-tone transmitter shows a 93 % circuit-only fidelity with 400 ns integration.