Quantum state interferography has recently been proposed as an interference-based technique for the measurement of the general qubit and pure qudit states [Phys. Rev. Lett. 125, 123601 (2020)]. This interferometric method exploits the relationship between the off-diagonal elements of the density matrix and the expectation values of non-Hermitian spin ladder operators. The extension of this method to a composite system is however nontrivial, as it involves the measurement of both single-photon and nonlocal multiphoton interferences. In this work, we present the theoretical analysis of the two-photon quantum state interferography of an arbitrary quantum state. We show that complete state information could in principle be obtained with two measurement settings and by recording six interferograms, using a single-photon sensitive imaging device. We then experimentally demonstrate two-photon nonlocal quantum state interferography of polarization-entangled photon pairs generated with type-I spontaneous parametric down conversion. Quantum state interferography of all four Bell states is performed. An upper bound on the separability of the bipartite states is established in terms of the visibility, phase average intensity, and phase shift of the interference patterns related to the antidiagonal elements of the matrix. Each of the four Bell states can be distinguished by the violation of these bounds uniquely.
Quantum state interferography has recently been proposed as an interference-based technique for the measurement of the general qubit and pure qudit states [Phys. Rev. Lett. 125, 123601 (2020)]. This interferometric method exploits the relationship between the off-diagonal elements of the density matrix and the expectation values of non-Hermitian spin ladder operators. The extension of this method to a composite system is however nontrivial, as it involves the measurement of both single-photon and nonlocal multiphoton interferences. In this work, we present the theoretical analysis of the two-photon quantum state interferography of an arbitrary quantum state. We show that complete state information could in principle be obtained with two measurement settings and by recording six interferograms, using a single-photon sensitive imaging device. We then experimentally demonstrate two-photon nonlocal quantum state interferography of polarization-entangled photon pairs generated with type-I spontaneous parametric down conversion. Quantum state interferography of all four Bell states is performed. An upper bound on the separability of the bipartite states is established in terms of the visibility, phase average intensity, and phase shift of the interference patterns related to the antidiagonal elements of the matrix. Each of the four Bell states can be distinguished by the violation of these bounds uniquely.
Quantum state tomography (QST) has been the traditional method for characterization of an unknown state. Recently, many direct measurement methods have been implemented to reconstruct the state in a resource efficient way. In this Letter, we present an interferometric method, in which any qubit state, whether mixed or pure, can be inferred from the visibility, phase shift, and average intensity of an interference pattern using a single-shot measurement-hence, we call it quantum state interferography. This provides us with a "black box" approach to quantum state estimation, wherein, between the incidence of the photon and extraction of state information, we are not changing any conditions within the setup, thus giving us a true single shot estimation of the quantum state. In contrast, standard QST requires at least two measurements for pure state qubit and at least three measurements for mixed state qubit reconstruction. We then go on to show that QSI is more resource efficient than QST for quantification of entanglement in pure bipartite qubits. We experimentally implement our method with high fidelity using the polarization degree of freedom of light. An extension of the scheme to pure states involving d-1 interferograms for d-dimensional systems is also presented. Thus, the scaling gain is even more dramatic in the qudit scenario for our method, where, in contrast, standard QST, without any assumptions, scales roughly as d^{2}.
At present, quantum entanglement is a resource, distributed to enable a variety of quantum information applications such as quantum key distribution, superdense coding, and teleportation. Necessarily, the distribution and characterization of entanglement is fundamental to its application. This dissertation details three research efforts to enable nonlocal entanglement detection, distribution, and characterization. Foremost of these efforts, we present the theory and demonstration of a nonlocal polarization interferometer capable of detecting entanglement and identifying Bell states statistically. This is possible due to the interferometer’s unique correlation dependence on the anti-diagonal elements of the density matrix, which have distinct bounds for separable states and unique values for the four Bell states. Second, we propose a nonlocal method of interferometrically mapping time-entangled photons to polarization entangled states, capitalizing on the strengths of both the robust temporal degree of freedom and the “easy to measure” polarization degree of freedom. Finally, we propose a method of estimating and representing correlation probabilities in nonlocal two-photon experiments using Bayes’ rule. Numerical simulations confirm that a vigorous consideration of the available information offers a correlation characterization superior to the standard approach.
Abstract Efficient certification and quantification of high dimensional entanglement of composite systems are challenging both theoretically as well as experimentally. Here, we demonstrate how to measure the linear entropy, negativity and the Schmidt number of bipartite systems from the visibility of Mach–Zehnder interferometer using single copies of the quantum state. Our result shows that for any two qubit pure bipartite state, the interference visibility is a direct measure of entanglement. We also propose how to measure the mutual predictability experimentally from the intensity patterns of the interferometric set-up without having to resort to local measurements of mutually unbiased bases. Furthermore, we show that the entanglement witness operator can be measured in a interference setup and the phase shift is sensitive to the separable or entangled nature of the state. Our proposal bring out the power of Interferometric set-up in entanglement detection of pure and several mixed states which paves the way towards design of entanglement meter.
Many quantum information protocols require a Bell-state measurement of entangled systems. Most optical Bell-state measurements utilize two-photon interference at a beam splitter. By creating polarization-entangled photons with spontaneous parametric down-conversion using a first-order Hermite-Gaussian pump beam, we invert the usual interference behavior and perform an incomplete Bell-state measurement in the coincidence basis. We discuss the possibility of a complete Bell-state measurement in the coincidence basis using hyperentangled states ( Phys. Rev. A, 58 (1998) R2623).
The nascent field of quantum information offers the promise of dramatic speed increases for certain types of computation and logical protocols which are classically impossible. The phenomenon of nonlocality is fundamental to this study, and polarization-entangled photons o er a clean, bright, and stable system for its experimental investigation. This thesis investigates, both experimentally and theoretically, the creation, manipulation, and measurement of polarization-entangled photon pairs. Our entangled photon pairs are created through spontaneous parametric down-conversion within a pair of adjacent, orthogonally oriented nonlinear crystals. The quality and brightness of this source is then dramatically improved through the use of birefringent crystals which compensate for an angle-dependent phase shift. The use of these compensation crystals has allowed measured count rates of two million pairs per second with 97.7% fidelity (with a maximally entangled state) or alternately, ten thousand pairs per second with 99.5% fidelity. By manipulating these entangled states, it is possible to study both how they change and how they can be used. We discuss the theory of state manipulation and the experimental implementation of extremely precise single-qubit operations. To study the operations themselves, we use quantum process tomography to characterize them and have successfully implemented the first experimental realization of ancilla-assisted process tomography. To study decoherence, we implemented the first experimental decoherence-free subspace. By using techniques developed during these investigations, we are able to transform our source of entangled photons into a source of any two-photon polarization state, mixed or pure. Developing new techniques for state creation and manipulation is possible because of simultaneous development in state measurement. In addition to detailing both a theoretical analysis and experimental instructions for state tomography, we experimentally and theoretically compared state tomography with tests of local realism (Bell inequalities) and entanglement witnesses (an entanglement detection technique). In the process, we have measured the largest violations of local realism to date, both statistical (over 2400-sigma) and absolute (S = 2:826 ± 0:005 -- within 0:2% of a maximal violation).
Optical quantum metrology uses specially-prepared states of light to probe sensitive samples. Choosing a suitable probe state allows one to extract more information per probe photon about an unknown parameter than is possible using any classical technique. In effect, these techniques improve the sensitivity of the measurement whenever the number of probe photons is constrained in some way. This thesis presents experimental and theoretical results on the use of pairs of time-frequency entangled photons in precision measurements. It begins with an overview of necessary background knowledge about quantum optics and quantum information. This is followed by a theoretical discussion on the estimation of a single delay using two-photon interference. We show that constraints on the probe photon's bandwidth complicate the measurement problem, requiring suitable optimization of the two-photon quantum state to avoid losing precision. We then consider the use of two-photon interference for linear spectroscopic measurements. Linear spectroscopy relates the absorption and phase spectrum of a sample to unknown electronic parameters. We describe a proof-of-principle experiment demonstrating that two-photon interferometric spectroscopy can be used for simultaneously measurement of both absorption and phase. This is followed by an information-theoretic discussion of the precision of this technique. For low losses, we show that the method provides phase sensitivity similar to classical interferometry while approaching the optimal absorption precision of any possible measurement. If the absorption and phase values are both related to a single unknown parameter, then our technique provides improved sensitivity to this parameter compared to both classical measurements and other quantum techniques in the presence of realistic levels of loss. We conclude with a discussion of quantum-optical coherence tomography, which is a two-photon interferometric method for determining the material structure of a sample. We present an ongoing experiment which aims to apply the method to tissue-like samples, where the quantum measurement is limited by a poor signal-to-noise ratio. Preliminary results demonstrate that this noise can be largely reduced by suitable frequency-domain filtering. This allows us to precisely determine the position of a scattering center using a few hundred detected photon pairs despite the presence of large amounts of noise. We follow this with a theoretical discussion of signal artifacts which are known to complicate the measured interferogram. We show these artifacts are due to a distinct interferometric effect, which can be distinguished from the signal of interest using the relative time delay between detected photons. We conclude with a brief discussion on possible techniques for artifact removal.