Superconducting mixers

Victor Y. Belitsky, Serguei Cherednichenko, Dag Winkler

This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.

E. Kollberg

Eugene M. Gershenzon, Gregory N Gol'tsman

Kangmin Zhou

China is now building an astronomical observatory including a THz telescope at Dome A on the Antarctic plateau. The development of superconducting HEB (Hot Electron Bolometer) mixers, the best choice for coherent detection at frequencies beyond 1 THz, becomes increasingly crucial. We present in this manuscript the investigation of high-sensitivity superconducting HEB mixers using quasi-optical technology in the THz region. The main results of this study are as follows: 1. We measured the dielectric constant of high-resistivity silicon at 77 K and 295 K by a vector measurement system. The measured permittivity is adopted to simulate the far-field beam pattern of a quasi-optical superconducting HEB mixer. 2. We measured the far-field beam pattern of a superconducting HEB mixer by both near-field heterodyne measurement system and far-field direct detection measurement system. The measured results accord well with the simulation. We also investigated the effect of HEB bias voltages and bath temperature on the far-field beam-pattern. 3. We successfully developed a high-sensitivity superconducting HEB mixer at 1.3 THz. The uncorrected measured double-sideband noise temperature is 600 K, which is a state-of-the-art result at this frequency. We systematically characterized heterodyne performances such as RF noise, conversion gain and noise bandwidth. We also measured the frequency response and calibrated it with a new method. Furthermore, we investigated the performance of this superconducting HEB mixer integrated with different elliptical lenses. 4. Finally, we measured the noise performance and the frequency response of a HEB mixer coupled to a 0.1-1.5 THz spiral antenna, the frequency dependence of the noise temperature has also been characterized. This study has provided a further understanding of superconducting HEB mixers and allowed the realization of a HEB mixer with state-of-the-art sensitivity at 1.3 THz. Hence the results of this study can find good use in the 5 m terahertz telescope (DATE5) at Dome A.

Syozo Imai, Seizo Morita, Yosihisa Takeuti +1 more

There are growing needs for low noise and wide band receiver in SMMW range, e.g., in radio astronomy [1]. Hitherto, Schottky diode mixer, Josephson mixer using point contact microbridges, and quasiparticle mixer using superconducting tunnel junctions have been investigated intensively in MMW range. Over wide SMMW range, however, only Schottky diode mixer was tested and used at present. Quasiparticle mixer now confronts a basic difficulty for operation in SMMW range, although it has very high potential as a SMMW mixer. On the otherhand, potential of Josephson mixer using microbridges is unclear.