Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Symposium on Turbo Codes and Iterative Information Processing

Quaternary Message Passing Decoding of LDPC Codes: Density Evolution Analysis and Error Floor

Emna Ben Yacoub, Balázs Matuz, Alexandre Graell i Amat, Gianluigi Liva

Published Aug 30, 2021• 0 citations
Publisher

Abstract

We revisit a coarsely quantized message passing decoding algorithm for low-density parity-check (LDPC) code ensembles, named quaternary message passing (QMP). Particularly, we analyze the performance of unstructured LDPC codes under QMP decoding by means of density evolution. The impact of degree-2 and degree-3 variable nodes on the error floor performance is also discussed. We design a code for QMP that performs within 0.55 dB of the 5G LDPC code at a block error rate of 10−4.

DOI
10.1109/istc49272.2021.9594240

Related papers

One and Two Bit Message Passing for SC-LDPC Codes With Higher-Order Modulation

Fabian Steiner, Emna Ben Yacoub, Balazs Matuz +2 more

Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.

arXiv:1902.10391•Journal of Lightwave Technology•Sep 24, 2019•21 citations

Protograph-Based LDPC Code Design for Ternary Message Passing Decoding

Emna Ben Yacoub, Fabian Steiner, Balázs Matuz +1 more

A ternary message passing (TMP) decoding algorithm for low-density parity-check codes is developed. All messages exchanged between variable and check nodes have a ternary alphabet, and the variable nodes exploit soft information from the channel. A density evolution analysis is developed for unstructured and protograph-based ensembles. For unstructured ensembles the stability condition is derived. Optimized ensembles for TMP decoding show asymptotic gains of up to 0.6 dB with respect to ensembles optimized for binary message passing decoding. Finite length simulations of codes from TMP-optimized ensembles show gains of up to 0.5 dB under TMP compared to protograph-based codes designed for unquantized belief propagation decoding.

arXiv:1809.10910•Sep 28, 2018•17 citations

One and Two Bit Message Passing for SC-LDPC Codes with Higher-Order Modulation

Fabian Steiner, Ben Yacoub, Emna, Balázs Matuz +2 more

Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.

•Jan 1, 2019•16 citations

Performance Analysis of Normalized Min-Sum Decoder for LDPC using non-uniform Quantization

K Pargunarajan, R Gandhiraj, Madaswamy Jayakumar

Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.

International Conference on Wireless Communications, Signal Processing and Networking (WiSPNET)•Mar 20, 2025•2 citations

New Message-Passing Decoding Algorithm of LDPC Codes by Partitioning Check Nodes

Sunghwan Kim, Min‐Ho Jang, Jong‐Seon No +2 more

In this paper, we propose a new sequential message-passing decoding algorithm of low-density parity-check (LDPC) codes by partitioning check nodes. This new decoding algorithm shows better bit error rate(BER) performance than that of the conventional message-passing decoding algorithm, especially for small number of iterations. Analytical results tell us that as the number of partitioned subsets of check nodes increases, the BER performance becomes better. We also derive the recursive equations for mean values of messages at variable nodes by using density evolution with Gaussian approximation. Simulation results also confirm the analytical results.

한국통신학회논문지•Apr 1, 2005•0 citations

Sequential message-passing decoding of LDPC codes by partitioning check nodes

Sunghwan Kim, Min‐Ho Jang, Jong‐Seon No +2 more

In this paper, we analyze the sequential message- passing decoding algorithm of low-density parity-check (LDPC) codes by partitioning check nodes. This decoding algorithm shows better bit error rate (BER) performance than the conventional message-passing decoding algorithm, especially for the small number of iterations. Analytical results indicate that as the number of partitioned subsets of check nodes increases, the BER performance is improved. We also derive the recursive equations for mean values of messages at check and variable nodes by using density evolution with a Gaussian approximation. From these equations, the mean values are obtained at each iteration of the sequential decoding algorithm and the corresponding BER values are calculated. They show that the sequential decoding algorithm converges faster than the conventional one. Finally, the analytical results are confirmed by the simulation results.

IEEE Transactions on Communications•Jul 1, 2008•7 citations
We revisit a coarsely quantized message passing decoding algorithm for low-density parity-check (LDPC) code ensembles, named quaternary message passing (QMP). Particularly, we analyze the performance of unstructured LDPC codes under QMP decoding by means of density evolution. The impact of degree-2 and degree-3 variable nodes on the error floor performance is also discussed. We design a code for QMP that performs within 0.55 dB of the 5G LDPC code at a block error rate of 10−4.
Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.
A ternary message passing (TMP) decoding algorithm for low-density parity-check codes is developed. All messages exchanged between variable and check nodes have a ternary alphabet, and the variable nodes exploit soft information from the channel. A density evolution analysis is developed for unstructured and protograph-based ensembles. For unstructured ensembles the stability condition is derived. Optimized ensembles for TMP decoding show asymptotic gains of up to 0.6 dB with respect to ensembles optimized for binary message passing decoding. Finite length simulations of codes from TMP-optimized ensembles show gains of up to 0.5 dB under TMP compared to protograph-based codes designed for unquantized belief propagation decoding.
Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.
Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.
In this paper, we propose a new sequential message-passing decoding algorithm of low-density parity-check (LDPC) codes by partitioning check nodes. This new decoding algorithm shows better bit error rate(BER) performance than that of the conventional message-passing decoding algorithm, especially for small number of iterations. Analytical results tell us that as the number of partitioned subsets of check nodes increases, the BER performance becomes better. We also derive the recursive equations for mean values of messages at variable nodes by using density evolution with Gaussian approximation. Simulation results also confirm the analytical results.
In this paper, we analyze the sequential message- passing decoding algorithm of low-density parity-check (LDPC) codes by partitioning check nodes. This decoding algorithm shows better bit error rate (BER) performance than the conventional message-passing decoding algorithm, especially for the small number of iterations. Analytical results indicate that as the number of partitioned subsets of check nodes increases, the BER performance is improved. We also derive the recursive equations for mean values of messages at check and variable nodes by using density evolution with a Gaussian approximation. From these equations, the mean values are obtained at each iteration of the sequential decoding algorithm and the corresponding BER values are calculated. They show that the sequential decoding algorithm converges faster than the conventional one. Finally, the analytical results are confirmed by the simulation results.