Flux qubits are among the first qubits that were ever demonstrated. They have some advantages when compared to capacitively shunted charge qubits, which are now commonly used for building prototypes of quantum processors. Specifically, flux qubits are intrinsically nonlinear systems and they remain so even with low charging energies, which is important for the suppression of large charge noise in solids. In spite of the clear advantages of flux qubits, their applications in multi-qubit devices—prototypes of quantum computers and simulators—are still limited. Flux qubits are also a very powerful tool for fundamental research. In this paper, we discuss the basic properties of flux qubits using the radio frequency superconducting quantum interference device geometry—the most fundamental realization of flux qubits. We also compare and analyze experimental realizations of flux qubits and propose further directions for research.
Flux qubits are among the first qubits that were ever demonstrated. They have some advantages when compared to capacitively shunted charge qubits, which are now commonly used for building prototypes of quantum processors. Specifically, flux qubits are intrinsically nonlinear systems and they remain so even with low charging energies, which is important for the suppression of large charge noise in solids. In spite of the clear advantages of flux qubits, their applications in multi-qubit devices—prototypes of quantum computers and simulators—are still limited. Flux qubits are also a very powerful tool for fundamental research. In this paper, we discuss the basic properties of flux qubits using the radio frequency superconducting quantum interference device geometry—the most fundamental realization of flux qubits. We also compare and analyze experimental realizations of flux qubits and propose further directions for research.
While quantum computation has the potential to revolutionize the scientific community, to date no architecture has been developed which offers the necessary combination of high coherence times and massive scalability. Superconducting flux qubits satisfy the second requirement well but to date useful devices are limited to coherence times of typically only a few &mus. In this dissertation we examine the possibilities of improving the coherence performance of the flux qubit to the levels required for fault-tolerant quantum computation. We find that coherence times for many devices are limited by photon-induced quasiparticles and mitigation of these quasiparticles increases coherence times by more than a factor of two. Beyond this, however, we find little improvement in flux qubit performance compared to prior results. Despite improved fabrication techniques and varied device designs we find flux qubit coherence times are still typically below 5 &mus. Furthermore, wide device-to-device variations are observed which prevent effective scaling of the flux qubit to quantum information circuits.Based on the proposal by You, et al. we develop of a capacitively-shunted version of the flux qubit called the C-shunt flux qubit. With the addition of a capacitive shunt across the small junction of the flux qubit we are able to reduce the amplitude sensitivity to both charge and flux noise by more than a factor of three. The result is a predicted ten-fold enhancement in the coherence times compared to the unshunted flux qubit. At the same time we preserve much of the anharmonicity of the flux qubit resulting in a device with coherence times comparable to modern transmons but with a factor of four better anharmonicity and more flexible coupling configurations.By using a high-quality MBE aluminum shunt process on an annealed sapphire substrate coupled with a more conventional electron-beam-evaporated aluminum Josephson junction process we fabricate hybrid C-shunt flux qubits. We also incorporate a new bridgeless junction technique which offers more robust and repeatable fabrication processing. This technique enables improved accuracy of the junction sizing, a trait which will become essential as we move to multi-qubit experiments. T1 and T2 times for these C-shunt devices reach in excess of 40 &mus at degeneracy, achieving the predicted ten-fold improvement based on the reduced noise sensitivity. At the same time we see decreased device-to-device variation with typical T1 times exceeding 20&ndash25 &mus at all bias points. Combined with the high anharmonicity and standard planar fabrication techniques these coherence times make the C-shunt flux qubit a competitive candidate for fault-tolerant quantum computation.
Superconducting quantum computing is a solid state quantum computing technology based on Josephson junction circuits. It becomes one of the most promising candidates for realizing practical quantum computer/simulator, because of its scalability, easy to coupling and control, compatibility to semiconductor technologies, etc. As the complicated electromagnetic environment in solid state metal and insulator, superconducting quantum bits (qubits) suffered from shot coherence time since its early development. In this review, we described some recently developed superconducting qubit structures, including Transmon/Xmon, Fluxonium and C-shunt flux qubit. Although these new qubit structures have very different circuit parameters and energy scales, they all find their way to effectively suppress environmental noises. As a result, their coherence time were improved significantly. Transmon, a transmission-line shunted plasma oscillation qubit, was now among the most popular structures for building a multi-qubit superconducting quantum circuit. It introduced a relatively large shunt capacitor to remarkably reduce the charge dispersion. Although the non-linearity is also decreased, by operating in a properly chosen EJ/Ec, transmon can greatly reduce the charge noise while only sacrificing a small amount of non-linearity. Xmon can be considered as a modified version of transmon. It is designed and optimized for multi-qubit operation and measurement with separate X/Y and Z control lines for each qubit, and a readout bus (a transmission line or a low-Q bandpass filter) for simultaneous readout of all the qubits. Fluxonium provide another solution for suppressing the charge noise in Cooper-pair box (CPB). It introduces a large shunt inductance to filter low-frequency offset charge in the small capacitor of the phase-slip junction (the small junction). To keep the qubit operating in the charge region, the shunt inductor should be large enough to keep the impedance larger than the superconducting impedance quantum RQ~1 kΩ. As a result, the inductance can only be provided by a large series of Josephson junctions. Fluxonium keeps the advantage of high anharmonicity of CPB. In addition, it introduces another degree of freedom: external flux Φext. Quasiparticles (electrons or holes) tunneling at the small junction add coherently to produce a ″1+cosφ″ term. As a result, when Φext= Φ0/2, dissipation caused by quasiparticle tunneling is suppressed and the energy relaxation time (T1) increases drastically. C-shunt flux qubit (CSFQ) decreases α and EJ to suppress flux noise in the qubit. While the charge noise becomes the dominant noise source, a large shunt capacitor is added to suppress the charge noise, similar to that in a transmon qubit. It is worth to notice that in CSFQ, the α decreases to below but near 1/2. As a result, the double-well potential no longer exists. The energy structure become similar to transmon, with the anharmonicity be opposite. CSFQ can get a much improved coherence time, while its anharmonicity can be larger than that of transmon. Those new superconducting qubit structures provide different solutions to improve the coherence time. Although it looks much different in circuit models and parameters, they have ideas in common, and may act as guides to other novel designs with longer coherence time. We can summarize as below. (1) The qubit circuit should be free of small superconducting islands. Charge fluctuation in small islands is a major source of decoherence. As a result, increase the area of the islands, that is, increase the capacitance becomes a straight forward way to suppress the charge noise. In Fluxonium, the small junction is connected with a large series of large junctions that there is also no small islands in the whole loop. (2) Remove superconducting loops in the qubit circuit, or minimize the loop size and loop current to suppress flux noise. (3) Bias the phase difference of the small junction to π, where dissipation caused by quasiparticle tunneling can be suppressed coherently. (4) Decrease the coupling bandwidth of qubit to the environment. In a circuit-QED readout scheme, a high-Q readout resonator that dispersively coupled to the qubit protects the qubit from exposed to the electromagnetic environment of the readout circuit. A ″Purcell filter″ can also be added to suppress such decoherence further. In conclusion, we overviewed some qubit engineering techniques or ideas to improve the coherence time, which is a very important figure for building practical quantum computer/simulator. We hope that someone can combine and optimize these ideas, while interact with developments in materials and micro-fabrication technologies, to develop novel new generation superconducting qubit structures in the near future.
Two classes of superconducting devices have been proposed as quantum bits (qubits) for realizing quantum logic operations. The flux qubits based on a superconducting quantum interference device (SQUID) appear to be particularly promising owing to the macroscopic nature of the qubit and potential integration with high-speed control circuitry in the form of rapid single-flux quantum electronics. Recent progress is discussed and near-term challenges mentioned. The radio frequency SQUID-based qubit offers a prospect for a reliably manufacturable scalable approach.
Superconducting qubits have in recent years become a promising candidate for the implementation of a quantum computer due to their design flexibility, good protection from decohering elementary excitations, and availability of well developed fabrication and measurement techniques. Superconducting flux qubits, for which the effect of offset charge noise is reduced due to the fact that the Josephson energy dominates over the charging energy, correspond to one of the proposed means of designing a superconducting qubit. A nonlinear dispersive readout scheme of flux qubits involving a DC SQUID magnetometer that avoids the effects of on-chip dissipation can be readily implemented, yielding high contrast output for single qubit readout. Coupling schemes via nonlinear Josephson elements have also been realized. On the other hand, while the means of isolating superconducting qubits from external noise sources has been found, the mechanisms by which they undergo relaxation and decoherence due to intrinsic noise sources in the junctions themselves are not very well understood, and the question of how to deal with these noise sources remains unanswered in the general case. Other questions deal with the problem of experimentally observing entanglement in an array of coupled superconducting qubits, and finding the means by which the existence of entanglement in a typical laboratory setup may to some extent be verified by measurements on a global scale. Following a brief introductory review, we will first investigate the influence of a Two-Level Fluctuator on a DC SQUID driven by a finite current bias. Then we introduce a directly measurable signature of multiqubit entanglement for a large system of qubits and show that it is compatible to a recently introduced measure of global entanglement.
We proposed and theoretically investigated the self-shunted superconducting flux qubits (SSFQs) with relatively large Josephson junctions with the diameter over1μm. Because of the large self-capacitance of several 10 fF in the junctions, the large shunt capacitor with dimensions of several 100$ \mu \text{m}oftheconventionalcapacitivelyshuntedfluxquantumbits(qubits)canbeeliminated,resultinginsignificantreductionofthefootprint.WesystematicallycalculatedtheSSFQperformances,suchastheanharmonicity,andinvestigatedtheirdependencesonthecircuitparameters.Asaresult,itwasshownthattheSSFQshavethelargeanharmonicityof400–2000MHzforthereasonableparameters,suchasthelargejunctionareaofaround1 \mu \text{m}^{2}andthesmallcriticalcurrentdensityofaround10\text{A/cm}^{2}$. Furthermore, we derived and estimated the relative relaxation time of the SSFQs due to the charge and flux noises. As a result, we found that the high anharmonicity over 800 MHz could be achieved without degrading the relaxation time from that of the high-coherence flux qubits. The SSFQs offer the new choice of the highly scalable qubits, which achieve both the small footprint and high anharmonicity.
In a quantum computer, the information carriers, which are bits in ordinary computers, are implemented as devices that exhibit coherent superpositions of physical states and entanglement. Such components, known as quantum bits or qubits, can be realized with various different types of two-state quantum systems. Quantum computers will be built for computational speed, with hoped for applications especially in cryptography and in other tasks where classical computers remain inefficient. Circuit quantum electrodynamics (cQED) is a quantum-computer architecture which employs superconducting electronic components and microwave photon fields as building blocks. Compared to cavity quantum electrodynamics (CQED), where atoms are trapped in physical cavities, cQED is more attractive in that its qubits are tunable and conveniently integrable with the electronics already in use. This architecture has shown some of the most promising qubit designs, despite their coherence times reaching tens of microseconds, are still below the state of the art with spin qubits, which reach milliseconds. Coherence times are historically the most relevant parameters describing the fitness of a qubit, although these days not necessarily the limiting factor. This thesis presents a comprehensive set of theoretical and experimental methods for measuring the characteristic parameters of superconducting qubits. We especially study transmission-line-shunted plasma oscillation qubits, or transmons, and presents experimental results for a single sample. Transmon capacitively couples a superconducting quantum interference device (SQUID) with a coplanar waveguide (CPW) resonator, often with added frequency tunability utilizing an external magnet. The number of superconducting charge carriers tunnelled through a junction in the SQUID are used as qubit degrees of freedom. Readout of the qubit state is carried out by measuring transmission through the CPW. A cryogenic setup is employed with measurement and driving pulses delivered from microwave sources. Steady-state spectroscopy is employed to determine the resonance frequencies of the qubit and the resonator, qubit-resonator coupling constants, and the energy parameters of the qubit. Pulse-modulated measurements are employed to determine the coherence times of the qubit. The related analysis- and simulation programs and scripts are collected togithub.com/patomaki.