In this thesis, we have studied an ultrahigh quality factor mechanical oscillator coupled to a microwave cavity. We will present an original technique to probe the losses of planar microwave cavities, as well as a resolved sideband cooling technique to actively cool this mechanical oscillator using the microwave cavity. Finally, we will present some optimizations of this experiment which open the path towards the ground state cooling of the mechanical oscillator. Such a hybrid quantum system could be used as an on-chip quantum memory, able to store fragile quantum states generated by superconducting quantum circuits for coherence times approaching a second.
In this thesis, we have studied an ultrahigh quality factor mechanical oscillator coupled to a microwave cavity. We will present an original technique to probe the losses of planar microwave cavities, as well as a resolved sideband cooling technique to actively cool this mechanical oscillator using the microwave cavity. Finally, we will present some optimizations of this experiment which open the path towards the ground state cooling of the mechanical oscillator. Such a hybrid quantum system could be used as an on-chip quantum memory, able to store fragile quantum states generated by superconducting quantum circuits for coherence times approaching a second.
Abstract Cavity electromechanics relies on parametric coupling between microwave and mechanical modes to manipulate the mechanical quantum state, and provide a coherent interface between different parts of hybrid quantum systems. High coherence of the mechanical mode is of key importance in such applications, in order to protect the quantum states it hosts from thermal decoherence. Here, we introduce an electromechanical system based around a soft-clamped mechanical resonator with an extremely high Q-factor (>109) held at very low (30 mK) temperatures. This ultracoherent mechanical resonator is capacitively coupled to a microwave mode, strong enough to enable ground-state-cooling of the mechanics ( nˉmin=0.76±0.16 n¯min=0.76±0.16 ). This paves the way towards exploiting the extremely long coherence times (tcoh > 100 ms) offered by such systems for quantum information processing and state conversion.
In the late 1960s and early 1970s, the development of mechanical resonators was pushed forward in efforts to record gravitational waves. In order to push down the limit of the smallest detectable force, the radiation circulating in a Fabry-Perot cavity was demonstrated to modify the damping of the cavity end-mirror suspended to act as a mechanical resonator. A few years later, motivated by the study of the internal properties of atoms and ions, the radiation pressure of light was realized as a means to cool atomic motion. In the following years, the ground-state cooling of ion motion was achieved in landmark studies. For mechanical resonators parametrically coupled to Fabry-Perot cavities, it took much longer to reach quantum ground-state cooling, both in the microwave domain, where the original experiments took place, and in the optical domain. Ground-state cooling in both regimes was reached by three groups during the preparation of this thesis and was largely due to advancements in the fabrication methods. \n \nGround-state cooling allows, in principle, the quantum nature of mechanical resonators to be probed and harnessed. Microwave domain devices, which are focused on in this thesis, have the advantage that nonlinear elements (superconducting quantum bits, qubits) are readily available. These elements enable nonclassical state preparation of the qubit and the subsequent transfer to the microwave cavity. The goal is to transfer these quantum states to mechanical resonators. This would allow mechanics to be used as a quantum mechanical memory in quantum information processing thanks to their long lifetimes. \n \nIn this thesis, various aspects of microwave domain circuit optomechanics are studied. The main goal of this thesis is to study how to enhance the coupling between a quantum regime microwave device and a mechanical resonator by using Josephson junction –based qubits. Coherent interaction between a superconducting qubit and a classical driven mechanical field is demonstrated. The analysis presented in this thesis predicts that ground-state cooling and coherent state transfer is possible in the single-phonon regime with transmon-regime qubits. Also, traditional linear optomechanical systems are considered in which the mechanical resonator is coupled to an electrical resonator. Such systems exhibit a rich spectrum of phenomena from which the quantum-limited amplification and multimode effects are considered in this thesis. It is shown that the system operates near quantum-limited amplification, which could be reached if the mechanical resonator was in the ground state.
Microscale and nanoscale mechanical resonators have been used in advanced technological applications, from high precision time keeping and mass sensing, to processing high frequency signals in mobile communications. In the last few decades, they have been an important part of progress in the field of quantum information and metrology and have been proposed as quantum memories or transducers for measuring or connecting different types of quantum systems. The field of cavity optomechanics and electromechanics is concerned with coupling the electromagnetic field of a resonant optical cavity or electrical circuit to mechanical motion. These systems provide potential means to control and engineer the state of a mechanical object at the quantum level. This thesis contains the description of mechanical systems in megahertz to a few hundred megahertz frequency range formed by nano-fabricating photonic, phononic, and electrical circuits on a chip. These structures are designed to provide a large radiation pressure coupling between mechanical motion and electromagnetic fields to address and manipulate motional degrees of freedom. Qualitatively novel quantum effects are expected when one takes a step beyond linear coupling and exploits higher order interactions. To that end, we integrate electrical, mechanical and photonic structures in a multimode photonic crystal structure to observe "x2-coupling", where the optical cavity frequency is coupled to the square of the mechanical displacement. Moreover, we have developed two integrated on-chip platforms based on Si3N4 and Si nanomembranes capable of interfacing superconducting qubits and optical photons and realizing reversible microwave-to-optical conversion. We employ radiation pressure to cool these mechanical resonators to their quantum ground state. Finally, we demonstrate a form of electromechanical crystal for coupling microwave photons and hypersonic phonons of frequency ωm/2π = 0.425 GHz by capacitively coupling a phononic crystal acoustic cavity to a superconducting microwave resonator. Moving to higher frequency acoustic cavities not only facilitates the integration of electromechanical circuits and nanophotonic systems capable of operation in the resolved sideband limit of optomechanics for noise-free quantum signal conversion, but it opens up the possibility of using phonons as information carriers via phononic circuits. Utilizing a two-photon resonance condition for efficient microwave pumping and phononic bandgap shield to eliminate acoustic radiation, we achieve large cooperative electromechanical coupling (C ≈ 30) and intrinsic decay time of 2.3 ms. Moreover, electrical read-out of the phonon occupancy shows that the acoustic mode thermalizes close to its quantum ground-state of motion (phonon occupancy nm=1.5) at a fridge temperature of Tf = 10 mK. We conclude by considering several designs and fabrication improvements to the hypersonic electromechanical crystals that would enable them to perform quantum conversion between the electrical and acoustic domain.
In the past several years, the field of optomechanics has progressed from proof-of-principle experiments to the realization of mechanical oscillators and measurements in the quantum regime. Mechanical oscillators are of great interest because they can have small dissipation rates, can couple to many different systems of interest, and are the fundamental elements of ultrasensitive force detectors. Coupling these mechanical oscillators to microwave or optical fields provides a twofold advantage. Firstly, information about mechanical position can be encoded in the interrogating field, enabling sensitive readout of the mechanical oscillator. Secondly, the radiation pressure force of that field can be used to control the state of the mechanical oscillator. Including a high-quality microwave or optical cavity enhances both of these effects, as the field strength is resonantly increased.\nThe major questions in the field of optomechanics in the last several years have dealt with using mechanical oscillators for ultrasensitive measurements and as tools for quantum information. Both of these goals have the prerequisite that we be able to read out the motion of the mechanical oscillator in a quantum efficient manner. To that end, we developed a nearly shot-noise limited microwave interferometer capable of measuring mechanical motion with an imprecision below that at the standard quantum limit. This achievement is not only a critical improvement for the electromechanical experiments we do, but is also an important tool for any experiment that encodes the information of interest in microwave fields. In order to use mechanical oscillators as tools for quantum information, the mechanical oscillator must also be cooled into the quantum regime and fully controllable by the interrogating fields. To this end, we used the radiation pressure of microwave fields to cool our macroscopic mechanical oscillator to less than one phonon. We also demonstrated coherent transfer between itinerant microwave states and the mechanical oscillator, even for incident fields with less than one photon of energy.\nThese accomplishments have set the foundation for further experiments to extend the quantum information abilities of optomechanical systems, couple diverse quantum systems via a mechanical intermediary, and potentially explore the foundations of quantum mechanics at macroscopic scales.
Mechanical oscillators in the quantum regime hold promise for quantum sensing, frequency conversion and information processing. Because mechanical motion is linear, coupling to an external nonlinear system, such as a qubit, is essential for these applications. Recent advances in piezoelectric interfaces between mechanical oscillators and superconducting qubits have successfully demonstrated precise control of non-classical states of motion. However, challenges associated with heterogeneous integration of piezoelectric materials have limited mechanical quality factors in these systems to around one million, constraining their broader utility. In this thesis, we explore an alternative approach that harnesses the nonlinearity of electrostatic forces to engineer interactions between superconducting circuits and mechanical oscillators. This strategy allows us to employ mechanical oscillators made of silicon, a non-piezoelectric material with extremely low acoustic loss. We reach the strong coupling regime between a superconducting qubit and a long-lived mechanical oscillator with a quality-factor of around a billion. We employ this system to generate non-classical states of motion that exhibit clear signatures of quantum behavior. Furthermore, we explore the origins of acoustic decoherence and implement strategies to mitigate its impact. The mechanical lifetimes, which exceed those of best superconducting qubits, open new possibilities for storing and processing microwave quantum information in motional states. Furthermore, our material-agnostic approach is broadly applicable to a variety of material platforms that possess significance for quantum science but lack a piezoelectric response.
We propose and analyze a quantum electromechanical system composed of a monolithic quartz bulk acoustic wave oscillator coupled to a superconducting transmon qubit via an intermediate LC electrical circuit. Monolithic quartz oscillators offer unprecedentedly high effective masses and quality factors for the investigation of mechanical oscillators in the quantum regime. Ground-state cooling of such mechanical modes via resonant piezoelectric coupling to an LC circuit, which is itself sideband cooled via coupling to a transmon qubit, is shown to be feasible. The fluorescence spectrum of the qubit, containing motional sideband contributions due to the couplings to the oscillator modes, is obtained and the imprint of the electromechanical steady state on the spectrum is determined. This allows the qubit to function both as a cooling resource for, and transducer of, the mechanical oscillator. The results described are relevant to any hybrid quantum system composed of a qubit coupled to two (coupled or uncoupled) thermal oscillator modes.