For a quantum memory to be useful as a quantum repeater, a long coherence time is a crucial requirement. In recent years, the most commonly explored medium for quantum storage has been atomic gases. We report an experiment to realize a quantum memory based on an Rb atomic ensemble in a one-dimensional far-detuned optical lattice. A multimode 30 W continuous wave fiber laser was used to construct a travelling wave lattice with a period of 25 m. The Rb atoms were loaded into a magneto-optical-trap, which was then adjusted to optimize the polarization gradient cooling. To trap the cooled atoms, we turned on a laser which has a wavelength of 1064 nm and therefore is red-detuned from the resonance frequencies of D1 and D2 transitions of 87Rb atoms. By taking the short-distance time-of-flight image the temperature of the atoms was found to be about 20 K. This system will provide a foundation for future quantum information storage studies.
For a quantum memory to be useful as a quantum repeater, a long coherence time is a crucial requirement. In recent years, the most commonly explored medium for quantum storage has been atomic gases. We report an experiment to realize a quantum memory based on an Rb atomic ensemble in a one-dimensional far-detuned optical lattice. A multimode 30 W continuous wave fiber laser was used to construct a travelling wave lattice with a period of 25 m. The Rb atoms were loaded into a magneto-optical-trap, which was then adjusted to optimize the polarization gradient cooling. To trap the cooled atoms, we turned on a laser which has a wavelength of 1064 nm and therefore is red-detuned from the resonance frequencies of D1 and D2 transitions of 87Rb atoms. By taking the short-distance time-of-flight image the temperature of the atoms was found to be about 20 K. This system will provide a foundation for future quantum information storage studies.
An innovative and practical scheme of building far-detuned optical lattice for 87Rb atoms is proposed.The disposals of aligning the lattice beams,tuning the lattice frequency and controlling the tapered amplifier for output are described in detail.Alignment of optical lattices is quite difficult in principle,for several beams are required to hit the same atomic cloud.For the relatively near-detuned one-and two-dimensional lattices,the coarse alignment is accomplished by tuning the lattice laser onto resonance with the magnetic-optic trap(MOT) frequency,and then blowing away the MOT in real time.A more precision alignment is implemented at the end of the MOT loading,the atoms are first pumped into the lower hyperfine level by turning off the repumping for some time;then,the pulsed lattice beams are turned on for a short time at some reasonably large detuning.Finally,a fluorescent image of the MOT is taken without repumping,in order to detect only those atoms which are repumped by the lattice laser.For the purpose of controlling the detuning of the lattice easily and accurately,a home-made grating wavemeter with a resolution better than 1 GHz is used.This way allows the laser to be locked at any frequency by using a software PID and is experimentally simple to implement.The intensity of the lattice is controlled directly by pulsing the current through the tapered amplifier using a function generator and a laser diode driver.This technique has already been demonstrated before by Prof.M.Kasevich's group at Stanford. Our experiment starts with a MOT capturing approximately 4107 atoms in 200 ms.The lattice loading is overlap with the end of polarization gradient cooling(PGC),after that,the molasses laser beams are extinguished, and the adiabatic expansion is accomplished in the same time by a decrease in the lattice light intensity according to release function.On the basis of MOT and PGC,the dependences of atomic loading on such parameters as the intensity and frequency detuning of optical lattice are investigated experimentally.The vibration frequency is measured by intentionally modulating the trap intensity.Experimental results show that the lattice structure facilitates the cooling with the temperature of atoms cloud being reduced to 1/3 compared with free space polarization gradient cooling.The system design,experimental results and conclusions are of definite significance and can serve as a fine reference for other kinds of lattices designs or alkali atomic plans.
We develop a simple and practical scheme to apply sideband cooling to a cloud of rubidium atoms. A sample containing 4 × 10 70 87 Rb is trapped in a far red detuned optical lattice. Through optimizing the relevant parameters, i.e., laser detuning, magnetic field, polarization, and duration time, a temperature around 1.5 μK and phase space density close to 1/500 are achieved. Compared with polarization gradient cooling, the temperature decreases by around one order of magnitude. This technique could be used in high precision measurement such as atomic clocks and atom interferometer. It could also serve as a precooling means before evaporation cooling in a dipole trap, and may be a promising method of achieving quantum degeneracy with purely optical means.
We report a way to overcome heating due to the reabsorption of scattered light when relatively many atoms are laser cooled at high density. A sample of $8\ifmmode\times\else\texttimes\fi{}{10}^{7}\mathrm{Cs}$ atoms, with $6\ifmmode\times\else\texttimes\fi{}{10}^{11}{\mathrm{atoms}\mathrm{}\mathrm{cm}}^{\mathrm{\ensuremath{-}}3},$ is loaded into a deep far-detuned one-dimensional optical lattice, which acts as a large volume three-dimensional (3D) trap. Polarization gradient cooling with a separate set of cooling beams is found to work well in this trap, populating the trap's vibrational ground state with more than half the atoms. After cooling, the lattice is shut off adiabatically, leaving a still dense sample at 1.2 \ensuremath{\mu}K. We propose and demonstrate a generalization to a 3D lattice, which will allow many more atoms to be loaded into conservative light traps, and can greatly increase the initial phase-space density for loading magnetic traps.
Quantum memories for light lie at the heart of long-distance provably-secure communication. Demand for a functioning quantum memory, with high efficiency and coherence times approaching a millisecond, is therefore at a premium. Here we report on work towards this goal, with the development of a 87 Rb magneto-optical trap with a peak optical depth of 1000 for the D2 F = 2 → F ' = 3 transition using spatial and temporal dark spots. With this purpose-built cold atomic ensemble we implemented the gradient echo memory (GEM) scheme on the D1 line. Our data shows a memory efficiency of 80 ± 2% and coherence times up to 195 μ s.
We present experiments with cold atoms in optical dipole potentials which are directed towards developing an integrated coherent atom optics with micro-optical systems. We describe an experiment on evaporative cooling in a far-detuned optical dipole trap for 87 Rb. The dipole trap is created by a solid state laser at a wavelength of 1030 nm. To achieve high initial phase space densities allowing for efficient evaporative cooling, we have optimised the loading process from a magneto-optical trap into the dipole trap. Starting with an initial phase space density of 2 × 10 −4 the trap depth was ramped down and temperatures below 200 nK and phase space densities of about 0.2 could be reached. These investigations aim at the creation of an 'all-optical' BEC based on a simple experimental scheme. As an example for an integrated atom optical system, we present the transport of atoms in a ring-shaped guiding structure, i.e. optical storage ring, for cold atoms which is produced by a micro-fabricated ring lens.
This dissertation reports on the design, construction, and investigation of a pulsed optical dipole force trap which uses laser light to confine ultracold rubidium (Rb) atoms. Because the laser frequency is detuned far from the atomic resonance frequency, the optical dipole force trap is also called a "far-off-resonance trap" (FORT). The use of pulsed laser light to create an optical trap may find application in expanding the number of atomic species which can be confined. The experiments reported here are principally aimed, however, at understanding the physics of pulsed FORT dynamics in anticipation of using the free electron laser (FEL) at Jefferson Lab (Jlab) to construct a FORT. The Jlab FEL will provide a tunable, high power laser light source enabling the realization of spatially large and/or energetically deep traps which are not presently accessible with table-top laser sources. Here, a mode-locked Nd:YAG laser is used as a pulsed laser source. Since the conservative optical dipole force trap does not cool Rb atoms, ultracold atoms must be loaded into the FORT. The optical dipole force trap is formed at the focus of a Gaussian, 1.06 μm Nd:YAG laser beam which is located at the center of a high vacuum chamber and superimposed onto the center of a pre-cooled Rb atom cloud that has been previously accumulated in a magneto-optic trap (MOT). The performance of the pulsed FORT is compared to a continuous wave mode (cw) FORT which is built using the same laser beam; the operation of the two kinds of FORTs can be switched easily without disturbing the experimental alignment. The dependencies of FORT loading efficiency to FORT and MOT parameters such as FORT laser power, loading time, storage/holding time, detuning of the primary MOT laser frequency, and repump laser intensity are investigated. There are about 1.5×107 ultracold rubidium atoms in the MOT. At 7 Watts FORT laser power, about 8% of the atoms are loaded successfully into the cw FORT and about 5% into the pulsed FORT under similar, but not identical, conditions. In most respects both the cw and pulsed FORTs show comparable behavior. The behavior of both FORTs depends strongly on FORT laser power. As expected, at higher power, more atoms can be loaded into the FORT. Both FORTs also depend on the loading time and holding time.