Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Acta Physica Sinica

A two-dimensional magneto-optical trap for a cesium fountain clock

WU Chang-jiang, Jun Ruan, Jiang Chen, Hui Zhang, Shougang Zhang

Published Jan 1, 2013• 7 citations
Publisher

Abstract

To study the relationship of atomic beam flow with cooling intensity, laser detuning, and magnetic field gradient, the numerical simulation is performed and a two-dimensional magneto-optical trap setup is built. A low-velocity atomic beam flow is generated with a total flux of 2.1 109/s. Theoretical analysis and experimental results are in good consistence. Optimal detuning and magnetic field gradient can produce the largest atomic beam flow.

DOI
10.7498/aps.62.063201

Related papers

A novel simplified two-dimensional magneto-optical trap as an intense source of slow cesium atoms

N. Castagna, Jocelyne Guéna, Mark D. Plimmer +1 more

We describe the design and performance of a slow atom source based on a 2D magneto-optical trap (MOT) that uses an innovative simple optical configuration. Metal-coated retro-reflecting prisms replace mirrors and quarter-wave plates so the optical power of the cooling laser beam is recycled. This source has been characterised for three different configurations: with and without transverse magnetic field gradient, and with a pusher beam to obtain a 2D+-MOT. The longitudinal velocity is of the order of 25 m·s−1, with a transverse velocity spread ≤1 m·s−1, while the typical atomic flux density obtained is up to 1.3×1014 at ·s−1·m−2 for a cesium vapour pressure of ~4×10−8 mbar in the source. We use this slow atom beam, instead of cesium vapour, to load a 3D moving optical molasses that feeds a continuous cold atom fountain. We obtain a gain of a factor ~20 in the atomic flux launched by the fountain.

The European Physical Journal Applied Physics•Apr 1, 2006•23 citations

Intense source of cold cesium atoms based on a two-dimensional magneto–optical trap with independent axial cooling and pushing

黄家强, 颜学术, 吴晨菲 +2 more

We report our studies on an intense source of cold cesium atoms based on a two-dimensional(2D) magneto–optical trap(MOT) with independent axial cooling and pushing.The new-designed source,proposed as 2D-HP MOT,uses hollow laser beams for axial cooling and a thin pushing laser beam to extract a cold atomic beam.With the independent pushing beam,the atomic flux can be substantially optimized.The total atomic flux maximum obtained in the 2D-HP MOT is4.02 × 1010atoms/s,increased by 60 percent compared to the traditional 2D+MOT in our experiment.Moreover,with the pushing power 10 μW and detuning 0Γ,the 2D-HP MOT can generate a rather intense atomic beam with the concomitant light shift suppressed by a factor of 20.The axial velocity distribution of the cold cesium beams centers at 6.8 m/s with an FMHW of about 2.8 m/s.The dependences of the atomic flux on the pushing power and detuning are studied in detail.The experimental results are in good agreement with the theoretical model.

中国物理B：英文版•Jan 1, 2016•0 citations

Realization of an intense cold Rb atomic beam based on a two-dimensional magneto-optical trap: Experiments and comparison with simulations

Saptarishi Chaudhuri, Sanjukta Roy, C. S. Unnikrishnan

We discuss the implementation and characterization of the source of a slow, intense, and collimated beam of rubidium atoms. The cold atomic beam is produced by two-dimensional magneto-optical trapping in directions transverse to the atomic beam axis and unbalanced Doppler cooling in the axial direction. The vacuum design allows use of relatively low laser power and a considerably simplified assembly. The atomic beam has a high flux of about $2\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}\mathrm{atoms}∕\mathrm{s}$ at a total cooling laser power of $55\phantom{\rule{0.3em}{0ex}}\mathrm{mW}$. It has a narrow longitudinal velocity distribution with mean velocity $15\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}$ with full width at half maximum $3.5\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}$ and has a low divergence of $26\phantom{\rule{0.3em}{0ex}}\mathrm{mrad}$. The high flux enables ultrafast loading of about ${10}^{10}$ atoms into a three-dimensional (3D) magneto-optical trap within 500 ms. The variation of the atomic beam flux was studied as a function of the rubidium vapor pressure, cooling laser power, transverse cooling laser beam length, detuning of the cooling laser, and relative intensities of the cooling beams along the atomic beam axis. We also discuss a detailed comparison of our measurements of the cold atomic beam with a 3D numerical simulation.

Physical Review A•Aug 18, 2006•63 citations

A cold cesium beam source based on a two-dimensional magneto-optical trap

Weibin Xie, Qing Wang, Xuan He +4 more

A beam source is proposed for the production of an intense cold cesium atomic beam that can be used in cesium beam atomic clocks. The source is based on a two-dimensional magneto-optical trap (2D-MOT), but introduces hollow cooling and pushing lights in the axial direction to create a 2D+-MOT, which separates the cooling and pushing functions while the low-power pushing light pushes atoms out to form a cold atomic beam. This cold cesium atomic beam source reduces the light shift due to leakage light and retains longitudinal cooling to increase the flux of the cold atomic beam compared with that of the conventional 2D+-MOT scheme. The specifics of the design are investigated, the atomic velocity and beam flux are calculated, and the results are experimentally verified. The results demonstrate that when the power of the pushing light is 180 µW and when its frequency resonates with the 4 → 5′ transition of the Cs D2 line, the most probable longitudinal velocity of the outgoing cold atomic beam, the width of velocity distribution, and the atomic beam flux are 19.38 m/s, 8.1 m/s, and 1.7 × 1010 atoms/s, respectively.

AIP Advances•Jul 1, 2022•4 citations

Low velocity, high flux, continuous source of cesium atoms

N. Castagna, Jocelyne Guéna, Mark D. Plimmer +1 more

We present a 2D magneto-optical trap (MOT) that uses an innovative simple optical configuration. Instead of mirrors and quarter-wave plates we use metal-coated retro-reflecting prisms so as to recycle the optical power of the cooling laser beam. We have characterised this source for three different configurations: with and without transverse magnetic field gradient, as well as with a pusher beam to produce a 2D+-MOT. The longitudinal velocity is about 25 m·s-1, with a transverse velocity spread ≤ 1 m·s-1, while the typical atomic flux density can be as much as 1.3×1014 at·s-1·m-2 for a cesium vapour pressure of ~4×10-8 mbar in the source. We use this low velocity atomic beam, instead of thermal vapour, to load a 3D moving optical molasses that launches a continuous cold cesium fountain. We achieve a gain of a factor ~ 20 in the fountain's atomic flux.

European Frequency and Time Forum•Mar 27, 2006•1 citation

Optimized atomic flux from a frequency-modulated two-dimensional magneto-optical trap for cold fermionic potassium atoms

Jae Hoon Lee, Jongchul Mun

We present our study on enhancement and optimization of potassium-40 (K40) atomic beam flux from a two-dimensional magneto-optical trap (2D MOT) by modulating the frequency of cooling laser. The laser cooling beam frequencies of the 2D MOT were effectively broadened via electro-optical modulators at 10 MHz, with a modulation index ranging from β=0 to 7, depending on the laser intensity. Laser parameters of the 2D MOT beams and the magnetic field gradient were scanned for optimal settings for maximum atomic beam flux. When compared to a conventional 2D MOT with fixed laser frequencies, we were able to obtain a 3.7 times enhancement of the atomic flux when the total laser power was 640 mW. Numerical calculations predict further improvement for higher laser beam intensities.

Journal of the Optical Society of America B•Jun 12, 2017•8 citations
To study the relationship of atomic beam flow with cooling intensity, laser detuning, and magnetic field gradient, the numerical simulation is performed and a two-dimensional magneto-optical trap setup is built. A low-velocity atomic beam flow is generated with a total flux of 2.1 109/s. Theoretical analysis and experimental results are in good consistence. Optimal detuning and magnetic field gradient can produce the largest atomic beam flow.
We describe the design and performance of a slow atom source based on a 2D magneto-optical trap (MOT) that uses an innovative simple optical configuration. Metal-coated retro-reflecting prisms replace mirrors and quarter-wave plates so the optical power of the cooling laser beam is recycled. This source has been characterised for three different configurations: with and without transverse magnetic field gradient, and with a pusher beam to obtain a 2D+-MOT. The longitudinal velocity is of the order of 25 m·s−1, with a transverse velocity spread ≤1 m·s−1, while the typical atomic flux density obtained is up to 1.3×1014 at ·s−1·m−2 for a cesium vapour pressure of ~4×10−8 mbar in the source. We use this slow atom beam, instead of cesium vapour, to load a 3D moving optical molasses that feeds a continuous cold atom fountain. We obtain a gain of a factor ~20 in the atomic flux launched by the fountain.
We report our studies on an intense source of cold cesium atoms based on a two-dimensional(2D) magneto–optical trap(MOT) with independent axial cooling and pushing.The new-designed source,proposed as 2D-HP MOT,uses hollow laser beams for axial cooling and a thin pushing laser beam to extract a cold atomic beam.With the independent pushing beam,the atomic flux can be substantially optimized.The total atomic flux maximum obtained in the 2D-HP MOT is4.02 × 1010atoms/s,increased by 60 percent compared to the traditional 2D+MOT in our experiment.Moreover,with the pushing power 10 μW and detuning 0Γ,the 2D-HP MOT can generate a rather intense atomic beam with the concomitant light shift suppressed by a factor of 20.The axial velocity distribution of the cold cesium beams centers at 6.8 m/s with an FMHW of about 2.8 m/s.The dependences of the atomic flux on the pushing power and detuning are studied in detail.The experimental results are in good agreement with the theoretical model.
We discuss the implementation and characterization of the source of a slow, intense, and collimated beam of rubidium atoms. The cold atomic beam is produced by two-dimensional magneto-optical trapping in directions transverse to the atomic beam axis and unbalanced Doppler cooling in the axial direction. The vacuum design allows use of relatively low laser power and a considerably simplified assembly. The atomic beam has a high flux of about $2\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}\mathrm{atoms}∕\mathrm{s}$ at a total cooling laser power of 55mW55\phantom{\rule{0.3em}{0ex}}\mathrm{mW}55mW. It has a narrow longitudinal velocity distribution with mean velocity 15m∕s15\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}15m∕s with full width at half maximum 3.5m∕s3.5\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}3.5m∕s and has a low divergence of 26mrad26\phantom{\rule{0.3em}{0ex}}\mathrm{mrad}26mrad. The high flux enables ultrafast loading of about 1010{10}^{10}1010 atoms into a three-dimensional (3D) magneto-optical trap within 500 ms. The variation of the atomic beam flux was studied as a function of the rubidium vapor pressure, cooling laser power, transverse cooling laser beam length, detuning of the cooling laser, and relative intensities of the cooling beams along the atomic beam axis. We also discuss a detailed comparison of our measurements of the cold atomic beam with a 3D numerical simulation.
A beam source is proposed for the production of an intense cold cesium atomic beam that can be used in cesium beam atomic clocks. The source is based on a two-dimensional magneto-optical trap (2D-MOT), but introduces hollow cooling and pushing lights in the axial direction to create a 2D+-MOT, which separates the cooling and pushing functions while the low-power pushing light pushes atoms out to form a cold atomic beam. This cold cesium atomic beam source reduces the light shift due to leakage light and retains longitudinal cooling to increase the flux of the cold atomic beam compared with that of the conventional 2D+-MOT scheme. The specifics of the design are investigated, the atomic velocity and beam flux are calculated, and the results are experimentally verified. The results demonstrate that when the power of the pushing light is 180 µW and when its frequency resonates with the 4 → 5′ transition of the Cs D2 line, the most probable longitudinal velocity of the outgoing cold atomic beam, the width of velocity distribution, and the atomic beam flux are 19.38 m/s, 8.1 m/s, and 1.7 × 1010 atoms/s, respectively.
We present a 2D magneto-optical trap (MOT) that uses an innovative simple optical configuration. Instead of mirrors and quarter-wave plates we use metal-coated retro-reflecting prisms so as to recycle the optical power of the cooling laser beam. We have characterised this source for three different configurations: with and without transverse magnetic field gradient, as well as with a pusher beam to produce a 2D+-MOT. The longitudinal velocity is about 25 m·s-1, with a transverse velocity spread ≤ 1 m·s-1, while the typical atomic flux density can be as much as 1.3×1014 at·s-1·m-2 for a cesium vapour pressure of ~4×10-8 mbar in the source. We use this low velocity atomic beam, instead of thermal vapour, to load a 3D moving optical molasses that launches a continuous cold cesium fountain. We achieve a gain of a factor ~ 20 in the fountain's atomic flux.
We present our study on enhancement and optimization of potassium-40 (K40) atomic beam flux from a two-dimensional magneto-optical trap (2D MOT) by modulating the frequency of cooling laser. The laser cooling beam frequencies of the 2D MOT were effectively broadened via electro-optical modulators at 10 MHz, with a modulation index ranging from β=0 to 7, depending on the laser intensity. Laser parameters of the 2D MOT beams and the magnetic field gradient were scanned for optimal settings for maximum atomic beam flux. When compared to a conventional 2D MOT with fixed laser frequencies, we were able to obtain a 3.7 times enhancement of the atomic flux when the total laser power was 640 mW. Numerical calculations predict further improvement for higher laser beam intensities.