Moratuwa Engineering Research Conference (MERCon)

Gain Performance of Single-Pump Phase Sensitive Amplifier in the Quadratic Gain Regime

Dushani Munasinghe, Gresha S. Samarakkody, Sachinthani Alahakoon, Ruwan U. Weerasuriya

Published Jul 1, 2020• 0 citations

Abstract

In optical communication systems, Phase Sensitive Amplifier (PSA) is well known for its superior noise performance in the sub-quantum limit. Therefore, PSAs are highly suitable for long haul transmission systems where amplification and regeneration is critical. In this paper, we analyze the gain performance of a single pump non-degenerate PSA operating in the quadratic gain regime. The variation of gain characteristics with pump power and fiber length has been discussed. It could be seen that for a 5km long fiber, increasing of pump power above 4W subjected to the increasing of amplifier gain while maintaining the relative phase at a stable constant value of 0.001 rad. Therefore, by fine tuning parameters like fiber nonlinearity, pump power and fiber length, a phase stabilized gain performance of the PSA could be achieved when it is operating in the quadratic gain regime.

DOI: 10.1109/mercon50084.2020.9185352

Related papers

Detailed characterization of a fiber-optic parametric amplifier in phase-sensitive and phase-insensitive operation

Joseph Kakande, Carl Lundström, Peter A. Andrekson +5 more

We experimentally demonstrate a single-pumped, non-degenerate phase-sensitive parametric amplifier with a precise control of phase and amplitude of the in-going waves and investigate in detail its gain, attenuation and saturation properties in comparison with operation in phase insensitive amplifier (PIA) mode. We experimentally observe the variation of the gain and attenuation as a function of the relative phase, pump power and the signal-idler power ratio. The phase sensitive gain spectrum is studied over a 24 nm symmetrical bandwidth and we achieve a maximum phase sensitive amplification (PSA) gain of 33 dB. A departure from the theoretical maximum attenuation as the gain increases is observed and explained.

Optics ExpressFeb 17, 201070 citations

Phase and Amplitude Regeneration of Differential Phase-Shift Keyed Signals Using Phase-Sensitive Amplification

Kevin Croussore, Guifang Li

Phase-sensitive amplifiers (PSAs) offer numerous advantages over phase-insensitive amplifiers in optical communications. Squeezing of optical phase through PSA can remove accumulated phase jitter, which is a critical functionality for an all- optical, phase-shift keyed network. In recent experiments, reviewed in this report, different implementations of PSA were used for phase regeneration of both return-to-zero differential phase-shift keying and nonreturn-to-zero differential phase-shift keying data. The first demonstration explored the properties and performance of PSA that occurs in nonlinear interferometers. Experiments confirmed that a PSA operating in the depleted pump regime provides simultaneous reduction of amplitude and phase noise (PN). Phase regeneration performance limit was reached as a consequence of pump-wave imperfections, which can be significantly reduced through proper design. PSA that occurs directly in fiber in a traveling-wave configuration through partially degenerate four-wave mixing was also studied. The latter implementation offers stronger phase-matched gain and suppression of amplitude-to-phase noise conversion. Technical issues that remain to be addressed are identified for each implementation. Results characterized using coherent detection offer direct measurements of the phase-regenerative behavior.

IEEE Journal of Selected Topics in Quantum ElectronicsJan 1, 2008103 citations

Phase sensitive parametric amplifiers and their applications

Joseph Kakande

Phase sensitive amplification (PSA) is a remarkably powerful tool if implemented correctly - it allows amplification with a noise figure lower than quantum mechanics normally dictates, and also allows the development of systems that coherently process the phase of their optical inputs. PSA at infrared wavelengths can be achieved using second or third order optical nonlinearities - indeed the first demonstrations of PSA utilised degenerate three photon mixing in bulk crystals, allowing the observation of effects such as quantum quadrature squeezing. This PhD research project was aimed at translating the fascinating science of PSAs into applications, based on Kerr nonlinearity in optical fibres, capable of being deployed in modern core optical networks runnning at 40 Gbit/s and higher. This objective was an integral part of the European Union FP7 project PHASORS. Studies, both theoretical and experimental, were carried out on wideband non-degenerate PSAs. The inline cascaded fiber optic parametric amplifier (FOPA), in which a first phase insensitive FOPA is used to generate phase locked signal-idler pairs, followed by a second FOPA in which PSA takes place, was used to experimentally demonstrate PSA gain characteristics in linear and saturated modes of operation, with PSA obtained over 20 nm in the telecom C-band. Focus was then re-directed towards applying a dual pump PSA to DPSK regeneration. The amplitude and phase limiting characteristics of these devices were experimentally studied, in particular revealing that amplitude saturation arises due to an interplay between input phase and nonlinear phase matching along the nonlinear fibre. This feature was used to identify a regime of operation for DPSK regeneration combining simultaneous phase and amplitude regeneration. A practical DPSK regenerator based on a degenerate dual pump phase sensitive FOPA was built. The device advanced the state of the art by incorporating a pump synthesis stage that allowed black-box operation. Detailed measurements using noise sources with varying frequency distributions in both amplitude and in phase, are presented, and the ability of the system to improve the phase and amplitude characteristics of signals at its input was verified. Also presented are results showing the regenerator installed in the middle of an 800 km dark fiber link. Finally, a novel scheme was proposed and demonstrated that utilised parametric mixing to perform arbitrary phase quantization. This relied on the coherent addition of an M-level PSK signal with a conjugated (M-1)th phase harmonic, scaled by a coefficient m, to achieve M-level phase quantization. The concept was successfully demonstrated with QPSK data signals at 56 Gbaud, as well as used to quantize lower bandwidth test signals from 2 to 6 phase levels.

Mar 1, 20123 citations

Characterization and Applications of Vector Phase-Sensitive Amplifiers

Abel Lorences-Riesgo

This work is devoted to the characterization of vector phase-sensitive amplifiers and processors. A detailed analysis of degenerate vector phase-sensitive amplifier (PSA) is performed.The gain and phase-sensitive extinction ratio are theoretically analyzed using three-wave theory. Experiments and simulation results confirm the validity of this three-wave theory. The influence of polarization-mode dispersion is also evaluated, showing that aligning the pump polarizations at the fiber input is essential in order to achieve the theoretically predicted results. The scheme is also compared to the degenerate scalar PSA scheme. At the same pump power, the vector PSA has lower gain but also less influence from higher-order idlers and lower pump depletion due to FWM between the pumps. Using the degenerate vector PSA, phase-sensitive (PS) amplification of dual-polarization (DP) binary phase-shift keying (BPSK) signals was demonstrated. To the best of our knowledge, this was the first demonstration of a DP-modulated signal with large net phase-sensitive gain. Furthermore, we also demonstrated that this scheme can phase regenerate the signal. The same scheme was also used for a different purpose: quadrature decomposition into two cross-polarized waves. We demonstrated demultiplexing of quadrature phase-shift keying (QPSK) signal into two cross-polarized BPSK signals by the operating the amplifier in phase-insensitive mode. The design of a novel phase-locked loop scheme enabled stable operation and negligible penalty in the decomposition.

Jan 1, 20150 citations

Phase Sensitive Amplification in a Periodically Poled Silica Fiber

Nicolas Englebert, Francesco De Lucia, Pier J. A. Sazio +2 more

Summary form only given. When a signal propagates through a transmission line, it is deteriorated by amplitude and phase noise, which reduces its signal-to-noise ratio (SNR) [1]. According to Shannon's theory, the SNR determines the maximum spectral efficiency. It is therefore necessary to limit the noise [3]. For this purpose, one can use phase sensitive amplifiers (PSA) instead of phase insensitive amplifiers (PIA) like Erbium-doped fiber amplifiers. PSAs amplify only one phase quadrature of the signal while deamplifying the other, thanks to a required phase relationship between the pump and the signal. This unique property, known as phase-squeezing, allows to obtain noise figures (NF) as low as 0 dB whereas PIAs, based on stimulated emission, cannot be go below the 3 dB quantum limit [2]. Moreover, the phase-squeezing property of PSAs can be used for quantum communication or even in metrology [1]. PSA can be realized with χ(2)material through degenerate parametric amplification [2]. The large spectral separation between the pump and the signal makes it very easy to filter out the pump after amplification. A ± 11 dB amplification with a sub-quantum NF and a regeneration of a DPSK signal was experimentally performed in LiNbO3 [3]. A fiber based approach would however be preferable for telecommunication purposes. PSA's based on four wave-mixing have been demonstrated, but the long length and the difficulty to separate pump from the signal [1] hinders its practical implementation. Here we present the first demonstration of a PSA based on periodically poled silica fiber (PPSF). This design has the advantage of all-fiber devices as well as simple pump filtering. The experimental set-up is depicted in Figure 1. A 20 mW CW fiber laser at 1550 nm is sent through a 99:1 coupler to be divided into a signal and a pump. The pump is modulated into 1 ns wide pulses with a repetition rate of 50 MHz. It is then amplified and frequency doubled in a PPLN crystal. The peak power of the 775 nm pump pulses reaches 10W. The pump and CW signal are then combined in a WDM and sent through a 30 cm long PPSF [4] where the signal undergoes parametric amplification. A second WDM is used to separate the pump from the amplified signal. The wave plates and the polarization controller in the pump path, allow to simultaneously control the polarization of the pump and the power in the fundamental mode of the PPSF (at 775 nm the fibre is slightly multimode). The relative phase between the pump and signal is controlled by fine tuning the frequency of the laser via a built-in piezo.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)Jun 1, 20190 citations

Pump Frequency Allocation and Dispersion Effect on Dual-Pump Phase Sensitive Amplifier Gain Spectrum

Ruwan U. Weerasuriya, Junda Chen, Rasmus Larsson +1 more

Dual-pump fiber optical parametric amplifiers offer wide, flat gain spectra across arbitrary wavelengths, often outperforming the use of single-pump designs. However, gain flatness depends on the pump frequencies’ center of gravity relative to the nonlinear fiber’s zero-dispersion wavelength. This study experimentally investigated the gain, gain flatness, and noise figure of degenerate dual-pump fiber-optic phase-sensitive amplification at various separations between these points. We demonstrated 38 dB gain with 1.5 dB gain flatness variation over a 30 nm bandwidth as well as a noise figure below the conventional 3 dB quantum limit for a degenerate signal.

IEEE Photonics Technology LettersJul 30, 20253 citations