Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference

Superconducting bandpass ΔΣ modulator with 2.23 GHz center frequency and 42.6 GHz sampling rate

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich, M. B. Ketchen

Published Jun 25, 2003• 14 citations
Publisher

Abstract

A superconducting bandpass /spl Delta//spl Sigma/ modulator employing a 2.23 GHz microstrip resonator and a single flux quantum comparator clocked at 42.6 GHz achieves 49 dB peak SNR over a 20.8 MHz bandwidth. At 40.2 GHz clock rate, in-band noise over a 19.6 MHz bandwidth is -57 dBFS. The test chip with integrated acquisition memory contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2K.

DOI
10.1109/isscc.2002.992999

Related papers

Superconducting bandpass ΔΣ modulator with 2.23-GHz center frequency and 42.6-GHz sampling rate

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.

IEEE Journal of Solid-State Circuits•Dec 1, 2002•21 citations

Experimental demonstration of superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

Superconducting bandpass delta-sigma (/spl Delta//spl Sigma/) modulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demonstrated operation of a superconducting bandpass /spl Delta//spl Sigma/ modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key implementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic coupling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sampling rate are presented.

IEEE Transactions on Applied Superconductivity•Jun 1, 2003•11 citations

Superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, H.-S. Lee, James A. Misewich +1 more

Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.

Superconductor Science and Technology•Nov 1, 1999•13 citations

Experimental Demonstration of Superconducting

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

Superconducting bandpass delta-sigma ( ) mod- ulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demon- strated operation of a superconducting bandpass modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key im- plementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic cou- pling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sam- pling rate are presented.

•Jan 1, 2003•0 citations

Noise-Shaping Characteristics of Superconducting Band-Pass Sigma-Delta Modulators

Tatsunori Hashimoto, H. Hasegawa, Shuichi Nagasawa +3 more

The noise-shaping characteristics of superconducting band-pass single-loop sigma-delta modulators were clearly observed for the first time at 4 K using a 2.86 GHz sampling clock and a 0.69 GHz signal. The modulator consisted of a Josephson comparator, a driver, and a lumped-element-circuit superconducting resonator. The modulator chips were fabricated using NEC's Nb standard process. Digital data from the modulator were consecutively acquired using a semiconductor data acquisition system. By using a fast Fourier transform (FFT) software, the output spectrum of the noise-shaping characteristics was calculated from the measured data. Also, the input-output characteristics were measured experimentally, and the modulator's linearity was confirmed.

Japanese Journal of Applied Physics•Oct 1, 2001•5 citations

Flux quantum sigma-delta analog-to-digital converters for rf signals

Donald L. Miller, John X. Przybysz, A. Hodge Worsham +1 more

The sigma-delta architecture is the method of choice for analog-to-digital converters (ADCs) for high dynamic range applications. This architecture uses oversampling and precise feedback to generate a shaped spectral distribution of the quantization noise. Subsequent digital filtering suppresses out-of-band quantization noise, yielding a large signal to in-band noise ratio. A unique advantage of superconducting electronics is the availability of the flux quantum to provide quantum mechanically accurate feedback at GHz rates. Josephson digital technology extends sigma-delta ADCs from MHz sampling rates to GHz sampling rates, from kHz signal bandwidths to MHz signal bandwidths, with comparable or better dynamic range when compared to semiconductor implementations. This paper presents circuits for Josephson sigma-delta ADCs, including single-loop and double-loop modulators operating at sampling rates up to 2 GHz, and circuits for quantized feedback. The first demonstration of double-loop noise shaping is also presented.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•25 citations
A superconducting bandpass /spl Delta//spl Sigma/ modulator employing a 2.23 GHz microstrip resonator and a single flux quantum comparator clocked at 42.6 GHz achieves 49 dB peak SNR over a 20.8 MHz bandwidth. At 40.2 GHz clock rate, in-band noise over a 19.6 MHz bandwidth is -57 dBFS. The test chip with integrated acquisition memory contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2K.
This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.
Superconducting bandpass delta-sigma (/spl Delta//spl Sigma/) modulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demonstrated operation of a superconducting bandpass /spl Delta//spl Sigma/ modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key implementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic coupling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sampling rate are presented.
Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.
Superconducting bandpass delta-sigma ( ) mod- ulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demon- strated operation of a superconducting bandpass modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key im- plementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic cou- pling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sam- pling rate are presented.
The noise-shaping characteristics of superconducting band-pass single-loop sigma-delta modulators were clearly observed for the first time at 4 K using a 2.86 GHz sampling clock and a 0.69 GHz signal. The modulator consisted of a Josephson comparator, a driver, and a lumped-element-circuit superconducting resonator. The modulator chips were fabricated using NEC's Nb standard process. Digital data from the modulator were consecutively acquired using a semiconductor data acquisition system. By using a fast Fourier transform (FFT) software, the output spectrum of the noise-shaping characteristics was calculated from the measured data. Also, the input-output characteristics were measured experimentally, and the modulator's linearity was confirmed.
The sigma-delta architecture is the method of choice for analog-to-digital converters (ADCs) for high dynamic range applications. This architecture uses oversampling and precise feedback to generate a shaped spectral distribution of the quantization noise. Subsequent digital filtering suppresses out-of-band quantization noise, yielding a large signal to in-band noise ratio. A unique advantage of superconducting electronics is the availability of the flux quantum to provide quantum mechanically accurate feedback at GHz rates. Josephson digital technology extends sigma-delta ADCs from MHz sampling rates to GHz sampling rates, from kHz signal bandwidths to MHz signal bandwidths, with comparable or better dynamic range when compared to semiconductor implementations. This paper presents circuits for Josephson sigma-delta ADCs, including single-loop and double-loop modulators operating at sampling rates up to 2 GHz, and circuits for quantized feedback. The first demonstration of double-loop noise shaping is also presented.