Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)

Performance of heterodyne mixers using arrays of SIS junctions

Denis Crété, William R. McGrath, P. L. Richards, Frances L. Lloyd

Published Dec 1, 1985• 0 citations
Publisher

Abstract

The SIS quasiparticle tunnel junction has been demonstrated to be the most sensitive mixing element for millimeter wave receivers [1,2]. Conversion gain greater than 1 and noise temperature approaching the quantum limit [3,4] has been observed. The required local oscillator power, which can be as small as 10−8W, leads to a low saturation threshold for these mixers [5,6]. The practical benefits, including higher saturation power, of using series arrays are sufficiently important that a substantial number of experiments using arrays have been reported [2,6,7,8,9]. It has not been clear, however, whether there has been any sacrifice in mixer conversion efficiency (gain) or noise. We present a systematic experimental investigation of mixing performance in series arrays of N junctions, where N = 1, 5, 10, 25 and 50.

DOI
10.1109/irmm.1985.9126605

Related papers

Performance of Arrays of SIS Junctions in Heterodyne Mixers

Denis Crété, William R. McGrath, P. L. Richards

We have made a systematic experimental study of the performance of millimeter-wave quasiparticle heterodyne mixers which use arrays of SIS tunnel junctions. Sets of arrays with N =1, 5, 10, 25, and 50 junctions in series were fabricated by photolithography. All of the arrays in a given set were made on a single silicon wafer so that their response time parameter omega/sub S/R/sub N/C would be the same. Junction areas were scaled so that the total impedance was the same for each array in a set. Sets of arrays from four wafers with values of omega/sub S/R/sub N/C ranging from 2.6 to 13 were evaluated in mixers at 33 and 36 GHz. These measurements showed that the signal power required to saturate the mixers varies as N/sup 2/ and that the conversion efficiency is nearly independent of N for all values of omega/sub S/R/sub N/C. The mixer noise temperature is independent of N for large values of omega/sub S/R/sub N/C. Therefore, the dynamic range of an SIS quasiparticle mixer can increase in proportion to N/sup 2/. For small values of as omega/sub S/R/sub N/C, however, the mixer noise increases systematically with N. This correlation suggests that the junction capacitance affects the coupling between junctions that can contribute to the noise.

IEEE Transactions on Microwave Theory and Techniques•Apr 1, 1987•24 citations

Experimental Study of Noise Temperature and Conversion Loss of SIS Junction Mixers

J.C. Macfarlane, Lewis B. Whitbourn, R. A. BATCHELOR

Experiments on the performance of superconductor-insulator-superconductor (SIS) tunnel junctions as heterodyne mixers at 40 GHz are reported. The techniques developed for the fabrication of multi-junction SIS series arrays differ from, and are considerably simpler than, other methods described in the literature. Results are reported on mixer noise temperature, conversion loss, saturation, local oscillator power levels and mixer dynamic range. Factors affecting the mixer's conversion performance are identified and comparisons are made with other reported results. It is concluded that mixer performance in the present experiments is limited by imperfect impedance matching at the signal frequency, due to relatively large values of parasitic capacitance in the junctions. Future work is aimed at both reducing the junction capacitance and redesigning the mixer mount to give improved r.f. matching.

Australian Journal of Physics•Jun 1, 1986•2 citations

Conversion Efficiency and Noise Measurements of SIS Array Mixers

Herman van Kempen, William R. McGrath, P. L. Richards +3 more

Quasiparticle heterodyne mixers which use series arrays [1] of Pb-alloy SIS tunnel junctions have been tested at 36 GHz. These arrays each showed a conversion loss of approximately 5dB. Single-sideband noise temperatures of 9.8 ± 5K, 34 ± 12 K, and 85 ± 25 K were measured for 1, 10 and 50 junction arrays respectively. Significantly increased saturation levels were observed for the 10 and 50 junction arrays.

International Conference on Submillimeter Waves and Their Applications•Dec 1, 1981•3 citations

Computer simulations of the performance of quasiparticle heterodyne mixers

T. M. Shen, P. L. Richards

Heterodyne mixers for millimeter wavelengths which have conversion gain and noise comparable to the quantum limit can be made using the non-linearity of the quasi-particle I-V curve of SIS or SIN tunnel junctions. When the voltage range of the non-linearity becomes small compared with hω/e, classical device theory breaks down and photon assisted tunneling theory must be used to understand mixer performance. In this paper we describe detailed computer simulations of SIS and SIN quasiparticle mixers. Predictions for conversion efficiency and noise are given for both devices as a function of operating frequency, bias voltage, RF source conductance and local oscillator power. A novel type of SIN harmonic mixer is proposed for which gain is also predicted.

IEEE Transactions on Magnetics•Jan 1, 1981•23 citations

Predicted conversion gain in superconductor-insulator-superconductor quasiparticle mixers

John R. Tucker

A computer simulation is constructed to describe the performance of superconductor-insulator-superconductor (SIS) quasiparticle heterodyne receivers in terms of photon-assisted tunneling theory. The results predict that conversion efficiencies greater than unity can be realized at millimeter wave frequencies, with noise temperatures approaching the fundamental quantum limit. The nonlinearity responsible for the mixing is the extremely rapid onset of quasiparticle tunneling current in SIS junctions near the full gap voltage 2Δ/e, and is independent of the Josephson pair currents. Substantial gain is expected under a variety of conditions and for a wide range of source and load impedances.

Applied Physics Letters•Mar 15, 1980•106 citations

Quasiparticle heterodyne mixing in SIS tunnel junctions

P. L. Richards, T. M. Shen, R. Harris +1 more

The rapid onset of quasiparticle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2 delta/e is being used for millimeter wave heterodyne mixing. Junctions with 2 micron diameter and RN = 50 ohms have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Single sideband conversion efficiencies of 0.18 and mixer noise temperatures as low as TM approximately 14K have been observed. Both results agree with shot noise limited mixer theory. Photon assisted tunneling effects are seen which indicate the approach to photon noise limited operation. (Author)

STIN•Oct 1, 1978•1 citation
The SIS quasiparticle tunnel junction has been demonstrated to be the most sensitive mixing element for millimeter wave receivers [1,2]. Conversion gain greater than 1 and noise temperature approaching the quantum limit [3,4] has been observed. The required local oscillator power, which can be as small as 10−8W, leads to a low saturation threshold for these mixers [5,6]. The practical benefits, including higher saturation power, of using series arrays are sufficiently important that a substantial number of experiments using arrays have been reported [2,6,7,8,9]. It has not been clear, however, whether there has been any sacrifice in mixer conversion efficiency (gain) or noise. We present a systematic experimental investigation of mixing performance in series arrays of N junctions, where N = 1, 5, 10, 25 and 50.
We have made a systematic experimental study of the performance of millimeter-wave quasiparticle heterodyne mixers which use arrays of SIS tunnel junctions. Sets of arrays with N =1, 5, 10, 25, and 50 junctions in series were fabricated by photolithography. All of the arrays in a given set were made on a single silicon wafer so that their response time parameter omega/sub S/R/sub N/C would be the same. Junction areas were scaled so that the total impedance was the same for each array in a set. Sets of arrays from four wafers with values of omega/sub S/R/sub N/C ranging from 2.6 to 13 were evaluated in mixers at 33 and 36 GHz. These measurements showed that the signal power required to saturate the mixers varies as N/sup 2/ and that the conversion efficiency is nearly independent of N for all values of omega/sub S/R/sub N/C. The mixer noise temperature is independent of N for large values of omega/sub S/R/sub N/C. Therefore, the dynamic range of an SIS quasiparticle mixer can increase in proportion to N/sup 2/. For small values of as omega/sub S/R/sub N/C, however, the mixer noise increases systematically with N. This correlation suggests that the junction capacitance affects the coupling between junctions that can contribute to the noise.
Experiments on the performance of superconductor-insulator-superconductor (SIS) tunnel junctions as heterodyne mixers at 40 GHz are reported. The techniques developed for the fabrication of multi-junction SIS series arrays differ from, and are considerably simpler than, other methods described in the literature. Results are reported on mixer noise temperature, conversion loss, saturation, local oscillator power levels and mixer dynamic range. Factors affecting the mixer's conversion performance are identified and comparisons are made with other reported results. It is concluded that mixer performance in the present experiments is limited by imperfect impedance matching at the signal frequency, due to relatively large values of parasitic capacitance in the junctions. Future work is aimed at both reducing the junction capacitance and redesigning the mixer mount to give improved r.f. matching.
Heterodyne mixers for millimeter wavelengths which have conversion gain and noise comparable to the quantum limit can be made using the non-linearity of the quasi-particle I-V curve of SIS or SIN tunnel junctions. When the voltage range of the non-linearity becomes small compared with hω/e, classical device theory breaks down and photon assisted tunneling theory must be used to understand mixer performance. In this paper we describe detailed computer simulations of SIS and SIN quasiparticle mixers. Predictions for conversion efficiency and noise are given for both devices as a function of operating frequency, bias voltage, RF source conductance and local oscillator power. A novel type of SIN harmonic mixer is proposed for which gain is also predicted.
A computer simulation is constructed to describe the performance of superconductor-insulator-superconductor (SIS) quasiparticle heterodyne receivers in terms of photon-assisted tunneling theory. The results predict that conversion efficiencies greater than unity can be realized at millimeter wave frequencies, with noise temperatures approaching the fundamental quantum limit. The nonlinearity responsible for the mixing is the extremely rapid onset of quasiparticle tunneling current in SIS junctions near the full gap voltage 2Δ/e, and is independent of the Josephson pair currents. Substantial gain is expected under a variety of conditions and for a wide range of source and load impedances.
The rapid onset of quasiparticle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2 delta/e is being used for millimeter wave heterodyne mixing. Junctions with 2 micron diameter and RN = 50 ohms have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Single sideband conversion efficiencies of 0.18 and mixer noise temperatures as low as TM approximately 14K have been observed. Both results agree with shot noise limited mixer theory. Photon assisted tunneling effects are seen which indicate the approach to photon noise limited operation. (Author)