Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)

Submillimeter-wave response in tunnel-type and bridge-type Josephson junction

S. Morita, S. Imai, Nobuo Mikoshiba

Published Dec 1, 1983• 0 citations
Publisher

Abstract

The study of the Josephson junction is a new field for optically-pumped submillimeter laser spectroscopy. We report submillimeter-wave techniques for this spectroscopy and experimental results on the Shapiro step.
DOI
10.1109/irmm.1983.9126403

Related papers

All-Nb thin film microbridge-type Josephson junction for submillimeter-wave detection

Nobumitsu Hirose, Y. Harada, Matsuo Sekine +2 more

Infrared Physics•Oct 1, 1993•0 citations

Nonlinear response of tunnel-type Josephson junctions at submillimeter-wave frequencies

S. Morita, S. Takaki, S. Imai +2 more

We have fabricated tunnel-type Josephson junctions with very small junction area by pressing the tip of a sharpened Nb wire onto a thinly oxidized Sn film, and studied their submillimeter-wave responses. It turns out that the junctions have a very high cutoff frequency, and are suitable for the investigation of the response to the submillimeter waves with the frequency higher than 1 THz. From the frequency and laser-power dependence of the Shapiro step, it is found that the tunnel-type junction shows much larger higher-order steps, and accordingly has much stronger nonlinearity than the bridge-type junction in the submillimeter-wave region. The large enhancement of the steps due to the Riedel singularity is also observed in the tunnel-type junction. In addition to the Shapiro steps, photon-assisted tunneling steps are observed clearly, reflecting the large and sharp gap structure in the dc IV curves of the tunnel-type junctions.

IEEE Transactions on Magnetics•May 1, 1983•6 citations

Study of harmonic-wave mixing with Josephson junctions in submillimeter region

幹夫 岸本

•Jan 1, 1985•0 citations

Frequency Dependence of the Submillimeter-Wave Response in the Tunnel-Type and Bridge-Type Josephson Junctions

Seizo Morita, Satoru Takaki, Syozo Imai +2 more

We have fabricated ultrasmall tunnel-type Josephson junctions with Nb–SnO x –Sn film point-contacts. Using these junctions, we have measured for the first time the Shapiro steps in the submillimeter-wave region and have compared the strength of steps of this junction with that of the bridge-type Nb–Sn ingot point-contacts. We found that the tunnel-type junction shows a sharper Riedel peak than the bridge-type junction.

Japanese Journal of Applied Physics•Jun 1, 1982•6 citations

Millimeter and submillimeter wave generation by phase-locked 1D and 2D Josephson-junction arrays

Victor K. Kornev, Alexey Arzumanov, A.D. Mashtakov +1 more

•Jan 1, 1995•0 citations

Correlation between Types of Junction and Submillimeter-Wave Responses in Point-Contact Josephson Junctions

Seizo Morita, Takashi Noguchi, Satoru Takaki +4 more

It has been found that point-contact Josephson junctions can be clearly classified into bridge-type and tunnel-type by introducing new parameters characterizing their I-V curves. Nearly-ideal tunnel-type junctions with Nb–SuO x –Sn (Film) point-contacts were obtained. Tunnel-type junctions showed larger gap energies than bridge-type junctions in Nb–SnO x –Sn and Nb–NbO x –NbN point-contacts. The submillimeter-wave responses were measured in Nb–Nb point-contacts, and it was found that the contacts with the best performance were bridge-type junctions with a sharp gap structure; tunnel-type junctions showed rather bad performance. On irradiation with laser light, the center of the Shapiro step moved to the lower-current side in bridge-type junctions but to the higher-current side in tunnel-type junctions. These differences can be explained by differences in the heating effects between bridge-type and tunnel-type junctions.

Japanese Journal of Applied Physics•Jan 1, 1982•6 citations
We have fabricated tunnel-type Josephson junctions with very small junction area by pressing the tip of a sharpened Nb wire onto a thinly oxidized Sn film, and studied their submillimeter-wave responses. It turns out that the junctions have a very high cutoff frequency, and are suitable for the investigation of the response to the submillimeter waves with the frequency higher than 1 THz. From the frequency and laser-power dependence of the Shapiro step, it is found that the tunnel-type junction shows much larger higher-order steps, and accordingly has much stronger nonlinearity than the bridge-type junction in the submillimeter-wave region. The large enhancement of the steps due to the Riedel singularity is also observed in the tunnel-type junction. In addition to the Shapiro steps, photon-assisted tunneling steps are observed clearly, reflecting the large and sharp gap structure in the dc IV curves of the tunnel-type junctions.
It has been found that point-contact Josephson junctions can be clearly classified into bridge-type and tunnel-type by introducing new parameters characterizing their I-V curves. Nearly-ideal tunnel-type junctions with Nb–SuO x –Sn (Film) point-contacts were obtained. Tunnel-type junctions showed larger gap energies than bridge-type junctions in Nb–SnO x –Sn and Nb–NbO x –NbN point-contacts. The submillimeter-wave responses were measured in Nb–Nb point-contacts, and it was found that the contacts with the best performance were bridge-type junctions with a sharp gap structure; tunnel-type junctions showed rather bad performance. On irradiation with laser light, the center of the Shapiro step moved to the lower-current side in bridge-type junctions but to the higher-current side in tunnel-type junctions. These differences can be explained by differences in the heating effects between bridge-type and tunnel-type junctions.