A novel design of a radio-frequency (RF) power limiter for protecting sensitive superconductor receiver components from high-power microwave signals is presented. In this approach, two low-Tcsuperconductor microstrip lines, one of which is coupled with an array of RF superconducting quantum interference devices (rf-SQUIDs), are combined with a pair of hybrid couplers to provide the power limiting operation at very low RF power levels. The key concept is built on the fact that a microstrip line coupled to an array of rf-SQUIDs behaves as a power-dependent phase shifter and its phase can be controlled by the input RF power. This phenomenon is exploited to achieve the desired RF power-limiting operation. The device is fabricated using an eight-layer niobium-based superconducting process node SFQ5ee by MIT Lincoln Laboratory (MIT-LL). A monolithically integrated wideband hybrid coupler is used in this design as it dictates the bandwidth of the overall device. The operating frequency of the power limiter is 10 GHz with a 2-GHz bandwidth. The performance of the device is measured for input RF power levels ranging from −30 to +10 dBm, as well as arising intermodulation products are experimentally investigated. The output power increases linearly with the input power up to −15 dBm, and for higher power levels, the device offers an increasing attenuation to limit the output RF power starting above −15 dBm.
Microwave SQUID (Superconducting QUantum Interference Device) multiplexing is a suitable technique for reading a large number of detector channels, using only a few connecting lines. In the HOLMESexperiment, this is based on inductively coupled rf-SQUIDs fed by TES (Transition Edge Sensors). Operation of the whole rf-SQUID chain is achieved with a single transmission line, by means of the recently introduced flux-ramp modulation technique—a sawtooth signal which allows signal reconstruction while operating the rf-SQUIDs in an open loop condition. Due to the crucial role of the sawtooth signal, it is very important that it does not suffer from ground-loop disturbances and electromagnetic interference (EMI). Introducing a transformer between the sawtooth source and the SQUID is very effective in suppressing disturbances. The sawtooth signal has both slow and fast components, and the frequency can vary between a few kHz up to a MHz, depending on the TES signal and SQUID characteristics. A transformer able to handle such a broad range of conditions must have very stringent characteristics and needs to be custom designed. Our solution exploits standard commercial and inexpensive transformers for LAN networks, stacked in a user-selectable number, to better fit the bandwidth requirements. A model that allows handling of the low- and high-frequency operating range has been developed.