Nitrogen-vacancy (NV) centers in diamond photonic nanostructures have attracted much attention as efficient single photon emitters and quantum bits. These quantum optical devices mostly require single or low-density NV centers doped in thin diamond membranes. In contrast, this study focuses on diamond photonic nanostructures with a high concentration of NV centers to achieve a diamond color center laser with a sufficient gain available as a visible light source and a sensitive magnetic-field sensor. We employ high-dose helium ion implantation to type-Ib diamond substrates and thermal annealing, which enables us to obtain uniform thin diamond membranes containing a dense ensemble of NV centers. Luminescence spectroscopy reveals the kinetics of NV centers at high temperature from which we find an optimum annealing temperature maximizing the NV center emission while suppressing the transformation from NV to H3 centers. Furthermore, fine photonic nanowires are also successfully fabricated in the air-suspended diamond membrane, and they exhibit intense photoluminescence from the NV centers with a concentration as high as 7 × 1016 cm−3 (0.4 ppm). These results suggest a route to the fabrication of diamond photonic nanostructures containing a dense ensemble of NV centers, which can be a key material for developing diamond-based light emitting and magnetic-field sensing devices.
Nitrogen-vacancy (NV) centers in diamond photonic nanostructures have attracted much attention as efficient single photon emitters and quantum bits. These quantum optical devices mostly require single or low-density NV centers doped in thin diamond membranes. In contrast, this study focuses on diamond photonic nanostructures with a high concentration of NV centers to achieve a diamond color center laser with a sufficient gain available as a visible light source and a sensitive magnetic-field sensor. We employ high-dose helium ion implantation to type-Ib diamond substrates and thermal annealing, which enables us to obtain uniform thin diamond membranes containing a dense ensemble of NV centers. Luminescence spectroscopy reveals the kinetics of NV centers at high temperature from which we find an optimum annealing temperature maximizing the NV center emission while suppressing the transformation from NV to H3 centers. Furthermore, fine photonic nanowires are also successfully fabricated in the air-suspended diamond membrane, and they exhibit intense photoluminescence from the NV centers with a concentration as high as 7 × 1016 cm−3 (0.4 ppm). These results suggest a route to the fabrication of diamond photonic nanostructures containing a dense ensemble of NV centers, which can be a key material for developing diamond-based light emitting and magnetic-field sensing devices.
Precise control over the spatial distribution and charge state of nitrogen-vacancy (NV) centers in diamond is a key requirement for further advancing this platform in quantum sensing and photonic applications. Here, we investigate nitrogen ion implantation as a scalable method to engineer NV centers in bulk single-crystalline (SC) and a 5 μ m -thick polycrystalline (PC) diamond membrane. Nitrogen-doped regions (1–80 ppm) were fabricated using a 0.7 MeV ion beam and high-temperature annealing, with NV center formation verified by confocal fluorescence imaging and spectral analysis. In SC bulk diamond, we estimate the NV concentration from spectral analysis and model the fluorescence response as a function of implantation dose, capturing both the initial increase at low concentrations and a saturation behavior at higher doses due to quenching mechanisms. In contrast, PC diamond membranes show a weaker dependence at low implantation fluences, consistent with pre-existing nitrogen impurities, thus making a statistical model significantly more complex. The activation yield is found to be of order of 1%, which is lower than in N-rich diamond samples, as implanted N is predominantly interstitial. Photoluminescence spectroscopy indicates that NV 0 is the dominant charge state in both materials, with a laser-power-dependent redistribution between neutral and negative charge states. Optically detected magnetic resonance (ODMR) measurements in SC bulk diamond resolve the hyperfine structure and allow extraction of the dephasing time ( T 2 ∗ ), while in PC diamond membranes, where NV centers tend do form near the grain boundaries, the ODMR signals are observed but spectral resolution is currently limited by impurities, grain-dependent NV orientations, and photoluminescence background.
The negatively-charged nitrogen-vacancy (NV) center is the most studied optical center in diamond and is very important for applications in quantum information science. Many proposals for integrating NV centers in quantum and sensing applications rely on their tailored fabrication in ultra pure host material. In this study, we use ion implantation to controllably introduce nitrogen into high purity, low nitrogen chemical vapor deposition diamond samples. The properties of the resulting NV centers are studied as a function of implantation temperature, annealing temperature, and implantation fluence. We compare the implanted NV centers with native NV centers present deep in the bulk of the as-grown samples. The results for implanted NV centers are promising but indicate, at this stage, that the deep native NV centers possess overall superior optical properties. In particular, the implanted NV centers obtained after annealing at 2000 °C under a stabilizing pressure of 8 GPa showed an ensemble linewidth of 0.17 nm compared to 0.61 nm after annealing at 1000 °C. Over the same temperature range, the ensemble NV−/NV0 ratio increased by a factor of ∼5, although this was accompanied by an overall decrease in the NV count.
The development of material-processing techniques that can be used to generate optical diamond nanostructures containing a single-color center is an important problem in quantum science and technology. In this work, we present the combination of ion implantation and top-down diamond nanofabrication in two scenarios: diamond nanopillars and diamond nanowires. The first device consists of a 'shallow' implant (∼20 nm) to generate nitrogen-vacancy (NV) color centers near the top surface of the diamond crystal prior to device fabrication. Individual NV centers are then mechanically isolated by etching a regular array of nanopillars in the diamond surface. Photon anti-bunching measurements indicate that a high yield (>10%) of the devices contain a single NV center. The second device demonstrates 'deep' (∼1 μm) implantation of individual NV centers into diamond nanowires as a post-processing step. The high single-photon flux of the nanowire geometry, combined with the low background fluorescence of the ultrapure diamond, allowed us to observe sustained photon anti-bunching even at high pump powers.
Deploying nitrogen vacancy (NV) centers in diamond as nanoscale quantum sensors for condensed matter and materials physics requires placing the NV centers close to the sensing target. One solution is to fabricate diamond nanostructures and integrate them with materials and devices. However, diamond etching and ion milling can introduce subsurface damage and surface defects that degrade the charge stability and spin coherence of NV centers near the surface. Here we report a procedure for fabricating low-damage nanostructured diamond membranes, and we show that this fabrication scheme preserves the optical and spin properties of state-of-the-art shallow NV center quantum sensors, within nanometers of the diamond surface, while providing significant photonic enhancement. Furthermore, we demonstrate a pick-and-place transfer method, which enables integration with diverse sensing targets.
Creating dense and shallow nitrogen-vacancy (NV) ensembles with good spin properties is a prerequisite for developing diamond-based quantum sensors exhibiting better performance. Ion implantation is a key enabling tool for precisely controlling spatial localization and density of NV color centers in diamond. However, it suffers from a low creation yield, while higher ion fluences significantly damage the crystal lattice. In this work, we realize N2+ ion implantation in the 30–40 keV range at high temperatures. At 800 °C, NV's ensemble photoluminescence emission is three to four times higher than room temperature implanted films, while narrow electron spin resonance linewidths of 1.5 MHz, comparable to well-established implantation techniques, are obtained. In addition, we found that ion fluences above 2 × 1014 ions/cm2 can be used without graphitization of the diamond film, in contrast to room temperature implantation. This study opens promising perspectives in optimizing diamond films with implanted NV ensembles that could be integrated into quantum sensing devices.
Silicon-vacancy (SiV) centers in diamond are gaining an increased interest for application, such as in quantum technologies and sensing. Due to the strong luminescence concentrated in its sharp zero-phonon line at room temperature, SiV centers are being investigated as single-photon sources for quantum communication, and also as temperature probes for sensing. Here, we discussed strategies for the fabrication of SiV centers in diamond based on Si-ion implantation followed by thermal activation. SiV color centers in high-quality single crystals have the best optical properties, but polycrystalline micro and nanostructures are interesting for applications in nano-optics. Moreover, we discuss the photoluminescence properties of SiV centers in phosphorous-doped diamond, which are relevant for the creation of electroluminescent devices, and nanophotonics strategies to improve the emission characteristics of the SiV centers. Finally, the optical properties of such centers at room and high temperatures show the robustness of the center and give perspectives for temperature-sensing applications.