Hybrid systems that couple superconducting qubits to mechanical oscillators facilitate quantum control of individual phonons and have the potential to enable compact, highly coherent quantum memories and processors. To date, however, the utility of hybrid quantum acoustic devices has been limited by poor qubit and mechanical coherence times that are far shorter than those exhibited by their unhybridized counterparts. A primary challenge lies in the intrinsic nature of elastic waves in solids: the slow speed of sound results in a dense spectrum of acoustic modes, making it difficult to prevent spontaneous emission of the qubit into phononic degrees of freedom. In this thesis, I will present a systematic effort to suppress loss mechanisms in superconducting qubits and mechanical resonators in the context of circuit quantum acoustics. I begin by demonstrating the use of crystallographic orientation optimization to passively suppress diffraction losses in narrow-aperture quartz surface acoustic wave (SAW) resonators. We then study the coupling of SAW resonators to a quasi-continuum of bulk acoustic modes; this motivates us to abandon bulk piezoelectric media in favor of bandgap-protected thin-film devices. By fabricating suspended phononic crystal resonators from thin-film quartz, we demonstrate an order-of-magnitude improvement in the coherence of this class of devices. I conclude by presenting preliminary measurements of a new flip-chip architecture for circuit quantum acoustics -- the `acoustic trampoline' -- that is designed to maximize qubit-mechanical coupling while simultaneously suppressing spontaneous acoustic emission.
Multimode bulk acoustic systems show promise for use in superconducting quantum computation. They can serve as a medium-term memory storage, with exceptional coherence times being demonstrated, and they exhibit a mode density that is physically highly compact. Here, we experimentally demonstrate accessing individual acoustic modes without being hindered by the uniform frequency spacing of the modes. We use sideband control where a low-frequency modulation is applied to the transmon qubit energy. The amplitude of the modulation defines the qubit-acoustic mode coupling and its frequency detunes the acoustic sidebands, therefore selectively enabling the switching on or off of the interaction, and it allows for full control of the individual modes.
Optomechanically induced transparency (OMIT) is usually modeled and studied in the resolved-sideband regime, but many compact microcavity platforms operate in the unresolved-sideband limit
(κ≫Ωm). Here we investigate OMIT in this regime using a tunable fiber-based Fabry-Perot microcavity coupled to a suspended hexagonal boron nitride (hBN) drum resonator in a membrane-in-the-middle geometry. The system achieves a large single-photon coupling rate of
g0/2π∼180 kHz and exhibits strong radiation-pressure backaction. By measuring OMIT spectra as a function of pump power and cavity detuning, we observe a crossover from a transparency-like dip to a gain feature in the reflected response. These maps are quantitatively reproduced by the full linearized optomechanical response, demonstrating the breakdown of the standard rotating-wave approximation used in the resolved-sideband limit. Finally, we drive the system into a nonlinear regime to generate optomechanical frequency combs. These results establish hBN fiber-cavities as a versatile architecture for unresolved-sideband optomechanics, nonlinear dynamics, and hybrid device integration.