Abstract The development of superconducting quantum processors relies on understanding and mitigating decoherence in superconducting qubits. Piezoelectric coupling contributes to decoherence by mediating energy exchange between microwave photons and acoustic phonons. Although bulk centrosymmetric materials like silicon and sapphire are non-piezoelectric and commonly used as qubit substrates, the lack of centrosymmetry at interfaces may induce piezoelectric losses. This effect was predicted decades ago but never experimentally observed in superconducting devices. Here, we report interface piezoelectricity at aluminum-silicon junctions and demonstrate it as a significant loss channel in superconducting devices. Using aluminum interdigital transducers on silicon, we observe piezoelectric transduction from room to millikelvin temperatures, with an effective electromechanical coupling factor K 2 ≈ (3 ± 0.4) × 10 −5 %, comparable to weakly piezoelectric substrates. Modeling shows this mechanism limits qubit quality factors to Q ~ 10 4 − 10 8 , depending on surface participation and mode matching. These findings reveal interface piezoelectricity as a major dissipation channel and highlight the need for heterostructure and phononic engineering in next-generation superconducting qubits.
Dissipation remains a central obstacle to improving superconducting quantum circuits, yet the microscopic origins of loss in widely used materials platforms are not fully understood. Here, we report the observation of interface piezoelectricity-induced dissipation in superconducting qubits fabricated on high-resistivity silicon. Our devices use a transmon qubit with a shunt capacitor that simultaneously serves as an interdigital transducer embedded in a surface acoustic wave resonator. By tuning the qubit transition into resonance with discrete mechanical modes, we observe up to a factor-of-two reduction in qubit lifetime, consistent with energy exchange between the qubit and mechanical modes mediated by piezoelectric coupling at the aluminum-silicon interface. Our findings provide direct evidence for interface piezoelectricity as a distinct loss channel in superconducting qubits. Combined with multiphysics simulations, these findings suggest that interface piezoelectric loss can dominate over loss from two-level systems at sufficiently high frequencies.
Circuit quantum acoustodynamics (cQAD) devices have a wide range of applications in quantum science, all of which depend crucially on the quantum coherence of the mechanical subsystem. In this context, high-overtone bulk acoustic-wave resonators (HBARs) are particularly promising, since they have shown very high quality factors with negligible dephasing. However, the introduction of piezoelectric films, which are necessary for coupling to a superconducting circuit, can lead to additional loss channels, such as surface scattering and two-level systems (TLS). Here, we study the acoustic dissipation of HBAR resonators in cQAD systems and find that the defect density of the piezoelectric material and its interface with the bulk are limiting factors for the coherence. We measure acoustic modes with phonon lifetimes up to 400
μs and lifetime-limited coherence times approaching one millisecond in the quantum regime. When coupled to a superconducting qubit, this leads to a hybrid system with a large quantum coherence cooperativity of
CT2=1.1×105. These results represent a new milestone for the performance of cQAD devices and offer concrete paths forward for further improvements.