We present a precise measurement of a weak radio frequency electric field with a frequency of ≲ 3 GHz employing a resonant atomic probe that is constituted with a Rydberg cascade three-level atom, including a cesium ground state |6S1/2⟩, an excited state |6P3/2⟩, and Rydberg state |nD5/2⟩. Two radio frequency (RF) electric fields, noted as local and signal fields, couple the nearby Rydberg transition. The two-photon resonant Rydberg electromagnetically induced transparency (Rydberg-EIT) is employed to directly read out the weak signal field having hundreds of kHz difference between the local and signal fields that is encoded in the resonant microwave-dressed Rydberg atoms. The minimum detectable signal fields of E Smin = 1.36 ± 0.04 mV/m for 2.18 GHz coupling |68D5/2⟩ → |69P3/2⟩ transition and 1.33 ± 0.02 mV/m for 1.32 GHz coupling |80D5/2⟩ → |81P3/2⟩ transition are obtained, respectively. The bandwidth dependence is also investigated by varying the signal field frequency and corresponding −3 dB bandwidth of 3 MHz is attained. This method can be employed to perform a rapid and precise measurement of the weak electric field, which is important for the atom-based microwave metrology.
We present a precise measurement of a weak radio frequency electric field with a frequency of ≲ 3 GHz employing a resonant atomic probe that is constituted with a Rydberg cascade three-level atom, including a cesium ground state |6S1/2⟩, an excited state |6P3/2⟩, and Rydberg state |nD5/2⟩. Two radio frequency (RF) electric fields, noted as local and signal fields, couple the nearby Rydberg transition. The two-photon resonant Rydberg electromagnetically induced transparency (Rydberg-EIT) is employed to directly read out the weak signal field having hundreds of kHz difference between the local and signal fields that is encoded in the resonant microwave-dressed Rydberg atoms. The minimum detectable signal fields of E Smin = 1.36 ± 0.04 mV/m for 2.18 GHz coupling |68D5/2⟩ → |69P3/2⟩ transition and 1.33 ± 0.02 mV/m for 1.32 GHz coupling |80D5/2⟩ → |81P3/2⟩ transition are obtained, respectively. The bandwidth dependence is also investigated by varying the signal field frequency and corresponding −3 dB bandwidth of 3 MHz is attained. This method can be employed to perform a rapid and precise measurement of the weak electric field, which is important for the atom-based microwave metrology.
Rydberg atoms, with large principal quantum number, exhibit certain properties, such as long lifetimes and strong interactions with fields and other atoms, which have been extensively investigated recently. One of the properties is the electromagnetically induced transparency (EIT) of Rydberg ladder system, which can be used to measure the radio frequency (RF) field with high sensitivity. In this paper, we investigate the quantum coherent effect of cesium Rydberg atom in a three-level ladder system involving the ground state (6S1/2), the excited state (6P3/2) and 49S1/2 Rydberg state in room temperature vapor cell. The probe laser (852 nm) drives the transition of 6S1/2(F=4)→6P3/2(F'=5), while the coupling laser (510 nm) couples the Rydberg transition of 6P3/2 (F'=5)→nS1/2. A typical electromagnetically induced transparency spectrum is obtained when the weak probe laser is scanned through the transition of 6S1/2(F=4)→6P3/2(F'=5) and the coupling laser tuning to Rydberg transition. The two-photon RF spectra are observed when the RF field with a frequency of ～16.9 GHz couples the Rydberg transition of 49S1/2→47D3/2, where the EIT signal is split into two EIT peaks due to the interaction between the RF field and Rydberg atoms. The dependences of EIT splitting on the power of RF field are investigated. The results show that the EIT splitting increases with the power of RF field, which can inversely be used to measure the RF field with a higher spatial resolution in the future.
Rydberg atoms are highly excited atoms with large principal quantum number n, big sizes (~n2) and long lifetimes (~n3). Rydberg atoms are very sensitive to an external field due to the large polarizabilities of Rydberg atoms (~n7). Electromagnetically induced transparency (EIT) of Rydberg atom provides an ideal method to detect Rydberg atoms without destroying atoms, and can be used to measure the external direct current and radio frequency (RF) field. In this paper, we study the EIT effect of a cesium ladder-type three-level atom involving Rydberg state exposed to a weak RF field. The ground state (6S1/2), the excited state (6P3/2) and Rydberg state (48D5/2) constitute the Rydberg three-level system, in which the probe laser couples 6S1/2(F=4)6P3/2(F'=5) transition, whereas the coupling laser scans across the 6P3/248D5/2 Rydberg transition. The coupling laser (510 nm laser, propagating in the z-axis direction and linear polarization in the y-axis direction) and the probe laser (852 nm laser, linear polarization in the y-axis direction) counter-propagate through a 50-mm-long cesium vapor cell at room temperature, yielding Rydberg EIT spectra. Rydberg EIT signal is detected as a function of the detuning of the coupling laser. When a weak RF (80 MHz) electric field polarized in the x-axis direction is applied to a pair of electrode plates located on both sides of the cesium cell, the EIT spectrum of Rydberg 48D5/2 shows the Stark splitting and the even order harmonic sidebands. The experimental results are analyzed by using the Floquet theory. The simulation results accord well with the experimentally measured results. Furthermore, we also investigate the influence of the self-ionization effect of Rydberg atom on the Stark spectrum by changing the RF frequency. We put forward a proposal to avoid the effect of ionization by placing electrode plates in the cesium cell. In the weak RF-field domain, mj=5/2 Stark line crosses mj=1/2, 3/2 sidebands, these cross points provide an antenna-free method of accurately calibrating the RF electric field based on Rydberg atoms.
We demonstrate a continuously tunable electric field measurement based on the far off-resonant AC stark effect in a Rydberg atomic vapor cell. In this configuration, a strong far off-resonant field, denoted as a local oscillator (LO) field, acts as a gain to shift the Rydberg level to a high sensitivity region. An incident weak signal field with a few hundreds of kHz difference from the LO field is mixed with the LO field in the Rydberg system to generate an intermediate frequency signal, which is read out by Rydberg electromagnetically induced transparency (Rydberg-EIT) spectroscopy. Not like resonant EIT-Autler–Townes spectra, we realize the electric field measurement of the signal frequency from 2 to 5 GHz using a single Rydberg state. The detectable field strength is down to 2.25 μV/cm with sensitivity of the electrometry 712 nV cm−1 Hz−1/2, and a linear dynamic range is over 65 dB. The detectable field strength is comparable with a resonant microwave-dressed Rydberg heterodyne receiver using the same system, which is 0.96 μV/cm with sensitivity of 304 nV cm–1 Hz−1/2. We also show the system has an inherent polarization selectivity feature. Our method can provide high sensitivity of electric field measurement and be extended to arbitrary frequency measurements.
The high polarizability of Rydberg atoms enables the multi-parameters measurement of electromagnetic fields. In this paper, we report on an atomic antenna based on Rydberg atoms in a room temperature vapor cell. The EIT is a destructive interference spectroscopy with a narrow linewidth and can be used to detect small electric fields through Autler-Townes splitting or Stark shifts. In our experiments, we employ cascade-type two-photon excitation electromagnetically induced transparency (EIT) spectroscopy to measure the shift of the Rydberg energy level. We introduce a low-frequency electric field (~kHz frequency) using a built-in electrode technique in the cesium cell. The interaction between the Rydberg atom and electric field induces the Stark shifts, where the amplitude of the electric field is converted into corresponding two-photon detuning by the EIT effect. Furthermore, the amplitude of the low-frequency electric field is converted into an intensity signal of EIT probe beam. Under weak field conditions, it is an approximate linear relationship between EIT transmission signal and input electric field amplitude, enabling measurement of waveform, amplitude, and frequency. We have demonstrated optical measurements of low-frequency electric field using Rydberg atoms. By increasing the power of probe beam and coupling beam, the EIT can increase the response bandwidth from ~MHz to hundreds of MHz. This provides a scalable approach for measuring high-frequency electric fields.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.
The large electric dipole moment of the Rydberg atom allows for strong coupling with weak electric fields, and is widely used in electric field measurements because of its reproducibility, precision and stability. The combination of Rydberg atoms and electromagnetically induced transparency (EIT) technology has been used for detecting and characterizing radio-frequency (RF) electric fields. In this work, by selecting probe light (852 nm), dressed light (1470 nm), and coupled light (780 nm), the Rydberg state (49P3/2) of Cs atom is prepared by using a three-photon excitation scheme through using all-infrared light excitation of Rydberg atoms. We experimentally observe the EIT spectra of the Rydberg states decorated by radio-frequency electric fields, which optically detects Rydberg atoms. The effect of the amplitude and frequency of the RF electric field on the spectrum is explored in light of changes in the EIT spectrum. The results show that in the region of weak electric field, only the ac Stark energy shift and spectral broadening occur. As the electric field is further enhanced, the sideband phenomenon occurs in both the primary peak and secondary peak of the EIT. In the region of strong field, the Rydberg energy level produces a series of Floquet states with higher-order terms, as well as state shifting and mixing, resulting in asymmetry in the spectra of the EIT sideband peaks. The effect of frequency on the shielding effect of the Cs vapor cell is further discussed based on the shift of the main peak of the EIT. The demodulation of the electric field in a range of 50 Hz–1 kHz with a fidelity of 95% is achieved by modulating the low-frequency electric field to the RF electric field. The results can provide valuable references for spectral detection and traceable measurements of low-frequency electric fields.