Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)

Slow Light using Photorefractive Beam Fanning

Nacera Bouldja, Marc Sciamanna, Delphine Wolfersberger

Published Jun 1, 2019• 0 citations
Publisher

Abstract

Slow-down of the light velocity has potential applications in information processing [1] and interferometers. Recently, several works have experimentally [2] demonstrated the deceleration of light in photorefractive crystals using a two wave mixing (TWM). A low velocity value of the order of 0.02 cm/s has been reported in BaTiO3crystal for Gaussian pulse profiles of long duration of 1.3 s [3]. It was also reported that the time delay depends mainly on the coupling photorefractive gain. However, the photorefractive grating build-up time in that crystal does not allow to slow down pulses shorter than ms, which limits its interest for telecoms applications.

DOI
10.1109/cleoe-eqec.2019.8873007

Related papers

Slow light using photorefractive nonlinear optics

Nacera Bouldja, Marc Sciamanna, Delphine Wolfersberger

Slow and fast light are achieved in two experiments using SPS photorefractive crystal at room temperature. We report that the photorefractive gain achieved by the two wave mixing (TWM) method can control the group velocity of the transmitted light pulses at visible wavelength. It is shown theoretically and experimentally that the time delay and the shape of the output pulse change as a function of the photorefractive gain. The beam fanning has also been used to control the velocity propagation of a single light pulse in the same crystal at λ = 1064 nm. Depending on the orientation of the polar axis, it is possible to accelerate or decelerate a short pulse with duration of order of μs in the crystal.

SPIE Conference on Nonlinear Optics and its Applications•Apr 1, 2020•0 citations

Photorefractive induced slowdown of nanosecond light pulses in the nanosecond regime

Nacera Bouldja, A. A. Grabar, Marc Sciamanna +1 more

Recently, several works have shown that the light group velocity can be reduced using the recording of dynamic refractive index gratings in photorefractive (PR) crystals [1] , [2] , [3] . The slowdown of light is performed using optical beams wave mixing: it yields the output pulse amplification and increases the light dispersion inside the PR crystal. For example, the TWM method demonstrated that the delay time ∆ τ can be varied as a function of the TWM gain values Γ and the input pulse widths T 0 . However, several works have shown that the results achieved by this method are limited in terms of pulse duration. Indeed, only long pulses with time duration of ms−s can be slowdown in a PR crystal both at the visible and the infrared wavelengths [4] .

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 21, 2021•0 citations

Slowdown of nanosecond light pulses with photorefractive two-wave mixing

Nacera Bouldja, Михайло Володимирович Цигика, A. A. Grabar +2 more

In the demonstrations of slow light in photorefractive (PR) materials, the delays are only reported for long pulse durations (ms to s) that are in discrepancy with typical ns-pulse length in data processing applications. Here we demonstrate that the slowdown of light in a PR crystal can be also achieved in the nanosecond regime at room temperature. We experimentally show that the use of a pulsed laser with a high peak intensity may indeed reduce the ${\mathrm{Sn}}_{2}{\mathrm{P}}_{2}{\mathrm{S}}_{6}$ crystal response time to a scale of ns and achieve a two-wave mixing (TWM) gain of $7.9\phantom{\rule{4pt}{0ex}}{\text{cm}}^{\ensuremath{-}1}$. We show the slowdown of light pulses whose duration ranges from 10 to 100 ns with a fractional delay up to 0.3. These results are similar to those obtained in optical fibers, except that the slow light with PR TWM is achieved through smaller propagation lengths and at wide wavelength ranges. This could reveal potential applications of PR slow light systems and have a significant impact for future optical communications systems.

Physical Review A•Feb 3, 2022•6 citations

Slow light with photorefractive four-wave mixing

P. Mathey, Grégory Gadret, Konstantin Shcherbin

A slowing down of light pulses using backward-wave four-wave mixing is achieved in photorefractive crystals with different coupling strength. The delay and width of the output pulse are studied as a function of the input pulse width and pump intensity ratio for the amplified transmitted beam and for the phase-conjugated beam. The delay characteristics are compared with those of the two-beam coupling. It is demonstrated that the four-wave mixing process ensures a larger slowing down of short pulses (pulses with width shorter than the photorefractive response time) as compared to the photorefractive two-beam coupling scheme and guarantees the elimination of forerunners. The delay of long pulses in the four-wave mixing configuration is almost the same as the one that can be reached with two-beam coupling. The effect of absorption on the nonlinear shape transformation of the output pulses is discussed qualitatively.

Physical Review A•Dec 1, 2011•11 citations

Slow light with photorefractive beam fanning

Nacera Bouldja, Marc Sciamanna, Delphine Wolfersberger

The beam fanning naturally occurring in a photorefractive crystal is shown to slow down a single light pulse at room temperature. Slow light is demonstrated for both visible and infrared wavelength light pulses as short as the response time of the photorefractive crystal and with fractional delay- i.e ratio of delay to output pulse duration- up to 0.4.

Optics Express•Jan 30, 2020•7 citations

Zero-broadening slow light from photorefractive two-wave mixing

Nacera Bouldja, Marc Sciamanna, A. A. Grabar +1 more

The ability to delay short light pulses is a promising solution for all-optical telecommunications, but suffers from a large distortion of the delayed pulse as a consequence of the high material dispersion. In this Letter, we demonstrate the possibility to all-optically control the group delay in a photorefractive (PR) crystal by the use of the two-wave mixing (TWM) effect in the pulse regime at room temperature. Most importantly, we show that a proper choice of the pump pulse width in the TWM process enables us to slow down shorter or longer signal pulses without distortion. The technique is demonstrated both at visible (638 nm) and infrared (1064 nm) wavelengths and for slowed-down pulses with durations ranging from 10 ns up to 30 ms, hence confirming its broad applicability.

Optics Letters•Aug 28, 2023•2 citations
Slow-down of the light velocity has potential applications in information processing [1] and interferometers. Recently, several works have experimentally [2] demonstrated the deceleration of light in photorefractive crystals using a two wave mixing (TWM). A low velocity value of the order of 0.02 cm/s has been reported in BaTiO3crystal for Gaussian pulse profiles of long duration of 1.3 s [3]. It was also reported that the time delay depends mainly on the coupling photorefractive gain. However, the photorefractive grating build-up time in that crystal does not allow to slow down pulses shorter than ms, which limits its interest for telecoms applications.
Slow and fast light are achieved in two experiments using SPS photorefractive crystal at room temperature. We report that the photorefractive gain achieved by the two wave mixing (TWM) method can control the group velocity of the transmitted light pulses at visible wavelength. It is shown theoretically and experimentally that the time delay and the shape of the output pulse change as a function of the photorefractive gain. The beam fanning has also been used to control the velocity propagation of a single light pulse in the same crystal at λ = 1064 nm. Depending on the orientation of the polar axis, it is possible to accelerate or decelerate a short pulse with duration of order of μs in the crystal.
Recently, several works have shown that the light group velocity can be reduced using the recording of dynamic refractive index gratings in photorefractive (PR) crystals [1] , [2] , [3] . The slowdown of light is performed using optical beams wave mixing: it yields the output pulse amplification and increases the light dispersion inside the PR crystal. For example, the TWM method demonstrated that the delay time ∆ τ can be varied as a function of the TWM gain values Γ and the input pulse widths T 0 . However, several works have shown that the results achieved by this method are limited in terms of pulse duration. Indeed, only long pulses with time duration of ms−s can be slowdown in a PR crystal both at the visible and the infrared wavelengths [4] .
In the demonstrations of slow light in photorefractive (PR) materials, the delays are only reported for long pulse durations (ms to s) that are in discrepancy with typical ns-pulse length in data processing applications. Here we demonstrate that the slowdown of light in a PR crystal can be also achieved in the nanosecond regime at room temperature. We experimentally show that the use of a pulsed laser with a high peak intensity may indeed reduce the Sn2P2S6{\mathrm{Sn}}_{2}{\mathrm{P}}_{2}{\mathrm{S}}_{6}Sn2​P2​S6​ crystal response time to a scale of ns and achieve a two-wave mixing (TWM) gain of $7.9\phantom{\rule{4pt}{0ex}}{\text{cm}}^{\ensuremath{-}1}$. We show the slowdown of light pulses whose duration ranges from 10 to 100 ns with a fractional delay up to 0.3. These results are similar to those obtained in optical fibers, except that the slow light with PR TWM is achieved through smaller propagation lengths and at wide wavelength ranges. This could reveal potential applications of PR slow light systems and have a significant impact for future optical communications systems.
A slowing down of light pulses using backward-wave four-wave mixing is achieved in photorefractive crystals with different coupling strength. The delay and width of the output pulse are studied as a function of the input pulse width and pump intensity ratio for the amplified transmitted beam and for the phase-conjugated beam. The delay characteristics are compared with those of the two-beam coupling. It is demonstrated that the four-wave mixing process ensures a larger slowing down of short pulses (pulses with width shorter than the photorefractive response time) as compared to the photorefractive two-beam coupling scheme and guarantees the elimination of forerunners. The delay of long pulses in the four-wave mixing configuration is almost the same as the one that can be reached with two-beam coupling. The effect of absorption on the nonlinear shape transformation of the output pulses is discussed qualitatively.
The ability to delay short light pulses is a promising solution for all-optical telecommunications, but suffers from a large distortion of the delayed pulse as a consequence of the high material dispersion. In this Letter, we demonstrate the possibility to all-optically control the group delay in a photorefractive (PR) crystal by the use of the two-wave mixing (TWM) effect in the pulse regime at room temperature. Most importantly, we show that a proper choice of the pump pulse width in the TWM process enables us to slow down shorter or longer signal pulses without distortion. The technique is demonstrated both at visible (638 nm) and infrared (1064 nm) wavelengths and for slowed-down pulses with durations ranging from 10 ns up to 30 ms, hence confirming its broad applicability.