We investigate some effects related to quantum measurement process. We study a theoretical model for atomic detections in microwave cavity experiments. The model allows for the introduction of empirical imperfections in the analysis of experiments in this system. Two investigations on foundations of Quantum Zeno Effect are presented. Thefirst one consists in experimental proposals for the effect observation in a bipartite system. Empirical limitations are made explicit. In the second investigation, we show that the Quantum Zeno Effect prevails even if the measurements are not complete. Finally we present a protocol which allows for the quantum evolution control through a single auxiliary system.
We investigate some effects related to quantum measurement process. We study a theoretical model for atomic detections in microwave cavity experiments. The model allows for the introduction of empirical imperfections in the analysis of experiments in this system. Two investigations on foundations of Quantum Zeno Effect are presented. Thefirst one consists in experimental proposals for the effect observation in a bipartite system. Empirical limitations are made explicit. In the second investigation, we show that the Quantum Zeno Effect prevails even if the measurements are not complete. Finally we present a protocol which allows for the quantum evolution control through a single auxiliary system.
We propose an experiment for the observation of the quantum Zeno effect (QZE) in a bipartite system. The setup involves two microwave cavities and a ``tunneling'' photon, which is observed by the passage of Rydberg atoms. Our proposal allows for the consideration of two types of measurements, namely, sequential observations of the atomic state and its inclusive measurement. In the present system the two processes are shown to lead to the same result in the ideal case. We consider realistic atom-field interaction times, cavity dissipation, and limited detection efficiency. Analytical expressions for the ``tunneling'' probability are obtained exhibiting a competition between the environment induced exponential decay and the characteristic t2 (for short times) dependence of the QZE. We show that for sufficiently small dissipation constants the effect can be observed with current experimental facilities.
This is a theoretical thesis in the area of quantum measurement theory. Due to the extensive breadth of this field we choose to narrow our focus to examine a particular problem - the quantum Zeno effect (defined below). Quantum measurement theory is introduced in Chap. 1, using the terminology of effects and operations. This approach allows an operational definition of such terms as a state vector, an ensemble, and a measurement device (for instance), and a consideration of interactions between quantum systems and inaccurate measurement devices. We further introduce the quantum trajectories approach to consider the evolution of an individual quantum system subject to measurement. The quantum Zeno effect is introduced in Chap. 2. Any quantum treatment of a measurement interaction must consider the measurement backaction onto the measured system and this backaction will disrupt the free evolution of the system. The quantum Zeno effect occurs in the strong measurement limit where the measurement backaction totally freezes the evolution of the system, thus rendering the measurement useless. The effect is introduced via projective measurements of two level systems subject to measurement of level populations. At this stage we are able to discuss the main questions addressed by this thesis, and present its structure in Chap. 2. We then develop a new measurement model for the interaction between a system and a measurement device in Chap. 3. Our motivation in doing this is to better model the usual laboratory meter, and in our approach the meter dynamics are such that it relaxes towards an appropriate readout of the system parameter of interest. The irreducible quantum noise of the meter introduces fluctuations that drive the stochastic dynamical collapse of the system wavefunction. In our model, the measured system dynamics (if treated selectively) are described by a stochastic, nonlinear Schroedinger equation. A double well system subject to position measurement provides a natural first application for this model. This is done in Chap. 4 where we monitor the coherent tunnelling of a particle from one well to the other. The advantage afforded by considering this system is that it displays differing regimes where the measurement observable (position) is approximated as possessing either, respectively, a continuous or a discrete eigenvalue structure. Thus, we use this one model to explore the quantum Zeno effect in both measurement regimes. The above treatment is of a theoretical measurement model. In Chap. 5 we turn to consider a recent experimental test of the quantum Zeno effect which examined the dynamics of a two level atom subject to pulsed measurements of atomic level populations. We treat a slightly modified experiment in a fully continuous measurement regime. By first unravelling the optical Bloch equations, and second, using the quantum trajectories approach we demonstrate the existence of certain measurement regimes where there is a quantum Zeno effect, and other regimes where no measurement of the atomic populations is being effected at all. Through these results we demonstrate the importance of making a full analysis of the system-detector interaction before any conclusions can be made. In the remainder of the thesis we propose further possible tests of the quantum Zeno effect. In Chap. 6 the evolution of a Rydberg atom exchanging one photon with a single cavity mode subject to measurement is examined. The measurement is made by monitoring the photon number occupancy of the cavity mode using a beam of Rydberg atoms configured so as to perform phase sensitive detection. In the limit of frequent monitoring we show that the free oscillation of the atomic inversion is disrupted, and the atom is trapped close to its initial state. This is the quantum Zeno effect. In Chap. 7 we realize the Zeno effect on two possible systems. We consider first, a two level Jaynes-Cumming atom interacting with a cavity mode, and second, two electromagnetic modes configured as a multi-level parametric frequency converter. These systems interact with another cavity mode via a quadratic coupling system based on four wave mixing, and constructed to be a quantum nondemolition measurement of the photon number. This mode is damped to the environment thus effecting a measurement of the system populations. Again we show that this interaction, can manifest the quantum Zeno effect. Our explicit modelling of the system-detector interaction enables us to show how the effect depends on the resolution time of the detector. Finally, we consider a proposed measurement of the square of the quadrature phase of an electromagnetic mode in Chap. 8. Here, a three mode interaction mediated by a second order nonlinear susceptibility is considered. One mode, the pump, is prepared in a feedback generated photon number state to give insight into the role of pump noise. The other two modes are treated as an angular momentum system, and we show that photon counting on the two mode rotation system effects the above mentioned measurement. In addition, this measurement provides a direct measure of the second order squeezing of the signal. With that we finish our investigation of the quantum Zeno effect using the techniques of quantum measurement theory. However, in the epilogue [Chap. 9] we note that no thesis in quantum measurement theory would be complete without some consideration of the ``meaning attributed to the theory. In the epilogue we take a novel historical approach and examine the method by which metaphysical theories are formed to draw conclusions regarding quantum metaphysics.
The quantum Zeno effect is the inhibition of the free evolution of a system when that system is subject to a measurement process. The authors of one recent experiment study, W. M. Itano et al., [Phys. Rev. A 41, 2295 (1990)] claimed a demonstration of the quantum Zeno effect. This was done by performing discontinuous atomic-level measurements on a coherently evolving two-level atomic stystem. The measurement was implemented using a pulsed laser strong enough to saturate the two-level atomic system. In this paper, we examine the simpler case where the measurement laser is continuously on and does not saturate the two-level atomic system. In contrast to previous treatments, we show certain parameter regimes wherein an effective state reduction does occur. We ascertain the experimental parameter regimes under which a measurement can be said to have been performed. We show that, in some regimes, fully efficient photon detection does not give good information about the atomic-level populations and hence no measurement has been performed. Throughout, we emphasize that the design of an atomic level-measurement device requires more than the analysis of a mechanism for photon detection or of coherence loss. We gain insight into the operation of a particular measurement process by following the selective evolution of various systems using the quantum-trajectories approach.
The quantum Zeno effect consists in the hindrance of the evolution of a quantum system that is very frequently monitored and found to be in its initial state at every single measurement. On the basis of the correct formula for the survival probability, i.e. the probability of finding the system in its initial state at every single measurement, we critically analyze a recent proposal and experimental test, that make use of an oscillating system. PACS: 03.65.Bz, 42.50.-p 1 The seminal formulation of the quantum Zeno effect, due to Misra and Sudarshan [1], deals with the probability of observing an unstable system in its initial state throughout a time interval ∆ = [0, t]. The purpose of this note is to point out that the quantum Zeno effect has not been experimentally observed, yet, in its original formulation. Indeed, we shall argue that the interesting proposal by Cook [2], that makes use of a two-level system undergoing Rabi oscillations, as well as the beautiful experiment performed by Itano et al. [3], investigate the probability of finding the
We present a scheme for experimentally observing the quantum Zeno effect using the quantum-nondemolition measurement recently proposed by Brune et al. [Phys. Rev. Lett. 65, 976 (1990)]. The Zeno effect refers to the freezing of the (unitary) free dynamics of a system by rapid measurements. We generalize the Zeno effect to be any change in the survival probability of an initial state induced by very rapid measurements, when such measurements are the dominant source of fluctuations in the system. We derive a master equation for the evolution of a cavity mode when the photon number is monitored by this method. This equation describes a phase-diffusion process. We propose that this measurement scheme be used to monitor the exchange of a single photon between the cavity and a single Rydberg atom. We show that for very rapid monitoring the free oscillation of the atomic inversion is disrupted and the atom can be trapped close to the initial excited state. This is the quantum Zeno effect.
A simple model of indirect pre-measurements on an unstable quantum state is presented in this paper. The model is completely solvable and the solutions are used to compare the time evolution of the unstable state with and without the influence of the pre-measurement. We find that by choosing the details of the process of pre-measurement appropriately, it is possible to observe both suppression and enhancement of the rate of decay of the unstable state. When the pre-measurements are assumed to lead on to actual measurements, we see that the quantum Zeno effect, and in some instances the 'anti-Zeno' effect, can be produced by repeating the measurement many times in succession. The Zeno effect can appear in our model either as a real consequence of repeated measurements or sometimes merely as an artefact of the manner in which the observations on the system are performed. The anti-Zeno effect appears almost exclusively as an artefact of the details of the measurement. Numerical investigations are included to delineate the regimes in which the quantum Zeno effect and possibly the anti-Zeno effect can occur.