This paper proposes a novel iterative decoder based on concatenated belief propagation (BP) for CRC-aided polar codes. Compared to the conventional BP-based decoders for polar codes, soft cancellation (SCAN) decoder can generate a log likelihood ratio (LLR) of coded bit with lower computational complexity without sacrificing the detection capability. Unfortunately, its performance is not as good as that of CRC-aided successive cancellation list decoder (SCLD) although SCAN decoder has advantage of hardware implementation. To compensate the performance gap, we exploit CRC structure for not only error detection but also error correction with the assistance of its error correction capability at a short code length by exchanging LLRs between SCAN decoder and BP decoder on the basis of CRC. Moreover, the sub-optimal criterion for selecting a parity check matrix of CRC for BP decoder is proposed. Finally, computer simulations are conducted to confirm the validity of our proposed method. The proposed method can obtain the gain of about 0.6 dB at BER=10-3compared to the native SCAN decoder without requiring huge memory size as in SCLD.
This paper proposes a novel iterative decoder based on concatenated belief propagation (BP) for CRC-aided polar codes. Compared to the conventional BP-based decoders for polar codes, soft cancellation (SCAN) decoder can generate a log likelihood ratio (LLR) of coded bit with lower computational complexity without sacrificing the detection capability. Unfortunately, its performance is not as good as that of CRC-aided successive cancellation list decoder (SCLD) although SCAN decoder has advantage of hardware implementation. To compensate the performance gap, we exploit CRC structure for not only error detection but also error correction with the assistance of its error correction capability at a short code length by exchanging LLRs between SCAN decoder and BP decoder on the basis of CRC. Moreover, the sub-optimal criterion for selecting a parity check matrix of CRC for BP decoder is proposed. Finally, computer simulations are conducted to confirm the validity of our proposed method. The proposed method can obtain the gain of about 0.6 dB at BER=10-3compared to the native SCAN decoder without requiring huge memory size as in SCLD.
Belief propagation (BP) is an iterative and parallel decoding algorithm for polar code that satisfies high throughput and low latency requirements in 5G scenarios. In this work, we proposed a cyclic redundancy check aided belief propagation decoding with the box and match algorithm (CBP-BMA) to enhance the error-correction performance further. This algorithm first runs the BP decoder with early stopping criteria and then uses the soft decoded BP log-likelihood ratio (LLR) as the soft input to the box and match algorithm (BMA) decoder. The simulation results show that even if the reprocessing order of the BMA decoder is as low as one, the proposed algorithm shows a significant improvement than BP decoding. With code rate R=0.5 and code length N=128, the suggested algorithm has a gain of roughly 0.3dB at the desired bit error rate (BER) of 10–3.
Although iterative decoding of polar codes has recently made huge progress based on the idea of permuted factor graphs, it still suffers from a non-negligible performance degradation when compared to state-of-the-art CRC-aided successive cancellation list (CA-SCL) decoding. In this work, we show that iterative decoding of polar codes based on the belief propagation list (BPL) algorithm can approach the error-rate performance of CA-SCL decoding and, thus, can be efficiently used for decoding the standardized 5G polar codes. Rather than only utilizing the cyclic redundancy check (CRC) as a stopping condition (i.e., for error-detection), we also aim to benefit from the error-correction capabilities of the outer CRC code. For this, we develop two distinct soft-decision CRC decoding algorithms: a Bahl-Cocke-Jelinek-Raviv (BCJR)-based approach and a sum product algorithm (SPA)-based approach. Further, an optimized selection of permuted factor graphs is analyzed and shown to reduce the decoding complexity significantly. Finally, we benchmark the proposed CRC-aided belief propagation list (CA-BPL) decoding to state-of-the-art 5G polar codes under CA-SCL decoding and, thereby, showcase an error-rate performance not just close to the CA-SCL but also close to the maximum likelihood (ML) bound as estimated by ordered statistic decoding (OSD).
Due to the design principle of parallel processing, belief propagation (BP) decoding is attractive, and it provides good error-correction performance compared with successive cancellation (SC) decoding. However, its error-correction performance is still inferior to that of successive cancellation list (SCL) decoding. Consequently, this paper proposes a novel flip-list- (FL)-enabled belief propagation (BP) method to improve the error-correction performance of BP decoding for polar codes with low computational complexity. The proposed technique identifies the vulnerable channel log-likelihood ratio (LLR) that deteriorates the BP decoding result. The FL is utilized to efficiently identify the erroneous channel LLRs and correct them for the next BP decoding attempt. The preprocessed channel LLR through FL improves the error-correction performance with minimal flipping attempts and reduces the computational complexity. The proposed technique was compared with the state-of-the-art BP, i.e., BP bit-flip (BP-BF), generalized BP-flip (GBPF), cyclic redundancy check (CRC)-aided (CA-SCL) decoding, and ordered statistic decoding (OSD), algorithms. Simulation results showed that the FL-BP had an excellent block error rate (BLER) performance gain up to 0.7 dB compared with BP, BP-BF, and GBPF decoder. Besides, the computational complexity was reduced considerably in the high signal-to-noise ratio (SNR) regime compared with the BP-BF and GBPF decoding methods.
Polar codes are the first class of error correcting codes that provably achieve the channel capacity at infinite code length. They were selected for use in the fifth generation of cellular mobile communications (5G). In practical scenarios such as 5G, a cyclic redundancy check (CRC) is concatenated with polar codes to improve their finite length performance. This is mostly beneficial for sequential successive-cancellation list decoders. However, for parallel iterative belief propagation (BP) decoders, CRC is only used as an early stopping criterion with incremental error-correction performance improvement. In this paper, we first propose a CRC-polar BP (CPBP) decoder by exchanging the extrinsic information between the factor graph of the polar code and that of the CRC. We then propose a neural CPBP (NCPBP) algorithm which improves the CPBP decoder by introducing trainable normalizing weights on the concatenated factor graph. Our results on a 5G polar code of length 128 show that at the frame error rate of 10-5and with a maximum of 30 iterations, the error-correction performance of CPBP and NCPBP are approximately 0.25 dB and 0.5 dB better than that of the conventional CRC-aided BP decoder, respectively, while introducing almost no latency overhead.
We show that the performance of iterative belief propagation (BP) decoding of polar codes can be enhanced by decoding over different carefully chosen factor graph realizations. With a genie-aided stopping condition, it can achieve the successive cancellation list (SCL) decoding performance which has already been shown to achieve the maximum likelihood (ML) bound provided that the list size is sufficiently large. The proposed decoder is based on different realizations of the polar code factor graph with randomly permuted stages during decoding. Additionally, a different way of visualizing the polar code factor graph is presented, facilitating the analysis of the underlying factor graph and the comparison of different graph permutations. In our proposed decoder, a high rate Cyclic Redundancy Check (CRC) code is concatenated with a polar code and used as an iteration stopping criterion (i.e., genie) to even outperform the SCL decoder of the plain polar code (without the CRC-aid). Although our permuted factor graph-based decoder does not outperform the SCL-CRC decoder, it achieves, to the best of our knowledge, the best performance of all iterative polar decoders presented thus far.
This paper presents deep learning (DL) methods to optimize polar belief propagation (BP) decoding and concatenated LDPC-polar codes. First, two-dimensional offset Min-Sum (2-D OMS) decoding is proposed to improve the error-correction performance of existing normalized Min-Sum (NMS) decoding. Two optimization methods used in DL, namely back-propagation and stochastic gradient descent, are exploited to derive the parameters of proposed algorithms. Numerical results demonstrate that there is no performance gap between 2-D OMS and exact BP on various code lengths. Then the concatenated OMS algorithms with low complexity are presented for concatenated LDPC-polar codes. As a result, the optimized concatenated OMS decoding yields error-correction performance with CRC-aided successive cancellation list (CA-SCL) decoder of list size 2 on length-1024 polar codes. In addition, the efficient hardware architectures of scalable polar OMS decoder are described and the proposed decoder is reconfigurable to support three code lengths (N = 256, 512, 1024) and two decoding algorithms (2-D OMS and concatenated OMS). The polar OMS decoder implemented on 65 nm CMOS technology achieves a maximum coded throughput of 5.4 Gb/s at Eb/N0= 4 dB for code length 1024 and 7.5 Gb/s at Eb/N0= 3.5 dB for code length 256, which are comparable to the state-of-the-art polar BP decoders. Moreover, a 5.1 Gb/s throughput at Eb/N0= 4 dB is achieved under concatenated OMS decoding mode for code length 1024 with a latency of 200 ns, which is superior to existing CA-SCL decoders that have similar error-correction performance.