Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Measuring and quantifying classical crosstalk in multi-qubit superconducting circuits

Petar Jurcevic, Abhinav Kandala, Antonio D. Corcoles, Easwar Magesan, Jerry M. Chow, Jay Gambetta

Published Mar 4, 2019• 0 citations
OpenAlex

Related papers

Fast and accurate flux-crosstalk characterization in superconducting-qubit circuits

Xiaoyan Yang, Peng Wang, Ran Guo +12 more

Physical Review Applied•Jan 21, 2026•0 citations

Suppression of Qubit Crosstalk in a Tunable Coupling Superconducting Circuit Device

Pranav Mundada, Gengyan Zhang, Andrew Houck

Bulletin of the American Physical Society•Mar 7, 2018•0 citations

Protected qubits, Floquet engineering and crosstalk suppression with superconducting circuits

Pranav Mundada

•Jan 1, 2021•0 citations

Characterizing and mitigating flux crosstalk in superconducting qubits–couplers system

Myrron Albert Callera Aguila, N. Li, Chen-Hsun Ma +12 more

Superconducting qubits have achieved exceptional gate fidelities, exceeding the error-correction threshold in recent years. One key ingredient of such improvement is the introduction of tunable couplers to control the qubit-to-qubit coupling through frequency tuning. Moving toward fault-tolerant quantum computation, increasing the number of physical qubits is another step toward effective error correction codes. Under a multiqubit architecture, flux control (Z) lines are crucial in tuning the frequency of the qubits and couplers. However, dense flux lines result in magnetic flux crosstalk, wherein magnetic flux applied to one element inadvertently affects neighboring qubits or couplers. This crosstalk obscures the idle frequency of the qubit when flux bias is applied, which degrades gate performance and calibration accuracy. In this study, we characterize flux crosstalk and suppress it in a multiqubit-coupler chip with multi-Z lines without adding additional readout for couplers. By quantifying the mutual flux-induced frequency shifts of qubits and couplers, we construct a cancellation matrix that enables precise compensation of non-local flux, demonstrating a substantial reduction in Z-line crosstalk from 56.5‰ to 0.13‰, which is close to statistical error. Flux compensation corrects the CZ SWAP measurement, leading to a symmetric map with respect to flux bias. Compared with a crosstalk-free calculated CZ SWAP map, the measured map indicates that our approach provides a near-zero crosstalk for the coupler-transmon system. These results highlight the effectiveness of our approach in enhancing flux crosstalk-free control and supporting its potential for scaling superconducting quantum processors.

APL Quantum•Feb 18, 2026•2 citations

Crosstalk in superconducting quantum circuits

Christian Kraglund Andersen, Yves Salathé, Johannes Heinsoo +4 more

Bulletin of the American Physical Society•Mar 13, 2017•0 citations

Multi-mode coaxial transmon qubits for quantum computing and sensing

Wills, James Fox

Superconducting circuits are well established as a viable candidate for the realisation of quantum computers. Circuits based on the transmon qubit are now ubiquitous, owing to its simple design and reduced control wiring overhead. An issue with transmon qubit-based architectures is the always-on unwanted interactions that impose limits on gate speeds and introduce errors into their operation. In addition, understanding sources of noise and decoherence is essential to the low-error operation quantum computers. This thesis describes the implementation of a multi-mode superconducting qubit in a coaxial circuit QED architecture. Constructed from three superconducting islands, connected via two Josephson junctions, the device possesses two transmon-like modes with orthogonal field symmetries. The unique polarisation of each mode allows for engineering dissipation and coupling in the system, extending functionality beyond the single-mode transmon. Experimental results on the unit-cell of the two-mode coaxial transmon are presented, demonstrating coherent control and simultaneous dispersive readout of the modes of the device. A predictive theory of charge sensitivity in a multi-mode superconducting qubit is presented, and experimental results in agreement of this theory are shown, observing sensitivity to four charge-parity configurations and two independent gate-charge offsets. The utility of a multi-mode qubit as a charge detector in spatially tracking local-charge drift of ≃ 100 µm length scales is also shown, demonstrating the use of these devices as tools in understanding charge noise in superconducting circuits. Finally, a system of a pair of coupled two-mode coaxial transmons is introduced, demonstrating a highly mode-selective coupling architecture. A suppressed quantum crosstalk of 2 kHz between protected modes of the devices is measured, along with equal single qubit gate fidelities when operated both individually and simultaneously. A first characterisation of a microwave activated conditional phase interaction between computational modes driven via ancillary transitions (AT-MAP) is presented. Whilst not shown in this work, this state-dependent two-qubit interaction can be used to generate entanglement. Combined with the low crosstalk demonstrated, this shows the multi-mode qubit architecture is a promising candidate for the construction of larger scale quantum processors with fast gates and low crosstalk-related errors.

•Jan 1, 2022•0 citations
Superconducting qubits have achieved exceptional gate fidelities, exceeding the error-correction threshold in recent years. One key ingredient of such improvement is the introduction of tunable couplers to control the qubit-to-qubit coupling through frequency tuning. Moving toward fault-tolerant quantum computation, increasing the number of physical qubits is another step toward effective error correction codes. Under a multiqubit architecture, flux control (Z) lines are crucial in tuning the frequency of the qubits and couplers. However, dense flux lines result in magnetic flux crosstalk, wherein magnetic flux applied to one element inadvertently affects neighboring qubits or couplers. This crosstalk obscures the idle frequency of the qubit when flux bias is applied, which degrades gate performance and calibration accuracy. In this study, we characterize flux crosstalk and suppress it in a multiqubit-coupler chip with multi-Z lines without adding additional readout for couplers. By quantifying the mutual flux-induced frequency shifts of qubits and couplers, we construct a cancellation matrix that enables precise compensation of non-local flux, demonstrating a substantial reduction in Z-line crosstalk from 56.5‰ to 0.13‰, which is close to statistical error. Flux compensation corrects the CZ SWAP measurement, leading to a symmetric map with respect to flux bias. Compared with a crosstalk-free calculated CZ SWAP map, the measured map indicates that our approach provides a near-zero crosstalk for the coupler-transmon system. These results highlight the effectiveness of our approach in enhancing flux crosstalk-free control and supporting its potential for scaling superconducting quantum processors.
Superconducting circuits are well established as a viable candidate for the realisation of quantum computers. Circuits based on the transmon qubit are now ubiquitous, owing to its simple design and reduced control wiring overhead. An issue with transmon qubit-based architectures is the always-on unwanted interactions that impose limits on gate speeds and introduce errors into their operation. In addition, understanding sources of noise and decoherence is essential to the low-error operation quantum computers. This thesis describes the implementation of a multi-mode superconducting qubit in a coaxial circuit QED architecture. Constructed from three superconducting islands, connected via two Josephson junctions, the device possesses two transmon-like modes with orthogonal field symmetries. The unique polarisation of each mode allows for engineering dissipation and coupling in the system, extending functionality beyond the single-mode transmon. Experimental results on the unit-cell of the two-mode coaxial transmon are presented, demonstrating coherent control and simultaneous dispersive readout of the modes of the device. A predictive theory of charge sensitivity in a multi-mode superconducting qubit is presented, and experimental results in agreement of this theory are shown, observing sensitivity to four charge-parity configurations and two independent gate-charge offsets. The utility of a multi-mode qubit as a charge detector in spatially tracking local-charge drift of ≃ 100 µm length scales is also shown, demonstrating the use of these devices as tools in understanding charge noise in superconducting circuits. Finally, a system of a pair of coupled two-mode coaxial transmons is introduced, demonstrating a highly mode-selective coupling architecture. A suppressed quantum crosstalk of 2 kHz between protected modes of the devices is measured, along with equal single qubit gate fidelities when operated both individually and simultaneously. A first characterisation of a microwave activated conditional phase interaction between computational modes driven via ancillary transitions (AT-MAP) is presented. Whilst not shown in this work, this state-dependent two-qubit interaction can be used to generate entanglement. Combined with the low crosstalk demonstrated, this shows the multi-mode qubit architecture is a promising candidate for the construction of larger scale quantum processors with fast gates and low crosstalk-related errors.