Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Theoretical model for a laser-pumped atomic K optical filter

Yun Chur Chung, T. M. Shay

Published Jan 1, 1987• 0 citations
OpenAlex

Related papers

Calculation of optical pumping in an atomic beam

A. Besedina, Gennadij I. Khvostenko, М. П. Чайка

Optics and Spectroscopy•May 1, 1978•0 citations

Theoretical model for a background noise limited laser-excited optical filter for doubled Nd lasers

Thomas M. Shay, Daniel Fernando Garcia

A simple theoretical model for the calculation of the dependence of filter quantum efficiency versus laser pump power in an atomic Rb vapor laser-excited optical filter is reported. Calculations for Rb filter transitions that can be used to detect the practical and important frequency-doubled Nd lasers are presented. The results of these calculations show the filter's quantum efficiency versus the laser pump power. The required laser pump powers required range from 2.4 to 60 mW/cm/sup 2/ of filter aperture.>

IEEE Journal of Quantum Electronics•Jun 1, 1990•8 citations

Theoretical model of an atomic line filter based on the combination of a double selective pump

Zhenyu Zhu, Hanyang Li, Weimin Sun +1 more

We present a model of an atomic filter based on laser-induced optical anisotropy that is achieved by the combination of a double selective pump. Most of these kinds of atomic optical filters reported previously adopt only one pump to make the atoms populate on particular sublevels. In this paper, another pump is added to the filter system to make sure all the atoms are in the pump–probe cycle. The feasibility of the re-pump is analyzed by employing the rate equation, and the contribution of the re-pump to the filter is discussed under various conditions. Simulation results show that the re-pump can not only enhance the transmission of the filter, but also vary the transmission spectrum peak wavelength.

Applied Optics•Dec 21, 2016•2 citations

A model for an atom laser

Yvan Castin, Maxim Olshanii, Jean Dalibard

•Jan 1, 1996•0 citations

Ultrahigh-Resolution, Wide-Field-Of-View Rb Optical Filter For The Detection Of Frequency-Doubled Nd Lasers

Thomas M. Shay

We report a simple theoretical model for the calculation of the dependence of filter quantum efficiency versus laser pump power in an atomic Rb vapor laser-excited optical filter. We present the calculations for a Rb filter transitions that can be used to detect the practial and important frequency-doubled Nd lasers. The results of these calculations show the filter's quantum efficiency versus the laser pump power. The laser pump powers required range from 2.4 to 60 mW per square centimeter of filter aperture.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 25, 1989•0 citations

A Model of a Pumped Continuous Atom Laser

Nicholas P. Robins, Craig M. Savage, Elena A. Ostrovskaya

arXiv:cond-mat/0004127•Springer eBooks•Nov 16, 2007•0 citations
A simple theoretical model for the calculation of the dependence of filter quantum efficiency versus laser pump power in an atomic Rb vapor laser-excited optical filter is reported. Calculations for Rb filter transitions that can be used to detect the practical and important frequency-doubled Nd lasers are presented. The results of these calculations show the filter's quantum efficiency versus the laser pump power. The required laser pump powers required range from 2.4 to 60 mW/cm/sup 2/ of filter aperture.>
We present a model of an atomic filter based on laser-induced optical anisotropy that is achieved by the combination of a double selective pump. Most of these kinds of atomic optical filters reported previously adopt only one pump to make the atoms populate on particular sublevels. In this paper, another pump is added to the filter system to make sure all the atoms are in the pump–probe cycle. The feasibility of the re-pump is analyzed by employing the rate equation, and the contribution of the re-pump to the filter is discussed under various conditions. Simulation results show that the re-pump can not only enhance the transmission of the filter, but also vary the transmission spectrum peak wavelength.
We report a simple theoretical model for the calculation of the dependence of filter quantum efficiency versus laser pump power in an atomic Rb vapor laser-excited optical filter. We present the calculations for a Rb filter transitions that can be used to detect the practial and important frequency-doubled Nd lasers. The results of these calculations show the filter's quantum efficiency versus the laser pump power. The laser pump powers required range from 2.4 to 60 mW per square centimeter of filter aperture.