Optics Letters

Photodetection system immune to amplitude-to-phase conversion noise for ultralow noise photonic microwave generation

Lingke Wang, Junchao Huang, Yifei Duan, Liang Liu, Tang Li

Published Oct 12, 2018• 4 citations

Abstract

Microwave signals generated by photodetection of the pulse train of an optical frequency comb locked to an ultrastable laser have ultrahigh spectral purity and frequency stability. The amplitude-to-phase noise conversion (APC) that occurs in the photodetection, however, degrades the phase noise of the generated microwave signal over the range from tens of hertz to several kilohertz. Here we demonstrate active APC compensation by precisely tuning the bias voltage applied to a photodetector using the APC coefficient measured by comparing with a reference photodetector. In this scheme, the APC was dramatically reduced and a long-term steady rejection of the laser relative intensity noise of more than 60 dB was achieved.

DOI: 10.1364/ol.43.005122

Related papers

Stabilization improvement of the squeezed optical fields using a high signal-to-noise ratio bootstrap photodetector

Xiaoli Wang, Liang Wu, Shaocong Liang +6 more

High-precision cavity locking is crucial for squeezing optical fields. Here, a bootstrapped low-noise photodetector is utilized in the generation process of the squeezed state of light. This process is based on a combination of a modified trans-impedance amplifier (TIA) circuit and a two-stage bootstrap amplifier circuit. This not only achieves high-precision and long-term stable locking of the optical cavity, but it also improves the degree to which the light field is squeezed. The experiment results show that the detector has a high signal-to-noise ratio (SNR) of 26.7 dB at the analysis frequency of 3 MHz when measuring the shot noise with an injection optical power of 800 µW, and the equivalent optical power noise level is lower than 2.4 pW/Hz in the frequency range of 1-30 MHz. Moreover, the squeezing degree of the quadrature amplitude squeezed state light field can be improved by more than 34.9% when the detector is used for optical cavity locking. The photodetector is useful in continuous variable (CV) quantum information research.

Optics ExpressDec 5, 20225 citations

Frequency combs at the quantum limit

Roman Schmeissner

Precision metrology is one application of optical frequency combs. Classical noise in their properties typically limits achievable measurement sensitivity. Amplitude and phase noise in optical frequency combs have already been studied extensively. So far, noise sidebands close to the carrier of either individual optical frequencies or of the mean field have been considered. This thesis develops methods to precisely characterize amplitude and phase noise down to the quantum limit. To this aim a transmissive, broadband passive cavity is developed. It filters and inter-converts amplitude and phase noise. The analysis of its signal by the use of homodyne detection provides a quantum limited measurement of phase noise. The application of ultrafast pulse shaping enables the measurement of the spectral correlations of amplitude and phase noise. Being represented by the use of covariance matrices, the entire noise correlations over the optical spectrum are characterized on the example of a Ti:Sapph oscillator. The measured noise correlations exhibit spectral structures, so-called modes. Their shape matches with the theoretical prediction. This concept known from multi-partite optical quantum systems is consequently applicable to classical noise in frequency combs. The knowledge of the intrinsic noise modes is likely provide an improvement of precision metrology experiments with combs.

Jun 13, 20140 citations

Experimental Implementation of a Fiber Noise Cancellation System for Slow Light Laser Locking

Alexander Bengtsson

An electromagnetic wave propagating through an optical fiber is sensitive to external disturbances, such as mechanical vibrations and temperature and pressure fluctuations, which add phase noise onto the wave. For high-precision frequency-based applications this phase noise has to be removed. By partially reflecting light from the remote end of the fiber back through the fiber, and comparing it to light that has not passed through the fiber, their beat note can be phase locked to a stable reference, using an acousto-optic modulator for phase noise compensation. This effectively cancels the phase noise at the remote end of the fiber. In this project, two such fiber noise cancellation systems have been successfully assembled. The fiber noise cancellation systems will be used for laser locking to a slow light crystal cavity. Using spectral hole burning, a very low group velocity can be obtained in rare-earth-ion-doped crystals. By depositing mirrors on such a crystal, it could act as a reference cavity with a very long effective length, but without the increased difficulty of isolating the cavity from mechanical vibrations associated with a physically long cavity. By locking a laser to a slow light crystal cavity, an improved stability could potentially be achieved. A possible setup for slow light crystal cavity laser locking experiments, where the fiber noise cancellation systems have been integrated, is also presented in this thesis.

Jan 1, 20170 citations

Cryogenic and Room Temperature Microwave Generation with High-Speed Photodetection of Ultrashort Optical Pulse Trains

Franklyn Quinlan

The photodetection of ultrashort optical pulse trains has applications in RF and microwave photonics systems that wish to take advantage of the exceptional frequency and timing precision available from optical sources. Room temperature applications include low phase noise microwave generation and sources for very long baseline interferometry, whereas cryogenic applications include driving quantum-based voltage standards and the drive and readout of superconducting qubits. Both room temperature and cryogenic applications of short pulse detection are reviewed.

International Topical Meeting on Microwave PhotonicsOct 14, 20250 citations

Phase noise in photonic communications systems using linear amplifiers

J. P. Gordon, L. F. Mollenauer

Spontaneous emission noise limits the capacity and range of photonic communications systems that use linear optical amplifiers. We consider here the question of phase detection in such systems. Amplitude-to-phase-noise conversion occurs owing to the nonlinear Kerr effect in the transmission fiber, resulting in optimal phase noise performance when the nonlinear phase shift of the system is approximately 1 rad. Error-free state-of-the-art systems that use phase detection at multigigabit rates are thereby limited to a range of a few thousand kilometers.

Optics LettersDec 1, 1990660 citations

Laser-Frequency Stabilization Based on Steady-State Spectral-Hole Burning in Eu3+∶Y2SiO5

Shon Cook, Till Rosenband, David R. Leibrandt

We present and analyze a method of laser-frequency stabilization via steady-state patterns of spectral holes in Eu(3+)∶Y(2)SiO(5). Three regions of spectral holes are created, spaced in frequency by the ground-state hyperfine splittings of (151)Eu(3+). The absorption pattern is shown not to degrade after days of laser-frequency stabilization. An optical frequency comparison of a laser locked to such a steady-state spectral-hole pattern with an independent cavity-stabilized laser and a Yb optical lattice clock demonstrates a spectral-hole fractional frequency instability of 1.0×10(-15)τ(-1/2) that averages to 8.5(-1.8)(+4.8)×10(-17) at τ=73 s. Residual amplitude modulation at the frequency of the rf drive applied to the fiber-coupled electro-optic modulator is reduced to less than 1×10(-6) fractional amplitude modulation at τ>1 s by an active servo. The contribution of residual amplitude modulation to the laser-frequency instability is further reduced by digital division of the transmission and incident photodetector signals to less than 1×10(-16) at τ>1 s.

arXiv:1504.02390Physical Review LettersJun 23, 201560 citations