Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

SPIE Quantum Technologies

Quantum optical state comparison amplification of coherent states

Ross J. Donaldson, Luca Mazzarella, Robert John Collins, Ugo Zanforlin, John Jeffers, Gerald S. Buller

Published May 29, 2018• 0 citations
Publisher

Abstract

As light propagates through a transmission media, such as an optical fiber, it experiences a length-dependent loss which can reduce the communication efficiency as the transmission distance increases. In conventional telecommunications, optical signals can be transmitted over inter-continental distances, due to deterministic all-optical amplifiers. However, quantum communications are still limited to transmission distances of typically a few 100’s km since deterministic amplifiers cannot be used to amplify quantum signals. The use of deterministic amplification on a quantum signal will introduce noise that will mask the original quantum properties of the signal, introducing uncertainty or errors to any measurement. Nondeterministic methods for amplifying quantum signals via post-selection can be used instead, providing a solution to create a low noise quantum amplifier. Several methods for nondeterministic amplification have already been experimentally demonstrated. However, these devices rely on “quantum resources” which makes implementation challenging. Here we present an overview of experimental demonstrations for amplifying coherent states using a method called state comparison amplification. This is a nondeterministic protocol that performs amplification of known sets of phase-encoded coherent states using two modular stages. The outcome of each stage is recorded using single-photon detectors and time-stamped electronics to enable post-selection. State comparison amplification is a relatively simple technique, only requiring “off-the-shelf” components. The presentation will show several demonstrations of state comparison amplification including an amplifier which has high gain, fidelity, and success rate with the added advantage of being robust to channel noise and easily reconfigurable. Finally, we will discuss the effect of introducing a feedforward mechanism allowing for unsuccessful state amplifications.

DOI
10.1117/12.2307820

Related papers

A high-gain and high-fidelity coherent state comparison amplifier

Ross J. Donaldson, Luca Mazzarella, Robert John Collins +2 more

Abstract Optical signals are subject to a distance-dependent loss as they propagate through transmission media. High-intensity, classical, optical signals can routinely be amplified to overcome the degradation caused by this loss. However, quantum optical states cannot be deterministically amplified and any attempt to do so will introduce intrinsic noise that spoils the desired quantum properties. Non-deterministic optical amplification, based on post-selection of the output depending on certain conditioning detection outcomes, is an emerging enabling technology in quantum measurement and quantum communications. Here we present an investigation into the properties of a simple, modular optical state comparison amplifier operating on weak coherent states. This amplifier requires no complex quantum resources and is based on linear optical components allowing for a high amplification rate at high gain and fidelity. We examine the amplifier’s performance in different configurations and develop an accurate analytical model that accounts for typical experimental scenarios.

Communications Physics•Sep 6, 2018•16 citations

Experimental Implementation of a Quantum Optical State Comparison Amplifier

Ross J. Donaldson, Robert John Collins, Electra Eleftheriadou +3 more

We present an experimental demonstration of a practical nondeterministic quantum optical amplification scheme that employs two mature technologies, state comparison and photon subtraction, to achieve amplification of known sets of coherent states with high fidelity. The amplifier uses coherent states as a resource rather than single photons, which allows for a relatively simple light source, such as a diode laser, providing an increased rate of amplification. The amplifier is not restricted to low amplitude states. With respect to the two key parameters, fidelity and the amplified state production rate, we demonstrate significant improvements over previous experimental implementations, without the requirement of complex photonic components. Such a system may form the basis of trusted quantum repeaters in nonentanglement-based quantum communications systems with known phase alphabets, such as quantum key distribution or quantum digital signatures.

arXiv:1404.4277•Physical Review Letters•Mar 26, 2015•33 citations

Quantum Optical State Comparison Amplifier

Electra Eleftheriadou, Stephen Mark Barnett, John Jeffers

It is a fundamental principle of quantum theory that an unknown state cannot be copied or, as a consequence, an unknown optical signal cannot be amplified deterministically and perfectly. Here we describe a protocol that provides nondeterministic quantum optical amplification in the coherent state basis with high gain and high fidelity and which does not use quantum resources. The scheme is based on two mature quantum optical technologies: coherent state comparison and photon subtraction. The method compares favorably with all previous nondeterministic amplifiers in terms of fidelity and success probability.

arXiv:1311.5730•Physical Review Letters•Nov 19, 2013•28 citations

Feedforward-assisted coherent-state comparison amplifier

M. Bathaee, N. Marjan, Alireza Bahrampour

Quantum optical coherent-state comparison amplifiers are nondeterministic devices which can amplify rather noiselessly a weak coherent state with an unknown phase from a finite discrete set. The high fidelity and high success probability of this amplifier are accomplished by a comparison stage and some photon subtraction stages. Due to the heralding nature of these amplifiers, they work part of the time. Here, we propose a feedforward protocol to increase the heralded times by correcting the incorrect guess. Hence, we enhance the fidelity and success probability more. Finally, the schematic experimental configuration of the feedforward-assisted coherent-state comparison amplifier is proposed.

Physical Review A•Oct 8, 2019•1 citation

On-chip implementation of the probabilistic quantum optical state comparison amplifier

David W. Canning, Ross J. Donaldson, Sebabrata Mukherjee +6 more

Propagation losses in transmission media limit the transmission distance of optical signals. In the case where the signal is made up of quantum optical states, conventional deterministic optical amplification schemes cannot be used to increase the transmission distance as the copying of an arbitrary and unknown quantum state is forbidden. One strategy that can offset propagation loss is the use of probabilistic, or non-deterministic, amplification schemes - an example of which is the state comparison amplifier. Here we report a state comparison amplifier implemented in a compact, fiber-coupled femtosecond laser-written waveguide chip as opposed to the large, bulk-optical components of previous designs. This pathfinder on-chip implementation of the quantum amplifier has resulted in several performance improvements: the polarization integrity of the written waveguides has resulted in improved visibility of the amplifier interferometers; the potential of substantially-reduced losses throughout the amplifier configuration; and a more compact and environmentally-stable amplifier which is scalable to more complex networks.

Optics Express•Oct 17, 2019•12 citations

Quantum state correction using a measurement-based feedforward mechanism

Ross J. Donaldson, Luca Mazzarella, Ugo Zanforlin +3 more

One of the weaknesses of quantum optical state postselection schemes is the low success probability. Typically there is a trade-off between amplifier properties such as success probability and output state fidelity. However, here we present a state comparison amplifier for optical coherent states, which features an active measurement and feedforward mechanism to correct for errors made during the initial amplification. The simple and relatively low latency mechanism allows us to correct for a binary phase alphabet. We demonstrate a significant simultaneous improvement in the amplifier characteristic parameters: output state fidelity, correct state fraction, and success probability. This demonstrates that nondeterministic quantum amplification can be enhanced significantly by measurement and feedforward.

Physical Review A•Aug 26, 2019•11 citations
As light propagates through a transmission media, such as an optical fiber, it experiences a length-dependent loss which can reduce the communication efficiency as the transmission distance increases. In conventional telecommunications, optical signals can be transmitted over inter-continental distances, due to deterministic all-optical amplifiers. However, quantum communications are still limited to transmission distances of typically a few 100’s km since deterministic amplifiers cannot be used to amplify quantum signals. The use of deterministic amplification on a quantum signal will introduce noise that will mask the original quantum properties of the signal, introducing uncertainty or errors to any measurement. Nondeterministic methods for amplifying quantum signals via post-selection can be used instead, providing a solution to create a low noise quantum amplifier. Several methods for nondeterministic amplification have already been experimentally demonstrated. However, these devices rely on “quantum resources” which makes implementation challenging. Here we present an overview of experimental demonstrations for amplifying coherent states using a method called state comparison amplification. This is a nondeterministic protocol that performs amplification of known sets of phase-encoded coherent states using two modular stages. The outcome of each stage is recorded using single-photon detectors and time-stamped electronics to enable post-selection. State comparison amplification is a relatively simple technique, only requiring “off-the-shelf” components. The presentation will show several demonstrations of state comparison amplification including an amplifier which has high gain, fidelity, and success rate with the added advantage of being robust to channel noise and easily reconfigurable. Finally, we will discuss the effect of introducing a feedforward mechanism allowing for unsuccessful state amplifications.
Abstract Optical signals are subject to a distance-dependent loss as they propagate through transmission media. High-intensity, classical, optical signals can routinely be amplified to overcome the degradation caused by this loss. However, quantum optical states cannot be deterministically amplified and any attempt to do so will introduce intrinsic noise that spoils the desired quantum properties. Non-deterministic optical amplification, based on post-selection of the output depending on certain conditioning detection outcomes, is an emerging enabling technology in quantum measurement and quantum communications. Here we present an investigation into the properties of a simple, modular optical state comparison amplifier operating on weak coherent states. This amplifier requires no complex quantum resources and is based on linear optical components allowing for a high amplification rate at high gain and fidelity. We examine the amplifier’s performance in different configurations and develop an accurate analytical model that accounts for typical experimental scenarios.
We present an experimental demonstration of a practical nondeterministic quantum optical amplification scheme that employs two mature technologies, state comparison and photon subtraction, to achieve amplification of known sets of coherent states with high fidelity. The amplifier uses coherent states as a resource rather than single photons, which allows for a relatively simple light source, such as a diode laser, providing an increased rate of amplification. The amplifier is not restricted to low amplitude states. With respect to the two key parameters, fidelity and the amplified state production rate, we demonstrate significant improvements over previous experimental implementations, without the requirement of complex photonic components. Such a system may form the basis of trusted quantum repeaters in nonentanglement-based quantum communications systems with known phase alphabets, such as quantum key distribution or quantum digital signatures.
It is a fundamental principle of quantum theory that an unknown state cannot be copied or, as a consequence, an unknown optical signal cannot be amplified deterministically and perfectly. Here we describe a protocol that provides nondeterministic quantum optical amplification in the coherent state basis with high gain and high fidelity and which does not use quantum resources. The scheme is based on two mature quantum optical technologies: coherent state comparison and photon subtraction. The method compares favorably with all previous nondeterministic amplifiers in terms of fidelity and success probability.
Quantum optical coherent-state comparison amplifiers are nondeterministic devices which can amplify rather noiselessly a weak coherent state with an unknown phase from a finite discrete set. The high fidelity and high success probability of this amplifier are accomplished by a comparison stage and some photon subtraction stages. Due to the heralding nature of these amplifiers, they work part of the time. Here, we propose a feedforward protocol to increase the heralded times by correcting the incorrect guess. Hence, we enhance the fidelity and success probability more. Finally, the schematic experimental configuration of the feedforward-assisted coherent-state comparison amplifier is proposed.
Propagation losses in transmission media limit the transmission distance of optical signals. In the case where the signal is made up of quantum optical states, conventional deterministic optical amplification schemes cannot be used to increase the transmission distance as the copying of an arbitrary and unknown quantum state is forbidden. One strategy that can offset propagation loss is the use of probabilistic, or non-deterministic, amplification schemes - an example of which is the state comparison amplifier. Here we report a state comparison amplifier implemented in a compact, fiber-coupled femtosecond laser-written waveguide chip as opposed to the large, bulk-optical components of previous designs. This pathfinder on-chip implementation of the quantum amplifier has resulted in several performance improvements: the polarization integrity of the written waveguides has resulted in improved visibility of the amplifier interferometers; the potential of substantially-reduced losses throughout the amplifier configuration; and a more compact and environmentally-stable amplifier which is scalable to more complex networks.
One of the weaknesses of quantum optical state postselection schemes is the low success probability. Typically there is a trade-off between amplifier properties such as success probability and output state fidelity. However, here we present a state comparison amplifier for optical coherent states, which features an active measurement and feedforward mechanism to correct for errors made during the initial amplification. The simple and relatively low latency mechanism allows us to correct for a binary phase alphabet. We demonstrate a significant simultaneous improvement in the amplifier characteristic parameters: output state fidelity, correct state fraction, and success probability. This demonstrates that nondeterministic quantum amplification can be enhanced significantly by measurement and feedforward.