The motion of sub-atomic particles is characteristically quantum mechanical in nature. In contrast, quantum aspects of the motion of massive, many-atom objects are typically obscured by high phonon occupation and thermal noise. This contrast is now diminishing, owing to research efforts to bring the control and measurement of macroscopic motion fully into the quantum regime, using objects with masses from attograms to kilograms. This achievement will be critical for constructing force detectors sensitive to gravitational waves, verifying the correspondence principle at macroscopic scales, and realizing protocols that mechanically store and exchange quantum information. Here, we directly observe the quantization of the collective motion of an ultracold atomic ensemble by measuring the inability of a 0.6 attogram centre-of-mass mode to emit energy from its ground state. Moreover, the optical output of our strongly coupled cavity-optomechanical system contains a spectroscopic record of the energy exchanged between light and motion, directly quantifying the heat deposited by a quantum position measurement's backaction. These results, in addition to providing a method for calibrating the motion of low-occupation mechanical systems, offer new possibilities for investigating collective modes of degenerate gases and for diagnosing optomechanical measurement backaction.
The motion of sub-atomic particles is characteristically quantum mechanical in nature. In contrast, quantum aspects of the motion of massive, many-atom objects are typically obscured by high phonon occupation and thermal noise. This contrast is now diminishing, owing to research efforts to bring the control and measurement of macroscopic motion fully into the quantum regime, using objects with masses from attograms to kilograms. This achievement will be critical for constructing force detectors sensitive to gravitational waves, verifying the correspondence principle at macroscopic scales, and realizing protocols that mechanically store and exchange quantum information. Here, we directly observe the quantization of the collective motion of an ultracold atomic ensemble by measuring the inability of a 0.6 attogram centre-of-mass mode to emit energy from its ground state. Moreover, the optical output of our strongly coupled cavity-optomechanical system contains a spectroscopic record of the energy exchanged between light and motion, directly quantifying the heat deposited by a quantum position measurement's backaction. These results, in addition to providing a method for calibrating the motion of low-occupation mechanical systems, offer new possibilities for investigating collective modes of degenerate gases and for diagnosing optomechanical measurement backaction.
We directly measure the quantized collective motion of a gas of thousands of ultracold atoms, coupled to light in a high-finesse optical cavity. We detect strong asymmetries, as high as 3:1, in the intensity of light scattered into low- and high-energy motional sidebands. Owing to high cavity-atom cooperativity, the optical output of the cavity contains a spectroscopic record of the energy exchanged between light and motion, directly quantifying the heat deposited by a quantum position measurement's backaction. Such backaction selectively causes the phonon occupation of the observed collective modes to increase with the measurement rate. These results, in addition to providing a method for calibrating the motion of low-occupation mechanical systems, offer new possibilities for investigating collective modes of degenerate gases and for diagnosing optomechanical measurement backaction.
A common goal of recent research is the elucidation and control over quantum mechanical behavior in ever-larger physical systems. In this thesis I present an alternative target for investigating the quantum motion of macroscopic bodies: the collective motion of an ultracold atomic gas trapped within a high-finesse Fabry-Perot optical cavity in the single-atom strong-coupling regime of cavity quantum electrodynamics (CQED). When ultracold atoms are trapped in the Lamb-Dicke regime, the cavity-mode structure selects a single collective degree of freedom that is at once actuated by the optical forces from cavity probe light and measured by the cavity’s optical properties. Dispersive optical bistability arising from collective motion of the atomic medium was observed. Measurement of the collective motion was subject to quantum measurement backaction by the quantum force fluctuations of the cavity optical field. The strength and spectrum of these backaction force fluctuations was measured by quantifying the cavity-light-induced heating rate of the intracavity atomic ensemble, finding quantitative agreement with the expected heating rate from quantum optical fluctuations. Dynamical phenomena in the optomechanical system were explored experimentally and theoretically. Quantum limited measurements are discussed and were
An exciting scientific goal, common to many fields of research, is the development of ever-larger physical systems operating in the quantum regime. Relevant to this dissertation is the objective of preparing and observing a mechanical object in its motional quantum ground state. In order to sense the object's zero-point motion, the probe itself must have quantum-limited sensitivity. Cavity optomechanics, the interactions between light and a mechanical object inside an optical cavity, provides an elegant means to achieve the quantum regime. In this dissertation, I provide context to the successful cavity-based optical detection of the quantum-ground-state motion of atoms-based mechanical elements; mechanical elements, consisting of the collective center-of-mass (CM) motion of ultracold atomic ensembles and prepared inside a high-finesse Fabry-P'erot cavity, were dispersively probed with an average intracavity photon number as small as 0.1. I first show that cavity optomechanics emerges from the theory of cavity quantum electrodynamics when one takes into account the CM motion of one or many atoms within the cavity, and provide a simple theoretical framework to model optomechanical interactions. I then outline details regarding the apparatus and the experimental methods employed, highlighting certain fundamental aspects of optical detection along the way. Finally, I describe background information, both theoretical and experimental, to two published results on quantum cavity optomechanics that form the backbone of this dissertation. The first publication shows the observation of zero-point collective motion of several thousand atoms and quantum-limited measurement backaction on that observed motion. The second publication demonstrates that an array of near-ground-state collective atomic oscillators can be simultaneously prepared and probed, and that the motional state of one oscillator can be selectively addressed while preserving the near-zero-point motion of neighboring oscillators.
A cloud of ultracold atoms trapped within the confines of a high-finesse optical cavity shakes from the pressure of the light that probes it. This form of measurement backaction, a central component of quantum measurement theory, is the subject of this dissertation. Enlisting the collective motion of ultracold atoms as the mechanical degree of freedom in a cavity optomechanical system, we reach settings cold and quiet enough to allow for the effects of measurement backaction to manifest. We report predictions for and experimental observa- tions of the Standard Quantum Limit for force sensitivity, optical ponderomotive squeezing, and the possibility of complex squeezing through generalized optical correlations.
In many experiments isolated atoms and ions have been inserted into high-finesse optical resonators for the study of fundamental quantum optics and quantum information. Here, we introduce another application of such a system, as the realization of cavity optomechanics where the collective motion of an atomic ensemble serves the role of a moveable optical element in an optical resonator. Compared with other optomechanical systems, such as those incorporating nanofabricated cantilevers or the large cavity mirrors of gravitational observatories, our cold-atom realization offers direct access to the quantum regime. We describe experimental investigations of optomechanical effects, such as the bistability of collective atomic motion and the first quantification of measurement backaction for a macroscopic object, and discuss future directions for this nascent field.
The application of quantum mechanics to macroscopic motion suggests many counterintuitive phenomena. While the quantum nature of the motion of individual atoms and molecules has long been successfully studied, an equivalent demonstration of the motion of a near-macroscopic structure remains a challenge in experimental physics. A nanomechanical resonator is an excellent system for such a study. It typically contains > 10 10 atoms, and it may be modeled in terms of macroscopic parameters such as bulk density and elasticity. Yet it behaves like a simple harmonic oscillator, with mass low enough and resonant frequency high enough for its quantum zero-point motion and single energy quanta to be experimentally accessible. In pursuit of quantum phenomena in a mechanical oscillator, two important goals are to prepare the oscillator in its quantum ground state, and to measure its position with a precision limited by the Heisenberg uncertainty principle. In this work we have demonstrated techniques that advance towards both of these goals. Our system comprises a 30 micron × 170 nm, 2.2 pg, 5.57 MHz nanomechanical resonator capacitively coupled to a 5 GHz superconducting microwave resonator. The microwave resonator and nanomechanical resonator are fabricated together onto a single silicon chip and measured in a dilution refrigerator at temperatures below 150 mK. At these temperatures the coupling of the motion to the thermal environment is very small, resulting in a very high mechanical Q, approaching ∼ 10 6 . By driving with a microwave pump signal, we observed sidebands generated by the mechanical motion and used these to measure the thermal motion of the resonator. Applying a pump tone red-detuned from the microwave resonance, we used the microwave field to damp the mechanical resonator, extracting energy and "cooling" the motion in a manner similar to optical cooling of trapped atoms. Starting from a mode temperature of ∼ 150 mK, we reached ∼ 40 mK by this "backaction cooling" technique, corresponding to an occupation factor only ∼ 150 times above the ground state of motion. We also determined the precision of our device in measurement of position. Quantum mechanics dictates that, in a continuous position measurement, the precision may be no better than the zero-point motion of the resonator. Increasing the coupling of the resonator to detector will eventually result in back-action driving of the motion, adding imprecision and enforcing this limit. We demonstrated that our system is capable of precisions approaching this limit, and identified the primary experimental factors preventing us from reaching it: noise added to the measurement by our amplifier, and excess dissipation appearing in our microwave resonator at high pump powers. Furthermore, by applying both red- and blue-detuned phase-coherent microwave pump signals, we demonstrated back-action evading (BAE) measurement sensitive to only a single quadrature of the motion. By avoiding the back-action driving in the measured quadrature, such a technique has the potential for precisions surpassing the limit of the zero-point motion. With this method, we achieved a measurement precision of ∼ 100 fm, or 4 times the quantum zero-point motion of the mechanical resonator. We found that the measured quadrature is insensitive to back-action driving by at least a factor of 82 relative to the unmeasured quadrature. We also identified a mechanical parametric amplification effect which arises during the BAE measurement. This effect sets limits on the BAE performance but also mechanically preamplifies the motion, resulting in a position resolution 1.3 times the zero-point motion. We discuss how to overcome the experimental limits set by amplifier noise, pump power and parametric amplification. These results serve to define the path forward for demonstrating truly quantum-limited measurement and non-classical states of motion in a nearly-macroscopic object.