Quantum optical metrology deals with estimation of an unknown parameter by exploiting the non-classical properties of the light. The unknown parameter that we are trying to estimate is the optical phase. Precise optical phase measurement has been a well-known problem and has many applications, most notably the gravitational wave detection. In this thesis we investigate the interferometric measurement schemes. We consider the parity detection for a class of input states that have been shown to exhibit sub-shot noise limited phase estimate with their respective detection schemes. Our results indicate that the parity detection applies to all these strategies with various input states and thus acts as a unified detection scheme towards the goal of interferometric phase estimates beyond the shot-noise limit. We also consider the performance of the so-called optimal state with the canonical phase measurement scheme that was proposed by Sanders and Milburn [Phys. Rev. Lett. 75, 2944 (1995)] in presence of photon loss. The model for photon loss is a generic fictitious beam splitter and the analytical treatment requires density matrix approach rather than the state-vector formalism. We present full density-matrix calculations. Our results indicate that, for a given amount of loss, the phase estimate saturates but does not diverge as one would expect with increasing the loss. Finally, we study the continuous measurement and feedback scheme with optical homodyne detection for a single optical qubit. We found a protocol that speeds up the rate of increase of the average purity of the system and generates a deterministic evolution for the purity in the limit of strong feedback.
Quantum optical metrology deals with estimation of an unknown parameter by exploiting the non-classical properties of the light. The unknown parameter that we are trying to estimate is the optical phase. Precise optical phase measurement has been a well-known problem and has many applications, most notably the gravitational wave detection. In this thesis we investigate the interferometric measurement schemes. We consider the parity detection for a class of input states that have been shown to exhibit sub-shot noise limited phase estimate with their respective detection schemes. Our results indicate that the parity detection applies to all these strategies with various input states and thus acts as a unified detection scheme towards the goal of interferometric phase estimates beyond the shot-noise limit. We also consider the performance of the so-called optimal state with the canonical phase measurement scheme that was proposed by Sanders and Milburn [Phys. Rev. Lett. 75, 2944 (1995)] in presence of photon loss. The model for photon loss is a generic fictitious beam splitter and the analytical treatment requires density matrix approach rather than the state-vector formalism. We present full density-matrix calculations. Our results indicate that, for a given amount of loss, the phase estimate saturates but does not diverge as one would expect with increasing the loss. Finally, we study the continuous measurement and feedback scheme with optical homodyne detection for a single optical qubit. We found a protocol that speeds up the rate of increase of the average purity of the system and generates a deterministic evolution for the purity in the limit of strong feedback.
One important problem in quantum optics is to resolve an extremely small change of phase shift. The complementarity between photon number and phase sets an ultimate limit, the so-called Heisenberg limit, on the phase measurement sensitivity. The precise phase estimation has many technological applications, such as optical gyroscopes, gravitational wave detection, quantum imaging and sensing. In this thesis I show that the utilization of the parity measurement in the optical interferometry is actually applicable to a wide range of quantum entangled input states. Comparison of the performance of the various quantum states then can be made within such a unified output measurement scheme. Based on such a universal detection scheme, we present a comparison of the phase sensitivity reduction for various quantum states of light in the presence of photon loss. I also provide a simple condition that could be used to check whether an arbitrary state can achieve the Heisenberg limit independently of the detection scheme. It implies that the fidelity between the two output states with zero phase and minimal detectable phase applied respectively should significantly different from unity as the minimal phase shift scaling as 1/N, whereas the average number of input photons N goes to infinity. Next I give several measures to characterize the which-way information in the interference experiment. We define a new distinguishability associated with the fidelity between two density matrices to measure the which-way information. We demonstrate that the changes of mutual entropy as well as the entanglement of formation of the whole system, i.e. the physical system plus the which-way detector can also be used to describe the which-way information. With such quantities, we show that as the fringe visibility of the interference pattern gets larger, the less which-way information is obtained. Finally, I show that coherent light coupled with photon number resolving detectors can provide a super-resolution much below the Rayleigh diffraction limit, with sensitivity no worse than shot-noise in terms of the detected photon power. This scheme would have applications to laser radar, given the difficulty in making entangled states of light, as well as their susceptibility to atmospheric absorption.
We investigate the utility of parity detection to achieve Heisenberg-limited phase estimation for optical interferometry. We consider the parity detection with several input states that have been shown to exhibit sub-shot-noise interferometry with their respective detection schemes. We show that with parity detection, all these states achieve the sub-shot-noise limited phase uncertainty. Thus making the parity detection a unified detection strategy for quantum optical metrology. We also consider quantum states that are a combination of a NOON state and a dual-Fock state, which gives a great deal of freedom in the preparation of the input state, and is found to surpass the shot-noise limit.
Noise present in an environment has significant impacts on a quantum system affecting properties like coherence, entanglement and other metrological features of a quantum state. In this dissertation, we address the effects of different types of noise that are present in a communication channel (or medium) and an interferometric setup, and analyze their effects in the contexts of preserving coherence and entanglement, phase sensitivity, and limits on rate of communication through noisy channels. We first consider quantum optical phase estimation in quantum metrology when phase fluctuations are introduced in the system by its interaction with a noisy environment. By considering path-entangled dual-mode photon Fock states in a Mach-Zehnder optical interferometric configuration, we show that such phase fluctuations affect phase sensitivity and visibility by adding noise to the phase to be estimated. We also demonstrate that the optimal detection strategy for estimating a phase in the presence of such phase noise is provided by the parity detection scheme. We then investigate the random birefringent noise present in an optical fiber affecting the coherence properties of a single photon polarization qubit propagating through it. We show that a simple but effective control technique, called dynamical decoupling, can be used to suppress the effects of the dephasing noise, thereby preserving its ability to carry the encoded quantum information in a long-distance optical fiber communication system. Optical amplifiers and attenuators can also add noise to an entangled quantum system, deteriorating the non-classical properties of the state. We show this by considering a two-mode squeezed vacuum state, which is a Gaussian entangled state, propagating through a noisy medium, and characterizing the loss of entanglement in the covariance matrix and the symplectic formalism for this state. Finally, we discuss limits on the rate of communication in the context of sending messages through noisy optical quantum communication channels. In particular, we prove that a strong converse theorem holds under a maximum photon number constraint for these channels, guaranteeing that the success probability in decoding the message vanishes in the asymptotic limit for the rate exceeding the capacity of the channels.
Optical quantum metrology uses specially-prepared states of light to probe sensitive samples. Choosing a suitable probe state allows one to extract more information per probe photon about an unknown parameter than is possible using any classical technique. In effect, these techniques improve the sensitivity of the measurement whenever the number of probe photons is constrained in some way. This thesis presents experimental and theoretical results on the use of pairs of time-frequency entangled photons in precision measurements. It begins with an overview of necessary background knowledge about quantum optics and quantum information. This is followed by a theoretical discussion on the estimation of a single delay using two-photon interference. We show that constraints on the probe photon's bandwidth complicate the measurement problem, requiring suitable optimization of the two-photon quantum state to avoid losing precision. We then consider the use of two-photon interference for linear spectroscopic measurements. Linear spectroscopy relates the absorption and phase spectrum of a sample to unknown electronic parameters. We describe a proof-of-principle experiment demonstrating that two-photon interferometric spectroscopy can be used for simultaneously measurement of both absorption and phase. This is followed by an information-theoretic discussion of the precision of this technique. For low losses, we show that the method provides phase sensitivity similar to classical interferometry while approaching the optimal absorption precision of any possible measurement. If the absorption and phase values are both related to a single unknown parameter, then our technique provides improved sensitivity to this parameter compared to both classical measurements and other quantum techniques in the presence of realistic levels of loss. We conclude with a discussion of quantum-optical coherence tomography, which is a two-photon interferometric method for determining the material structure of a sample. We present an ongoing experiment which aims to apply the method to tissue-like samples, where the quantum measurement is limited by a poor signal-to-noise ratio. Preliminary results demonstrate that this noise can be largely reduced by suitable frequency-domain filtering. This allows us to precisely determine the position of a scattering center using a few hundred detected photon pairs despite the presence of large amounts of noise. We follow this with a theoretical discussion of signal artifacts which are known to complicate the measured interferogram. We show these artifacts are due to a distinct interferometric effect, which can be distinguished from the signal of interest using the relative time delay between detected photons. We conclude with a brief discussion on possible techniques for artifact removal.
Photon number states are assigned a parity of +1 if their photon number is even and a parity of −1 if odd. The parity operator, which is minus one to the power of the photon number operator, is a Hermitian operator and thus a quantum mechanical observable although it has no classical analogue, the concept being meaningless in the context of classical light waves. In this paper we review work on the application of the parity operator to the problem of quantum metrology for the detection of small phase shifts with quantum optical interferometry using highly entangled field states such as the so-called N00N states, and states obtained by injecting twin Fock states into a beam splitter. With such states and with the performance of parity measurements on one of the output beams of the interferometer, one can breach the standard quantum limit, or shot-noise limit, of sensitivity down to the Heisenberg limit, the greatest degree of phase sensitivity allowed by quantum mechanics for linear phase shifts. Heisenberg limit sensitivities are expected to eventually play an important role in attempts to detect gravitational waves in interferometric detection systems such as LIGO and VIRGO.
Phase estimation has a wide range of applications. Over the years, several strategies have been studied to improve precision in phase estimation. These strategies include using exotic quantum states to quantum detection schemes. This dissertation summarizes my effort in improving the precision of phase estimation with a linear and nonlinear interferometer. Chapter 1 introduces quantum optics and quantum metrology. I introduce all relevant quantum states of light used. We also look into tools and terminologies of quantum metrology such as Fisher information, shot-noise limit, Heisenberg limit, etc., along with examples of phase estimation with a Mach-Zehnder interferometer. In Chapter 2, I discuss multiple phase estimation using a multimode interferometer. Building upon previous work, our scheme consists of a multimode interferometer with single-photon inputs. By using a quantum Fisher information analysis, we show that our scheme gives a constant improvement over other schemes. We also show that our scheme with photon-number-resolving detection approaches the quantum Cram\'er-Rao bound. Moreover, we also consider the probabilistic nature of photon emission at the input, and we study its effect on phase sensitivity. I discuss phase estimation with SU(1,1) interferometer in Chapter 3. We look at phase sensitivity in this interferometer with different input states. Namely, we consider two different phase estimation scheme, one using thermal and squeezed states, and others using coherent and displaced squeezed states with parity and on-off as a detection scheme. We also look into the effect of photon loss inside the interferometer. In Chapter 4, we revisit phase estimation in SU(1,1) interferometer from the perspective of quantum Fisher information. I discuss in detail a longstanding confusion regarding the use of quantum Fisher information in SU(1,1) interferometer. We show that phase averaging or quantum Fisher information matrix method is needed in general for calculating the phase sensitivity which resolves inconsistencies reported in previously published articles.