Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

An atomic clock with Cs atoms for space applications

Sumanta Khan, Vineet Bharti, Vasant Natarajan A

Published Oct 30, 2017• 0 citations
OpenAlex

Abstract

We demonstrate the development of an atomic clock using a diode laser and a vapor cell of Cs atoms. We use the technique of coherent population trapping (CPT). The required phase coherence between the probe and control beams, whose frequency difference is the clock frequency, is obtained by frequency modulating the laser with an electro-optic modulator (EOM). The EOM is fiber coupled and hence does not require alignment, which is advantageous for space applications. The atoms are contained in a vapor cell, which is again useful in satellite launches.

Related papers

Observation of CPT for the ground hyperfine interval in $^{133}$Cs

Sumanta Khan, Vineet Bharti, Vasant Natarajan A

We use the technique of coherent population trapping (CPT) to access the ground hyperfine interval (clock transition) in $^{133}$Cs. The probe and control beams required for CPT are obtained from a single compact diode laser system. The phase coherence between the beams, whose frequency difference is the clock frequency, is obtained by frequency modulating the laser with an electro-optic modulator (EOM). The EOM is fiber coupled and hence does not require alignment, and the atoms are contained in a vapor cell. Both of these should prove advantageous for potential use as atomic clocks in satellites.

arXiv:1710.10788•Oct 30, 2017•0 citations

Feasibility toward a compact high performance coherent population trapping clock

Peter Yun, François Tricot, Emeric de Clercq +4 more

We demonstrate a vapor-cell atomic-clock prototype based on a continuous-wave interrogation and double-modulation coherent population trapping (DM-CPT) technique. The DM-CPT technique uses a synchronous modulation of polarization and the relative phase of a bichromatic laser beam in order to increase the number of atoms trapped in a dark state, i.e., a nonabsorbing state. The narrow resonance, observed in the transmission of a Cs vapor cell, is used as a narrow frequency discriminator in an atomic clock. A detailed characterization of the CPT resonance versus numerous parameters is reported. A short-term fractional-frequency stability of 3.2×10−13τ−1/2 up to a 100-s averaging time is measured. These performances are more than one order of magnitude better than industrial Rb clocks and are comparable to those of the best laboratory-prototype vapor-cell clocks. The noise-budget analysis shows that the short- and midterm frequency stability is mainly limited by the power fluctuations of the microwave used to generate the bichromatic laser. These preliminary results demonstrate that the DM-CPT technique is well suited for the development of a high-performance atomic clock, with the potential compact and robust setup due to its linear architecture. This clock could find future applications in industry, telecommunications, instrumentation, or global navigation satellite systems.

•Apr 14, 2019•0 citations

Laser-pumped and laser-cooled atomic clocks for space applications

Walter F. Buell

Highly stable atomic frequency standards are of increasing importance for a variety of space applications, ranging from communication to navigation and time transfer to tests of fundamental science. We present a discussion of the improvements possible with laser pumping of vapor cell clocks, including applying coherent population trapping (CPT) techniques. We also present our progress toward a cold atom clock based on magneto-optically trapped atoms for space applications.

Laser and Particle Beams•Dec 1, 1998•9 citations

Frequency Shifts in a Coherent Population Trapping Cs Vapor Cell Atomic Clock

Juliette Breurec, Moustafa Abdel Hafiz, Claudio Eligio Calosso +2 more

We report on measurements of frequency shifts in a microwave cesium vapor cell atomic clock based on coherent population trapping (CPT). The dependence of the clock frequency on numerous experimental parameters, such as the laser power, the laser frequency, the microwave power, the cell temperature, the static magnetic field, but also the temperature of some key components, or the translation and rotation of critical wave plates and optical elements, is investigated. The stability budget of the clock frequency at one day is reported and discussed. This study constitutes a solid database for the future demonstration of a CPT-based cell clock with enhanced mid- and long-term stability performances.

IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control•May 29, 2025•4 citations

Atomic Frequency Standard based on Coherent Population Trapping in Rb-87 Atoms for Space Application

Pragya Tiwari, Manjula Ramachandra, Madan Mohan Kandpal +11 more

Space-borne atomic frequency standards demand a high level of performance and stability throughout the mission life in the harsh environment of space. Recently, atomic clocks employing Coherent Population Trapping (CPT), a quantum interference phenomenon in alkali atoms, have shown much promise for space application. This paper presents the development and realization of compact and reliable CPT atomic clock for ISRO's navigational satellites. In our approach, quantum interference in Rb-87 atoms are pursued for obtaining the clock resonance, owing to their larger ground state hyperfine transition energy (higher Q-factor). Quantum interference is realized by generating two resonant optical laser fields from a VCSEL diode by modulating its drive current at RF frequency which corresponds to the ground state hyperfine separation in Rb-87 atoms. The emission frequency of the laser diode is stabilized by locking it with respect to the D1 hyperfine transition with the help of a servo control loop, thereby the instabilities associated with laser frequency fluctuations are minimized. The resulting CPT resonance (<;kHz) as shown in Figure 1 is used as reference to stabilize the crystal oscillator frequency (10 MHz) that serves both as clock output and seed for generating the RF field.

URSI Asia-Pacific Radio Science Conference•Mar 1, 2019•0 citations

A CPT-based Cs vapor cell atomic clock with a short-term fractional frequency stability of 3 x 10-13τ-1/2

Moustafa Abdel Hafiz, Xiaochi Liu, Stéphane Guérandel +2 more

This article reports on the development and short-term fractional frequency stability of a continuous-regime (CW) Cs vapor cell atomic clock based on coherent population trapping (CPT). The push-pull optical pumping technique is used to increase the number of atoms that participate to the clock transition, yielding a typical CPT resonance contrast of 25% for a CPT linewidth of about 450 Hz. The clock short-term fractional frequency stability is measured to be 3 x 10 -13 τ -1/2 up to 100 seconds averaging time, in correct agreement with the signal-to-noise ratio limit. The mid-term frequency stability results are currently mainly limited by laser power effects. The detection of high-contrast narrow Raman-Ramsey fringes is demonstrated with this setup by making the atoms interact with a light pulse sequence.

Journal of Physics Conference Series•Jun 1, 2016•6 citations
We demonstrate the development of an atomic clock using a diode laser and a vapor cell of Cs atoms. We use the technique of coherent population trapping (CPT). The required phase coherence between the probe and control beams, whose frequency difference is the clock frequency, is obtained by frequency modulating the laser with an electro-optic modulator (EOM). The EOM is fiber coupled and hence does not require alignment, which is advantageous for space applications. The atoms are contained in a vapor cell, which is again useful in satellite launches.
Observation of CPT for the ground hyperfine interval in 133^{133}133Cs
We use the technique of coherent population trapping (CPT) to access the ground hyperfine interval (clock transition) in 133^{133}133Cs. The probe and control beams required for CPT are obtained from a single compact diode laser system. The phase coherence between the beams, whose frequency difference is the clock frequency, is obtained by frequency modulating the laser with an electro-optic modulator (EOM). The EOM is fiber coupled and hence does not require alignment, and the atoms are contained in a vapor cell. Both of these should prove advantageous for potential use as atomic clocks in satellites.
We demonstrate a vapor-cell atomic-clock prototype based on a continuous-wave interrogation and double-modulation coherent population trapping (DM-CPT) technique. The DM-CPT technique uses a synchronous modulation of polarization and the relative phase of a bichromatic laser beam in order to increase the number of atoms trapped in a dark state, i.e., a nonabsorbing state. The narrow resonance, observed in the transmission of a Cs vapor cell, is used as a narrow frequency discriminator in an atomic clock. A detailed characterization of the CPT resonance versus numerous parameters is reported. A short-term fractional-frequency stability of 3.2×10−13τ−1/2 up to a 100-s averaging time is measured. These performances are more than one order of magnitude better than industrial Rb clocks and are comparable to those of the best laboratory-prototype vapor-cell clocks. The noise-budget analysis shows that the short- and midterm frequency stability is mainly limited by the power fluctuations of the microwave used to generate the bichromatic laser. These preliminary results demonstrate that the DM-CPT technique is well suited for the development of a high-performance atomic clock, with the potential compact and robust setup due to its linear architecture. This clock could find future applications in industry, telecommunications, instrumentation, or global navigation satellite systems.
We report on measurements of frequency shifts in a microwave cesium vapor cell atomic clock based on coherent population trapping (CPT). The dependence of the clock frequency on numerous experimental parameters, such as the laser power, the laser frequency, the microwave power, the cell temperature, the static magnetic field, but also the temperature of some key components, or the translation and rotation of critical wave plates and optical elements, is investigated. The stability budget of the clock frequency at one day is reported and discussed. This study constitutes a solid database for the future demonstration of a CPT-based cell clock with enhanced mid- and long-term stability performances.
Space-borne atomic frequency standards demand a high level of performance and stability throughout the mission life in the harsh environment of space. Recently, atomic clocks employing Coherent Population Trapping (CPT), a quantum interference phenomenon in alkali atoms, have shown much promise for space application. This paper presents the development and realization of compact and reliable CPT atomic clock for ISRO's navigational satellites. In our approach, quantum interference in Rb-87 atoms are pursued for obtaining the clock resonance, owing to their larger ground state hyperfine transition energy (higher Q-factor). Quantum interference is realized by generating two resonant optical laser fields from a VCSEL diode by modulating its drive current at RF frequency which corresponds to the ground state hyperfine separation in Rb-87 atoms. The emission frequency of the laser diode is stabilized by locking it with respect to the D1 hyperfine transition with the help of a servo control loop, thereby the instabilities associated with laser frequency fluctuations are minimized. The resulting CPT resonance (<;kHz) as shown in Figure 1 is used as reference to stabilize the crystal oscillator frequency (10 MHz) that serves both as clock output and seed for generating the RF field.
This article reports on the development and short-term fractional frequency stability of a continuous-regime (CW) Cs vapor cell atomic clock based on coherent population trapping (CPT). The push-pull optical pumping technique is used to increase the number of atoms that participate to the clock transition, yielding a typical CPT resonance contrast of 25% for a CPT linewidth of about 450 Hz. The clock short-term fractional frequency stability is measured to be 3 x 10 -13 τ -1/2 up to 100 seconds averaging time, in correct agreement with the signal-to-noise ratio limit. The mid-term frequency stability results are currently mainly limited by laser power effects. The detection of high-contrast narrow Raman-Ramsey fringes is demonstrated with this setup by making the atoms interact with a light pulse sequence.