Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Optics

Generation of octupled microwave signal via frequency multiplication method

Mandeep Singh, Sanjeev Kumar Raghuwanshi

Published Aug 31, 2017• 1 citation
Publisher

Abstract

Abstract We propose experimentally a technique to generate a low noise frequency octupled microwave signal. We demonstrate that by carefully arranging the phase of 90° between two MZMs (out of three), a low noise photonically assisted octupled microwave signal can be generated. A 25.6 GHz optical microwave signal is achieved with 3.2 GHz of local RF oscillator signal. Moreover, the intensity expressions at the output of photodiode are derived for both with and without dispersion terms. Finally, we advocate the impact of the electrical spurious suppression ratio on the extinction ratio of the modulators. Our experimental and simulation results agree well with the theoretical analysis.

DOI
10.1088/2040-8986/aa895f

Related papers

Photonic-assisted microwave quantum-noise randomized cipher generation for signal security of wireless communications

Ken Tanizawa, Fumio Futami

Security enhancement is a major challenge in future 6G wireless networks. In this study, we have introduced a symmetric-key encryption system, which utilizes multilevel signaling, for the security of microwave signals against wireless interception. The system achieves quantum-noise signal masking at microwave frequencies via optical-tomicrowave frequency conversion based on the homodyne process, thus providing high signal security. We show experimental demonstrations of quantum-noise randomized phase-shift keying modulation/quadrature amplitude modulation cipher generation at a frequency of ~GHz via the intensity modulation/direct detection analog intermediate frequency over fiber transmission. The proposed system simultaneously achieves microwave signal delivery over a fiber link and signal encryption based on sufficient quantum-noise signal masking for wireless communication systems.

Next-Generation Optical Communication: Components, Sub-Systems, and Systems•Mar 15, 2023•2 citations

Photonic-Assisted Multi-Tone Microwave Frequency Measurement Based on Pulse Identification

Xiaobing Xie, Chao Luo, Huiyun Tang +3 more

We report a photonic-assisted method for measuring the frequencies of a multi-tone microwave with high accuracy based on pulse identification. The unknown microwave signal and a linearly chirped signal are modulated to an optical carrier using a dual-polarization Mach–Zehnder modulator. Carrier-suppressed single-sideband modulation avoids the generation of undesired frequency components after photodetection. An electrical bandpass filter with a narrow bandwidth selects the beat signal between the unknown signal and the linearly chirped optical tone. A pulse, generated by the beat signal, can be observed using an oscilloscope (OSC). By identifying the beating pulse position, we can accurately determine the frequency of the unknown signal. The single-tone and multi-tone microwave signal ranges of 6–16 GHz and 26–36 GHz are successfully measured, respectively. The measurement errors for single-tone and multi-tone signals are both less than ±1 MHz.

Photonics•Dec 24, 2024•4 citations

Pure intensity modulated frequency doubled optical clock signal generation by using ultra low-chirp and high extinction-ratio optical modulation

Tetsuya Kawanishi, Takahide Sakamoto, Akito Chiba +3 more

We demonstrated ultra low-chirp and high extinction-ratio modulation, by using an integrated lithium niobate modulator. The odd order optical sideband components were highly suppressed to achieve a chirp-free intensity modulated frequency doubled signal.

Opto-Electronics and Communications Conference (OECC)•Jul 1, 2009•6 citations

Impact of Optical Amplification and Pulse Interleaving on Low Phase Noise Photonic Microwave Generation

Franklyn Quinlan, Fred N. Baynes, Tara M. Fortier +4 more

Using carefully constructed pulse interleavers, we demonstrate ~10 dB reduction in the quantum noise from optical amplification for short pulse detection, resulting in a phase noise floor on a 10 GHz microwave of −175 dBc/Hz.

•Jan 1, 2014•1 citation

Dynamical low-noise microwave source for cold-atom experiments

Bernd Meyer-Hoppe, Maximilian Baron, Christophe Cassens +4 more

The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source with two independently controllable output paths. Both paths generate frequencies in the range of 6.835 GHz ± 25 MHz for hyperfine transitions in 87Rb. The presented microwave source combines two commercially available frequency synthesizers: an ultra-low-noise oscillator at 7 GHz and a direct digital synthesizer for radio frequencies. We demonstrate a low integrated phase noise of 480 µrad in the range of 10 Hz to 100 kHz and fast updates of frequency, amplitude, and phase in sub-µs time scales. The highly dynamic control enables the generation of shaped pulse forms and the deployment of composite pulses to suppress the influence of various noise sources.

arXiv:2003.10989•Review of Scientific Instruments•Jul 1, 2023•10 citations

Quantum microwave photonics in radio-over-fiber systems

Yaqing Jin, Yang Ye, Huibo Hong +7 more

As the main branch of microwave photonics, radio-over-fiber technology provides high bandwidth, low-loss, and long-distance propagation capability, facilitating wide applications ranging from telecommunication to wireless networks. With ultrashort pulses as the optical carrier, a large capacity is further endowed. However, the wide bandwidth of ultrashort pulses results in the severe vulnerability of high-frequency radio frequency (RF) signals to fiber dispersion. With a time-energy entangled biphoton source as the optical carrier combined with the single-photon detection technique, a quantum microwave photonics method in radio-over-fiber systems is proposed and demonstrated experimentally. The results show that it not only realizes unprecedented nonlocal RF signal modulation with strong resistance to the dispersion but also provides an alternative mechanism to distill the RF signal out from the dispersion effectively. Furthermore, the spurious-free dynamic ranges of the nonlocally modulated and distilled RF signals have been significantly improved. With the ultra-weak detection and the high-speed processing advantages endowed by the low-timing-jitter single-photon detection, the quantum microwave photonics method opens new possibilities in modern communication and networks.

Photonics Research•May 19, 2022•16 citations
Abstract We propose experimentally a technique to generate a low noise frequency octupled microwave signal. We demonstrate that by carefully arranging the phase of 90° between two MZMs (out of three), a low noise photonically assisted octupled microwave signal can be generated. A 25.6 GHz optical microwave signal is achieved with 3.2 GHz of local RF oscillator signal. Moreover, the intensity expressions at the output of photodiode are derived for both with and without dispersion terms. Finally, we advocate the impact of the electrical spurious suppression ratio on the extinction ratio of the modulators. Our experimental and simulation results agree well with the theoretical analysis.
Security enhancement is a major challenge in future 6G wireless networks. In this study, we have introduced a symmetric-key encryption system, which utilizes multilevel signaling, for the security of microwave signals against wireless interception. The system achieves quantum-noise signal masking at microwave frequencies via optical-tomicrowave frequency conversion based on the homodyne process, thus providing high signal security. We show experimental demonstrations of quantum-noise randomized phase-shift keying modulation/quadrature amplitude modulation cipher generation at a frequency of ~GHz via the intensity modulation/direct detection analog intermediate frequency over fiber transmission. The proposed system simultaneously achieves microwave signal delivery over a fiber link and signal encryption based on sufficient quantum-noise signal masking for wireless communication systems.
We report a photonic-assisted method for measuring the frequencies of a multi-tone microwave with high accuracy based on pulse identification. The unknown microwave signal and a linearly chirped signal are modulated to an optical carrier using a dual-polarization Mach–Zehnder modulator. Carrier-suppressed single-sideband modulation avoids the generation of undesired frequency components after photodetection. An electrical bandpass filter with a narrow bandwidth selects the beat signal between the unknown signal and the linearly chirped optical tone. A pulse, generated by the beat signal, can be observed using an oscilloscope (OSC). By identifying the beating pulse position, we can accurately determine the frequency of the unknown signal. The single-tone and multi-tone microwave signal ranges of 6–16 GHz and 26–36 GHz are successfully measured, respectively. The measurement errors for single-tone and multi-tone signals are both less than ±1 MHz.
The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source with two independently controllable output paths. Both paths generate frequencies in the range of 6.835 GHz ± 25 MHz for hyperfine transitions in 87Rb. The presented microwave source combines two commercially available frequency synthesizers: an ultra-low-noise oscillator at 7 GHz and a direct digital synthesizer for radio frequencies. We demonstrate a low integrated phase noise of 480 µrad in the range of 10 Hz to 100 kHz and fast updates of frequency, amplitude, and phase in sub-µs time scales. The highly dynamic control enables the generation of shaped pulse forms and the deployment of composite pulses to suppress the influence of various noise sources.
As the main branch of microwave photonics, radio-over-fiber technology provides high bandwidth, low-loss, and long-distance propagation capability, facilitating wide applications ranging from telecommunication to wireless networks. With ultrashort pulses as the optical carrier, a large capacity is further endowed. However, the wide bandwidth of ultrashort pulses results in the severe vulnerability of high-frequency radio frequency (RF) signals to fiber dispersion. With a time-energy entangled biphoton source as the optical carrier combined with the single-photon detection technique, a quantum microwave photonics method in radio-over-fiber systems is proposed and demonstrated experimentally. The results show that it not only realizes unprecedented nonlocal RF signal modulation with strong resistance to the dispersion but also provides an alternative mechanism to distill the RF signal out from the dispersion effectively. Furthermore, the spurious-free dynamic ranges of the nonlocally modulated and distilled RF signals have been significantly improved. With the ultra-weak detection and the high-speed processing advantages endowed by the low-timing-jitter single-photon detection, the quantum microwave photonics method opens new possibilities in modern communication and networks.