Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Communications Letters

Two-Side State-Aided Bit-Flipping Decoding of Generalized Low Density Parity Check Codes

Sherif Elsanadily, Ashraf M. Mahran, Osama M. Elghandour

Published Jun 27, 2017• 10 citations
Publisher

Abstract

A modified bit-flipping (BF) decoding algorithm is proposed for hard-decoding of generalized low- density parity-check codes over binary channels. This approach introduces an extra bit between the variable nodes and constraint nodes representing the decision reliability of each node. The local decoding failure is also analyzed to provide a reasonable treatment for the most of its causes. The approach is not in the direction of constructing codes with minimum trapping sets, but to reduce their effect in the decoder at a cost of little increase in the resources. The algorithm, which is called two-side state-aided BF, is shown by simulations to outperform previous BF algorithms in terms of error performance.

DOI
10.1109/lcomm.2017.2720165

Related papers

Channel-independent weighted bit-flipping decoding algorithm for low-density parity-check codes

T.-C. Chen

In this study, a new method for improving hard-decision bit-flipping (BF) decoding is proposed for low-density parity-check codes. The flipping criterion is derived theoretically from the soft-decision belief-propagation decoding algorithm. The proposed BF decoding algorithm is channel independent and is improved by introducing a more efficient method for computing the reliability of the parity checks. Extensive simulations are provided to demonstrate the efficiency of the proposed algorithm. Simulation results show that the proposed algorithm can achieve about 1.6 dB coding gain improvement at BER=10−5 while reducing up to 53% iterations for decoding and maintaining low-decoding complexity, compared with the conventional weighted BF algorithm.

IET Communications•Nov 27, 2012•10 citations

An efficient bit-flipping decoding algorithm for LDPC codes

Tso-Cho Chen

In this paper, a new method for improving hard-decision bit-flipping (BF) decoding is proposed for low-density parity-check codes. The flipping criterion is derived theoretically from the soft-decision belief-propagation decoding algorithm. The proposed BF decoding algorithm is channel independent and is improved by introducing a more efficient method for computing the reliability of the parity checks. Extensive simulations are provided to demonstrate the efficiency of the proposed algorithm. Simulation results show that the proposed algorithm can achieve about 1.5dB coding gain improvement at BER = 5×10−6while reducing up to 48% iterations for decoding and maintaining low decoding complexity, compared with the conventional weighted BF algorithm.

Cross Strait Quad-Regional Radio Science and Wireless Technology Conference (CSQRWC)•Jul 1, 2012•6 citations

An Improved Iterative Bit-flipping Decoding Algorithm for Low-density Parity-check Codes

Meiling Zhang

An improved iterative bit-flipping(BF) algorithm adapted for decoding low-density parity-check(LDPC) codes is proposed to improve the performance of the hard-decision BF decoding algorithm.The new algorithm uses an alternating threshold pattern to determine the bits whether to be flipped or not,and the flipping error probability is effectively decreased.Simulation results show that compared with BF algorithm,the improved BF algorithm improves both the error-correction performance and the convergence speed while maintaining the low computational complexity.

Telecommunication Engineering•Jan 1, 2012•0 citations

Weighted candidate bit based bit-flipping decoding algorithms for LDPC codes

Zhu Qing, Lenan Wu

In order to improve the bit-flipping (BF) decoding algorithms, a weighted hard-decision based BF decoding algorithm for low-density parity-check (LDPC) codes is presented, in which the weights of variable-nodes are employed. A new metric is defined for the weight of candidate bits not only in unsatisfied parity check equations but also in satisfied ones. The connection between min-sum decoding algorithm and the proposed algorithm is presented. Simulation results show that the new decoding algorithm can provide better FER performance and faster convergence speed than the original candidate bit based bit-flipping (CBBF) algorithm.

International Conference on Consumer Electronics, Communications and Networks (CECNet)•Nov 1, 2013•4 citations

Improved Bit-Flipping Method for Decoding Structured Low-Density Parity-Check Codes

Meiling Zhang

An improved bit-flipping(BF) algorithm with low complexity for decoding structured low-density parity-check codes(LDPC) is proposed to improve the performance of the hard-decision BF algorithm.The hard-decision bits are divided into two groups based on the magnitudes of the received symbols,and at each iteration,the proposed algorithm can flip more than one bit with using two thresholds,and the flipping error probability is effectively decreased.The improved BF algorithm requires some real number comparisons before iterations and requires only logical operations during the iterations.Compared with the weighted bit-flipping algorithm and its modifications,the new method is with significantly lower complexity.Simulations show that the proposed algorithm is provided with very fast convergence speed and excellent performance with significantly low complexity.

Beijing Youdian Xueyuan xuebao•Jan 1, 2012•0 citations

Two-Round Selection-Based Bit Flipping Decoding Algorithm for LDPC Codes

Soufian Addi, Mostafa Belkasmi, Ahlam Berkani +1 more

This paper presents a novel iterative reliability-based bit flipping (BF) algorithm for decoding low-density parity-check codes. The new decoder is a single BF algorithm called two-round selection -based bit flipping. It introduces the idea of a two-round selection of the flipped bit, based successively on hard and soft received channel values. In the first stage, a set of unreliable bits is identified, and then a second selection is used, to pick out among them the bit to flip. In the second round of selection, the initial belief about received signals, contributes efficiently to selecting the best candidate bit. We demonstrate through simulations over the binary-input additive white Gaussian noise channel and the Rayleigh fading channel that the proposed algorithm exhibits better decoding performance when compared with some well-known soft decision BF algorithms. A complexity analysis of the proposal and a comparison to other BF decoders are also presented.

Wireless Communications and Mobile Computing•Nov 28, 2023•0 citations
A modified bit-flipping (BF) decoding algorithm is proposed for hard-decoding of generalized low- density parity-check codes over binary channels. This approach introduces an extra bit between the variable nodes and constraint nodes representing the decision reliability of each node. The local decoding failure is also analyzed to provide a reasonable treatment for the most of its causes. The approach is not in the direction of constructing codes with minimum trapping sets, but to reduce their effect in the decoder at a cost of little increase in the resources. The algorithm, which is called two-side state-aided BF, is shown by simulations to outperform previous BF algorithms in terms of error performance.
In this study, a new method for improving hard-decision bit-flipping (BF) decoding is proposed for low-density parity-check codes. The flipping criterion is derived theoretically from the soft-decision belief-propagation decoding algorithm. The proposed BF decoding algorithm is channel independent and is improved by introducing a more efficient method for computing the reliability of the parity checks. Extensive simulations are provided to demonstrate the efficiency of the proposed algorithm. Simulation results show that the proposed algorithm can achieve about 1.6 dB coding gain improvement at BER=10−5 while reducing up to 53% iterations for decoding and maintaining low-decoding complexity, compared with the conventional weighted BF algorithm.
In this paper, a new method for improving hard-decision bit-flipping (BF) decoding is proposed for low-density parity-check codes. The flipping criterion is derived theoretically from the soft-decision belief-propagation decoding algorithm. The proposed BF decoding algorithm is channel independent and is improved by introducing a more efficient method for computing the reliability of the parity checks. Extensive simulations are provided to demonstrate the efficiency of the proposed algorithm. Simulation results show that the proposed algorithm can achieve about 1.5dB coding gain improvement at BER = 5×10−6while reducing up to 48% iterations for decoding and maintaining low decoding complexity, compared with the conventional weighted BF algorithm.
An improved iterative bit-flipping(BF) algorithm adapted for decoding low-density parity-check(LDPC) codes is proposed to improve the performance of the hard-decision BF decoding algorithm.The new algorithm uses an alternating threshold pattern to determine the bits whether to be flipped or not,and the flipping error probability is effectively decreased.Simulation results show that compared with BF algorithm,the improved BF algorithm improves both the error-correction performance and the convergence speed while maintaining the low computational complexity.
In order to improve the bit-flipping (BF) decoding algorithms, a weighted hard-decision based BF decoding algorithm for low-density parity-check (LDPC) codes is presented, in which the weights of variable-nodes are employed. A new metric is defined for the weight of candidate bits not only in unsatisfied parity check equations but also in satisfied ones. The connection between min-sum decoding algorithm and the proposed algorithm is presented. Simulation results show that the new decoding algorithm can provide better FER performance and faster convergence speed than the original candidate bit based bit-flipping (CBBF) algorithm.
An improved bit-flipping(BF) algorithm with low complexity for decoding structured low-density parity-check codes(LDPC) is proposed to improve the performance of the hard-decision BF algorithm.The hard-decision bits are divided into two groups based on the magnitudes of the received symbols,and at each iteration,the proposed algorithm can flip more than one bit with using two thresholds,and the flipping error probability is effectively decreased.The improved BF algorithm requires some real number comparisons before iterations and requires only logical operations during the iterations.Compared with the weighted bit-flipping algorithm and its modifications,the new method is with significantly lower complexity.Simulations show that the proposed algorithm is provided with very fast convergence speed and excellent performance with significantly low complexity.
This paper presents a novel iterative reliability-based bit flipping (BF) algorithm for decoding low-density parity-check codes. The new decoder is a single BF algorithm called two-round selection -based bit flipping. It introduces the idea of a two-round selection of the flipped bit, based successively on hard and soft received channel values. In the first stage, a set of unreliable bits is identified, and then a second selection is used, to pick out among them the bit to flip. In the second round of selection, the initial belief about received signals, contributes efficiently to selecting the best candidate bit. We demonstrate through simulations over the binary-input additive white Gaussian noise channel and the Rayleigh fading channel that the proposed algorithm exhibits better decoding performance when compared with some well-known soft decision BF algorithms. A complexity analysis of the proposal and a comparison to other BF decoders are also presented.