Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Single-photon-level spatial-mode-selective frequency up-conversion in a multimode χ(2) waveguide

Y. B. Kwon, M. Giribabu, Carsten Langrock, M. M. Fejer, Michael Vasilyev

Published Jan 1, 2017• 10 citations
Publisher

Abstract

We experimentally demonstrate selective up-conversion of either TM00 or TM01 mode of a 1540 nm single-photon signal into TM01 mode at 775 nm with >70% efficiency, better than −10 dB crosstalk, and >102 signal-to-noise-photon ratio.
DOI
10.1364/cleo_qels.2017.ff2e.2

Related papers

Spatial-mode-selective quantum frequency conversion (Conference Presentation)

Young Bong Kwon, M. Giribabu, Lu Li +4 more

Spatial-mode-selective frequency conversion is potentially useful for both classical and quantum communication applications. By a judicious choice of the quasi-phase-matching period in a Kai(2) multimode waveguide, such conversion can be achieved with high efficiency (close to 100%) and with low crosstalk (< -20 dB). For space-division multiplexing application with classical signals, where each spatial mode represents a separate signal channel, the selective conversion of a spatial mode without disrupting other signal modes can be used for reconfigurable spatial-mode de-multiplexing. This classical de-multiplexing capability can be also extended to the quantum regime, where the quantum state of the signal is preserved during frequency conversion, owing to the unitary nature of the sum-frequency generation (SFG) process. Building upon our previous experimental demonstration of the classical spatial-mode-selective frequency up-conversion in a two-mode PPLN waveguide, here we report the extension of this work into the single-photon-level regime. The signal (1540 nm) in either a single mode (TM00 or TM01) or a superimposition mode (TM00+TM01, TM00+iTM01) of the waveguide is selectively up-converted into TM01 SFG mode, by interacting with an appropriate pump mode (1560 nm). An accurate measurement of the single-photon-level SFG signals requires thorough filtering of the unwanted photons contributed by the second harmonic of the pump, residual pump noise extending to the signal band, and the Raman noise generated in the waveguide. We have investigated these unwanted photon sources and suppressed them by a combination of thin-film-interference and volume-Bragg-grating filters. Resulting single-photon-counting measurements show >70% internal conversion efficiency, better than -12dB crosstalk, and >100 ratio of the signal to background photon counts for all selected modes and mode superpositions.

Nonlinear Frequency Generation and Conversion: Materials and Devices•Mar 14, 2018•1 citation

Channel-selective frequency up-conversion for frequency-multiplexed quantum network

Shoichi Murakami, Shunsuke Hiraoka, Toshiki Kobayashi +2 more

We demonstrate channel-selective frequency up-conversion from telecom wavelengths around 1540 nm for optical fiber communication to visible wavelengths around 780 nm, based on second-order optical nonlinearity in a cavity of the converted modes. In our experiment, we selectively convert a light from any frequency mode within frequency-multiplexed telecom signals to a desired output mode, determined by the cavity resonances. Based on the experimental results of the frequency up-conversion, we derive the signal-to-noise ratio of the process at the single-photon level, and discuss its applicability to channel-selective quantum frequency conversion (CS-QFC) in the context of frequency-multiplexed quantum networks. Finally, we describe specific use cases of the CS-QFC, which show its utility as a reconfigurable switching element in frequency-multiplexed networks, particularly for selectively performing Bell-state measurements between two photons originating from different frequencies.

quant-pharXiv:2511.16085•Optics Express•Nov 21, 2025•1 citation

Spatial-Mode-Selective Quantum Frequency Conversion in a χ^(2) Slab Waveguide

Michael Vasilyev, Young B. Kwon, Yu-Ping Huang

We numerically investigate single-spatial-mode-selective up-conversion in a diffractionless χ(2) slab waveguide by optimizing its one-dimensional pump profile. Singular-value decomposition of the Green’s function predicts ~5-dB discrimination between the first two modes’ conversion efficiencies.

Research in Optical Sciences•Jan 1, 2014•2 citations

Spatial-mode-selective quantum frequency conversion in nonlinear waveguides

Young Bong Kwon, Michael Vasilyev

We investigate spatial-mode-selective frequency up-converters of quantum states from infrared to visible region, which could be useful not only for interfacing the optical fiber links with quantum memories and for increasing the photon detection efficiency, but also for classical demultiplexing of spatial modes that are otherwise difficult to discriminate in both spatial and spatial-frequency domains. We consider two approaches: first, based on sum-frequency generation (SFG) in 2D free space, and second, based on SFG in a multimode waveguide with 2D confinement. For the latter approach, we find that under proper quasi-phase-matching arrangement, several different pairs of signal and pump modes are converted to the same SFG mode. By adjusting the relative phases and magnitudes of the pump modes, any superposition of the corresponding signal modes can be selected for up-conversion without affecting other modes.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 7, 2015•6 citations

Mode-selective frequency up-conversion in a χ(2)waveguide

Young Bong Kwon, Michael Vasilyev

We study sum-frequency generation (SFG) in a multimode PPKTP waveguide. We show that under proper quasi-phasematching, it can support one of the two scenarios. In the first, a single pump mode up-converts several different signal modes to different SFG modes. In the second, several different pairs of signal and pump modes are converted to the same SFG mode. By adjusting the relative phases and magnitudes of the pump modes, any superposition of the corresponding signal modes can be selected for up-conversion without affecting other modes, which can be used for spatial-mode de-multiplexing in both classical and quantum communications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 20, 2014•6 citations

Frequency up-conversion at the single-photon level in a periodically-poled lithium-niobate waveguide

Sarah Dugan, X. Li, Paul L. Voss +1 more

Using sum-frequency generation we fully up-convert signal photons at 1550 nm to 775 nm. Due to coupling and filtering losses at the output, overall quantum efficiency is /spl sime/3.4% with dark-count probability of 3%.

Quantum Electronics and Laser Science Conference•Dec 10, 2005•2 citations
Spatial-mode-selective frequency conversion is potentially useful for both classical and quantum communication applications. By a judicious choice of the quasi-phase-matching period in a Kai(2) multimode waveguide, such conversion can be achieved with high efficiency (close to 100%) and with low crosstalk (< -20 dB). For space-division multiplexing application with classical signals, where each spatial mode represents a separate signal channel, the selective conversion of a spatial mode without disrupting other signal modes can be used for reconfigurable spatial-mode de-multiplexing. This classical de-multiplexing capability can be also extended to the quantum regime, where the quantum state of the signal is preserved during frequency conversion, owing to the unitary nature of the sum-frequency generation (SFG) process. Building upon our previous experimental demonstration of the classical spatial-mode-selective frequency up-conversion in a two-mode PPLN waveguide, here we report the extension of this work into the single-photon-level regime. The signal (1540 nm) in either a single mode (TM00 or TM01) or a superimposition mode (TM00+TM01, TM00+iTM01) of the waveguide is selectively up-converted into TM01 SFG mode, by interacting with an appropriate pump mode (1560 nm). An accurate measurement of the single-photon-level SFG signals requires thorough filtering of the unwanted photons contributed by the second harmonic of the pump, residual pump noise extending to the signal band, and the Raman noise generated in the waveguide. We have investigated these unwanted photon sources and suppressed them by a combination of thin-film-interference and volume-Bragg-grating filters. Resulting single-photon-counting measurements show >70% internal conversion efficiency, better than -12dB crosstalk, and >100 ratio of the signal to background photon counts for all selected modes and mode superpositions.
We demonstrate channel-selective frequency up-conversion from telecom wavelengths around 1540 nm for optical fiber communication to visible wavelengths around 780 nm, based on second-order optical nonlinearity in a cavity of the converted modes. In our experiment, we selectively convert a light from any frequency mode within frequency-multiplexed telecom signals to a desired output mode, determined by the cavity resonances. Based on the experimental results of the frequency up-conversion, we derive the signal-to-noise ratio of the process at the single-photon level, and discuss its applicability to channel-selective quantum frequency conversion (CS-QFC) in the context of frequency-multiplexed quantum networks. Finally, we describe specific use cases of the CS-QFC, which show its utility as a reconfigurable switching element in frequency-multiplexed networks, particularly for selectively performing Bell-state measurements between two photons originating from different frequencies.
We investigate spatial-mode-selective frequency up-converters of quantum states from infrared to visible region, which could be useful not only for interfacing the optical fiber links with quantum memories and for increasing the photon detection efficiency, but also for classical demultiplexing of spatial modes that are otherwise difficult to discriminate in both spatial and spatial-frequency domains. We consider two approaches: first, based on sum-frequency generation (SFG) in 2D free space, and second, based on SFG in a multimode waveguide with 2D confinement. For the latter approach, we find that under proper quasi-phase-matching arrangement, several different pairs of signal and pump modes are converted to the same SFG mode. By adjusting the relative phases and magnitudes of the pump modes, any superposition of the corresponding signal modes can be selected for up-conversion without affecting other modes.
We study sum-frequency generation (SFG) in a multimode PPKTP waveguide. We show that under proper quasi-phasematching, it can support one of the two scenarios. In the first, a single pump mode up-converts several different signal modes to different SFG modes. In the second, several different pairs of signal and pump modes are converted to the same SFG mode. By adjusting the relative phases and magnitudes of the pump modes, any superposition of the corresponding signal modes can be selected for up-conversion without affecting other modes, which can be used for spatial-mode de-multiplexing in both classical and quantum communications.