Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Low Temperature Physics

From single SQUID to superconducting quantum arrays

Victor K. Kornev, Nikolay V. Kolotinskiy, Aleksei Sharafiev, Igor I. Soloviev, Oleg A. Mukhanov

Published Jul 1, 2017• 10 citations
Publisher

Abstract

Superconducting quantum arrays (SQAs) capable of providing highly linear voltage response to magnetic signal and high dynamic range have been suggested and developed. Base elements of the arrays, quantum cells, were devised and studied in detail. Using niobium process, SQAs with different number of the cells and prototypes of the SQA-based broadband active electrically small antennas were fabricated and tested.

DOI
10.1063/1.4995632

Related papers

Superconducting Quantum Arrays for Broadband RF Systems

Victor K. Kornev, Aleksei Sharafiev, Igor I. Soloviev +2 more

Superconducting Quantum Arrays (SQAs), homogenous arrays of Superconducting Quantum Cells, are developed for implementation of broadband radio frequency (RF) systems capable of providing highly linear magnetic signal to voltage transfer with high dynamic range, including active electrically small antennas (ESAs). Among the proposed quantum cells which are bi-SQUID and Differential Quantum Cell (DQC), the latter delivered better performance for SQAs. A prototype of the transformer-less active ESA based on a 2D SQA with nonsuperconducting electric connection of the DQCs was fabricated using HYPRES niobium process with critical current density 4.5 kA/cm 2 . The measured voltage response is characterized by a peak-to-peak swing of ~100 mV and steepness of ~6500 μV/μT.

Journal of Physics Conference Series•May 12, 2014•3 citations

Superconducting Quantum Arrays

Victor K. Kornev, Aleksei Sharafiev, Igor I. Soloviev +3 more

Superconducting Quantum Arrays (SQAs) based on integration of quantum cells each consisting of two Josephson-junction parallel arrays [Differential Quantum Cell (DQC)] are analyzed for applications in broadband radio frequency systems. These SQAs are capable of providing highly linear magnetic signal to voltage transfer with high dynamic range. Both detail study of the quantum cells with realistic parameters and analysis of their characteristics, including voltage response linearity, are presented and discussed. A prototype of an active electrically small antenna is implemented based on an SQA containing 560 DQCs. We demonstrated the SQA voltage response swing as high as ~ 100 mV at a transfer factor of ~ 6.5 mV/μT.

IEEE Transactions on Applied Superconductivity•Apr 17, 2014•33 citations

Active Superconducting Electrically Small Antennas: Design Issues of Basic Cells

Nikolay V. Kolotinskiy, Daniil E. Bazulin, Victor K. Kornev

We discuss design issues and present Nb-based layout designs of two basic cells for broadband active electrically small antennas based on superconducting quantum arrays. The cells are the differential array circuit and bi-SQUID. The cell layouts realize parameter values answering results of the in-depth theoretical analysis performed earlier for attaining the high-linearity voltage response to magnetic signal. The layouts are to give reference approaches to the antenna circuit designs to be fabricated using niobium process.

IEEE Transactions on Applied Superconductivity•Jan 29, 2021•2 citations

Superconducting Quantum Arrays for broadband RF systems

Victor K. Kornev, Aleksei Sharafiev, Igor I. Soloviev +1 more

Superconductive Quantum Arrays (SQA) are suggested for the implementation of broadband radio frequency systems capable of providing highly linear magnetic signal to voltage transfer with high dynamic range. Possible basic cells of the arrays and their attainable characteristics are considered. Results of experimental studies and possible applications are presented and discussed.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•5 citations

Broadband active electrically small superconductor antennas

Victor K. Kornev, Nikolay V. Kolotinskiy, Aleksei Sharafiev +2 more

Abstract A new type of broadband active electrically small antenna (ESA) based on superconducting quantum arrays (SQAs) has been proposed and developed. These antennas are capable of providing both sensing and amplification of broadband electromagnetic signals with a very high spurious-free dynamic range (SFDR)—up to 100 dB (and even more)—with high sensitivity. The frequency band can range up to tens of gigahertz, depending on Josephson junction characteristic frequency, set by fabrication. In this paper we review theoretical and experimental studies of SQAs and SQA-based antenna prototypes of both transformer and transformer-less types. The ESA prototypes evaluated were fabricated using a standard Nb process with critical current density 4.5 kA cm −2 . Measured device characteristics, design issues and comparative analysis of various ESA types, as well as requirements for interfaces, are reviewed and discussed.

Superconductor Science and Technology•Jun 19, 2017•24 citations

Output Power and Loading of Superconducting Quantum Array

Victor K. Kornev, Nikolay V. Kolotinskiy, Vitaly A. Skripka +2 more

Using numerical simulation, we investigate the output power and loading tradeoffs for Superconducting Quantum Arrays (SQAs) suggested for the implementation of broadband radio-frequency systems, including active electrically small antennas capable of providing highly linear transfer characteristics with a high dynamic range. Standard matching loads used for linear microwave networks, including passive antennas, are not applicable for the active SQA-based circuits generally due to the strong shunting effect restricting the attainable linearity. At the same time, the output power of an active device can be increased by a power supply even for the impedance-mismatched circuits. Both the optimum achievable balance of the shunt effects and getting the required output power are analyzed and discussed in detail.

IEEE Transactions on Applied Superconductivity•Nov 20, 2014•23 citations
Superconducting quantum arrays (SQAs) capable of providing highly linear voltage response to magnetic signal and high dynamic range have been suggested and developed. Base elements of the arrays, quantum cells, were devised and studied in detail. Using niobium process, SQAs with different number of the cells and prototypes of the SQA-based broadband active electrically small antennas were fabricated and tested.
Superconducting Quantum Arrays (SQAs), homogenous arrays of Superconducting Quantum Cells, are developed for implementation of broadband radio frequency (RF) systems capable of providing highly linear magnetic signal to voltage transfer with high dynamic range, including active electrically small antennas (ESAs). Among the proposed quantum cells which are bi-SQUID and Differential Quantum Cell (DQC), the latter delivered better performance for SQAs. A prototype of the transformer-less active ESA based on a 2D SQA with nonsuperconducting electric connection of the DQCs was fabricated using HYPRES niobium process with critical current density 4.5 kA/cm 2 . The measured voltage response is characterized by a peak-to-peak swing of ~100 mV and steepness of ~6500 μV/μT.
Superconducting Quantum Arrays (SQAs) based on integration of quantum cells each consisting of two Josephson-junction parallel arrays [Differential Quantum Cell (DQC)] are analyzed for applications in broadband radio frequency systems. These SQAs are capable of providing highly linear magnetic signal to voltage transfer with high dynamic range. Both detail study of the quantum cells with realistic parameters and analysis of their characteristics, including voltage response linearity, are presented and discussed. A prototype of an active electrically small antenna is implemented based on an SQA containing 560 DQCs. We demonstrated the SQA voltage response swing as high as ~ 100 mV at a transfer factor of ~ 6.5 mV/μT.
We discuss design issues and present Nb-based layout designs of two basic cells for broadband active electrically small antennas based on superconducting quantum arrays. The cells are the differential array circuit and bi-SQUID. The cell layouts realize parameter values answering results of the in-depth theoretical analysis performed earlier for attaining the high-linearity voltage response to magnetic signal. The layouts are to give reference approaches to the antenna circuit designs to be fabricated using niobium process.
Abstract A new type of broadband active electrically small antenna (ESA) based on superconducting quantum arrays (SQAs) has been proposed and developed. These antennas are capable of providing both sensing and amplification of broadband electromagnetic signals with a very high spurious-free dynamic range (SFDR)—up to 100 dB (and even more)—with high sensitivity. The frequency band can range up to tens of gigahertz, depending on Josephson junction characteristic frequency, set by fabrication. In this paper we review theoretical and experimental studies of SQAs and SQA-based antenna prototypes of both transformer and transformer-less types. The ESA prototypes evaluated were fabricated using a standard Nb process with critical current density 4.5 kA cm −2 . Measured device characteristics, design issues and comparative analysis of various ESA types, as well as requirements for interfaces, are reviewed and discussed.
Using numerical simulation, we investigate the output power and loading tradeoffs for Superconducting Quantum Arrays (SQAs) suggested for the implementation of broadband radio-frequency systems, including active electrically small antennas capable of providing highly linear transfer characteristics with a high dynamic range. Standard matching loads used for linear microwave networks, including passive antennas, are not applicable for the active SQA-based circuits generally due to the strong shunting effect restricting the attainable linearity. At the same time, the output power of an active device can be increased by a power supply even for the impedance-mismatched circuits. Both the optimum achievable balance of the shunt effects and getting the required output power are analyzed and discussed in detail.