Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frequenz

Intensity Reflection Coefficient Based Min-Sum Decoding for Low Density Parity Check Codes

Mohammad Rakibul Islam, Khandaker Sultan Mahmood, Md Farhan Tasnim Oshim, Md. Moshiur Rahman Farazi

Published Jan 30, 2012• 2 citations
Publisher

Abstract

Abstract Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon’s limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a factor, intensity reflection coefficient (IRC),

DOI
10.1515/freq-2012-0043

Related papers

Intensity reflection coefficient based Min-Sum decoding for Low Density Parity Check Codes

Md. Moshiur Rahman Farazi, Mohammad Rakibul Islam, Khandaker Sultan Mahmood +1 more

Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon's limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a factor, intensity reflection coefficient (IRC) in the check to bit node updating process. Simulation results demonstrate that the proposed algorithms are effective in imparting a better performance in terms of a lower bit error rate (BER) at low to medium signal to noise ratio (SNR) when compared to the traditional MS or Belief Propagation (BP) algorithm while adding a minimum amount of complexity.

International Conference on Advanced Communication Technology•Jan 1, 2012•1 citation

Difference to sum ratio factor based min-sum decoding for Low Density Parity Check Codes

Mohammad Rakibul Islam, Khandaker Sultan Mahmood, Md. Moshiur Rahman Farazi +3 more

Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon's limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a difference to sum ratio factor, κ in the check to bit node updating process. The algorithm is further extended by implementing hard decision of the Bit-Flipping (BF) algorithm over the soft decision of MS algorithm. Simulation results demonstrate that the proposed algorithms are effective in imparting a better performance in terms of a lower bit error rate (BER) at medium to high signal to noise ratio (SNR) when compared to the traditional MS algorithm while adding fair amount of complexity.

Computing, Communications and IoT Applications (ComComAp)•Jan 1, 2012•1 citation

Optimized Min-Sum Decoding Algorithm for Low Density Parity Check Codes

Mohammad Rakibul Islam, Dewan Siam Shafiullah, Muhammad Mostafa +2 more

Abstract ― Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.

•Oct 31, 2015•2 citations

Optimized Min-Sum Decoding Algorithm for Low Density Parity Check Codes

Mohammad Rakibul, Dewan Siam Shafiullah, Muhammad Mostafa +1 more

Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.

International Journal of Advanced Computer Science and Applications•Jan 1, 2011•19 citations

Optimized Min-Sum decoding algorithm for Low Density PC codes

Dewan Siam Shafiullah, Mohammad Rakibul Islam, Muhammad Mostafa Amir Faisal +1 more

Low Density Parity Check (LDPC) approaches Shannon -limit performance for binary field and long code lengths. However performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding, while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.

International Conference on Advanced Communication Technology•Jan 1, 2012•5 citations

Improved LDPC decoding algorithms based on min-sum algorithm

Y.V. A. C. Kumara, Chandika Bandara Wavegedara

Low-Density Parity check (LDPC) codes offer high-performance error correction near the Shannon limit which employs large code lengths and some iterations in the decoding process. The conventional decoding algorithm of LDPC is the Log Likelihood Ratio based Belief Propagation (LLR BP) which is also known as the `Sum-Product algorithm' which gives the best decoding performance and requires the most computational complexity and implementations with increased hardware complexity. Another simpler variant of this algorithm is used which is known as `min-sum algorithm' which reduces computational complexity as well as hardware complexity but with reduced accuracy. This paper analyzes the reason min-sum algorithm is more prone to errors when compared to the sum-product algorithm, and puts forward two improved algorithms which improve the performance of the min-sum algorithm with comparable algorithmic complexity.

Moratuwa Engineering Research Conference (MERCon)•Apr 1, 2016•8 citations
Abstract Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon’s limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a factor, intensity reflection coefficient (IRC),
Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon's limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a factor, intensity reflection coefficient (IRC) in the check to bit node updating process. Simulation results demonstrate that the proposed algorithms are effective in imparting a better performance in terms of a lower bit error rate (BER) at low to medium signal to noise ratio (SNR) when compared to the traditional MS or Belief Propagation (BP) algorithm while adding a minimum amount of complexity.
Low Density Parity Check Codes (LDPC) give groundbreaking performance which is known to approach Shannon's limits for sufficiently large block length. Historically and recently, LDPC have been known to give superior performance than concatenated coding. In the following paper, a proposal to modify the standard Min-Sum (MS) algorithm for decoding LDPC codes is presented. This is done by introduction of a difference to sum ratio factor, κ in the check to bit node updating process. The algorithm is further extended by implementing hard decision of the Bit-Flipping (BF) algorithm over the soft decision of MS algorithm. Simulation results demonstrate that the proposed algorithms are effective in imparting a better performance in terms of a lower bit error rate (BER) at medium to high signal to noise ratio (SNR) when compared to the traditional MS algorithm while adding fair amount of complexity.
Abstract ― Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.
Low Density Parity Check (LDPC) code approaches Shannon–limit performance for binary field and long code lengths. However, performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods, an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program, and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.
Low Density Parity Check (LDPC) approaches Shannon -limit performance for binary field and long code lengths. However performance of binary LDPC code is degraded when the code word length is small. An optimized min-sum algorithm for LDPC code is proposed in this paper. In this algorithm unlike other decoding methods an optimization factor has been introduced in both check node and bit node of the Min-sum algorithm. The optimization factor is obtained before decoding program and the same factor is multiplied twice in one cycle. So the increased complexity is fairly low. Simulation results show that the proposed Optimized Min-Sum decoding algorithm performs very close to the Sum-Product decoding, while preserving the main features of the Min-Sum decoding, that is low complexity and independence with respect to noise variance estimation errors.
Low-Density Parity check (LDPC) codes offer high-performance error correction near the Shannon limit which employs large code lengths and some iterations in the decoding process. The conventional decoding algorithm of LDPC is the Log Likelihood Ratio based Belief Propagation (LLR BP) which is also known as the `Sum-Product algorithm' which gives the best decoding performance and requires the most computational complexity and implementations with increased hardware complexity. Another simpler variant of this algorithm is used which is known as `min-sum algorithm' which reduces computational complexity as well as hardware complexity but with reduced accuracy. This paper analyzes the reason min-sum algorithm is more prone to errors when compared to the sum-product algorithm, and puts forward two improved algorithms which improve the performance of the min-sum algorithm with comparable algorithmic complexity.