Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer eBooks

A Low Frequency Squeezed State Source

Bernard Yurke, John S. Denker

Published Jan 1, 1984• 0 citations
Publisher
DOI
10.1007/978-1-4757-0605-5_176

Related papers

A four-wave-mixing source of low-frequency squeezed light

Colin F. McCormick, Vincent Boyer, E. Arimondo +1 more

APS•Mar 1, 2007•0 citations

Generation of a Low-frequency Squeezed States at Telecommunication Wavelength

要立婷 YAO Li-ting, 冯晋霞 Feng Jinxia, 高英豪 GAO Ying-hao +1 more

Acta Sinica Quantum Optica•Jan 1, 2017•2 citations

Advanced techniques for squeezed-light-enhanced gravitational-wave detection

J. Gniesmer

Quantum noise is one of the limiting factors in laser-interferometric gravitational-wave (GW) detectors. The application of squeezed states in these interferometers allows the reduction of quantum noise in one quadrature. Due to opto-mechanical coupling in a GW detector the squeezed quadrature needs to be rotated within the spectrum to achieve a broadband noise reduction. So far, the implementation of additional filter cavities is considered that allow for the optimal, frequency-dependent rotation of the squeezed quadrature. However, these cavities need to have low loss, a length in the order of \unit[100]{m} and must be situated in the vacuum system, making them cost-intensive. In 2017, Ma and coworkers proposed a scheme for the broadband quantum-noise reduction without the need of additional filter cavities. It was shown by Brown et al. that a similar scheme can be used to broadband-enhance interferometers with a detuned signal-recycling cavity. Here, we performed a proof-of-principle experiment of the proposal on a table-top-scale. Squeezed states were produced detuned to the carrier field of a \unit[2.5]{m}-linear cavity and read out in a bichromatic homodyne detection. The frequencies of the lower and upper local oscillator were at entangled sidebands of the squeezed field. Depending on the relations between the involved frequencies, we can address both variants of the proposal. We show, that the frequency-dependences of the resulting noise spectra fit to a theoretical model we derived from the theory used by Ma et al. With this work we set the path towards an implementation of these schemes in a GW-detector prototype, where the compatibility of the approach with a low-frequency suspended interferometer can be tested. Moreover, we used the same setup to show nonclassical interferometer enhancement at low frequencies by high-frequency squeezed states. Here, a heterodyne readout scheme was implemented to avoid limiting noises at low frequencies. The application of squeezed states centered around the local oscillator frequency yielded an improvement in signal-to-noise ratio of $\unit[3.4]{dB}\pm\unit[0.3]{dB}$. Additionally, I designed, built and characterized a compact source of squeezed vacuum-states at \unit[1064]{nm} with a footprint of just $\unit[0.8]{m^2}$. I show measurements of squeezed states from this source with a reduction of quantum noise of $\unit[10.7]{dB}\pm\unit[0.2]{dB}$ below the vacuum noise and present a noise reduction in the frequency range from \unit[70]{kHz} to \unit[65]{MHz}.

•Jan 1, 2019•0 citations

An Integrated Source of Pure Single Mode Squeezing

Edward C. R. Deacon, Alexandre Maïnos, Jacob F. F. Bulmer +3 more

Springer proceedings in physics•Jan 1, 2026•0 citations

Towards Low-frequency Squeezed Light and Its Applications with Four-wave Mixing in Rubidium Vapor

Meng-Chang Wu

We study a variety of mechanisms that introduce noise into squeezed light generated by a four-wave mixing (4WM) process in Rb vapor. The noise from the seeding beam itself is a general noise that appears in any squeezed light generated from a seeding process. This noise dominates in the squeezed light at acoustic and lower measurement frequencies. A second excess noise source is observed in the twin beams pumped by either a diode laser system or a Ti:sapphire laser system. This excess noise is much stronger in the diode laser systems. It is present in the twin beams at measurement frequencies when the 4WM gain is reduced toward unity. Most of this excess noise can be removed with a dual-seeded 4WM scheme. A third noise source we examine is from a two-beam coupling that degrades the squeezing of the dual-seeded 4WM process at low frequencies of the order of the atomic transition linewidth. This noise can be avoided by seeding skew rays in the 4WM gain region. This gives us an insight to solve this "cross talk" problem by imaging the source in the 4WM gain region. In addition to studying noise sources, we propose a gain-independent calibration scheme that relies on higher order correlation function for the absolute calibration of photodiodes. Having low frequency squeezing is really important if we record quantum images with a CCD camera, which has a slow shutter speed. Also, it's been very difficult for people to get low-frequency squeezing. We obtain a record level of low-frequency squeezing using a simple dual-seeding technique. With this study of noise sources we are closer to having a portable quantum light source using diode lasers.

•Jan 1, 2020•0 citations

General two-mode squeezed states

R. F. Bishop, Apostol Vourdas

The European Physical Journal B•Dec 1, 1988•39 citations
Quantum noise is one of the limiting factors in laser-interferometric gravitational-wave (GW) detectors. The application of squeezed states in these interferometers allows the reduction of quantum noise in one quadrature. Due to opto-mechanical coupling in a GW detector the squeezed quadrature needs to be rotated within the spectrum to achieve a broadband noise reduction. So far, the implementation of additional filter cavities is considered that allow for the optimal, frequency-dependent rotation of the squeezed quadrature. However, these cavities need to have low loss, a length in the order of \unit[100]{m} and must be situated in the vacuum system, making them cost-intensive. In 2017, Ma and coworkers proposed a scheme for the broadband quantum-noise reduction without the need of additional filter cavities. It was shown by Brown et al. that a similar scheme can be used to broadband-enhance interferometers with a detuned signal-recycling cavity. Here, we performed a proof-of-principle experiment of the proposal on a table-top-scale. Squeezed states were produced detuned to the carrier field of a \unit[2.5]{m}-linear cavity and read out in a bichromatic homodyne detection. The frequencies of the lower and upper local oscillator were at entangled sidebands of the squeezed field. Depending on the relations between the involved frequencies, we can address both variants of the proposal. We show, that the frequency-dependences of the resulting noise spectra fit to a theoretical model we derived from the theory used by Ma et al. With this work we set the path towards an implementation of these schemes in a GW-detector prototype, where the compatibility of the approach with a low-frequency suspended interferometer can be tested. Moreover, we used the same setup to show nonclassical interferometer enhancement at low frequencies by high-frequency squeezed states. Here, a heterodyne readout scheme was implemented to avoid limiting noises at low frequencies. The application of squeezed states centered around the local oscillator frequency yielded an improvement in signal-to-noise ratio of $\unit[3.4]{dB}\pm\unit[0.3]{dB}$. Additionally, I designed, built and characterized a compact source of squeezed vacuum-states at \unit[1064]{nm} with a footprint of just $\unit[0.8]{m^2}$. I show measurements of squeezed states from this source with a reduction of quantum noise of $\unit[10.7]{dB}\pm\unit[0.2]{dB}$ below the vacuum noise and present a noise reduction in the frequency range from \unit[70]{kHz} to \unit[65]{MHz}.
We study a variety of mechanisms that introduce noise into squeezed light generated by a four-wave mixing (4WM) process in Rb vapor. The noise from the seeding beam itself is a general noise that appears in any squeezed light generated from a seeding process. This noise dominates in the squeezed light at acoustic and lower measurement frequencies. A second excess noise source is observed in the twin beams pumped by either a diode laser system or a Ti:sapphire laser system. This excess noise is much stronger in the diode laser systems. It is present in the twin beams at measurement frequencies when the 4WM gain is reduced toward unity. Most of this excess noise can be removed with a dual-seeded 4WM scheme. A third noise source we examine is from a two-beam coupling that degrades the squeezing of the dual-seeded 4WM process at low frequencies of the order of the atomic transition linewidth. This noise can be avoided by seeding skew rays in the 4WM gain region. This gives us an insight to solve this "cross talk" problem by imaging the source in the 4WM gain region. In addition to studying noise sources, we propose a gain-independent calibration scheme that relies on higher order correlation function for the absolute calibration of photodiodes. Having low frequency squeezing is really important if we record quantum images with a CCD camera, which has a slow shutter speed. Also, it's been very difficult for people to get low-frequency squeezing. We obtain a record level of low-frequency squeezing using a simple dual-seeding technique. With this study of noise sources we are closer to having a portable quantum light source using diode lasers.