Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Microwares

Perturbation Simulation for Superconducting Submillimeter Array Oscillators

Guan Bo-ran

Published Jan 1, 2002• 0 citations
OpenAlex

Abstract

Josephson junction arrays have been thoroughly investigated as oscillators in the submillimeter wave regions in this paper. The basic principles of the Josephson junction arrays oscillators are discussed. According to these principles, the models of the oscillators and the results of numerical perturbation simulations are acquired. The simulation result shows that the junctions in the 2D array can mutually phase locked in a considerable area if the parameters can be carefully selected. This is essentially important for the successful applicabilities.

Related papers

Phase-locked one- and two-dimensional Josephson-junction arrays as millimeter and submillimeter wave generators

Victor K. Kornev, A.V. Arrmanov, A.D. Mashtakov +1 more

The results of numerical simulations of phase-locked 1D and 2D Josephson-junction arrays are reported. It is shown that the multi-junction structures with non-local junction interaction provide phase-locked oscillation state within wide critical current margins /spl Delta/I/sub c/ up to 40...50%. The effective non-local interaction in 2D structure based on 4-junction interferometer cell can be provided by the regular single flux quantum array flow across it. The wide tolerable spread in /spl Delta/I/sub c/ allows one to realize both (i) phase-locked 2D high-T/sub c/ Josephson-junction array with the oscillation frequency F close to characteristic value F/sub c/ and (ii) based on Nb tunnel Josephson-junction technology 1D array with the voltage-controlled phase-locked oscillation frequency within wide frequency band from 0.4 F/sub c/ to 1.2 F/sub c/.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•5 citations

Submillimeter wave generation using Josephson junction arrays

K. L. Wan, A. K. Jain, James E. Lukens

A submillimeter-wave oscillator using a phase-locked array of Josephson junctions is demonstrated. With an array of 40 shunted tunnel junctions, the oscillator delivers 1 mu W of power at 350 GHz into a 60- Omega load on the chip. The operating frequency of the oscillator is tunable over a range of about 10%. Experiments on two coupled lead alloy tunnel junctions show that Josephson oscillations exist to about 1 THz. Using a similar design and a higher gap superconductor such as NbN for the transmission lines, arrays operating at 1 THz with power outputs of 1 mW should be feasible.>

IEEE Transactions on Magnetics•Mar 1, 1989•25 citations

Dynamics of quasioptical Josephson junction arrays for submillimeter coherent sources

A. Pance, Michael J. Wengler

The dynamics of the quasi-optical two-dimensional Josephson junction arrays for oscillators is investigated. Numerical time-domain simulations of small-scale parallel arrays were performed. It is found that the DC biasing circuit determines the states of these arrays. It is also found that other states exist in which parts of the array operate in phase. The authors investigate the sensitivity of in-phase states to variations in junction critical currents and to nonvanishing fluctuations. It is found that the DC self-field effects do not provide a stable phase-locking mechanism and that RF interactions are necessary for locking the array in phase.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•5 citations

High frequency behaviour of coupled and uncoupled Josephson junctions based on high temperature superconductors

Jens Scherbel

Josephson junctions made from high temperature superconductors (HTS) are active high frequency devices which can be used as oscillators or frequency mixers in the submillimeter-wave region. The frequencies of these electromagnetic waves range from 300 GHz up to 3 THz. Up to now, this wave band is a relatively unexploited region of the electromagnetic spectrum because it is very difficult to produce and detect submillimeter-waves. However, submillimeter-wave technologies are becoming important in many practical scientific applications such as radio astronomy, atmospheric research, plasma diagnostics and THz-imaging, recently. In this work, the behaviour HTS Josephson junctions have been investigated experimentally and theoretically with the aim to THz-applications. In the first part the behaviour of intrinsic Josephson junction stacks are measured, and the possibility of phase locking is discussed by the theoretical analysis of two different shunt technologies depending on the parameter spread of the junction and the shunt parameters. It could be shown that stacks made from sputtered BSCCO layers does not act as intrinsic Josephson junction arrays because of their many micro shorts resulting from the layer growth. However, the stacks made from sputtered TBCCO show clear intrinsic Josephson junction behaviour. But their quasiparticle branches in the current-voltage characteristic deviate from the behaviour predicted by the common used RCSJ model. These branches can be discussed within a tunneling model using d-wave superconductor density of states. A temperature dependent current distribution and a zero bias anomaly was found. Furthermore, the coherent behaviour is studied for intrinsic arrays with additional side-wall shunts. The existence of thresholds of phase locking at especial junction and shunt parameters are demonstrated and discussed in regard to THz-oscillator applications. It was found that the Josephson junctions in a stack can be phase locked even if they have a parameter spread in the critical current up to 15% using a resonant shunt. In the second part of this work the mixing properties of HTS bicrystal Josephson junctions as wave guide mixers for 115 and 345 GHz have been investigated. (orig.)

•Jan 1, 2001•0 citations

Submillimeter-band high-power generation using multilayered Josephson junctions

Alexey Vladimirovich Ustinov, Shigeki Sakai

We report on numerical simulations of 10- and 19-layer stacked Josephson junctions. Simulations are performed using the experimentally feasible parameters for Nb/Al–AlOx/Nb junctions. With an appropriate choice of parameters such as magnetic field and coupling, the current–voltage curves of N-layer stacks systematically indicate in-phase locking among the inner N−2 junctions. The simulation results suggest that multilayer Josephson junctions are very promising as submillimeter-band high-power oscillators.

Applied Physics Letters•Aug 3, 1998•57 citations

Quasioptical Josephson oscillator

Michael J. Wengler, A. Pance, B. Liu +1 more

Work with large two-dimensional arrays of Josephson junctions for submillimeter power generation is discussed. The basic design of the quasioptical Josephson oscillator (QJO) is presented. The reasons for each design decision are discussed. Superconducting devices have not yet been fabricated, but scale models and computer simulations have been done. A novel method for characterizing array RF coupling structures is described, and initial results with this model are presented. Microwave scale models of the radiation structure were built, and a series of measurements was made with a network analyzer. These measurements were summed in a computer to find properties of the structure when all elements in it are operating in phase. The goal of these measurements was to develop structures for oscillators which are tunable over a very broad band. Computer programs simulating a Josephson junction in any frequency-dependent coupling structure have been developed. An iterative harmonic balance technique finds the time-domain current and voltage waveforms across the junction for an arbitrary frequency-dependent RF load impedance. DC bias, and therefore oscillator frequency, can be held fixed in this technique, in contrast to time-domain techniques where the oscillation frequency is found after the waveform is found. With these programs design goals for maximum oscillator power and design limits to achieve tolerable harmonic distortion were found.

IEEE Transactions on Magnetics•Mar 1, 1991•18 citations
Josephson junction arrays have been thoroughly investigated as oscillators in the submillimeter wave regions in this paper. The basic principles of the Josephson junction arrays oscillators are discussed. According to these principles, the models of the oscillators and the results of numerical perturbation simulations are acquired. The simulation result shows that the junctions in the 2D array can mutually phase locked in a considerable area if the parameters can be carefully selected. This is essentially important for the successful applicabilities.
The results of numerical simulations of phase-locked 1D and 2D Josephson-junction arrays are reported. It is shown that the multi-junction structures with non-local junction interaction provide phase-locked oscillation state within wide critical current margins /spl Delta/I/sub c/ up to 40...50%. The effective non-local interaction in 2D structure based on 4-junction interferometer cell can be provided by the regular single flux quantum array flow across it. The wide tolerable spread in /spl Delta/I/sub c/ allows one to realize both (i) phase-locked 2D high-T/sub c/ Josephson-junction array with the oscillation frequency F close to characteristic value F/sub c/ and (ii) based on Nb tunnel Josephson-junction technology 1D array with the voltage-controlled phase-locked oscillation frequency within wide frequency band from 0.4 F/sub c/ to 1.2 F/sub c/.
A submillimeter-wave oscillator using a phase-locked array of Josephson junctions is demonstrated. With an array of 40 shunted tunnel junctions, the oscillator delivers 1 mu W of power at 350 GHz into a 60- Omega load on the chip. The operating frequency of the oscillator is tunable over a range of about 10%. Experiments on two coupled lead alloy tunnel junctions show that Josephson oscillations exist to about 1 THz. Using a similar design and a higher gap superconductor such as NbN for the transmission lines, arrays operating at 1 THz with power outputs of 1 mW should be feasible.>
The dynamics of the quasi-optical two-dimensional Josephson junction arrays for oscillators is investigated. Numerical time-domain simulations of small-scale parallel arrays were performed. It is found that the DC biasing circuit determines the states of these arrays. It is also found that other states exist in which parts of the array operate in phase. The authors investigate the sensitivity of in-phase states to variations in junction critical currents and to nonvanishing fluctuations. It is found that the DC self-field effects do not provide a stable phase-locking mechanism and that RF interactions are necessary for locking the array in phase.>
Josephson junctions made from high temperature superconductors (HTS) are active high frequency devices which can be used as oscillators or frequency mixers in the submillimeter-wave region. The frequencies of these electromagnetic waves range from 300 GHz up to 3 THz. Up to now, this wave band is a relatively unexploited region of the electromagnetic spectrum because it is very difficult to produce and detect submillimeter-waves. However, submillimeter-wave technologies are becoming important in many practical scientific applications such as radio astronomy, atmospheric research, plasma diagnostics and THz-imaging, recently. In this work, the behaviour HTS Josephson junctions have been investigated experimentally and theoretically with the aim to THz-applications. In the first part the behaviour of intrinsic Josephson junction stacks are measured, and the possibility of phase locking is discussed by the theoretical analysis of two different shunt technologies depending on the parameter spread of the junction and the shunt parameters. It could be shown that stacks made from sputtered BSCCO layers does not act as intrinsic Josephson junction arrays because of their many micro shorts resulting from the layer growth. However, the stacks made from sputtered TBCCO show clear intrinsic Josephson junction behaviour. But their quasiparticle branches in the current-voltage characteristic deviate from the behaviour predicted by the common used RCSJ model. These branches can be discussed within a tunneling model using d-wave superconductor density of states. A temperature dependent current distribution and a zero bias anomaly was found. Furthermore, the coherent behaviour is studied for intrinsic arrays with additional side-wall shunts. The existence of thresholds of phase locking at especial junction and shunt parameters are demonstrated and discussed in regard to THz-oscillator applications. It was found that the Josephson junctions in a stack can be phase locked even if they have a parameter spread in the critical current up to 15% using a resonant shunt. In the second part of this work the mixing properties of HTS bicrystal Josephson junctions as wave guide mixers for 115 and 345 GHz have been investigated. (orig.)
We report on numerical simulations of 10- and 19-layer stacked Josephson junctions. Simulations are performed using the experimentally feasible parameters for Nb/Al–AlOx/Nb junctions. With an appropriate choice of parameters such as magnetic field and coupling, the current–voltage curves of N-layer stacks systematically indicate in-phase locking among the inner N−2 junctions. The simulation results suggest that multilayer Josephson junctions are very promising as submillimeter-band high-power oscillators.
Work with large two-dimensional arrays of Josephson junctions for submillimeter power generation is discussed. The basic design of the quasioptical Josephson oscillator (QJO) is presented. The reasons for each design decision are discussed. Superconducting devices have not yet been fabricated, but scale models and computer simulations have been done. A novel method for characterizing array RF coupling structures is described, and initial results with this model are presented. Microwave scale models of the radiation structure were built, and a series of measurements was made with a network analyzer. These measurements were summed in a computer to find properties of the structure when all elements in it are operating in phase. The goal of these measurements was to develop structures for oscillators which are tunable over a very broad band. Computer programs simulating a Josephson junction in any frequency-dependent coupling structure have been developed. An iterative harmonic balance technique finds the time-domain current and voltage waveforms across the junction for an arbitrary frequency-dependent RF load impedance. DC bias, and therefore oscillator frequency, can be held fixed in this technique, in contrast to time-domain techniques where the oscillation frequency is found after the waveform is found. With these programs design goals for maximum oscillator power and design limits to achieve tolerable harmonic distortion were found.