Due to its near-optimum decoding for low-density parity check (LDPC) codes and turbo codes, the belief propagation (BP) algorithm has recently received a lot of attention in the coding community. In this paper, the iterative decoding of complex-rotary codes (CRC) based on the belief propagation is researched. The decoding performance of CRC is as good as those of the finite geometry codes and the difference set cyclic codes. A modest performance gain is made over the low density parity check codes with similar parameters. Two new low complexity algorithms for decoding complex-rotary codes are developed. The complexity of the new algorithms is remarkably low in comparison with the BP algorithm.
Due to its near-optimum decoding for low-density parity check (LDPC) codes and turbo codes, the belief propagation (BP) algorithm has recently received a lot of attention in the coding community. In this paper, the iterative decoding of complex-rotary codes (CRC) based on the belief propagation is researched. The decoding performance of CRC is as good as those of the finite geometry codes and the difference set cyclic codes. A modest performance gain is made over the low density parity check codes with similar parameters. Two new low complexity algorithms for decoding complex-rotary codes are developed. The complexity of the new algorithms is remarkably low in comparison with the BP algorithm.
In modern communication systems, the concatenation of a low-density parity-check (LDPC) code with a cyclic redundancy check (CRC) code is commonly used for error correction. In this paper, we propose a low-complexity two-stage scheme for decoding these codes using their concatenation structures. In the first stage, the traditional belief propagation (BP)-based iterative algorithm with a relative small maximum number of iterations is performed for decoding the LDPC code. If an LDPC codeword is obtained in this stage, the decoding process terminates. Otherwise, the second stage of the decoding process is performed, in which the guessing random additive noise decoding (GRAND) algorithm is applied to the CRC code. A list of information sequences satisfying the CRC check is obtained, each of which is then encoded to an LDPC codeword. The most likely codeword among them is the output of the decoding approach. The simulation results indicate that the proposed two-stage decoding approach can outperform the traditional BP-based iterative algorithm with a large maximum number of iterations. Moreover, the average complexity of the proposed approach is relatively low.
At the heart of modern coding theory lies the fact that low-density parity-check (LDPC) codes can be efficiently decoded by belief propagation (BP). The BP is an inference algorithm which operates on a graphical model of a code, and lends itself to low-complexity and high-speed implementations, making it the algorithm of choice in many applications. It has unprecedentedly good error rate performance, so good that when decoded by the BP, LDPC codes approach theoretical limits of channel capacity. However, this capacity approaching property holds only in the asymptotic limit of code length, while codes of practical lengths suffer abrupt performance degradation in the low noise regime known as the error floor phenomenon. Our study of error floor has led to an interesting and surprising finding that it is possible to design iterative decoders which are much simpler yet better than belief propagation! These decoders do not propagate beliefs but a rather different kind of messages that reflect the local structure of the code graph. This has opened a plethora of exciting theoretical problems and applications. This paper introduces this new paradigm.
Two simplified versions of the belief propagation algorithm for fast iterative decoding of low-density parity check codes on the additive white Gaussian noise channel are proposed. Both versions are implemented with real additions only, which greatly simplifies the decoding complexity of belief propagation in which products of probabilities have to be computed. Also, these two algorithms do not require any knowledge about the channel characteristics. Both algorithms yield a good performance-complexity trade-off and can be efficiently implemented in software as well as in hardware, with possibly quantized received values.
Previously, the belief propagation (BP) algorithm has received a lot of attention in the coding community, mostly due to its near-optimum decoding for low-density parity check (LDPC) codes and its connection to turbo decoding. In this paper, we investigate the performance achieved by the BP algorithm for decoding one-step majority logic decodable (OSMLD) codes. The BP algorithm is expressed in terms of likelihood ratios rather than probabilities, as conventionally presented. The proposed algorithm fits better the decoding of OSMLD codes with respect to its numerical stability due to the fact that the weights of their check sums are often much higher than that of the corresponding LDPC codes. Although it has been believed that OSMLD codes are far inferior to LDPC codes, we show that for medium code lengths (say between 200-1000 bits), the BP decoding of OSMLD codes can significantly outperform BP decoding of their equivalent LDPC codes. The reasons for this behavior are elaborated.
In this paper, reliability based decoding is combined with belief propagation (BP) decoding for low-density parity check (LDPC) codes. At each iteration, the soft output values delivered by the BP algorithm are used as reliability values to perform reduced complexity soft decision decoding of the code considered. This approach allows to bridge the error performance gap between belief propagation decoding which remains suboptimum, and maximum likelihood decoding which is too complex to be implemented for the codes considered. Trade-offs between decoding complexity and error performance are also investigated. In particular, a stopping criterion which reduces the average number of iterations at the expense of very little performance degradation is proposed for this combined decoding approach. Simulation results for several Gallager (1963, 1968) LDPC codes and different set cyclic codes of hundreds of information bits are given and elaborated.
Iterative decoding techniques have been receiving more and more attentions with the invention of turbo codes and the rediscovery of low-density parity-check (LDPC) codes. An important aspect in the study of iterative decoding is the tradeoff between decoding performance and complexities. For both LDPC codes and turbo codes, optimum decoding algorithms can provide very good performance. However, complicated operations are involved in the optimum decoding, and prohibit the wide applications of LDPC codes and turbo codes in the next generation digital communication and storage systems. Although there exist sub-optimum decoding algorithms for both LDPC codes and turbo codes, the decoding performance is degraded with the sub-optimum algorithms, and under some circumstances, the gap is very large. This research investigates the reduced complexity decoding algorithms of LDPC codes and turbo codes. For decoding LDPC codes, new algorithms, namely the normalized BP-based algorithm and the offset BP-based algorithm, are proposed. For these two reduced complexity algorithms, density evolution algorithms are derived, and are used to determine the best decoder parameters associated with each of the algorithms. Numerical results show that the new algorithms can achieve near optimum decoding performances for infinite code lengths, and simulation results reveal the same conclusion for short to medium code lengths. In addition to the advantage of low computational complexities, the two new algorithms are less subject to quantization errors and correlation effects than the optimum BP algorithm, and consequently are more suitable for hardware implementation. For a special kind of LDPC codes - the geometric LDPC codes, we propose the normalized APP-based algorithm, which is even more simplified yet still can achieve the near optimum performance. For decoding turbo codes, two new sub-optimum decoding algorithms are proposed. The first is the bi-directional soft-output Viterbi algorithm (bi-SOVA), which is based on utilizing a backward SOYA decoding in addition to the conventional forward one, and can achieve better performance than the uni-directional SOYA. The second is the normalized Max-Log-MAP algorithm, which improves the performance of the Max-Log-MAP decoding by scaling the soft outputs with some predetermined factors.