Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Optics

Linear optical quantum memory

Jonathan P. Dowling, Hwang Lee, Farrokh Vatan, Pieter Kok, Robert M. Gingrich

Published Jan 1, 2003• 0 citations
Publisher

Abstract

In quantum computing a very important problem is that of building a quantum memory. We show that by using new techniques from scalable linear optical quantum computing (LOQC), it is possible to make an all linear-optical quantum memory capable of storing the computational qubit indefinitely. The same approach can be used to make a simple quantum repeater. Recent work by our group has shown how linear optical quantum computing ideas, recently proposed by Knill, Laflamme, and Milburn, and also by Franson and co-workers, can be used to make a scalable quantum repeater [1]. However, this repeater still requires a quantum memory to operate, which apparently requires resources other than those required for linear optical quantum computing. In this presentation, we will explicitly show how to construct a quantum memory using only LOQC resources and employing a simple error correction code for photon loss. The result is a simple, scalable, quantum memory. The device can also be operated as a quantum repeater that is far simpler than our original proposal to implement.

DOI
10.1364/fio.2003.thss3

Related papers

Loss tolerant linear optical quantum memory by measurement-based quantum computing

Michael Varnava, Dan E. Browne, Terry Rudolph

We give a scheme for loss tolerantly building a linear optical quantum memory which itself is tolerant to qubit loss. We use the encoding recently introduced in Varnava et al 2006 Phys. Rev. Lett. 97 120501, and give a method for efficiently achieving this. The entire approach resides within the 'one-way' model for quantum computing (Raussendorf and Briegel 2001 Phys. Rev. Lett. 86 5188–91; Raussendorf et al 2003 Phys. Rev. A 68 022312). Our results suggest that it is possible to build a loss tolerant quantum memory, such that if the requirement is to keep the data stored over arbitrarily long times then this is possible with only polynomially increasing resources and logarithmically increasing individual photon life-times.

arXiv:0705.1904•New Journal of Physics•Jun 29, 2007•26 citations

Quantum Logic Using Linear Optics

J. D. Franson, B. C. Jacobs, T. B. Pittman

In order for quantum communications systems to become widely used, it will probably be necessary to develop quantum repeaters that can extend the range of quantum key distribution systems and correct for errors in the transmission of quantum information. Quantum logic gates based on linear optical techniques appear to be a promising approach for the development of quantum repeaters, and they may have applications in quantum computing as well. Here we describe the basic principles of logic gates based on linear optics, along with the results from several experimental demonstrations of devices of this kind. A prototype source of single photons and a quantum memory device for photons are also discussed. These devices can be combined with a four-qubit encoding to implement a quantum repeater.

arXiv:quant-ph/0402097•Feb 15, 2004•0 citations

Quantum Logic Using Linear Optics

J. D. Franson, B. C. Jacobs, T. B. Pittman

In order for quantum communications systems to become widely used, it will probably be necessary to develop quantum repeaters that can extend the range of quantum key distribution systems and correct for errors in the transmission of quantum information. Quantum logic gates based on linear optical techniques appear to be a promising approach for the development of quantum repeaters, and they may have applications in quantum computing as well. Here we describe the basic principles of logic gates based on linear optics, along with the results from several experimental demonstrations of devices of this kind. A prototype source of single photons and a quantum memory device for photons are also discussed. These devices can be combined with a four-qubit encoding to implement a quantum repeater. 2 I.

•Feb 15, 2004•0 citations

Experimental Implementation of Efficient Linear Optics Quantum Computation

Gerard J Milburn, Timothy C. Ralph, Andrew G. White

One of the earliest proposals for implementing quantum computation was based on encoding each qubit in two optical modes, each containing exactly one photon. However, it is extremely difficult to unitarily couple two optical modes containing few photons. In 2001, Knill, Laflamme, and Milburn (KLM) found a way to circumvent this restriction and implement efficient quantum computation using only passive linear optics, photodetectors, and single photon sources. This efficient linear optical quantum computing (LOQC) is distinct from other linear optical schemes that are not efficiently scalable. The technological requirements for even the simplest gates in the KLM proposal initially seemed out of reach. However, Ralph, White, Munro and Milburn soon showed that, in principle, demonstrations of key gates and techniques could be achieved with current technology. The objective of the research undertaken in this project was to produce, in three years, a prototype two-qubit gate for photons using the KLM linear optics quantum computation approach, and to develop a blue-print for a multiple qubit device that might be implemented over a longer time scale. A non-deterministic two-qubit gate was demonstrated that operates with high fidelity. A number of key tasks were demonstrated using this gate, and several theoretical investigations of short, medium, and longer term issues for the LOQC approach were successfully completed.

•Nov 25, 2004•0 citations

Linear optical quantum computing with photonic qubits

Pieter Kok, William J. Munro, Kae Nemoto +3 more

Linear optics with photon counting is a prominent candidate for practical quantum computing. The protocol by Knill, Laflamme, and Milburn [2001, Nature (London) 409, 46] explicitly demonstrates that efficient scalable quantum computing with single photons, linear optical elements, and projective measurements is possible. Subsequently, several improvements on this protocol have started to bridge the gap between theoretical scalability and practical implementation. The original theory and its improvements are reviewed, and a few examples of experimental two-qubit gates are given. The use of realistic components, the errors they induce in the computation, and how these errors can be corrected is discussed.

arXiv:quant-ph/0512071•Reviews of Modern Physics•Jan 24, 2007•2,840 citations

Towards fault-tolerant linear optics quantum computing

A. G. Hayes

Quantum computing is an exciting field that promises great improvements to our ability to solve certain intractable classes of problem. Implementing a quantum computer will require a physical system in which quantum effects are strongly evident. Many different physical systems have been proposed for this task, including ion traps, quantum dots, neutral atoms and photons. This thesis focuses on optical implementations of a quantum computer, and specifically on single-photon designs, as opposed to those utilising coherent states. Photonic systems have shown a great deal of promise for quantum computing tasks since it was shown by Knill, Laflamme and Milburn (KLM) that scalable efficient quantum computing could be performed using only linear optical elements and measurement. This was made viable through the use of error-correcting codes. The work in this thesis covers the use of error-correcting codes in single-photon linear optics quantum computing (LOQC). The central feature of these schemes is the parity code introduced by KLM and used to overcome the gate errors that are inherent in this type of LOQC. First is a discussion of an improved scheme that incorporates the fusion gates used in Browne and Rudolph's cluster state proposal in order to simplify the encoding and gate procedures. This results in high-probability gates with a resource usage comparable to the cluster state schemes. The remainder of the thesis examines the application of further error correcting codes to handle other errors that may arise in any practical implementation of an optical quantum computer. The most significant type of error in any optical system is photon loss, and hence an extension of the parity code is presented that allows loss errors to be detected and corrected. Procedures for performing universal quantum computation whilst employing this encoding are also described. These enable the establishment of loss thresholds for parity-state based LOQC, revealing this code is capable of handling up to 10\% loss in all elements during general computation, or 17\% if it is used solely as an active memory. Although loss is the most common type of optical error, other types of error will also become an issue when attempting to produce large quantum computing systems. An analysis of the error thresholds and resource usage which can be expected when applying a general error correcting code such as the Steane code to this type of LOQC system is also presented. The error thresholds and resource requirements established are greater than those found for cat state optical quantum computing, but fall below those calculated for cluster states. However, the resource requirements of the scheme are significantly smaller than the cluster state requirements for an equivalent circuit. Finally, a new experiment is proposed, achievable with today's technology, for testing the loss-tolerant encoding described earlier. Expansions of the experiment that would demonstrate tolerance of actual experimental error are also discussed.

•Oct 1, 2010•0 citations
In quantum computing a very important problem is that of building a quantum memory. We show that by using new techniques from scalable linear optical quantum computing (LOQC), it is possible to make an all linear-optical quantum memory capable of storing the computational qubit indefinitely. The same approach can be used to make a simple quantum repeater. Recent work by our group has shown how linear optical quantum computing ideas, recently proposed by Knill, Laflamme, and Milburn, and also by Franson and co-workers, can be used to make a scalable quantum repeater [1]. However, this repeater still requires a quantum memory to operate, which apparently requires resources other than those required for linear optical quantum computing. In this presentation, we will explicitly show how to construct a quantum memory using only LOQC resources and employing a simple error correction code for photon loss. The result is a simple, scalable, quantum memory. The device can also be operated as a quantum repeater that is far simpler than our original proposal to implement.
We give a scheme for loss tolerantly building a linear optical quantum memory which itself is tolerant to qubit loss. We use the encoding recently introduced in Varnava et al 2006 Phys. Rev. Lett. 97 120501, and give a method for efficiently achieving this. The entire approach resides within the 'one-way' model for quantum computing (Raussendorf and Briegel 2001 Phys. Rev. Lett. 86 5188–91; Raussendorf et al 2003 Phys. Rev. A 68 022312). Our results suggest that it is possible to build a loss tolerant quantum memory, such that if the requirement is to keep the data stored over arbitrarily long times then this is possible with only polynomially increasing resources and logarithmically increasing individual photon life-times.
In order for quantum communications systems to become widely used, it will probably be necessary to develop quantum repeaters that can extend the range of quantum key distribution systems and correct for errors in the transmission of quantum information. Quantum logic gates based on linear optical techniques appear to be a promising approach for the development of quantum repeaters, and they may have applications in quantum computing as well. Here we describe the basic principles of logic gates based on linear optics, along with the results from several experimental demonstrations of devices of this kind. A prototype source of single photons and a quantum memory device for photons are also discussed. These devices can be combined with a four-qubit encoding to implement a quantum repeater.
In order for quantum communications systems to become widely used, it will probably be necessary to develop quantum repeaters that can extend the range of quantum key distribution systems and correct for errors in the transmission of quantum information. Quantum logic gates based on linear optical techniques appear to be a promising approach for the development of quantum repeaters, and they may have applications in quantum computing as well. Here we describe the basic principles of logic gates based on linear optics, along with the results from several experimental demonstrations of devices of this kind. A prototype source of single photons and a quantum memory device for photons are also discussed. These devices can be combined with a four-qubit encoding to implement a quantum repeater. 2 I.
One of the earliest proposals for implementing quantum computation was based on encoding each qubit in two optical modes, each containing exactly one photon. However, it is extremely difficult to unitarily couple two optical modes containing few photons. In 2001, Knill, Laflamme, and Milburn (KLM) found a way to circumvent this restriction and implement efficient quantum computation using only passive linear optics, photodetectors, and single photon sources. This efficient linear optical quantum computing (LOQC) is distinct from other linear optical schemes that are not efficiently scalable. The technological requirements for even the simplest gates in the KLM proposal initially seemed out of reach. However, Ralph, White, Munro and Milburn soon showed that, in principle, demonstrations of key gates and techniques could be achieved with current technology. The objective of the research undertaken in this project was to produce, in three years, a prototype two-qubit gate for photons using the KLM linear optics quantum computation approach, and to develop a blue-print for a multiple qubit device that might be implemented over a longer time scale. A non-deterministic two-qubit gate was demonstrated that operates with high fidelity. A number of key tasks were demonstrated using this gate, and several theoretical investigations of short, medium, and longer term issues for the LOQC approach were successfully completed.
Linear optics with photon counting is a prominent candidate for practical quantum computing. The protocol by Knill, Laflamme, and Milburn [2001, Nature (London) 409, 46] explicitly demonstrates that efficient scalable quantum computing with single photons, linear optical elements, and projective measurements is possible. Subsequently, several improvements on this protocol have started to bridge the gap between theoretical scalability and practical implementation. The original theory and its improvements are reviewed, and a few examples of experimental two-qubit gates are given. The use of realistic components, the errors they induce in the computation, and how these errors can be corrected is discussed.
Quantum computing is an exciting field that promises great improvements to our ability to solve certain intractable classes of problem. Implementing a quantum computer will require a physical system in which quantum effects are strongly evident. Many different physical systems have been proposed for this task, including ion traps, quantum dots, neutral atoms and photons. This thesis focuses on optical implementations of a quantum computer, and specifically on single-photon designs, as opposed to those utilising coherent states. Photonic systems have shown a great deal of promise for quantum computing tasks since it was shown by Knill, Laflamme and Milburn (KLM) that scalable efficient quantum computing could be performed using only linear optical elements and measurement. This was made viable through the use of error-correcting codes. The work in this thesis covers the use of error-correcting codes in single-photon linear optics quantum computing (LOQC). The central feature of these schemes is the parity code introduced by KLM and used to overcome the gate errors that are inherent in this type of LOQC. First is a discussion of an improved scheme that incorporates the fusion gates used in Browne and Rudolph's cluster state proposal in order to simplify the encoding and gate procedures. This results in high-probability gates with a resource usage comparable to the cluster state schemes. The remainder of the thesis examines the application of further error correcting codes to handle other errors that may arise in any practical implementation of an optical quantum computer. The most significant type of error in any optical system is photon loss, and hence an extension of the parity code is presented that allows loss errors to be detected and corrected. Procedures for performing universal quantum computation whilst employing this encoding are also described. These enable the establishment of loss thresholds for parity-state based LOQC, revealing this code is capable of handling up to 10\% loss in all elements during general computation, or 17\% if it is used solely as an active memory. Although loss is the most common type of optical error, other types of error will also become an issue when attempting to produce large quantum computing systems. An analysis of the error thresholds and resource usage which can be expected when applying a general error correcting code such as the Steane code to this type of LOQC system is also presented. The error thresholds and resource requirements established are greater than those found for cat state optical quantum computing, but fall below those calculated for cluster states. However, the resource requirements of the scheme are significantly smaller than the cluster state requirements for an equivalent circuit. Finally, a new experiment is proposed, achievable with today's technology, for testing the loss-tolerant encoding described earlier. Expansions of the experiment that would demonstrate tolerance of actual experimental error are also discussed.