We present a detailed experimental study of the physics involved in transferring atoms from a magneto-optical trap (MOT) to an optical dipole trap. The loading is a dynamical process determined by a loading rate and a density dependent loss rate. The loading rate depends on cooling and the flux of atoms into the trapping volume, and the loss rate is due to excited state collisions induced by the MOT light fields. From this study we found ways to optimize the loading of the optical dipole trap. Key ingredients for maximum loading are found to be a reduction of the hyperfine repump intensity, increased detuning of the MOT light, and a displacement of the optical dipole trap center with respect to the MOT. A factor of 2 increase in the number of loaded atoms is demonstrated by using a hyperfine repump beam with a shadow in it. In this way we load $8\ifmmode\times\else\texttimes\fi{}{10}^{6}{}^{85}\mathrm{Rb}$ atoms into a 1 mK deep optical dipole trap with a waist of $58 \ensuremath{\mu}\mathrm{m},$ which is 40% of the atoms initially trapped in the MOT.
We demonstrate an efficient scheme for continuous trap loading based upon spatially selective optical pumping. We discuss the case of
1S0 calcium atoms in an optical dipole trap (ODT), however, similar strategies should be applicable to a wide range of atomic species, which do not permit efficient conventional trap loading. Our starting point is a moderately cold $(\ensuremath{\approx}300\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K})$ and dense $(\ensuremath{\approx}9\ifmmode\times\else\texttimes\fi{}{10}^{9}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3})$ reservoir of metastable
3P2 atoms in a magneto-optic trap (triplet MOT). A focused
532nm laser beam produces a strongly elongated optical potential for
1S0 atoms with up to $350\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$ well depth. A weak focused laser beam at
430nm, carefully superimposed upon the ODT beam, selectively pumps the
3P2 atoms inside the capture volume to the singlet state, where they are confined by the ODT. The triplet MOT perpetually refills the capture volume with
3P2 atoms, thus providing a continuous stream of cold atoms into the ODT at a rate of ${10}^{7}\phantom{\rule{0.3em}{0ex}}{\mathrm{s}}^{\ensuremath{-}1}$. Limited by evaporation loss, in
200ms we typically load $5\ifmmode\times\else\texttimes\fi{}{10}^{5}$ atoms with $3.5\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3}$ peak density and axial and radial temperatures of 300 and $85\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$, respectively. After terminating the loading we observe evaporation during
50ms, typically leaving us with
105 atoms with nearly equal radial and axial temperatures close to $40\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$ and a peak density of $5\ifmmode\times\else\texttimes\fi{}{10}^{11}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3}$. A simple model is presented, which identifies the relevant physical mechanisms of the loading and decay dynamics. We point out that a comparable scheme could be employed to load a dipole trap with
3P0 atoms.
We present a robust continuous optical loading scheme for a Ioffe-Pritchard (IP) type magnetic trap. Atoms are cooled and trapped in a modified magneto-optical trap (MOT) consisting of a conventional 2D-MOT in radial direction and an axial molasses. The radial magnetic field gradient needed for the operation of the 2D-MOT is provided by the IP trap. A small axial curvature and offset field provide magnetic confinement and suppress spin-flip losses in the center of the magnetic trap without altering the performance of the 2D-MOT. Continuous loading of atoms into the IP trap is provided by radiative leakage from the MOT to a metastable level which is magnetically trapped and decoupled from the MOT light. We are able to accumulate 30 times more atoms in the magnetic trap than in the MOT. The absolute number of
2×108~atoms is limited by inelastic collisions. A model based on rate equations shows good agreement with our data. Our scheme can also be applied to other atoms with similar level structure like alkaline earth metals.
Summary form only given.Laser cooling, where excess kinetic energy is extracted by a photon, is ideally suited to loading atoms into a trap; however, quantization and reabsorption of light, limit the maximum phase-space density attainable. A sequence of laser cooling followed by evaporative cooling, where the excess energy is extracted by escaping atoms, may be used to overcome the laser cooling limit; however, such a scheme dramatically reduces the number of trapped atoms. A remaining challenge is to achieve continuous loading without the phase-space density limit imposed by near-resonant light. We consider continuous evaporative loading of a magnetic trap using a magnetically insensitive buffer gas. The key is to deliver sufficient cold atoms to the trapping region such that the steady-state trap population is large. To achieve this we employ an atomic fountain guided by a far-off resonant laser beam. At the apex of the fountain, the density can be a factor of 30-40 higher than in a magneto-optical trapping region, and importantly, the atoms are spatially separated from the region of resonant laser light. We propose to use this high-density region as a reservoir for continuous evaporative loading of a trap.
We report on an investigation of loading characteristics of deep microscopic dipole traps. The dipole trap is loaded from a low density magneto optical trap (MOT) containing
≈5×106 atoms. We determine the loading parameters that maximize the trapped atom number for a trap of waist 5 μm with trap depths ranging from 3.5 mK to 10 mK. We determine the optimal trap loading conditions and the loading rates, loss coefficients and temperature of the trapped atoms under these conditions. We show that it is possible to load a few hundred to thousand atoms in dipole traps of depth 3.5 mK to 8.5 mK under the optimal loading conditions.
In this work, we load a 1070 nm crossed optical dipole trap (ODT) from a 133Cs dark spontaneous emission optical trap. Obvious improvements in the loading rate and atomic lifetime are demonstrated, comparing with the values of the atoms which are loaded directly from a normal magneto-optical trap. We analyze the atomic number as a function of time in the ODT’s loading and holding processes based on the constant density and the constant volume approximations, respectively. We also demonstrate that the atomic temperature in holding process is related to the atomic collision, which consists of two-body collision and background gas induced collision. Finally the relationship between atomic collision and optical trap depth is measured and analyzed. The atomic loading way we present can be easily expanded to other species to obtain an atomic sample with large number and high density.