In this thesis, experimentally relevant aspects and open questions of quantum information processing and measurement in circuit quantum electrodynamics have been investigated theoretically. Circuit quantum electrodynamics is a relatively young field combining superconducting transmission line resonators on-chip with superconducting quantum bits which serve as artificial atoms. Remarkable experiments have underlined the prospects of circuit QED as a possible architecture for quantum information processing as well as a framework within which quantum optics experiments can be performed. In contrast to their optical counterparts, these experiments reach the ultra-strong coupling limit and allow e.g. the generation of Fock states, the study of decoherence and the observation of quantum jumps. We present the physics of superconducting circuits based on the Josephson junction as a non-linear circuit element. We discuss the various types of quantum bits (qubits) before turning to an introduction on cavity QED and conclude the introduction with a brief presentation of the most relevant experiments and a short introduction to the principles and prospects of quantum information processing. Building on the pioneering theoretical and experimental work in which up to three qubits have been integrated on a chip and successfully coupled via a cavity mode, we propose a scheme to overcome the natural limits concerning scalability in these systems. Usually, scalability is severely limited by the resonance width of the qubit transitions and the attainable frequency range for both qubit transition and cavity resonance frequencies. This limits the present setups to at most ten qubits. As a possible solution, we propose and investigate a cross-bar grid layout of cavities with qubits at the intersections. It turns out that this setup, allowing for up to about 1000 qubits, offers significant advantages over e.g. nearest-neighbor coupling schemes. In addition, it can serve as a building block for a truly scalable scheme for fault-tolerant quantum information processing with superconducting circuits by combining 7x7 arrays in a staircase manner. Furthermore, we discuss and simulate different possibilities to improve upon the suggested scheme by e.g. using resonant gates and optimal control theory. Another focus of the present thesis is measurement physics. In order to investigate e.g. the possibilities of using a circuit QED system to dispersively detect single microwave photons or to generate multi-qubit entangled states, we introduce in a pedagogical manner the basics of stochastic master equations which generate quantum trajectories before turning to concrete applications. Quantum trajectories have proven to be a state-of-the-art tool to analyze measurement situations in a very realistic manner by giving access to both the measurement record as well as the internal quantum dynamics conditioned on this record. Using the method of quantum trajectories as generated by stochastic master equations, we discuss a scheme to efficiently generate multi-qubit entangled states in a very flexible way. The method is based on a collective, dispersive qubit readout. By this measurement, a suitable product state of N qubits can be reliably converted into e.g. an N-qubit Greenberger-Horne-Zeilinger or W state. We propose and discuss the scheme and investigate the effects of decoherence and parameter spread as they would be encountered in experiment. Last but not least, we propose and fully analyze a scheme to dispersively detect single itinerant microwave photons. While experiments to generate single microwave photons have already been successfully performed, their single-shot quantum non-demolition detection has not been possible so far. The scheme presented in this thesis closes this gap in the circuit QED toolbox and reaches detection efficiencies of 30% only limited by fundamental quantum mechanics in this case the Quantum Zeno effect. This detection scheme could be used in quantum communication or quantum cryptography applications.
In this thesis, experimentally relevant aspects and open questions of quantum information processing and measurement in circuit quantum electrodynamics have been investigated theoretically. Circuit quantum electrodynamics is a relatively young field combining superconducting transmission line resonators on-chip with superconducting quantum bits which serve as artificial atoms. Remarkable experiments have underlined the prospects of circuit QED as a possible architecture for quantum information processing as well as a framework within which quantum optics experiments can be performed. In contrast to their optical counterparts, these experiments reach the ultra-strong coupling limit and allow e.g. the generation of Fock states, the study of decoherence and the observation of quantum jumps. We present the physics of superconducting circuits based on the Josephson junction as a non-linear circuit element. We discuss the various types of quantum bits (qubits) before turning to an introduction on cavity QED and conclude the introduction with a brief presentation of the most relevant experiments and a short introduction to the principles and prospects of quantum information processing. Building on the pioneering theoretical and experimental work in which up to three qubits have been integrated on a chip and successfully coupled via a cavity mode, we propose a scheme to overcome the natural limits concerning scalability in these systems. Usually, scalability is severely limited by the resonance width of the qubit transitions and the attainable frequency range for both qubit transition and cavity resonance frequencies. This limits the present setups to at most ten qubits. As a possible solution, we propose and investigate a cross-bar grid layout of cavities with qubits at the intersections. It turns out that this setup, allowing for up to about 1000 qubits, offers significant advantages over e.g. nearest-neighbor coupling schemes. In addition, it can serve as a building block for a truly scalable scheme for fault-tolerant quantum information processing with superconducting circuits by combining 7x7 arrays in a staircase manner. Furthermore, we discuss and simulate different possibilities to improve upon the suggested scheme by e.g. using resonant gates and optimal control theory. Another focus of the present thesis is measurement physics. In order to investigate e.g. the possibilities of using a circuit QED system to dispersively detect single microwave photons or to generate multi-qubit entangled states, we introduce in a pedagogical manner the basics of stochastic master equations which generate quantum trajectories before turning to concrete applications. Quantum trajectories have proven to be a state-of-the-art tool to analyze measurement situations in a very realistic manner by giving access to both the measurement record as well as the internal quantum dynamics conditioned on this record. Using the method of quantum trajectories as generated by stochastic master equations, we discuss a scheme to efficiently generate multi-qubit entangled states in a very flexible way. The method is based on a collective, dispersive qubit readout. By this measurement, a suitable product state of N qubits can be reliably converted into e.g. an N-qubit Greenberger-Horne-Zeilinger or W state. We propose and discuss the scheme and investigate the effects of decoherence and parameter spread as they would be encountered in experiment. Last but not least, we propose and fully analyze a scheme to dispersively detect single itinerant microwave photons. While experiments to generate single microwave photons have already been successfully performed, their single-shot quantum non-demolition detection has not been possible so far. The scheme presented in this thesis closes this gap in the circuit QED toolbox and reaches detection efficiencies of 30% only limited by fundamental quantum mechanics in this case the Quantum Zeno effect. This detection scheme could be used in quantum communication or quantum cryptography applications.
Circuit Quantum Electrodynamics (cQED), the study of the interaction between superconducting circuits behaving as artificial atoms and 1-dimensional transmission-line resonators, has shown much promise for quantum information processing tasks.For the purposes of quantum computing it is usual to approximate the artificial atoms as 2-level qubits, and much effort has been expended on attempts to isolate these qubits from the environment and to invent ever more sophisticated control and measurement schemes.Rather than focussing on these technological aspects of the field, this thesis investigates the opportunities for using these carefully engineered systems for answering questions of fundamental physics.The low dissipation and small mode volume of the circuits allows easy access to the strong-coupling regime of quantum optics, where one can investigate the interaction of light and matter at the level of single atoms and photons.A signature of strong coupling is the splitting of the cavity transmission peak into a pair of resolvable peaks when a single resonant atom is placed inside the cavity-an effect known as vacuum Rabi splitting.The cQED architecture is ideally suited for going beyond this linear response effect.This thesis shows that increasing the drive power results in two unique nonlinear features in the transmitted heterodyne signal: the supersplitting of each vacuum Rabi peak into a doublet, and the appearance of additional peaks with the characteristic √ n spacing of the Jaynes-Cummings ladder.These constitute direct evidence for the coupling between the quantized microwave field and the anharmonic spectrum of a superconducting qubit acting as an artificial atom.This thesis also addresses the idea of Bell tests, which are experiments that aim to disprove certain types of classical theories, presenting a proposed method for preparing maximally entangled 3-qubit states via a 'preparation by measurement' scheme using an optimized filter on the time-dependent signal obtained via homodyne monitoring of the transmitted microwave field.
In this paper, the coherent interaction of individual microwave photons with superconducting qubits is presented both for quantum information processing and for novel quantum optics experiments in the circuit quantum electrodynamics (QED) architecture. In the resonant regime we observe the vacuum Rabi mode splitting. In the non-resonant regime we use the dispersive coupling between the qubit and the cavity field to perform high visibility quantum non-demolition (QND) measurements of the qubit state. In the strong dispersive limit we also perform measurements of the cavity state from which the photon number statistics of the field can be extracted. Generally, the circuit QED architecture is attractive for quantum information processing and as an interface in hybrid quantum systems.
Superconducting qubits are a promising technology for building a scalable quantum computer. An important architecture employed in the field is called Circuit Quantum Electrodynamics (circuit QED), where such qubits are combined with high quality microwave cavities to study the interaction between artificial atoms and single microwave photons. The ultra-strong coupling achieved in these systems allows for control and readout of the quantum state of qubits to perform quantum information processing. The work on circuit QED performed in this thesis consisted of realizing an experimental setup for qubit experiments in a new laboratory, investigating the coherence and decay of higher energy levels of superconducting transmon qubits and finally demonstrating a novel coaxial form of circuit QED. Designing and building a 3D circuit QED setup involved the following main accomplishments: producing high quality 3D cavities; designing and installing the cryogenic microwave setup as well as the room temperature amplification and data acquisition circuitry; successfully developing a recipe for the fabrication of Josephson junctions; controlling and measuring superconducting 3D transmon qubits at 10mK. Several qubits were fully characterised and have shown coherence times of several microseconds and relaxation times up to 25μs. Superconducting qubits in fact possess higher energy levels that can provide significant computational advantages in quantum information applications. In experiments performed at MIT, preparation and control of the five lowest states of a transmon qubit was demonstrated, followed by an investigation of the phase coherence and decay dynamics of these higher energy levels. The decay was found to proceed mainly sequentially with relaxation times in excess of 20μs for all transitions. A direct measurement of the charge dispersion of these levels was performed to explore their characteristics of dephasing. This experiment was also reproduced on a 3D transmon fabricated and measured in Oxford, where due to a higher effective qubit temperature a multi-level decay model including thermal excitations was developed to explain the observed relaxation dynamics. Finally, a coaxial transmon, which we name the coaxmon, is presented and measured with a coaxial LC readout resonator and input/output coupling ports placed inline along the third dimension. This novel coaxial circuit QED architecture holds great promise for developing a scalable planar grid of qubits to build a quantum computer.
In a quantum computer, the information carriers, which are bits in ordinary computers, are implemented as devices that exhibit coherent superpositions of physical states and entanglement. Such components, known as quantum bits or qubits, can be realized with various different types of two-state quantum systems. Quantum computers will be built for computational speed, with hoped for applications especially in cryptography and in other tasks where classical computers remain inefficient. Circuit quantum electrodynamics (cQED) is a quantum-computer architecture which employs superconducting electronic components and microwave photon fields as building blocks. Compared to cavity quantum electrodynamics (CQED), where atoms are trapped in physical cavities, cQED is more attractive in that its qubits are tunable and conveniently integrable with the electronics already in use. This architecture has shown some of the most promising qubit designs, despite their coherence times reaching tens of microseconds, are still below the state of the art with spin qubits, which reach milliseconds. Coherence times are historically the most relevant parameters describing the fitness of a qubit, although these days not necessarily the limiting factor. This thesis presents a comprehensive set of theoretical and experimental methods for measuring the characteristic parameters of superconducting qubits. We especially study transmission-line-shunted plasma oscillation qubits, or transmons, and presents experimental results for a single sample. Transmon capacitively couples a superconducting quantum interference device (SQUID) with a coplanar waveguide (CPW) resonator, often with added frequency tunability utilizing an external magnet. The number of superconducting charge carriers tunnelled through a junction in the SQUID are used as qubit degrees of freedom. Readout of the qubit state is carried out by measuring transmission through the CPW. A cryogenic setup is employed with measurement and driving pulses delivered from microwave sources. Steady-state spectroscopy is employed to determine the resonance frequencies of the qubit and the resonator, qubit-resonator coupling constants, and the energy parameters of the qubit. Pulse-modulated measurements are employed to determine the coherence times of the qubit. The related analysis- and simulation programs and scripts are collected togithub.com/patomaki.
Quantum optics in superconducting circuits, known as circuit QED, studies the interaction of photons at microwave frequencies with artificial atoms made of Josephson junctions. Although quite young, remarkable progress has been made in this field over the past decade, especially given the interest in building a quantum computer using superconducting circuits. In this thesis based on the appended papers, we look at generation, engineering and detection of microwave photons using superconducting circuits. We do this by taking advantage of the strong coupling, on-chip tunability and huge nonlinearity available in superconducting circuits. First, we present the strong photon-photon interaction measured experimentally, as shown in the giant cross-Kerr effect. In this work, conditional phase shift of about 20 degrees per photon was measured between two coherent fields at single photon level. Given this strong interaction, we propose and analyze a cascaded setup based on the cross-Kerr effect to detect itinerant microwave photons, a long outstanding problem with only recent experimental realizations. We show that a nondestructive detection of microwave photons is possible with few cascaded transmons. The on-chip tunability of Superconducting Quantum Interference Device (SQUID) is exploited to create a tunable superconducting resonator in the next presented experimental work. Finally, we show that by placing the atom at the end of a transmission line, microwave photons can be generated efficiently and on-demand. We also present a setup that can generate the photons in arbitrary wave packets.
The field of cavity quantum electrodynamics (cavity QED) studies the interaction between light and matter on a fundamental level: a single atom interacts with a single photon. If the atom-photon coupling is larger than any dissipative effects, the system enters the strong-coupling limit. A peculiarity of this regime is the possibility to form coherent superpositions of light and matter excitations - a kind of 'molecule' consisting of an atomic and a photonic contribution. The novel research field of circuit QED extends cavity QED concepts to solid-state based system. Here, a superconducting quantum bit is coupled to an on-chip superconducting one-dimensional waveguide resonator. Owing to the small mode-volume of the resonant cavity, the large dipole moment of the 'artificial atom' and the enormous engineering potential inherent to superconducting quantum circuits, remarkable atom-photon coupling strengths can be realized. This thesis describes the theoretical framework, the development of fabrication techniques and the implementation of experimental characterization techniques for superconducting quantum circuits for circuit QED applications. In particular, we study the interaction between superconducting flux quantum bits and high-quality coplanar waveguide resonators in the strong-coupling limit. Furthermore, we report on the first experimental realization of a circuit QED system operating in the ultrastrong-coupling regime, where the atom-photon coupling rate reaches a considerable fraction of the relevant system frequencies. In these experiments we could observe phenomena that can not be explained within the renowned Jaynes-Cummings model.