Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

PROSPECTS FOR DEVELOPING GLONASS SPACEBOARD ATOMIC BEAM FREQUENCY STANDARD WITH LASER PUMPING

Russian Federation

Published Jan 1, 1993• 0 citations
OpenAlex

Abstract

An improvement of accuracy parameters of passive atomic frequency standards may be realized using effective techniques of laser pumping and detection. Under these conditions, such parameters are drastically .increased as a factor of atomic beam utilization, a difference in used in sublevelsf transition and an efficiency of detection. The paper presents the results of investigation and development of a rubidium beam frequency standard with semiconductor lasers used for pumping and detection. A

Related papers

DFB laser diode pumped Rubidium atomic frequency standard

Jiayao Huang, Y. Gu, X. H. Qi +5 more

We present our recently experimental results on a DFB laser diode pumped Rubidium atomic frequency standard. Our experiment was based on a homemade lamp-pumped Rubidium frequency standard with the discharge lamp assembly removed. In the experiment, we first locked a DFB laser diode to the87Rb cycling transition (5S1/2, F=2→5P3/2, F=3) by means of saturation absorption locking technique. After that, we optimized the parameters carefully related to the clock performance, such as temperature of the physical package, amplitude of the modulation signal for the laser locking. The preliminary short-term stability of our clock is measured 5.25×10−12τ−1/2(1s<τ<100s).

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2011•0 citations

Two-frequency Pumping in 87Rb Atomic Beam Frequency Standard with Laser Pumping/Detection for Space Application

A. Besedina, Arvid G. Gevorkyan, V. S. Zholnerov

We present our study on a two-frequency laser pumped87Rb atomic beam frequency standard for space applications. Two-frequency pumping was studied experimentally with using D2-line for the most efficient scheme (2-2' sigma; 1-1' pi) and proposed by us (2-2' sigma; 1-0' sigma) scheme. The achieved efficiency for two-frequency pumping using a new scheme was equal to 95%. In the shot noise limit we could achieve instability of sigmay(tau) les 1ldr10-13ldr tau-1/2Rb atomic beam frequency standard.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2007•2 citations

Experiments on a semiconductor laser pumped rubidium atomic clock

Minoru Hashimoto, Motoichi Ohtsu

Experiments were carried out to evaluate the performances of a semiconductor laser pumped rubidium (87Rb) atomic clock. Two kinds of Rb gas cells were used and their performances were compared [gas cell A (natural rubidium (87Rb/85Rb =\frac{3}{7}) and buffer gases) and gas cell B (87Rb and buffer gases)]. The highest microwave frequency stabilities were estimated as3.4 \times 10^{-12} \tau^{-1/2}and2.7 \times 10^{-12} \tau^{-1/2}at the optimal gas cell temperatures of 60°C and 48°C for the gas cellsAandB, respectively (τ: integration time). The light shift, i.e., microwave frequency shift induced by laser light, was measured as -0.50 Hz/MHz and -0.11 Hz/MHz for the gas cellsAandBat their optimal operating conditions given above. As an improved experiment by utilizing high temporal coherence of the laser, a novel double resonance spectral line shape with a drastically narrower linewidth was demonstrated. A technique, similar to FM laser spectroscopy, was employed for this purpose by utilizing laser FM sidebands which are induced by microwave frequency modulation and nonlinear susceptibility of three-level87Rb atoms. The minimum linewidth obtained was 20 Hz, which can be used as a sensitive frequency discriminator for an improved87Rb atomic clock.

IEEE Journal of Quantum Electronics•Apr 1, 1987•61 citations

Optical pumping of an atomic vapor with a frequency-modulated laser

F. Tremblay, A. Michaud, Jean Beaubien +1 more

Rubidium maser and passive frequency standards performances rely on the efficiency of the optical pumping scheme. When using a semiconductor laser as the pumping source in such experiments, one found that the sharpness of the laser spectrum allows only the excitation of a small class of atomic velocities. The use of a frequency-modulated laser has shown great promise by largely increasing the overall pumping efficiency.1 Broadening of the narrow laser spectrum ensures the contribution of all classes of atomic velocities present in the vapor.2 Different modulation waveforms, amplitudes and frequencies have very important effects in overall optical pumping efficiency. We theoretically evaluate the efficiency of a frequency-modulated laser pumping source by studying deterministic as well as random modulation. Important considerations are obtained regarding the optimal conditions concerning the magnitude and the bandwidth of the modulation signal. Moreover a deterministic modulation must be used to lock the laser frequency by interrogating an atomic cell and synchronously detecting the transmitted intensity. Experiments conducted on a rubidium 87 maser optically pumped with a semiconductor laser confirm the predictions. In fact the oscillation of the maser was only possible with the help of the laser frequency modulation.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

Construction and investigation of a quantum frequency discriminator utilizing an87Rb atomic beam with pumping and detection by injection lasers

A. Besedina, V. L. Velichanskiǐ, Alexander S. Zibrov +1 more

Construction and investigation of a quantum frequency discriminator utilizing an 87Rb atomic beam with pumping and detection by injection lasers, A N Besedina, V L Velichanskiĭ, A S Zibrov, V S Zholnerov

Soviet Journal of Quantum Electronics•Mar 31, 1991•4 citations

A compact, high-performance laser-pumped rubidium atomic frequency standard

C. Affolderbach, G. Mileti, Fabien Droz

The paper presents the realisation of a high-performance vapour-cell atomic frequency standard demonstrator based on laser optical pumping. The development of such devices aims to fully exploit the advantages of using a narrow-band diode laser pump light source instead of the discharge lamps commonly used in Rb gas-cell clocks. These advantages include improved control over the pump light spectrum, higher selectivity of the optical pumping, and increased signal contrast, and thus show the potential for the realisation of Rb atomic clocks with improved short-term frequency stability.

European Quantum Electronics Conference (EQEC)•Jan 18, 2006•1 citation
An improvement of accuracy parameters of passive atomic frequency standards may be realized using effective techniques of laser pumping and detection. Under these conditions, such parameters are drastically .increased as a factor of atomic beam utilization, a difference in used in sublevelsf transition and an efficiency of detection. The paper presents the results of investigation and development of a rubidium beam frequency standard with semiconductor lasers used for pumping and detection. A
We present our recently experimental results on a DFB laser diode pumped Rubidium atomic frequency standard. Our experiment was based on a homemade lamp-pumped Rubidium frequency standard with the discharge lamp assembly removed. In the experiment, we first locked a DFB laser diode to the87Rb cycling transition (5S1/2, F=2→5P3/2, F=3) by means of saturation absorption locking technique. After that, we optimized the parameters carefully related to the clock performance, such as temperature of the physical package, amplitude of the modulation signal for the laser locking. The preliminary short-term stability of our clock is measured 5.25×10−12τ−1/2(1s<τ<100s).
We present our study on a two-frequency laser pumped87Rb atomic beam frequency standard for space applications. Two-frequency pumping was studied experimentally with using D2-line for the most efficient scheme (2-2' sigma; 1-1' pi) and proposed by us (2-2' sigma; 1-0' sigma) scheme. The achieved efficiency for two-frequency pumping using a new scheme was equal to 95%. In the shot noise limit we could achieve instability of sigmay(tau) les 1ldr10-13ldr tau-1/2Rb atomic beam frequency standard.
Experiments were carried out to evaluate the performances of a semiconductor laser pumped rubidium (87Rb) atomic clock. Two kinds of Rb gas cells were used and their performances were compared [gas cell A (natural rubidium (87Rb/85Rb =\frac{3}{7}) and buffer gases) and gas cell B (87Rb and buffer gases)]. The highest microwave frequency stabilities were estimated as3.4 \times 10^{-12} \tau^{-1/2}and2.7 \times 10^{-12} \tau^{-1/2}at the optimal gas cell temperatures of 60°C and 48°C for the gas cellsAandB, respectively (τ: integration time). The light shift, i.e., microwave frequency shift induced by laser light, was measured as -0.50 Hz/MHz and -0.11 Hz/MHz for the gas cellsAandBat their optimal operating conditions given above. As an improved experiment by utilizing high temporal coherence of the laser, a novel double resonance spectral line shape with a drastically narrower linewidth was demonstrated. A technique, similar to FM laser spectroscopy, was employed for this purpose by utilizing laser FM sidebands which are induced by microwave frequency modulation and nonlinear susceptibility of three-level87Rb atoms. The minimum linewidth obtained was 20 Hz, which can be used as a sensitive frequency discriminator for an improved87Rb atomic clock.
Rubidium maser and passive frequency standards performances rely on the efficiency of the optical pumping scheme. When using a semiconductor laser as the pumping source in such experiments, one found that the sharpness of the laser spectrum allows only the excitation of a small class of atomic velocities. The use of a frequency-modulated laser has shown great promise by largely increasing the overall pumping efficiency.1 Broadening of the narrow laser spectrum ensures the contribution of all classes of atomic velocities present in the vapor.2 Different modulation waveforms, amplitudes and frequencies have very important effects in overall optical pumping efficiency. We theoretically evaluate the efficiency of a frequency-modulated laser pumping source by studying deterministic as well as random modulation. Important considerations are obtained regarding the optimal conditions concerning the magnitude and the bandwidth of the modulation signal. Moreover a deterministic modulation must be used to lock the laser frequency by interrogating an atomic cell and synchronously detecting the transmitted intensity. Experiments conducted on a rubidium 87 maser optically pumped with a semiconductor laser confirm the predictions. In fact the oscillation of the maser was only possible with the help of the laser frequency modulation.
The paper presents the realisation of a high-performance vapour-cell atomic frequency standard demonstrator based on laser optical pumping. The development of such devices aims to fully exploit the advantages of using a narrow-band diode laser pump light source instead of the discharge lamps commonly used in Rb gas-cell clocks. These advantages include improved control over the pump light spectrum, higher selectivity of the optical pumping, and increased signal contrast, and thus show the potential for the realisation of Rb atomic clocks with improved short-term frequency stability.