Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Science

Quantum Computing with Electrons Floating on Liquid Helium

P. M. Platzman, M. I. Dykman

Published Jun 18, 1999• 355 citations
Publisher

Abstract

A quasi-two-dimensional set of electrons (1 < N < 10(9)) in vacuum, trapped in one-dimensional hydrogenic levels above a micrometer-thick film of liquid helium, is proposed as an easily manipulated strongly interacting set of quantum bits. Individual electrons are laterally confined by micrometer-sized metal pads below the helium. Information is stored in the lowest hydrogenic levels. With electric fields, at temperatures of 10(-2) kelvin, changes in the wave function can be made in nanoseconds. Wave function coherence times are 0.1 millisecond. The wave function is read out with an inverted dc voltage, which releases excited electrons from the surface.

DOI
10.1126/science.284.5422.1967

Related papers

A quantum computer based on electrons floating on liquid helium

M. I. Dykman, P. M. Platzman

Electrons on a helium surface form a quasi two-dimensional system which displays the highest mobility reached in condensed matter physics. We propose to use this system as a set of interacting quantum bits. We will briefly describe the system and discuss how the qubits can be addressed and manipulated, including interqubit excitation transfer. The working frequency of the proposed quantum computer is ~1GHz. The relaxation rate can be at least 5 orders of magnitude smaller, for low temperatures.

arXiv:quant-ph/0109030•Sep 5, 2001•1 citation

Quantum computing with qubits made from electrons on a helium film

Arnold J. Dahm, İsmail Karakurt, Jeremy A. Heilman +1 more

A quantum computer based on the manipulation and detection of coherent states of electrons localized above a helium film is described. Each quantum logic element (qubit) is made of a combination of the ground and first excited states of an electron trapped in the image potential well at the surface. Potentials applied to micro-electrodes located beneath each electron confine the lateral motion of the electron and are used to operate gates. Mechanisms for one- and two-qubit logic operations and a readout of the final state are discussed. The principle decay channel for the excited state is via the emission of one phonon into the bulk liquid. Dechoherence times are calculated to be of order of 100 μs and allow greater than 104 serial operations.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 25, 2004•1 citation

Quantum computation with electrons trapped on liquid Helium by using the centimeter-wave manipulating techniques

Yufen Li, Suirong He, Miao Zhang +1 more

Abstract Surface-state electrons floating on liquid Helium have been served as one of the great potential experimental platforms to implement quantum computation, wherein the qubits are usually encoded by either the lowest two levels of the vertical vibrations (i.e., Hydrogen-like atoms) or the electronic spins. Given the relevant operations require additional techniques, such as the corresponding millimeter-wave or magnetic field manipulations, here we investigate how to implement the scalable quantum computation with a trapped electron array by alternatively using the usual centimeter-wave manipulating techniques. This is because the eigenfrequency of the present qubit, encoded by the two lowest levels of the lateral vibration of the trapped electron, is limited in the centimeter-wave band. We show that, by biasing the electrodes properly and driving the coplanar waveguide transmission line resonator, the electrons can be individually trapped in a series of anharmonic potentials on liquid Helium. Therefore, the well-developed circuit quantum electrodynamics technique for the implementation of superconducting quantum computation can be conveniently utilized here in the present quantum computing platform (proposed firstly in Phys Rev Lett 105:040503, 2010, to implement the fundamental logic gates, typically such as the single-qubit rotations of the individually addressable trapped electrons, the switchable two-qubit manipulations between the electrons trapped in the distant traps, and also the high-fidelity readouts of the target qubits. The feasibility of the proposal is also discussed by numerical simulations.

Quantum Information Processing•Aug 5, 2024•2 citations

Quantum computing with electrons floating on liquid helium

M. I. Dykman, P. M. Platzman

Electrons on a helium surface form a quasi two-dimensional system which displays the highest mobility reached in condensed matter physics. We propose to use this system as a set of interacting quantum bits. We will briefly describe the system and discuss how the qubits can be addressed and manipulated. The working frequency of the proposed quantum computer is ~ 1GHz. Careful analysis shows that the relaxation rate can be at least 5 orders of magnitude smaller, for low temperatures.

Quantum Information and Computation•Dec 1, 2001•8 citations

Quantum Computing with Electrons on Liquid Helium

İsmail Karakurt

A quantum computer based on electrons floating over liquid helium is described. Each qubit is made of combinations of ground and first excited states of an electron trapped over micro-electrodes just below the helium surface. We describe mechanisms for preparing the initial state of the qubit, operations with the qubits, and a proposed readout. This system is, in principle, capable of \\sim 104 operations in a decoherence time, the time in which the wave function collapses.

TURKISH JOURNAL OF PHYSICS•May 1, 2003•4 citations

The components for a quantum computer based on surface state electrons on liquid helium

Brian Naberhuis

It has been proposed in literature that a quantum computer can be made utilizing the electronic states of electrons bound to the surface of liquid helium. One can model a single electron on the surface as a 1d hydrogenic atom, providing a set of quantum electronic states which are easily tunable, with an untuned energy gap of 0.488\\,meV (̃120 GHz) between the ground state and the first excited state, and it is these two energy levels that are proposed as the 0 and 1 state of a qubit. To that end, three microfabricated devices are needed: a low temperature electron source of low energy electrons, a detector capable of detecting single electrons, and a microstructure capable of trapping and Stark shifting the energy levels of individual electrons in proximity close enough to perform multiple qubit operations. This dissertation contains a description of the devices microfabricated for these purposes. An electron source based on porous silicon was fabricated, tested, and proven to provide low energy electrons. Other more conventional techniques based on a thoriated tungsten filament were also explored. For electron detection, we have fabricated a transition edge superconducting microbolometer. Tests have shown it is capable of detecting a few eV of energy. For the microstructure, we fabricated a series of columns 200 nm in diameter, 1.5[mu]m in height, separated by 500 nm. For later tests, a microelectrode exposed through a 10[mu]m diameter hole in a ground plane was used. Initial experiments describing bolometer designs and electron confinement are discussed, as well as proposed microfabrication redesign to continue this work. Numerical time series computations of both single (NOT, PHASE) and two qubit (SWAP, [square root]SWAP, CNOT) gates are also presented

•Jan 1, 2007•0 citations
A quasi-two-dimensional set of electrons (1 < N < 10(9)) in vacuum, trapped in one-dimensional hydrogenic levels above a micrometer-thick film of liquid helium, is proposed as an easily manipulated strongly interacting set of quantum bits. Individual electrons are laterally confined by micrometer-sized metal pads below the helium. Information is stored in the lowest hydrogenic levels. With electric fields, at temperatures of 10(-2) kelvin, changes in the wave function can be made in nanoseconds. Wave function coherence times are 0.1 millisecond. The wave function is read out with an inverted dc voltage, which releases excited electrons from the surface.
A quantum computer based on the manipulation and detection of coherent states of electrons localized above a helium film is described. Each quantum logic element (qubit) is made of a combination of the ground and first excited states of an electron trapped in the image potential well at the surface. Potentials applied to micro-electrodes located beneath each electron confine the lateral motion of the electron and are used to operate gates. Mechanisms for one- and two-qubit logic operations and a readout of the final state are discussed. The principle decay channel for the excited state is via the emission of one phonon into the bulk liquid. Dechoherence times are calculated to be of order of 100 μs and allow greater than 104 serial operations.
Abstract Surface-state electrons floating on liquid Helium have been served as one of the great potential experimental platforms to implement quantum computation, wherein the qubits are usually encoded by either the lowest two levels of the vertical vibrations (i.e., Hydrogen-like atoms) or the electronic spins. Given the relevant operations require additional techniques, such as the corresponding millimeter-wave or magnetic field manipulations, here we investigate how to implement the scalable quantum computation with a trapped electron array by alternatively using the usual centimeter-wave manipulating techniques. This is because the eigenfrequency of the present qubit, encoded by the two lowest levels of the lateral vibration of the trapped electron, is limited in the centimeter-wave band. We show that, by biasing the electrodes properly and driving the coplanar waveguide transmission line resonator, the electrons can be individually trapped in a series of anharmonic potentials on liquid Helium. Therefore, the well-developed circuit quantum electrodynamics technique for the implementation of superconducting quantum computation can be conveniently utilized here in the present quantum computing platform (proposed firstly in Phys Rev Lett 105:040503, 2010, to implement the fundamental logic gates, typically such as the single-qubit rotations of the individually addressable trapped electrons, the switchable two-qubit manipulations between the electrons trapped in the distant traps, and also the high-fidelity readouts of the target qubits. The feasibility of the proposal is also discussed by numerical simulations.
It has been proposed in literature that a quantum computer can be made utilizing the electronic states of electrons bound to the surface of liquid helium. One can model a single electron on the surface as a 1d hydrogenic atom, providing a set of quantum electronic states which are easily tunable, with an untuned energy gap of 0.488\\,meV (̃120 GHz) between the ground state and the first excited state, and it is these two energy levels that are proposed as the 0 and 1 state of a qubit. To that end, three microfabricated devices are needed: a low temperature electron source of low energy electrons, a detector capable of detecting single electrons, and a microstructure capable of trapping and Stark shifting the energy levels of individual electrons in proximity close enough to perform multiple qubit operations. This dissertation contains a description of the devices microfabricated for these purposes. An electron source based on porous silicon was fabricated, tested, and proven to provide low energy electrons. Other more conventional techniques based on a thoriated tungsten filament were also explored. For electron detection, we have fabricated a transition edge superconducting microbolometer. Tests have shown it is capable of detecting a few eV of energy. For the microstructure, we fabricated a series of columns 200 nm in diameter, 1.5[mu]m in height, separated by 500 nm. For later tests, a microelectrode exposed through a 10[mu]m diameter hole in a ground plane was used. Initial experiments describing bolometer designs and electron confinement are discussed, as well as proposed microfabrication redesign to continue this work. Numerical time series computations of both single (NOT, PHASE) and two qubit (SWAP, [square root]SWAP, CNOT) gates are also presented