This work demonstrates the validation of a measurement equipment, such as a photodetector, by utilizing a single photon source that is based on laser fluorescence of nitrogen vacancies (NV-centers) in diamond. This validation method is done to further metrological characterisation and development of quantum technology. Measurement results and uncertainty analysis of the standard detector and photon counter, the coupling ratio as well as the measurement reproducibility and the influence of residual multiphoton processes are presented and discussed.
This work demonstrates the validation of a measurement equipment, such as a photodetector, by utilizing a single photon source that is based on laser fluorescence of nitrogen vacancies (NV-centers) in diamond. This validation method is done to further metrological characterisation and development of quantum technology. Measurement results and uncertainty analysis of the standard detector and photon counter, the coupling ratio as well as the measurement reproducibility and the influence of residual multiphoton processes are presented and discussed.
A widespread use of various relative calibration techniques is established in order to realize reliable and low uncertainty measurements of the detection efficiency, which is one key parameter characterizing single photon detectors. In the following paper we will present an approach to evaluate the relative detection efficiency of single photon avalanche photo diode (SPAD) detectors compared to a standard detector. This calibration technique is based upon the fiber-coupled relative efficiency calibration of analogue detectors, used in fiber-optic communication. For the first time, to our knowledge, an intrinsic single photon source based on the nitrogen-vacancy center in diamond was used for this purpose. Furthermore, the possible influence of different photon statistics, arising from different irradiation sources like thermal sources or lasers on the calibration results for the fiber exchange method has been theoretically studied.
The development of reliable devices to generate single photons is crucial for applications in quantum cryptography, as well as for fundamental quantum optics experiments. Due to their extremely high photostability at room temperature, optically active defects in solids, the so called color centers, are among the most promising candidates. Single NV (nitrogen-vacancy) centers in diamond have been demonstrated to be able to generate single photons and have already shown advantages compared to attenuated laser pulses in a quantum cryptography experiment. The nitrogen-vacancy center (NV center) in diamond consists of a substitutional nitrogen atom and an adjacent vacancy. This complex exhibits an optical transition with a fluorescence lifetime of 11.6 ns. The room temperature spectrum of the NV center consists of the zero-phonon line at 637 nm and broad phononic sidebands with a FWHM of more than 100 nm. Due to the existence of a shelving level the efficiency of the NV center as a single photon source is limited. Additionally, the high diffraction index of bulk diamond restricts the efficiency to collect the fluorescence light.
Single nitrogen vacancy (NV) centers in diamond serve as a photonic platform for quantum sensing and computing applications. They can be created deterministically using femtosecond laser pulses. Such writing process requires high-resolution fluorescence detection with a high signal-to-noise ratio, which is accomplished by setting up a homebuilt confocal fluorescence microscope. The microscope shall monitor the fluorescence of newly formed NV centers during the writing process. In addition, it will be used to characterize the NV centers’ spin coherence times, orientation in the diamond lattice and single-emitter characteristics via the intensity correlation function g(2)(tau). In the future, this setup is also planned to be employed for STED-microscopy of twin NV centers.
For applications in Quantum Information and Quantum Key Distribution an on-demand source of single photons is desirable because absolute security is of utmost importance. Photons are quantum systems; hence encoding information onto them offers a secure alternative to classical cryptography as a measurement cannot be performed on photons without altering their properties. The Nitrogen Vacancy (NV) centre in diamond is a good source of such photons. It is photo-stable and its location in diamond offers robustness. It has zero phonon line at 637 nm and its relative short luminescence life-time of about 12 ns makes it suitable for generating single photons. This thesis covers two aspects: Firstly the characterization of defects in diamonds and subsequent selection of diamonds suitable for use in the single photon setup and secondly, the development of the experimental setup for single photon generation. This thesis sets out to describe the development of a laboratory based single photon source using the NV centre in diamond. For this purpose a suite of diamond samples were selected and subjected to various spectroscopic tests in order to characterize and classify the samples, especially the presence of the NV centres and their concentrations. The characterization of the defects was done through the use of the following spectroscopic techniques: UltravioletVisible-Near infrared spectroscopy, Infrared spectroscopy, Electron Spin Resonance and Photoluminescence. These techniques enabled us to understand the types and origins of crystal defects that were present in the diamond samples used in this study and to use this to select diamonds that are most suitable for use in generation of single photons. The experimental setup for single photon generation using the NV centre is based on a confocal microscope arrangement. Single NV centres were identified by measuring the second order autocorrelation function of the fluorescence light emitted by the sample when illuminated with a laser. This measurement was done using a Hanbury-Brown Twiss (HBT) interferometer.
The development of a robust light source that emits one photon at a time is an outstanding challenge in quantum science and technology. Here, at the transition from many to single photon optical communication systems, fully quantum mechanical effects may be utilized to achieve new capabilities, most notably perfectly secure communication via quantum cryptography. Practical implementations place stringent requirements on the device properties, including stable photon generation, room temperature operation, and efficient extraction of many photons. Single photon light emitting devices based on fluorescent dye molecules, quantum dots, and carbon nanotube material systems have all been explored, but none have simultaneously demonstrated all criteria. Here, we describe the design, fabrication, and characterization of a bright source of single photons consisting of an individual Nitrogen-vacancy color center (NV center) in a diamond nanowire operating in ambient conditions. The nanowire plays a positive role in increasing the number of single photons collected from the NV center by an order of magnitude over devices based on bulk diamond crystals, and allows operation at an order of magnitude lower power levels. This result enables a new class of nanostructured diamond devices for room temperature photonic and quantum information processing applications, and will also impact fields as diverse as biological and chemical sensing, opto-mechanics, and scanning-probe microscopy.
The nitrogen-vacancy (NV) center is a defect in the structure of diamond, roughly the size of a single atom, that possesses properties that make it applicable to quantum information processing, high-resolution magnetic resonance imaging, and probing biological systems. When an NV center is excited by green light of wavelength 523 nm, it emits red light of in the range from 600-800 nm tens of nanoseconds later. A confocal microscope can be used to excite and collect emitted photons from NV centers. By detecting the intensity of the emitted red photons, we can determine the quantum state of a single NV center, which is needed to build various quantum computing, sensing and imaging devices. The autocorrelation method is used to detect antibunching in the emission of red photons and ascertain that the observed photons are being emitted from a single NV center. We have built an autocorrelation device that measures, with sub-nanosecond accuracy, the statistical distribution of the arrival times of the red photons emitted from a diamond sample at a photon counter. The device can measure fixed time values with a time resolution of 120 ps FWHM. For uncorrelated sources measured for 120 seconds at the TAC full range of 100 ns, the average counts in each histogram bin were about 0.01% of the predicted value. The autocorrelation device that we have built costs about 10 times less than commercial units used by other NV researchers.