Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Magneto-optical trap loaded from a low-velocity intense source

Chang Yong Park, Myung Sim Jun, D. Cho

Published Jun 1, 1999• 12 citations
Publisher

Abstract

We produced a slow atomic beam of rubidium with a low-velocity intense source (LVIS) and loaded a magneto-optical trap (MOT) in a connected chamber with the beam. The hole for the atomic beam allowed us to keep the MOT chamber at a much lower pressure than that of the LVIS. The LVIS produced an atomic beam with a continuous flux of (4.3±0.4)×109/s and an average velocity of only 11±3 m/s. The MOT captured the atoms with 67±15% efficiency, which was limited by the atomic-beam divergence. The MOT held 6×109 atoms with a typical trap-confinement time of 8 s.

DOI
10.1364/josab.16.000994

Related papers

A double magneto-optical trap system using a slow atomic beam for atom transfer

Shuyu Zhou, Zhen Xu, Zhou Shan-Yu +2 more

A rubidium double magneto-optical trap(MOT) system for Bose-Einstein condensation experiments has been set up. A slow atomic beam has been obtained with a low-velocity intense source (LVIS) and used to transfer atoms into an ultra-high-vacuum (UHV) MOT. By maintaining a pressure difference of 3 orders between LVIS-MOT and UHV-MOT, a lowest pressure of 1×10-9Pa can be achieved in UHV-MOT. The flux of the slow atomic beam is 1×109/s. About 4×108 87Rb atoms can be loaded into UHV-MOT. In this paper, maximum number of atoms captured in MOTs under two typical conditions have also been discussed.

Acta Physica Sinica•Jan 1, 2007•4 citations

Low-Velocity Intense Source of Atoms from a Magneto-optical Trap

Zheng‐Tian Lu, Kristan L. Corwin, Michael J. Renn +3 more

We have produced and characterized an intense, slow, and highly collimated atomic beam extracted from a standard vapor cell magneto-optical trap (MOT). The technique used is dramatically simpler than previous methods for producing very cold atomic beams. We have created a 0.6 mm diameter rubidium atomic beam with a continuous flux of $5\ifmmode\times\else\texttimes\fi{}{10}^{9}/\mathrm{s}$ and a pulsed flux 10 times greater. Its longitudinal velocity distribution is centered at 14 m/s with a FWHM of 2.7 m/s. Through an efficient recycling process, 70% of the atoms trapped in the MOT are loaded into the atomic beam.

Physical Review Letters•Oct 14, 1996•269 citations

Two-dimensional magneto-optical trap as a source of slow atoms

Kai Dieckmann, R. J. C. Spreeuw, Matthias Weidemüller +1 more

We experimentally study the use of two-dimensional magneto-optical trapping (2D-MOT) for the generation of slow beams of cold atoms out of a vapor cell. A particularly high flux of $9\ifmmode\times\else\texttimes\fi{}{10}^{9}$ rubidium atoms/s at a mean velocity of 8 m/s is obtained using a combination of magneto-optical trapping in two dimensions and Doppler cooling in the third dimension $({2\mathrm{D}}^{+}\ensuremath{-}\mathrm{MOT}).$ The resulting width of the velocity distribution is 3.3 m/s [full width at half maximum (FWHM)] with a beam divergence of 43 mrad (FWHM). We investigate the total flux as a function of vapor cell pressure and determine the velocity distribution of our slow atom sources. For comparison, we also realized a low-velocity intense source (LVIS), first reported by Lu et al. [Phys. Rev. Lett. 77, 3331 (1996)]. We find that the ${2\mathrm{D}}^{+}\ensuremath{-}\mathrm{MOT}$ yields a significantly higher flux than the LVIS, even when used with an order of magnitude less laser power.

Physical Review A•Nov 1, 1998•306 citations

Low-Velocity Intense Source of Atoms from a Magneto-optical Trap

Zheng‐Tian Lu, Kristan L. Corwin, Michael J. Renn +3 more

© 2008 by World Scientific Publishing Co. Pte. Ltd. All rights reserved. We have produced and characterized an intensc, slow, and highly collimatcd atomic bcani extracted from a standard vapor cell magneto-optical trap (MOT). Thc tcchniquc used is dramatically simpler than previous methods for producing very cold atomic beams. We have created a 0.6 nini diameter rubidium atomic beam with a continuous flux of 5 X 109/s and a pulsed flux 10 times greater. Its longitudinal velocity distribution is centered at 14 m/s with a FWHM of 2.7 m/s. Through an efficient recycling process, 70% of the atonis trapped in the MOT are loaded into the atomic beam. [SO03 1 -9007(96)01434-21].

WORLD SCIENTIFIC eBooks•Jan 1, 2008•3 citations

Realization of an intense cold Rb atomic beam based on a two-dimensional magneto-optical trap: Experiments and comparison with simulations

Saptarishi Chaudhuri, Sanjukta Roy, C. S. Unnikrishnan

We discuss the implementation and characterization of the source of a slow, intense, and collimated beam of rubidium atoms. The cold atomic beam is produced by two-dimensional magneto-optical trapping in directions transverse to the atomic beam axis and unbalanced Doppler cooling in the axial direction. The vacuum design allows use of relatively low laser power and a considerably simplified assembly. The atomic beam has a high flux of about $2\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}\mathrm{atoms}∕\mathrm{s}$ at a total cooling laser power of $55\phantom{\rule{0.3em}{0ex}}\mathrm{mW}$. It has a narrow longitudinal velocity distribution with mean velocity $15\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}$ with full width at half maximum $3.5\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}$ and has a low divergence of $26\phantom{\rule{0.3em}{0ex}}\mathrm{mrad}$. The high flux enables ultrafast loading of about ${10}^{10}$ atoms into a three-dimensional (3D) magneto-optical trap within 500 ms. The variation of the atomic beam flux was studied as a function of the rubidium vapor pressure, cooling laser power, transverse cooling laser beam length, detuning of the cooling laser, and relative intensities of the cooling beams along the atomic beam axis. We also discuss a detailed comparison of our measurements of the cold atomic beam with a 3D numerical simulation.

Physical Review A•Aug 18, 2006•63 citations

Low velocity intense rubidium beam source from a 3D magneto-optical trap

Xiaojia Wang, Yanying Feng, Hongbo Xue +1 more

We present an experimental set-up for the production of a beam source of cold 87Rb atoms, which is formed from a trapped cold atomic cloud in a three-dimensional (3D) magneto-optical trap (MOT). Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocity and high flux. The beam was measured to have a mean velocity of 12m/s and a longitudinal velocity spread of about 3m/s under nominal experimental conditions, based on the fluorescence and the time of flight (TOF) technologies. And its flux can be tuned by adjusting the MOT parameters from 108 to 109 atoms/s. Especially the beam performance dependence on trapping laser detuning and power is experimentally studied.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 25, 2011•0 citations
We produced a slow atomic beam of rubidium with a low-velocity intense source (LVIS) and loaded a magneto-optical trap (MOT) in a connected chamber with the beam. The hole for the atomic beam allowed us to keep the MOT chamber at a much lower pressure than that of the LVIS. The LVIS produced an atomic beam with a continuous flux of (4.3±0.4)×109/s and an average velocity of only 11±3 m/s. The MOT captured the atoms with 67±15% efficiency, which was limited by the atomic-beam divergence. The MOT held 6×109 atoms with a typical trap-confinement time of 8 s.
A rubidium double magneto-optical trap(MOT) system for Bose-Einstein condensation experiments has been set up. A slow atomic beam has been obtained with a low-velocity intense source (LVIS) and used to transfer atoms into an ultra-high-vacuum (UHV) MOT. By maintaining a pressure difference of 3 orders between LVIS-MOT and UHV-MOT, a lowest pressure of 1×10-9Pa can be achieved in UHV-MOT. The flux of the slow atomic beam is 1×109/s. About 4×108 87Rb atoms can be loaded into UHV-MOT. In this paper, maximum number of atoms captured in MOTs under two typical conditions have also been discussed.
We have produced and characterized an intense, slow, and highly collimated atomic beam extracted from a standard vapor cell magneto-optical trap (MOT). The technique used is dramatically simpler than previous methods for producing very cold atomic beams. We have created a 0.6 mm diameter rubidium atomic beam with a continuous flux of $5\ifmmode\times\else\texttimes\fi{}{10}^{9}/\mathrm{s}$ and a pulsed flux 10 times greater. Its longitudinal velocity distribution is centered at 14 m/s with a FWHM of 2.7 m/s. Through an efficient recycling process, 70% of the atoms trapped in the MOT are loaded into the atomic beam.
We experimentally study the use of two-dimensional magneto-optical trapping (2D-MOT) for the generation of slow beams of cold atoms out of a vapor cell. A particularly high flux of $9\ifmmode\times\else\texttimes\fi{}{10}^{9}$ rubidium atoms/s at a mean velocity of 8 m/s is obtained using a combination of magneto-optical trapping in two dimensions and Doppler cooling in the third dimension $({2\mathrm{D}}^{+}\ensuremath{-}\mathrm{MOT}).$ The resulting width of the velocity distribution is 3.3 m/s [full width at half maximum (FWHM)] with a beam divergence of 43 mrad (FWHM). We investigate the total flux as a function of vapor cell pressure and determine the velocity distribution of our slow atom sources. For comparison, we also realized a low-velocity intense source (LVIS), first reported by Lu et al. [Phys. Rev. Lett. 77, 3331 (1996)]. We find that the ${2\mathrm{D}}^{+}\ensuremath{-}\mathrm{MOT}$ yields a significantly higher flux than the LVIS, even when used with an order of magnitude less laser power.
© 2008 by World Scientific Publishing Co. Pte. Ltd. All rights reserved. We have produced and characterized an intensc, slow, and highly collimatcd atomic bcani extracted from a standard vapor cell magneto-optical trap (MOT). Thc tcchniquc used is dramatically simpler than previous methods for producing very cold atomic beams. We have created a 0.6 nini diameter rubidium atomic beam with a continuous flux of 5 X 109/s and a pulsed flux 10 times greater. Its longitudinal velocity distribution is centered at 14 m/s with a FWHM of 2.7 m/s. Through an efficient recycling process, 70% of the atonis trapped in the MOT are loaded into the atomic beam. [SO03 1 -9007(96)01434-21].
We discuss the implementation and characterization of the source of a slow, intense, and collimated beam of rubidium atoms. The cold atomic beam is produced by two-dimensional magneto-optical trapping in directions transverse to the atomic beam axis and unbalanced Doppler cooling in the axial direction. The vacuum design allows use of relatively low laser power and a considerably simplified assembly. The atomic beam has a high flux of about $2\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}\mathrm{atoms}∕\mathrm{s}$ at a total cooling laser power of 55mW55\phantom{\rule{0.3em}{0ex}}\mathrm{mW}55mW. It has a narrow longitudinal velocity distribution with mean velocity 15m∕s15\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}15m∕s with full width at half maximum 3.5m∕s3.5\phantom{\rule{0.3em}{0ex}}\mathrm{m}∕\mathrm{s}3.5m∕s and has a low divergence of 26mrad26\phantom{\rule{0.3em}{0ex}}\mathrm{mrad}26mrad. The high flux enables ultrafast loading of about 1010{10}^{10}1010 atoms into a three-dimensional (3D) magneto-optical trap within 500 ms. The variation of the atomic beam flux was studied as a function of the rubidium vapor pressure, cooling laser power, transverse cooling laser beam length, detuning of the cooling laser, and relative intensities of the cooling beams along the atomic beam axis. We also discuss a detailed comparison of our measurements of the cold atomic beam with a 3D numerical simulation.
We present an experimental set-up for the production of a beam source of cold 87Rb atoms, which is formed from a trapped cold atomic cloud in a three-dimensional (3D) magneto-optical trap (MOT). Via a radiation pressure difference generated by a specially designed leak tunnel along one trapping laser beam, the atoms are pushed out continuously with low velocity and high flux. The beam was measured to have a mean velocity of 12m/s and a longitudinal velocity spread of about 3m/s under nominal experimental conditions, based on the fluorescence and the time of flight (TOF) technologies. And its flux can be tuned by adjusting the MOT parameters from 108 to 109 atoms/s. Especially the beam performance dependence on trapping laser detuning and power is experimentally studied.