The family of Low Density Parity Check (LDPC) codes is a strong candidate to be used as Forward Error Correction (FEC) in future communication systems due to its strong error correction capability. Most LDPC decoders use the Message Passing algorithm for decoding, which is an iterative algorithm that passes messages between its variable nodes and check nodes. It is not until recently that computation power has become strong enough to make Message Passing on LDPC codes feasible. Although locally simple, the LDPC codes are usually large, which increases the required computation power. Earlier work on LDPC codes has been concentrated on the binary Galois Field, GF(2), but it has been shown that codes from higher order fields have better error correction capability. However, the most efficient LDPC decoder, the Belief Propagation Decoder, has a squared complexity increase when moving to higher order Galois Fields. Transmission over a channel with M-PSK signalling is a common technique to increase spectral efficiency. The information is transmitted as the phase angle of the signal. The focus in this Master’s Thesis is on simplifying the Message Passing decoding when having inputs from M-PSK signals transmitted over an AWGN channel. Symbols from higher order Galois Fields were mapped to M-PSK signals, since M-PSK is very bandwidth efficient and the information can be found in the angle of the signal. Several simplifications of the Belief Propagation has been developed and tested. The most promising is the Table Vector Decoder, which is a Message Passing Decoder that uses a table lookup technique for check node operations and vector summation as variable node operations. The table lookup is used to approximate the check node operation in a Belief Propagation decoder. Vector summation is used as an equivalent operation to the variable node operation. Monte Carlo simulations have shown that the Table Vector Decoder can achieve a performance close to the Belief Propagation. The capability of the Table Vector Decoder depends on the number of reconstruction points and the placement of them. The main advantage of the Table Vector Decoder is that its complexity is unaffected by the Galois Field used. Instead, there will be a memory space requirement which depends on the desired number of reconstruction points.
The family of Low Density Parity Check (LDPC) codes is a strong candidate to be used as Forward Error Correction (FEC) in future communication systems due to its strong error correction capability. Most LDPC decoders use the Message Passing algorithm for decoding, which is an iterative algorithm that passes messages between its variable nodes and check nodes. It is not until recently that computation power has become strong enough to make Message Passing on LDPC codes feasible. Although locally simple, the LDPC codes are usually large, which increases the required computation power. Earlier work on LDPC codes has been concentrated on the binary Galois Field, GF(2), but it has been shown that codes from higher order fields have better error correction capability. However, the most efficient LDPC decoder, the Belief Propagation Decoder, has a squared complexity increase when moving to higher order Galois Fields. Transmission over a channel with M-PSK signalling is a common technique to increase spectral efficiency. The information is transmitted as the phase angle of the signal. The focus in this Master’s Thesis is on simplifying the Message Passing decoding when having inputs from M-PSK signals transmitted over an AWGN channel. Symbols from higher order Galois Fields were mapped to M-PSK signals, since M-PSK is very bandwidth efficient and the information can be found in the angle of the signal. Several simplifications of the Belief Propagation has been developed and tested. The most promising is the Table Vector Decoder, which is a Message Passing Decoder that uses a table lookup technique for check node operations and vector summation as variable node operations. The table lookup is used to approximate the check node operation in a Belief Propagation decoder. Vector summation is used as an equivalent operation to the variable node operation. Monte Carlo simulations have shown that the Table Vector Decoder can achieve a performance close to the Belief Propagation. The capability of the Table Vector Decoder depends on the number of reconstruction points and the placement of them. The main advantage of the Table Vector Decoder is that its complexity is unaffected by the Galois Field used. Instead, there will be a memory space requirement which depends on the desired number of reconstruction points.
In this paper we investigate reduced complexity decoders for LDPC codes over M-PSK modulation. Capacity calculations show only minor losses if only phase information is considered in the decoder. We device a decoder based on phase angle summation, which unfortunately does not work for codes over Galois fields (but shows promising results for codes over integer rings). For codes over Galois fields we construct table-based decoders which gives performance close to belief propagation decoders at substantially reduced complexity
Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.
Low complexity decoding algorithms are necessary to meet data rate requirements in excess of 1 Tbps. In this paper, we study one and two bit message passing algorithms for belief propagation decoding of low-density parity-check (LDPC) codes and analyze them by density evolution. The variable nodes (VNs) exploit soft information from the channel output. To decrease the data flow, the messages exchanged between check nodes (CNs) and VNs are represented by one or two bits. The newly proposed quaternary message passing (QMP) algorithm is compared asymptotically and in finite length simulations to binary message passing (BMP) and ternary message passing (TMP) for spectrally efficient communication with higher-order modulation and probabilistic amplitude shaping (PAS). To showcase the potential for high throughput forward error correction, spatially coupled LDPC codes and a target spectral efficiency (SE) of 3 bits/QAM symbol are considered. Gains of about 0.7 dB and 0.1 dB are observed compared to BMP and TMP, respectively. The gap to unquantized belief propagation (BP) decoding is reduced to about 0.75 dB. For smaller code rates, the gain of QMP compared to TMP is more pronounced and amounts to 0.24 dB in the considered example.
In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finitegeometry LDPC codes, the proposed algorithm can perform as close as about 1 dB and 0.5 dB to belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.
In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finite-geometry LDPC codes, the proposed algorithm can achieve performance as close as 1.3 dB and 0.7 dB to that of belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.
Low-density parity-check (LDPC) codes have been known for their outstanding error-correction capabilities. With low- complexity decoding algorithms and a near capacity performance, these codes are among the most promising forward error correction schemes. LDPC decoding algorithms are generally sub-optimal and their performance not only depends on the codes, but also on many other factors, such as the code representation. In particular, a given non- binary code can be associated with a number of different field or ring image codes. Additionally, each LDPC code can be described with many different Tanner graphs. Each of these different images and graphs can possibly lead to a different performance when used with iterative decoding algorithms. Consequently, in this dissertation we try to find better representations, i.e., graphs and images, for LDPC codes. We take the first step by analyzing LDPC codes over multiple-input single-output (MISO) channels. In an n_T by 1 MISO system with a modulation of alphabet size 2M̂, each group of n_T transmitted symbols are combined and produce one received symbol at the receiver. As a result, we consider the LDPC-coded MISO system as an LDPC code over a 2̂{M n_T}-ary alphabet. We introduce a modified Tanner graph to represent MISO-LDPC systems and merge the MISO symbol detection and binary LDPC decoding steps into a single message passing decoding algorithm. We present an efficient implementation for belief propagation decoding that significantly reduces the decoding complexity. With numerical simulations, we show that belief propagation decoding over modified graphs outperforms the conventional decoding algorithm for short length LDPC codes over unknown channels. Subsequently, we continue by studying images of non-binary LDPC codes. The high complexity of belief propagation decoding has been proven to be a detrimental factor for these codes. Thereby, we suggest employing lower complexity decoding algorithms over image codes instead. We introduce three classes of binary image codes for a given non-binary code, namely: basic, mixed, and extended binary image codes. We establish upper and lower bounds on the minimum distance of these binary image codes, and present two techniques to find binary image codes with better performance under belief propagation decoding algorithm. In particular, we present a greedy algorithm to find optimized binary image codes. We then proceed by investigation of the ring image codes. Specifically, we introduce matrix-ring-image codes for a given non-binary code. We derive a belief propagation decoding algorithm for these codes, and with numerical simulations, we demonstrate that the low-complexity belief propagation decoding of optimized image codes has a performance very close to the high complexity BP decoding of the original non-binary code. Finally, in a separate study, we investigate the performance of iterative decoders over binary erasure channels. In particular, we present a novel approach to evaluate the inherent unequal error protection properties of irregular LDPC codes over binary erasure channels. Exploiting the finite length scaling methodology, that has been used to study the average bit error rate of finite-length LDPC codes, we introduce a scaling approach to approximate the bit erasure rates in the waterfall region of variable nodes with different degrees. Comparing the bit erasure rates obtained from Monte Carlo simulation with the proposed scaling approximations, we demonstrate that the scaling approach provides a close approximation for a wide range of code lengths. In view of the complexity associated with the numerical evaluation of the scaling approximation, we also derive simpler upper and lower bounds and demonstrate through numerical simulations that these bounds are very close to the scaling approximation