Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Nb superconducting hot electron bolometer mixers coupled with microstrip lines

W. F. M. Ganzevles, Pavel A. Yagoubov, J. R. Gao, T. M. Klapwijk, Piet A. J. de Korte

Published Mar 1, 2001• 1 citation
Publisher

Abstract

The measured direct and heterodyne response of a quasi-optically coupled superconducting Nb hot-electron bolometer mixer (HEBM) at 2.5 THz is reported. This mixer exploits a novel coupling circuit in which the microstrip line transformer is used to feed the rf signal from the twin slot antenna to the microbridge. The microstrip line is made of Au/SiO/sub 2//Al. Using a Fourier transform spectrometer, the frequency response of such a device is measured. We find a peak response at a frequency of 1.9 THz, which is 20% lower than predicted, and a bandwidth of 1.6 THz as we expect. By applying 2.5 THz radiation from a far infrared laser, we measure an uncorrected noise temperature T/sub N,rec/ of 4200 K.

DOI
10.1109/77.919409

Related papers

Direct response of microstrip line coupled Nb THz hot-electron bolometer mixers

W. F. M. Ganzevles, J. R. Gao, Piet A. J. de Korte +1 more

We study the direct response of a superconducting Nb hot-electron bolometer mixer centered at 2.5 THz that incorporates an Au/SiO2/Al microstrip transmission line. The direct response is studied using a Fourier transform spectrometer. We find a peak response at a frequency of 2.1 THz, which is 20% lower than predicted based on a model that neglects the inductance effect in the microbridge.

Applied Physics Letters•Oct 8, 2001•2 citations

Direct and Heterodyne Response of Quasi Optical Nb Hot-Electron Bolometer Mixers Designed for 2.5 Thz Radiation Detection

W. F. M. Ganzevles, J. R. Gao, W. M. Laauwen +3 more

We measure the direct response of a Nb di usion-cooled hot electron bolometer mixer in a frequency range between 0.5 THz and 3.5 THz. The mixer consists essentially of a twin slot antenna, a co-planar waveguide transmission line and a Nb superconducting bridge. It is designed for use in receivers with astronomical and atmospherical applications around 2.5 THz. We calculate the impedance of the antenna, the transmission line and the bridge separately using models which are developed for frequencies below 1 THz and predict the direct response of the mixer. We demonstrate that these models can be applied to much higher frequencies. However, the measured central frequency is 10-15% lower than predicted. Using a far infrared (FIR) laser, the device can be fully pumped at 2.5 THz. A preliminary Y-factor measurement shows a corrected noise temperature of

•May 1, 2000•4 citations

A low-noise 2.5 THz superconductive Nb hot-electron mixer

Boris S. Karasik, Michael C. Gaidis, William R. McGrath +2 more

We report on the development of a quasioptical Nb hot-electron bolometer mixer for a 2.5 THz heterodyne receiver. The devices are fabricated from a 12 nm thick Nb film, and have a 0.30 /spl mu/m/spl times/0.15 /spl mu/m in-plane size, thus exploiting diffusion as the electron cooling mechanism. The rf coupling was provided by a twin-slot planar antenna on an elliptical Si lens. A specially designed 2.5 THz system, using a CO/sub 2/-pumped FIR laser as local oscillator (LO), with rf hot/cold loads enclosed in vacuum to avoid atmospheric absorption, was used in the experiment. The experimentally measured double sideband (DSB) noise temperature of the receiver was as low as /spl les/3000 K, with an estimated mixer noise temperature of /spl ap/750 K. These results demonstrate the operation of the diffusion-cooled bolometer mixer above 2 THz.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•32 citations

Direct response of twin-slot antenna-coupled hot-electron bolometer mixers designed for 2.5 THz radiation detection

W. F. M. Ganzevles, L. R. Swart, J. R. Gao +2 more

We measure the direct response of a Nb diffusion-cooled hot-electron bolometer mixer in a frequency range between 0.5 and 3.5 THz. The mixer consists essentially of a twin-slot antenna, a co-planar waveguide transmission line and a Nb superconducting bridge. It is designed for use in receivers with astronomical and atmospherical applications around 2.5 THz. We calculate the impedance of the antenna, the transmission line, and the bridge separately using models which are developed for frequencies below 1 THz and predict the direct response of the mixer. We demonstrate that these models can be applied to much higher frequencies. However, the measured central frequency is 10%–15% lower than predicted.

Applied Physics Letters•May 29, 2000•28 citations

Low-noise and wideband hot-electron superconductive mixer for terahertz frequencies

Boris S. Karasik, Anders J. Skalare, William R. McGrath +7 more

Superconductive hot-electron bolometer (HEB) mixers have been built and tested in the frequency range from 1.1 THz to 2.5 THz. The mixer device is a 0.15 - 0.3 micrometer microbridge made from a 10 nm thick Nb film. This device employs diffusion as a cooling mechanism for hot electrons. The double sideband noise temperature was measured to be less than or equal to 3000 K at 2.5 THz and the mixer IF bandwidth is expected to be at least 10 GHz for a 0.1 micrometer long device. The local oscillator (LO) power dissipated in the HEB microbridge was 20 - 100 nW. Further improvement of the mixer characteristics can be potentially achieved by using Al microbridges. The advantages and parameters of such devices are evaluated. The HEB mixer is a primary candidate for ground based, airborne and spaceborne heterodyne instruments at THz frequencies. HEB receivers are planned for use on the NASA Stratospheric Observatory for Infrared Astronomy (SOFIA) and the ESA Far Infrared and Submillimeter Space Telescope (FIRST). The prospects of a submicron-size YBa2Cu3O7-(delta ) (YBCO) HEB are discussed. The expected LO power of 1 - 10 (mu) W and SSB noise temperature of approximately equals 2000 K may make this mixer attractive for various remote sensing applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 13, 1998•1 citation

Low-noise and wideband hot-electron superconductive mixers for THz frequencies

Boris S. Karasik, Anders J. Skalare, Rolf A. Wyss +5 more

Superconductive hot-electron bolometer (HEB) mixers have been built and tested in the frequency range 1.1-2.5 THz. The mixer device is a 0.15-03 /spl mu/m microbridge made from a 10 nm thick Nb film. This device employs diffusion as a cooling mechanism for hot electrons. The double sideband noise temperature was measured to be /spl les/3000 K at 2.5 THz and the mixer IF bandwidth is /spl ap/9-10 GHz for a 0.1 /spl mu/m long device. The local oscillator (LO) power dissipated in the HEB microbridge was 20-100 nW. Further improvement of the mixer characteristics can be potentially achieved by using Al microbridges. The advantages and parameters of such devices are evaluated The HEB mixer Is a primary candidate for ground based, airborne and spaceborne heterodyne instruments at THz frequencies. HEB receivers are planned for use on the NASA Stratospheric Observatory for Infrared Astronomy (SOFIA) and the ESA Far Infrared and Submillimeter Space Telescope (FIRST). The prospects of a submicron-size YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// (YBCO) HEB are also discussed. The expected LO power of 1-10 /spl mu/W and SSB noise temperature of /spl ap/2000 K may make this mixer attractive for various remote sensing applications.

IEEE International Conference on Terahertz Electronics (THz)•Nov 27, 2002•5 citations
The measured direct and heterodyne response of a quasi-optically coupled superconducting Nb hot-electron bolometer mixer (HEBM) at 2.5 THz is reported. This mixer exploits a novel coupling circuit in which the microstrip line transformer is used to feed the rf signal from the twin slot antenna to the microbridge. The microstrip line is made of Au/SiO/sub 2//Al. Using a Fourier transform spectrometer, the frequency response of such a device is measured. We find a peak response at a frequency of 1.9 THz, which is 20% lower than predicted, and a bandwidth of 1.6 THz as we expect. By applying 2.5 THz radiation from a far infrared laser, we measure an uncorrected noise temperature T/sub N,rec/ of 4200 K.
We measure the direct response of a Nb di usion-cooled hot electron bolometer mixer in a frequency range between 0.5 THz and 3.5 THz. The mixer consists essentially of a twin slot antenna, a co-planar waveguide transmission line and a Nb superconducting bridge. It is designed for use in receivers with astronomical and atmospherical applications around 2.5 THz. We calculate the impedance of the antenna, the transmission line and the bridge separately using models which are developed for frequencies below 1 THz and predict the direct response of the mixer. We demonstrate that these models can be applied to much higher frequencies. However, the measured central frequency is 10-15% lower than predicted. Using a far infrared (FIR) laser, the device can be fully pumped at 2.5 THz. A preliminary Y-factor measurement shows a corrected noise temperature of
We report on the development of a quasioptical Nb hot-electron bolometer mixer for a 2.5 THz heterodyne receiver. The devices are fabricated from a 12 nm thick Nb film, and have a 0.30 /spl mu/m/spl times/0.15 /spl mu/m in-plane size, thus exploiting diffusion as the electron cooling mechanism. The rf coupling was provided by a twin-slot planar antenna on an elliptical Si lens. A specially designed 2.5 THz system, using a CO/sub 2/-pumped FIR laser as local oscillator (LO), with rf hot/cold loads enclosed in vacuum to avoid atmospheric absorption, was used in the experiment. The experimentally measured double sideband (DSB) noise temperature of the receiver was as low as /spl les/3000 K, with an estimated mixer noise temperature of /spl ap/750 K. These results demonstrate the operation of the diffusion-cooled bolometer mixer above 2 THz.
We measure the direct response of a Nb diffusion-cooled hot-electron bolometer mixer in a frequency range between 0.5 and 3.5 THz. The mixer consists essentially of a twin-slot antenna, a co-planar waveguide transmission line and a Nb superconducting bridge. It is designed for use in receivers with astronomical and atmospherical applications around 2.5 THz. We calculate the impedance of the antenna, the transmission line, and the bridge separately using models which are developed for frequencies below 1 THz and predict the direct response of the mixer. We demonstrate that these models can be applied to much higher frequencies. However, the measured central frequency is 10%–15% lower than predicted.
Superconductive hot-electron bolometer (HEB) mixers have been built and tested in the frequency range from 1.1 THz to 2.5 THz. The mixer device is a 0.15 - 0.3 micrometer microbridge made from a 10 nm thick Nb film. This device employs diffusion as a cooling mechanism for hot electrons. The double sideband noise temperature was measured to be less than or equal to 3000 K at 2.5 THz and the mixer IF bandwidth is expected to be at least 10 GHz for a 0.1 micrometer long device. The local oscillator (LO) power dissipated in the HEB microbridge was 20 - 100 nW. Further improvement of the mixer characteristics can be potentially achieved by using Al microbridges. The advantages and parameters of such devices are evaluated. The HEB mixer is a primary candidate for ground based, airborne and spaceborne heterodyne instruments at THz frequencies. HEB receivers are planned for use on the NASA Stratospheric Observatory for Infrared Astronomy (SOFIA) and the ESA Far Infrared and Submillimeter Space Telescope (FIRST). The prospects of a submicron-size YBa2Cu3O7-(delta ) (YBCO) HEB are discussed. The expected LO power of 1 - 10 (mu) W and SSB noise temperature of approximately equals 2000 K may make this mixer attractive for various remote sensing applications.
Superconductive hot-electron bolometer (HEB) mixers have been built and tested in the frequency range 1.1-2.5 THz. The mixer device is a 0.15-03 /spl mu/m microbridge made from a 10 nm thick Nb film. This device employs diffusion as a cooling mechanism for hot electrons. The double sideband noise temperature was measured to be /spl les/3000 K at 2.5 THz and the mixer IF bandwidth is /spl ap/9-10 GHz for a 0.1 /spl mu/m long device. The local oscillator (LO) power dissipated in the HEB microbridge was 20-100 nW. Further improvement of the mixer characteristics can be potentially achieved by using Al microbridges. The advantages and parameters of such devices are evaluated The HEB mixer Is a primary candidate for ground based, airborne and spaceborne heterodyne instruments at THz frequencies. HEB receivers are planned for use on the NASA Stratospheric Observatory for Infrared Astronomy (SOFIA) and the ESA Far Infrared and Submillimeter Space Telescope (FIRST). The prospects of a submicron-size YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// (YBCO) HEB are also discussed. The expected LO power of 1-10 /spl mu/W and SSB noise temperature of /spl ap/2000 K may make this mixer attractive for various remote sensing applications.