Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Analysis of transient response and instability in fiber ring resonators containing an erbium-doped fiber amplifier and quantum dot-doped fiber saturable absorber

Sara Tofighi, Ali Reza Bahrampour

Published Nov 13, 2013• 1 citation
Publisher

Abstract

In this paper, the transient response of a double coupler fiber ring resonator containing an erbium-doped fiber amplifier (EDFA) in half part of the fiber ring resonator and a quantum dot-doped fiber (QDF) saturable absorber in the other half, is investigated. It is demonstrated that, depending on the device parameters and the input power of the signal and pump, various types of dynamic behaviors (such as bistability, monostability, and regenerative pulsation) can be observed in this intrinsic, optical bistable device. The proposed device can be exploited by optical communication networks to realize all-optical functionalities.

DOI
10.1364/josab.30.003215

Related papers

Optical bistability in fiber ring resonator containing an erbium doped fiber amplifier and quantum dot doped fiber saturable absorber

Sara Tofighi, Somayeh Safari Farshemi, Batool Sajad +2 more

In this paper we study the optical bistability in a double coupler fiber ring resonator which consists of an erbium doped fiber amplifier (EDFA) in half part of the fiber ring and a quantum dot doped fiber (QDF) saturable absorber in the other half. The bistability is provided by the QDF section of the ring resonator. The EDFA is employed to reduce the switching power. The transmitted and reflected bistability characteristics are investigated. It is shown that the switching power for this new bistable device is less than 10 mW.

Applied Optics•Oct 4, 2012•6 citations

Dynamic transmission properties of a nonlinear fiber ring resonator

Kazuhiko Ogusu, Hidenori Shigekuni, Yasuo Yokota

We present a method for calculating the dynamic input–output characteristics of a nonlinear fiber ring resonator caused by a change in input intensity. It is based on an original method developed by Bischofberger and Shen [Phys. Rev. A 19, 1169 (1979)] to study a transient nonlinear Fabry–Perot resonator. We treat a double-coupler fiber ring resonator, in which two types of optical bistability (transmission bistability and reflection bistability) are available and present the illustrative numerical results for a few cavity parameters. This analysis will be useful for a future experimental verification of optical bistability in fiber ring resonators and for the design of fiber bistable devices.

Optics Letters•Nov 15, 1995•31 citations

Fiber-ring laser with tunable optical bistability

Jiafeng Shao, Qin Shen, Z. J. Wu +3 more

The structure of combining two segments of erbium-doped fiber (EDF) together—one EDF acting as an amplifier and the other as an absorber—has a special gain characteristic curve which has a maximum gain with an increase in the input signal power. This special gain characteristic curve can lead to an optical bistability (OB) phenomenon in a fiber-ring laser employing an EDF of this structure. By adjusting the pump light power injected into the second segment of the EDF, we can change the behavior of the absorber and can, therefore, control the range of the bistability region. A method is proposed to calculate the tunable optical bistability, and the calculation result is in accordance with our experiment.

Laser Physics•Sep 1, 2008•1 citation

Transient analysis of a nonlinear fiber ring resonator

Francisco Javier Fraile-Pelaez, Miguel Prol, David J. Santos +1 more

In this letter we study the transient behavior of a nonlinear fiber ring resonator operating both as an optical bistable and as a differential amplifier. The speed of response of the structure is investigated, and some general considerations on the performance of these kinds of devices are presented.

Applied Physics Letters•Sep 13, 1993•12 citations

Dynamic behavior of reflection optical bistability in a nonlinear fiber ring resonator

Kazuhiko Ogusu

We present an analysis of the dynamic behavior of a nonlinear fiber ring resonator when an optical pulse with an arbitrary shape envelope is incident into it through a fiber directional coupler. The transient analysis is based on the extension of a well-known multiple-beam interference method to non-linear transmission problems. The steady-state analyses reported so far predict that the ring resonator exhibits reflection optical bistability in the input-output characteristics under appropriate conditions. But, our transient analysis shows that a nearly periodical oscillation of the transmitted power always takes place at a suitable initial detuning when the resonator has no loss or a small loss. It seems that the present instability is caused by the repetition of accumulation and release of the power in the ring resonator. We can obtain a bistable hysteresis loop by introducing a loss to the directional coupler. The dynamic behavior of bistability in a nonlinear fiber ring resonator with coupler loss is then investigated. It is found that a remarkable undershoot and overshoot occur in the switch-off curve and switch-on curve, respectively.

IEEE Journal of Quantum Electronics•Jan 1, 1996•31 citations

Saturable Absorption in Erbium-doped Fiber and Optical Bistability in Erbium-doped Fiber Ring Laser

Deeksha Jachpure, R. Vijaya

Saturable absorption in erbium-doped fiber is presented through absorption measurements using a tunable laser and variable power. Its consequent optical bistability is also observed in erbium-doped fiber ring laser with long lengths of the fiber. Higher absorption at shorter wavelengths enables a wider bistable range.

Photonics North (PN)•May 31, 2021•2 citations
In this paper, the transient response of a double coupler fiber ring resonator containing an erbium-doped fiber amplifier (EDFA) in half part of the fiber ring resonator and a quantum dot-doped fiber (QDF) saturable absorber in the other half, is investigated. It is demonstrated that, depending on the device parameters and the input power of the signal and pump, various types of dynamic behaviors (such as bistability, monostability, and regenerative pulsation) can be observed in this intrinsic, optical bistable device. The proposed device can be exploited by optical communication networks to realize all-optical functionalities.
In this paper we study the optical bistability in a double coupler fiber ring resonator which consists of an erbium doped fiber amplifier (EDFA) in half part of the fiber ring and a quantum dot doped fiber (QDF) saturable absorber in the other half. The bistability is provided by the QDF section of the ring resonator. The EDFA is employed to reduce the switching power. The transmitted and reflected bistability characteristics are investigated. It is shown that the switching power for this new bistable device is less than 10 mW.
We present a method for calculating the dynamic input–output characteristics of a nonlinear fiber ring resonator caused by a change in input intensity. It is based on an original method developed by Bischofberger and Shen [Phys. Rev. A 19, 1169 (1979)] to study a transient nonlinear Fabry–Perot resonator. We treat a double-coupler fiber ring resonator, in which two types of optical bistability (transmission bistability and reflection bistability) are available and present the illustrative numerical results for a few cavity parameters. This analysis will be useful for a future experimental verification of optical bistability in fiber ring resonators and for the design of fiber bistable devices.
The structure of combining two segments of erbium-doped fiber (EDF) together—one EDF acting as an amplifier and the other as an absorber—has a special gain characteristic curve which has a maximum gain with an increase in the input signal power. This special gain characteristic curve can lead to an optical bistability (OB) phenomenon in a fiber-ring laser employing an EDF of this structure. By adjusting the pump light power injected into the second segment of the EDF, we can change the behavior of the absorber and can, therefore, control the range of the bistability region. A method is proposed to calculate the tunable optical bistability, and the calculation result is in accordance with our experiment.
We present an analysis of the dynamic behavior of a nonlinear fiber ring resonator when an optical pulse with an arbitrary shape envelope is incident into it through a fiber directional coupler. The transient analysis is based on the extension of a well-known multiple-beam interference method to non-linear transmission problems. The steady-state analyses reported so far predict that the ring resonator exhibits reflection optical bistability in the input-output characteristics under appropriate conditions. But, our transient analysis shows that a nearly periodical oscillation of the transmitted power always takes place at a suitable initial detuning when the resonator has no loss or a small loss. It seems that the present instability is caused by the repetition of accumulation and release of the power in the ring resonator. We can obtain a bistable hysteresis loop by introducing a loss to the directional coupler. The dynamic behavior of bistability in a nonlinear fiber ring resonator with coupler loss is then investigated. It is found that a remarkable undershoot and overshoot occur in the switch-off curve and switch-on curve, respectively.